两相厌氧反应器相分离实验研究

在两相上流式厌氧生物反应器(UASB)动力学启动成功的条件下,选用钼酸盐作为产甲烷菌抑制剂,进行进一步的分相实验。实验前3 d在产酸相反应器进水中投加2.0 mmol/L的钼酸钠溶液,出水不进入产甲烷反应器。然后停止投加钼酸钠溶液,再运行3 d,出水依然不进入产甲烷反应器。6 d后,产酸反应器出水开始进入产甲烷反应器。结果表明:在停止投加钼酸盐后产酸菌便迅速恢复,而钼酸盐对产甲烷菌的作用是杀灭性的;产酸相出水去除效果降低,但是其酸化率由50%左右上升并最终稳定在60%左右,同时两相厌氧反应器整体去除效率提高。     

Temporal trend (1988-2008) of hexabromocyclododecane enantiomers in herring gull eggs from the German coastal region

Levels of α-, β-, and γ-hexabromocyclododecane (HBCD) were determined in pooled eggs from herring gulls (Larus argentatus) sampled on three bird sanctuaries near the German North Sea coast between 1988 and 2008 (Mellum and Trischen) and the German Baltic Sea coast between 1998 and 2008 (Heuwiese) and archived by the German Environmental Specimen Bank. Pressurized fluid extraction, gel permeation chromatography, and LC-MS/MS using ¹³C₁₂-labelled isotope standards and a chiral column were applied. α-HBCD was the dominating diastereomer and ranged between 3.7 and 107 ng g⁻¹ lw while β- and γ-HBCD were throughout close to LOQ. The highest α-HBCD concentration was found in eggs from Mellum sampled in the year 2000. Interestingly, HBCD in eggs from the three islands displayed similar time courses with levels increasing to a peak contamination around 2000 and decreasing levels ever since. Chiral signatures of α-HBCD in eggs differed among the islands but indicated a preferential enrichment of the first eluting enantiomer (−)-α-HBCD.     

Selective removal of diclofenac from contaminated water using molecularly imprinted polymer microspheres

A molecularly imprinted polymer (MIP) was synthesized by precipitation polymerization using diclofenac (DFC) as a template. Binding characteristics of the MIP were evaluated using equilibrium binding experiments. Compared to the non-imprinted polymer (NIP), the MIP showed an outstanding affinity towards DFC in an aqueous solution with a binding site capacity (Q_max) of 324.8 mg/g and a dissociation constant (K_d) of 3.99 mg/L. The feasibility of removing DFC from natural water by the MIP was demonstrated by using river water spiked with DFC. Effects of pH and humic acid on the selectivity and adsorption capacity of MIP were evaluated in detail. MIP had better selectivity and higher adsorption efficiency for DFC as compared to that of powdered activated carbon (PAC). In addition, MIP reusability was demonstrated for at least 12 repeated cycles without significant loss in performance, which is a definite advantage over single-use activated carbon.     

水合物法分离CO2研究

混合气体在形成水合物时,水合物内的气体组分与气相内不同。CO2溶解度远高于N2、O2、H2等气体,因此水合物法可分离燃煤电厂烟气中的CO2。分析了气体组成、压力、温度、促进剂和多孔介质等因素对水合物法分离CO2的影响,指出采用耦合技术降低操作压力和提高水合速度是今后改进和努力的方向。     

气流分选废旧线路板树脂粉末的实验研究

为了提高线路板树脂粉末各成分富集率,实验利用气流分选装置对线路板树脂粉末进行分选,通过调节分级机转速大小进行了4组实验。结果表明：在分级机转速为120 r/min时,2个卸料口获得分级产物Cu成分含量相差最大,卸料口1的Cu含量最大,达到16.2%;在分级机转速为360 r/min时,2个卸料口获得分级产物环氧树脂成分...     

气浮—磁分离工艺处理含油废水

采用气浮—磁分离工艺处理某石化企业的含油废水,重点考察了磁分离单元的工艺条件对除油率的影响。实验结果表明磁分离单元的最佳工艺条件为:絮凝剂聚合氯化铝加入量25 mg/L,磁种加入量100 mg/L,磁场强度40 mT,搅拌条件为先以150 r/min的转速搅拌2 min,再以50 r/min的转速搅拌5 min。在最佳工艺条件下进行气浮—磁分离工艺除油实验,在进水油质量浓度平均为29.5 mg/L时,气浮单元出水油质量浓度平均为8.5 mg/L,除油率平均为71.1%;磁分离单元出水油质量浓度平均为4.7 mg/L,除油率平均为44.1%;总除油率平均为83.8%。     

应用POMS复合膜分离去除废气中挥发性有机污染物

依靠POMS平板单层膜或POMS卷式膜上选择性分离层的选择性溶解和渗透作用,常温负压分离回收废气中乙酸乙酯等挥发性有机污染物(VOC)组分.结果表明,膜两侧操作压差和原料气流量对乙酸乙酯分离效率影响较大;当原料气处理量为1.770 0～2.810 0 m3/(m2·h)、膜两侧操作压差为0.08 MPa,POMS卷式膜乙酸乙酯渗透速率可达7.86 × 10-7 mol/(s·m2·Pa);乙酸乙酯为1 500～4 500 mg/m3时,其去除率可达80%.测得几种VOC组分在POMS复合膜中的溶解吸附量都比较可观,由此预测该膜处理废气中VOC可取得很好的净化效果.甲苯在POMS复合膜中的溶解吸附量低于乙酸乙酯,其实验测得渗透速率也小于乙酸乙酯.甲苯去除率也能达到80%.     

电解浮选用于活性污泥固液分离的正交实验研究

本研究旨在探索用电解浮选进行活性污泥固液分离的可行性。研究通过小试试验确定电解浮选进行活性污泥固液分离的适宜工艺条件,在装有Ti/RuO₂-IrO₂-TiO₂阳极、Ti阴极的电解浮选槽中进行了活性污泥固液分离的研究,针对影响电解气浮工艺的4个主要影响因素（水力停留时间、接触室电流密度、分离区电流密度和接触室极板间距）及3个合适的水平进行正交试验。结果表明,分离区电流密度是最主要影响因素。当进水SS浓度为1687 mg/L时,在停留时间为25 min,接触室电流密度为5 mA/cm²,分离区电流密度为4 mA/cm²,极板间距为3 mm的条件下进行电解浮选验证性试验,悬浮固体颗粒物去除率较高,去除率为98.9% ,能耗0.54 kWh/m³。     

胶质气体泡沫气浮分离含Cu(Ⅱ)废水的试验研究

用阴离子表面活性剂十二烷基硫酸钠(SDS)制备胶质气体泡沫并将之引入浮选柱,以胶质气体泡沫为浮选载体并通入常规浮选气泡对预先装入浮选柱的模拟含Cu(Ⅱ)废水进行浮选分离实验,考察了pH值、铜离子初始浓度、SDS用量和絮凝剂的添加对Cu(Ⅱ)去除率的影响。实验结果表明,采用胶质气体泡沫与常规柱浮选气泡相结合的方法处理含Cu(Ⅱ)废水,铜离子去除率可达99%以上。     

采用重选法处理蚀刻废液零排放资源化新工艺

阐述了广州市白云区南溪化工厂开发出的一套国内首创的对线路板蚀刻废液进行大规模集中资源化处理的零排放处理新工艺,这套新工艺采用重力分选的方法将在固相条件下生成的氧化铜分离出来,克服了原有工艺的缺陷,达到了理想的分离效果,使废液中所有的成分能够在较低的处理成本下全部分离回收,完全无三废排出,达到了清洁生产的要求。