ORBAL氧化沟在炼油污水处理上的应用

总结了石炼污水处理场采用ORBAL氧化沟做为二级生化处理设施的成功经验，并对ORBAL氧化沟和周边进水，周边出水二沉池的运行机理进行了说明。     

环境中二噁(口英)及其检测技术进展

从二(?)(?)类化合物的结构、来源、毒性等简要说明对其监测的必要性,且从仪器监测(包括气相色谱、气质联用、串联质谱等)和生物监测(包括利用指示生物、生物标志物等)概述了80年代以来国内外对二(?)(?)类物质尤其是几种极毒性化合物如多氯代二苯二(?)(?)(PCDDs)和多氯代二苯呋喃(PCDFs)等化合物的检测技术成果。     

难降解有机废水处理新技术

介绍了光氧化法、超临界氧化和低温等离子体化学三种废水处理新技术的原理,国内外研究的现状和未来的发展前景,分析了这些新技术在优化污染物废水处理方面得到工业应用所必须解决的主要技术问题.     

关于现代模具制造的研究

此文构造了面向工艺过程规划的现代模具制造框架,并与传统模具制造相对比,总结出现代模具制造的主要特点,存在的问题及相应对策。     

GdFeO3上CO氧化的Redox机理动力学

ＧｄＦｅＯ３用柠檬酸络合制备。用ＸＲＤ测定ＧｄＦｅＯ３为钙钛矿结构。用ＣＯ还原脉冲及用Ｏ２再氧化脉冲证实在ＧｄＦｅＯ３上ＣＯ氧化为Ｒｅｄｏｘ机理。用外循环流动无梯度反应顺研究了ＣＯ氧化稳态动力学。用正交设计法估计动力学方程中的参数。还原催化剂再氧化为控制步骤。     

毛细管色谱-多离子检测质谱法测定土壤中2,3,7,8-四氯二苯并二噁(2,3,7,8-TCDD)

环境中的多氯二苯并二(口恶)(口英)(PCDD_s)和多氯二苯并呋喃(PCDF_s)是当今最受重视的污染物之一,其中PCDD_s有75个异构体而PCDF_s有135个异构体,它们的毒性大小显著地依赖于氯原子的取代数和取代位置,由于这类污染物的低溶解度和高的辛醇/水分配系数,主要分布在土壤(85％)和沉积物(14％)中,只有1％进入空气、水和生物体.在自然环境中这类污染物代谢降解速度缓慢,从而增加了环境污染的复杂性.而鉴别这类污染物就成为一个主要研究课题.     

生物陶粒流化床-污泥滤层脱氮工艺的试验研究

采用生物陶粒流化床-污泥滤层工艺对含氮有机废水处理进行试验研究,研究结果表明:系统内可固着生长不受抑制的硝化菌种群,氨氮去除率可以达到93%￣95%;三相分离区形成稳定的污泥滤层,可使总氮去除率得以显著提高;当HRT为1.5h,曝气量为0.25m3/h,BOD容积负荷为9.2～10.4BOD5/m3.d,总氮容积负荷0.65kgTN/m3.d条件下,可得到BOD5的去除率85%,总氮去除率74%的处理效果。     

高压脉冲电凝聚技术处理活性染料废水试验研究

难生物降解有机废水是废水处理的难点。阐述了高压脉冲电凝聚技术处理高浓度、难生物降解有机废水的最新机理。采用高压脉冲电凝聚技术处理活性染料（活性红）生产废水．研究了影响高压脉冲电凝聚技术处理活性染料废水效果的操作条件及影响因素．结果表明，在最佳处理工艺条件下。CODCr浓度12628mg／L的生产废水经处理后CODCr去除率为65％左右。再经后续混凝沉淀，最终出水CODCr可降低到1000mg／L以下。     

Comparison of UV-based advanced oxidation processes for the removal of different fractions of NOM from drinking water

This study examined the effectiveness for degradation of hydrophobic (HPO), transphilic (TPI) and hydrophilic (HPI) fractions of natural organic matter (NOM) during UV/H₂O₂, UV/TiO₂ and UV/K₂S₂O₈ (UV/PS) advanced oxidation processes (AOPs). The changing characteristics of NOM were evaluated by dissolved organic carbon (DOC), the specific UV absorbance (SUVA), trihalomethanes formation potential (THMFP), organic halogen adsorbable on activated carbon formation potential (AOXFP) and parallel factor analysis of excitation–emission matrices (PARAFAC-EEMs). In the three UV-based AOPs, HPI fraction with low molecular weight and aromaticity was more likely to degradate than HPO and TPI, and the removal efficiency of SUVA for HPO was much higher than TPI and HPI fraction. In terms of the specific THMFP of HPO, TPI and HPI, a reduction was achieved in the UV/H₂O₂ process, and the higest removal rate even reached to 83%. UV/TiO₂ and UV/PS processes can only decrease the specific THMFP of HPI. The specific AOXFP of HPO, TPI and HPI fractions were all able to be degraded by the three UV-based AOPs, and HPO content is more susceptible to decompose than TPI and HPI content. UV/H₂O₂ was found to be the most effective treatment for the removal of THMFP and AOXFP under given conditions. C1 (microbial or marine derived humic-like substances), C2 (terrestrially derived humic-like substances) and C3 (tryptophan-like proteins) fluorescent components of HPO fraction were fairly labile across the UV-based AOPs treatment. C3 of each fraction of NOM was the most resistant to degrade upon the UV-based AOPs. Results from this study may provide the prediction about the consequence of UV-based AOPs for the degradation of different fractions of NOM with varied characteristics.     

Catalytic oxidation effect of MnSO4 on As(III) by air in alkaline solution

The catalytic oxidation effect of MnSO₄ on As(III) by air in an alkaline solution was investigated. According to the X-ray diffraction (XRD), scanning electron microscope-energy dispersive spectrometer (SEM-EDS) and X-ray photoelectron spectroscopy (XPS) analysis results of the product, it was shown that the introduction of MnSO₄ in the form of solution would generate Na_0.55Mn₂O₄·1.5H₂O with strong catalytic oxidation ability in the aerobic alkaline solution, whereas the catalytic effect of the other product MnOOH is not satisfactory. Under the optimal reaction conditions of temperature 90°C, As/Mn molar ratio 12.74:1, air flow rate 1.0 L/min, and stirring speed 300 r/min, As(III) can be completely oxidized after 2 hr reaction. The excellent catalytic oxidation ability of MnSO₄ on As(III) was mainly attributed to the indirect oxidation of As(III) by the product Na_0.55Mn₂O₄·1.5H₂O. This study shows a convenient and efficient process for the oxidation of As(III) in alkali solutions, which has potential application value for the pre-oxidation of arsenic-containing solution or the detoxification of As(III).