污泥投配率对污泥中温厌氧消化效果影响的试验研究

试验装置采用半连续流污泥中温厌氧消化反应器,污泥培养接近成熟后开始每天按不同污泥投配率加泥和排泥.结果表明:污泥投配率在3%～10%时,有机物分解率先增大后减小,去除率均在30%以上;污泥投配率在15%和20%时,污泥的有机物去除率非常小;污泥投配率在5%时,有机物分解率最大为41.2%;单位VSS产气量随污泥投配率的增大而呈先急剧上升后逐渐下降的趋势,当污泥投配率为5%时,单位VSS产气量为0.60 L/g,符合美国污水处理厂设计手册标准,其他污泥投配率下该指标均小于0.4 L/g.因此,认为实验用污泥中温消化的最佳污泥投配率为5%,这时污泥的可消化性较好.     

Enhanced sludge solubilization by microbubble ozonation

A microbubble ozonation process for enhancing sludge solubilization was proposed and its performance was evaluated in comparison to a conventional ozone bubble contactor. Microbubbles are defined as bubbles with diameters less than several tens of micrometers. Previous studies have demonstrated that microbubbles could accelerate the formation of hydroxyl radicals and hence improve the ozonation of dyestuff wastewater. The results of this study showed that microbubble ozonation was effective in increasing ozone utilization and improving sludge solubilization. For a contact time of 80 min, an ozone utilization efficiency of more than 99% was obtained using the microbubble system, while it gradually decreased from 94% to 72% for the bubble contactor. The rate of microbial inactivation was obviously faster in the microbubble system. At an ozone dose of 0.02 g O₃ g⁻¹ TSS, about 80% of microorganisms were inactivated in the microbubble system, compared with about 50% inactivation for the bubble contactor. Compared to the bubble contactor, more than two times of COD and total nitrogen, and eight times of total phosphorus content were released from the sludge into the supernatant by using the microbubble system at the same ozone dosage. The application of microbubble technology in ozonation processes may provide an effective and low cost approach for sludge reduction.     

Perfluorochemicals in wastewater treatment plants and sediments in Hong Kong

The study reported in this paper examined the concentrations of nineteen perfluorochemicals (PFCs), including perfluoroalkyl sulfonates, carboxylates, and sulfonamides in samples collected from Hong Kong wastewater treatment plants (WWTPs) and sediments. The study was the first to use an external isolator column to assist in the quantification of PFCs in environmental samples without having to make internal modifications to a liquid chromatography system. Perfluorooctanesulfonate was found to be the dominant PFC pollutant in Hong Kong, and the WWTP sludge was the major sink of PFCs discharged from the urban areas. Compared to discharge influenced by industrial activities, much less perfluorooctanoate was found in waste streams. The significantly lower level of perfluorodecanesulfonate in WWTP sludge reflects the important influence of consumer products on PFC distribution. The dominance of even-chain length perfluoroalkyl carboxylates in all of the WWTP sludge samples investigated further suggests the strong aerobic degradation of fluorotelomer alcohols in WWTPs.     

污泥中重金属的稳定化研究进展与去除方法简述

通过"十一五"污水处理厂的建设,我国污泥产量也随之大幅增长,污泥的处理处置已经成为制约社会经济发展的重要问题。国际上的经验表明土地利用是污泥最终处置的主要发展方向,然而污泥中的重金属成为其土地利用的主要障碍。越来越多的研究者意识到,重金属的环境危害不仅仅取决于其总量,更取决于重金属存在形态。目前,Tessier分步提取法作为主流的污泥重金属划分方法,取得了广泛应用,该法将污泥中的重金属分成5种形态,分别为可交换态、碳酸盐结合态、铁锰氧化物结合态、有机结合态和残渣态。本文以此为基础综述了目前国内外主要的污泥重金属稳定和去除方法的原理及研究进展,比较了不同重金属稳定及去除方法的优点与不足,并提出了新的展望。     

太阳能污泥干化在欧洲的应用

太阳能污泥干化指的是利用太阳能为主要能源对污水处理厂污泥进行干化和稳定化的污泥处理技术。该技术运用太阳能,借助传统温室干燥工艺,具有低温干化、运行费用低廉、操作简单、运行安全稳定、干化后的污泥仍保留原有的农用价值等特点。该文主要介绍了该工艺的工作原理及流程,工艺设计参数及其与传统热干化技术相比的优缺点,并简要介绍了该工艺在欧洲市场上的商业应用。     

Assessment of fates of estrogens in wastewater and sludge from various types of wastewater treatment plants

We measured five estrogens in the wastewater samples from the municipal wastewater treatment plants (M-WWTPs), livestock wastewater treatment plants (L-WWTPs), hospital WWTPs (H-WWTPs) and pharmaceutical manufacture WWTPs (P-WWTPs) in Korea. The L-WWTPs showed the highest total concentration (0.195-10.4 μg L⁻¹) of estrogens in the influents, followed by the M-WWTPs (0.028-1.15 μg L⁻¹), H-WWTPs (0.068-0.130 μg L⁻¹) and P-WWTPs (0.015-0.070 μg L⁻¹). Like the influents, the L-WWTPs (0.003-0.729 μg L⁻¹) and the M-WWTPs (0.001-0.299 μg L⁻¹) also showed higher total concentration of estrogens in the effluents than the H-WWTPs (0.002-0.021 μg L⁻¹) and P-WWTPs (0.011 μg L⁻¹ in one sample). The L-WWTPs (37.5-543 μg kg⁻¹, dry weight) showed higher total concentrations in sludge than the M-WWTPs (3.16-444 μg kg⁻¹, dry weight) like the wastewater. The distribution of estrogens in the WWTPs may be affected by their metabolism in the human body, their transition through biological treatment processes, and their usage for livestock growth. Unlike the concentration results, the daily loads of estrogens from the M-WWTPs were the highest, which is related to the high capacities of WWTPs.     

以呼吸速率为基础判断活性污泥抑制类型的研究

通过对活性污泥工艺中微生物抑制动力学的理论分析,把好氧微生物呼吸速率动力学引入与抑制动力学的研究中。在对不同抑制类型的呼吸速率动力学分析的基础上,比较基质降解的动力学公式和呼吸速率的动力学公式的差异,确定了判别竞争性抑制和非竞争性抑制的方法,就是通过测量投加抑制物和不投加抑制物的情况下最大呼吸速率的变化情况,当不投加抑制物和投加抑制物最大呼吸速率的比值超过1.2~1.5时,可以认为该抑制为非竞争性抑制。本文对该方法进行了试验研究。     

全耦合活性污泥模型(FCASM3)Ⅱ:模型校验

以采用AAO污水处理工艺的德清县狮山污水处理厂作为全耦合活性污泥模型(FCASM3)校验的现场试验基地,分别进行了常规水质指标测定和进水水质特征分析等试验研究,依据现场试验结果,完成了对活性污泥系统生物去除营养物质细观机理模型FCASM3的校验工作,动态校验结果表明,FCASM3模型可以对AAO连续流工艺系统实现较准确的细观模拟,营养物质生物去除过程的动态数值模拟结果与实测结果相一致.     

啤酒废水处理站的工程设计

本项目以哈尔滨啤酒(沈阳)有限公司啤酒厂为设计对象,其啤酒废水处理规模为1500m3/d,进水CODCr2000~2800mg/L。采用预处理-预酸化-IC反应器-活性污泥法-过滤为主体工艺,出水达到《辽宁省污水与废气排放标准》(DB21-60-89中一级标准)。为啤酒行业废水综合治理提供了较好的工艺途径。     

造纸污泥综合利用热电项目验收监测难点及对策

近年来,随着环境监测技术规范化建设的不断发展,国家环保部相继出台了包括火力发电、水泥制造、汽车制造、造纸工业在内的12个不同行业类型的建设项目竣工验收技术规范。然而,造纸污泥综合利用热电项目验收监测尚未列入规范编制日程,其中工程调查、标准制定、点位布设和报告编制等环节仍存在一定误区和难点。文章例从上述薄弱环节入手,对常见难点问题提出了相应的解决办法,可供广大环境监测工作者参考和借鉴。