沈阳市苏家屯区危险废物管理、处置现状与对策

对沈阳市苏家屯区危险废物现状进行了调查,分析了危险废物的来源、产生量、特征及存在的主要问题。在此基础上,提出对危险废物管理处置对策,包括开展危险废物申报登记;加强苏家屯区危险废物监督管理;源头控制危险废物污染产生和建设危险废物集中处置场等。     

河南双河油泥在生物降解过程中饱和烃污染物的组成与分布

分析了河南双河油泥在微生物降解过程中烷烃的组成与分布特征,结果表明,XT-4、F-2、C-2、A-1和AB-1菌的混合菌对饱和烃组分有好的降解效果:当饱和烃含量在60~70g/kg范围时,经过120d的降解,饱和烃降解率达到66.4%,随着降解的进行,正构烷烃分布由单峰形变成了双峰形;萜烷类抗微生物降解能力强,在本实验条件下,其组成与分布没有发生显著变化。微生物对烷烃类化合物易降解顺序为:正构烷烃>类异戊二烯烃>藿烷类,C21以前的正构烷烃>C22以后的正构烷烃,姥鲛烷>植烷,Tm>Ts,藿烷>莫烷。     

Recycling of an industrial sludge and marine clay as light-weight aggregates

The geographical limitations of Singapore, its restricted natural resources and voluminous municipal and industrial waste streams, make environmental management a major challenge for the island state. In an attempt to find ways to reduce importation of raw materials and the waste sent to landfill, light weight aggregates were produced from marine clay and a CaF(2)-rich semiconductor industry sludge. Aggregates were produced in a bench-scale rotary kiln with three clay/sludge loadings (90/10, 70/30 and 50/50%). All three mixtures showed good bloating behavior during firing and the ceramic pellets (1-1.5cm diameter) had densities well below that required for light-weight aggregates. In the initial tests, the pore sizes of the aggregates were in general too large resulting in high water absorption. Comparisons between the composition of the two waste products and the aggregates showed a significant loss of fluorine (40-60%) during processing; a problem which may require flue gas treatment. Leach testing showed that the formed aggregates would not pose a human or environmental hazard in terms of fluorine mobilization.     

好氧污泥颗粒化过程的影响因素分析

影响好氧颗粒污泥性质的因素多且复杂,具有灰色系统的特点.应用了灰色关联分析方法对好氧颗粒污泥的重要参数污泥体积指数(SVI)、沉降速率、颗粒粒径和污泥浓度(MLSS)进行了关联影响分析.结果表明:对颗粒污泥SVI的影响顺序为沉降速率＞颗粒粒径＞ MLSS,说明沉降速率对活性污泥的形态转变和颗粒化过程的作用最明显,SVI可作为评判颗粒化进程的一个理想指标;沉降速率对MLSS的影响最弱;颗粒粒径的最佳值为1.3～1.5 mm,此时,颗粒粒径对SVI降低的贡献最大,从而使颗粒污泥的沉降性能得到很大改善,并且使MLSS达到最大.     

污泥投配率对污泥中温厌氧消化效果影响的试验研究

试验装置采用半连续流污泥中温厌氧消化反应器,污泥培养接近成熟后开始每天按不同污泥投配率加泥和排泥.结果表明:污泥投配率在3%～10%时,有机物分解率先增大后减小,去除率均在30%以上;污泥投配率在15%和20%时,污泥的有机物去除率非常小;污泥投配率在5%时,有机物分解率最大为41.2%;单位VSS产气量随污泥投配率的增大而呈先急剧上升后逐渐下降的趋势,当污泥投配率为5%时,单位VSS产气量为0.60 L/g,符合美国污水处理厂设计手册标准,其他污泥投配率下该指标均小于0.4 L/g.因此,认为实验用污泥中温消化的最佳污泥投配率为5%,这时污泥的可消化性较好.     

城市能源利用与环境保护的综合管理初探

能源短缺和环境污染已成为中国推行全面协调可持续发展的重要制约因素,作为能源消耗的主体和环境污染的控制重点,在城市层面推动能源发展战略的转变和强化环境保护是发展的基本要求.鉴于能源与环境之间的高度关联性,在管理方面要求对能源发展和环境保护进行统筹考虑和综合管理,充分强调能源经济效率和环境制约因素在能源发展中的作用.通过制定合理的产业能效标准和排放绩效标准,为城市经济、能源和环境的可持续性发展提供科学性、系统性决策支持.     

啤酒废水处理站的工程设计

本项目以哈尔滨啤酒(沈阳)有限公司啤酒厂为设计对象,其啤酒废水处理规模为1500m3/d,进水CODCr2000~2800mg/L。采用预处理-预酸化-IC反应器-活性污泥法-过滤为主体工艺,出水达到《辽宁省污水与废气排放标准》(DB21-60-89中一级标准)。为啤酒行业废水综合治理提供了较好的工艺途径。     

Sustainability of silicon feedstock for a low-carbon society

We need to ensure the sustainable management of advanced materials, such as purified silicon, that contribute to a low-carbon society. Because a drastic increase in the demand for photovoltaic (PV) systems is tightening the supply of silicon for PV cells, the sustainability of silicon feedstock needs to be explored. For this purpose, a material flow analysis of silicon in Japan from 1996 to 2006 is presented in this paper. Our analysis finds that rapid growth in demand for polycrystalline silicon (pc-silicon) and single crystalline silicon (sc-silicon) has changed the structure of the purified silicon supply. The strong demand for purified silicon for solar cells is responsible for this change. While off-grade silicon obtained as a by-product of electronic-grade silicon (EG-Si) covered the demand for solar sells before 2000, pc-silicon is currently produced independently for solar cells via an energy-intensive process. Analysis of the resource effective-use index (REI), which indicates how effectively purified silicon is used, shows progress in the effective use of pc- and sc-silicon. REI analysis indicates that the effective use of pc-silicon is reaching a maximum, while the effective use of sc-silicon is advancing, with a corresponding increase in price. To ensure a sustainable supply of silicon feedstock, this paper proposes four solutions: (1) production of solar-grade pc-silicon by a less costly and less energy-consuming method; (2) reduction in the amount of crystalline silicon per watt in solar cells; (3) acceleration of the development and deployment of other solar cell types; and (4) reuse and recycling of solar cells in the future.     

Corruption in natural resource management: Implications for policy makers

Corruption is the main reason why resource-rich countries perform badly in economic terms. Corruption in resource-rich countries takes two main forms, rent-seeking and patronage. Resource rents induce rent-seeking as individuals compete for a share of the rents rather than use their time and skills more productively. And resource revenues induce patronage as governments pay off supporters to stay in power, resulting in reduced accountability and an inferior allocation of public funds. This paper systematically reviews the literature on natural resources and corruption, and outlines the main policy implications for donors and domestic policy makers. A main conclusion is that priority should be given to policies that address rent-seeking and patronage. In other words, policy in resource-rich countries should be less about macro-economic management and more about institutions to prevent rent-seeking and patronage, and about giving the right incentives to players in the resource sector. Moreover, all policies need to take into account their impact on rent-seeking and patronage, and some current policies may actually be harmful in this respect.     

Assessing the long-term supply risks for mineral raw materials—a combined evaluation of past and future trends

This paper develops a method for identifying and assessing long-term supply risks for mineral raw materials. The method is based on a combined evaluation of past and future supply and demand trends. By analysing raw material boom and bust cycles over the past 50 years, we have quantified indicators and defined benchmarks for identifying critical market situations. By applying the method, risks for supply shortage may be identified at an early stage. In addition, a numerical evaluation model has been developed for better comparison between various mineral raw materials. Compared to other assessment methods this method uses specific benchmarks for each raw material to better assess supply risks. The method is embedded within a systematic and comprehensive analytical approach.