河流型水源地源水典型氯化消毒副产物及其前体物的强化去除工艺

以长三角某典型河流型水源地源水为研究对象,设计了传统工艺及基于凹凸棒土处理单元的6种强化工艺,对各工艺及其处理单元应用于典型氯化消毒副产物(三卤甲烷和卤乙酸)及其前体物控制的技术和经济可行性进行了系统分析。结果表明,预O3+凹土强化混凝+O3-GAC强化的工艺对上述2种消毒副产物及其前体物的控制效果最佳;在传统工艺中单纯增加O3处理也能在一定程度上提高其对消毒副产物前体物的去除效果;KMnO4控制消毒副产物的效果一般,但KMnO4处理可强化后续单元对消毒副产物前体物的去除效果。各工艺处理出水中三卤甲烷和卤乙酸单项指标均能达标,但传统工艺和经凹土强化混凝+GAC强化的工艺出水三卤甲烷4种化合物的实测浓度与其各自限值的比值之和均大于1.0,不能满足水质要求,必须进行强化处理。凹土强化混凝单元在6种强化工艺条件下对三卤甲烷生成潜能(THMFP)和卤乙酸生成潜能(HAAFP)的去除率较传统混凝单元平均提高15.99%和4.92%;各强化工艺对THMFP和HAAFP的去除率较传统工艺均提高20%以上(除凹土强化混凝+GAC强化的工艺外),消毒副产物产生量降低40%以上,工艺成本降低20%以上。     

基于CFD的两种紫外消毒模型的比较研究

为了预测紫外反应器的消毒效率,提高模拟的准确度,对两种紫外光强模型进行了比较分析。利用CFD技术,采用数值模拟的方法,对线源和柱源两种光强模型进行了光强分布以及消毒效率的模拟,并采用生物实验进行了验证。结果表明:与柱源模型相比,线源模型在近灯管处强度高42.3%,在1.2 cm处二者趋于一致;针对同一管式紫外反应器,透光率为95%时,线源模型的模拟结果偏大,柱源结果偏小;透光率为80%时,线源及柱源模型的模拟结果都偏大,流量及模型影响较小,透光率成为主要影响因素。综合比较,柱源模型适用于小型管式紫外灯消毒数值模型的开发。     

二氧化氯应用于二次供水安全消毒的静态研究

采用二氧化氯（ClO2）作为二次供水的消毒剂进行静态实验研究,考察了ClO2投加量、氨氮与CODMn浓度及pH对ClO2衰减及消毒副产物氯酸盐（ClO3^-）和亚氯酸盐（ClO2）的生成影响,并建立了ClO3-和ClO2生成浓度的经验预测模型。结果表明：前4h内,随着消毒剂初始投加浓度提高,ClO2的衰减速率增加,4h后降解则较缓慢。ClO2加入水中,立即有ClO3^-与ClO2^-生成,4h后基本达到稳定,且随着药剂投加量的增加,ClO3^-和ClO2-的生成量逐渐增大。氨氮、CODMn及pH的升高,可加速ClO2的衰减,同时可促进ClO3^-和ClO2-的生成。其中,氨氮浓度从0．085mg／L升高到0．585mg／LClO3^-与ClO2-的生成浓度分别增加了6．49μg／L和8．32μg／L;CODMn从1．13mg／L升高到3．13mg／L,ClO3^-与ClO2-的生成浓度分别增加了13．75μg／L和9．23μg／L;pH从6．49升高到8．45,ClO3^-与ClO2-的生成浓度分别增加了13．28μg／L和10．01μg／L。     

氨氮浓度对次氯酸钠消毒中水的影响

研究了氨氮浓度对次氯酸钠消毒中水的影响,讨论了中水氨氮浓度、氯胺浓度、总余氯浓度、消毒接触时间和总大肠菌群指标的变化关系。结果表明,氨氮随消毒接触时间呈先降低再升高的趋势,中水氨氮浓度越高,其变化幅度越小,反之,则变化幅度较大;氯胺浓度随消毒接触时间的延长先升高再降低,而总余氯量则逐渐降低,并有一定的持续消毒作用;此外,总余氯随次氯酸钠投加量的增加呈先升高后降低再逐渐升高的趋势,整个反应过程符合折点加氯消毒理论;当次氯酸钠投加量与氨氮的比值（以后简称C1／N）为25／1时,氨氮消耗掉的次氯酸钠量最多,生成的总余氯量最少;当C1／N比大于25／1时,消毒后中水氨氮浓度为零,反之,则随C1／N比升高逐渐降低;而当氨氮浓度相同时,中水消毒达标的主要影响因素是水中总大肠菌群的数量。     

Inactivation and injury assessment of Escherichia coli during solar and photocatalytic disinfection in LDPE bags

Solar disinfection (SODIS) of Escherichia coli suspensions in low-density polyethylene bag reactors was investigated as a low-cost disinfection method suitable for application in developing countries. The efficiency of a range of SODIS reactor configurations was examined (single skin (SS), double skin, black-backed single skin, silver-backed single skin (SBSS) and composite-backed single skin) using E. coli suspended in model and real surface water. Titanium dioxide was added to the reactors to improve the efficiency of the SODIS process. The effect of turbidity was also assessed. In addition to viable counts, E. coli injury was characterised through spread-plate analysis using selective and non-selective media. The optimal reactor configuration was determined to be the SBSS bag (t₅₀ = 9.0 min) demonstrating the importance of UVA photons, as opposed to infrared in the SODIS disinfection mechanism. Complete inactivation (6.5-log) was achieved in the presence of turbidity (50 NTU) using the SBSS bag within 180 min simulated solar exposure. The addition of titanium dioxide (0.025 g L⁻¹) significantly enhanced E. coli inactivation in the SS reactor, with 6-log inactivation observed within 90 min simulated solar exposure. During the early stages of both SODIS and photocatalytic disinfection, injured E. coli were detected; however, irreversible injury was caused and re-growth was not observed. Experiments under solar conditions were undertaken with total inactivation (6.5-log) observed in the SS reactor within 240 min, incomplete inactivation (4-log) was observed in SODIS bottles exposed to the same solar conditions.     

Photocatalytic inactivation of Escherichia coli by natural sphalerite suspension: effect of spectrum, wavelength and intensity of visible light

The photocatalytic disinfection of Escherichia coli K-12 is investigated by the natural sphalerite (NS) under different spectra, wavelengths and intensities of visible light (VL) emitted by light-emitting-diode lamp (LED). The spectrum effect of VL on disinfection efficiency is studied by using white LED, fluorescent tube (FT) and xenon lamp (XE), which indicates that the “discreted peak spectrum” of FT is more effective to inactivate bacteria than “continuous spectrum” of LED and XE. Besides, the photocatalytic disinfection of bacteria is compared under different single spectrum (blue, green, yellow and red color) LEDs. The results show that the most effective wavelength ranges of VL for photocatalytic disinfection with the NS are 440-490 and 570-620 nm. Furthermore, a positive relationship is obtained between the disinfection efficiency and the VL intensity. The experiment shows that NS can completely inactivate 10⁷ cfu mL⁻¹E. coli K-12 within 8 h irradiation by white LED with the intensity of 200 mW cm⁻² at pH 8. Moreover, the destruction process of the cell wall and the cell membrane are directly observed by TEM. Finally, no bacterial colony can be detected within a 96 h regrowth test of inactivated bacteria, which reveals that the VL-photocatalytic disinfection leads to an irreversible damage to the bacterial cells.     

Chemical fractionation of Cu and Zn in stormwater, roadway dust and stormwater pond sediments

This study evaluated the chemical fractionation of Cu and Zn from source to deposition in a stormwater system. Cu and Zn concentrations and chemical fractionation were determined for roadway dust, roadway runoff and pond sediments. Stormwater Cu and Zn concentrations were used to generate cumulative frequency distributions to characterize potential exposure to pond-dwelling organisms. Dissolved stormwater Zn exceeded USEPA acute and chronic water quality criteria in approximately 20% of storm samples and 20% of the storm duration sampled. Dissolved Cu exceeded the previously published chronic criterion in 75% of storm samples and duration and exceeded the acute criterion in 45% of samples and duration. The majority of sediment Cu (92-98%) occurred in the most recalcitrant phase, suggesting low bioavailability; Zn was substantially more available (39-62% recalcitrant). Most sediment concentrations for Cu and Zn exceeded published threshold effect concentrations and Zn often exceeded probable effect concentrations in surface sediments.     

次氯酸钠药剂在不同水厂的应用

次氯酸钠药剂在水务行业应用广泛,常被用作消毒剂,对于保障水质具有重要的作用。介绍了近6年来次氯酸钠消毒剂在水务行业的应用情况,以期为不同性质水厂的运行提供参考。     

控制释放技术与水的消毒保质

介绍了控制释放技术及其在水消毒保质方面的应用 ,指出了控制释放技术在水消毒保质方面的优越性、重要意义及应用前景     

水消毒处理中膜技术的应用

本文较全面地评述了膜技术在水消毒处理中的应用 ,包括消毒机理、效果及影响因素 ,展望了应用前景