Performance of a novel vertical-flow settler: a comparative study

By increasing particle concentration and G value （root-mean-square velocity gradient） to enhance flocculation, a novel vertical-flow settler was designed to increase sedimentation effectiveness, and to simultaneously improve operational stabilization. Due to the gradual decrease in upward flow-rate of raw water, a floes blanket would form and suspend in the middle section of the settler, not at the bottom as in a conventional clarifier. Enough large floes, resulted from flocculation or fltration, would continuously settle out of the floes blanket, and simultaneously, the floes in raw water or those forming above the blanket would ceaselessly enter the floes blanket. As a result, the floes concentration in the blanket could keep a dynamic balance. The hydrodynamic shear in the blanket was improved by flow separation, which was induced by the abrupt change in flow channel. Due to the floes blanket and improved hydrodynamic shear, flocculation would be enhanced, which was helpful for removing fine particles in raw water. A comparative study showed that the novel vertical-flow settler had a much better performance in the removal of the particles in raw water than a conventional one, when they treated kaolin suspensions of different concentrations （500, 100 and 50 mg/L, respectively） coagulated by polyaluminum chloride（PAC1） at the up-flow rates of 1 and 2 mm/s, respectively.     

基于粒子群-支持向量机(PSO-SVM)的苯储罐泄漏事故风险预测

将支持向量机(SVM)模型运用于事故前苯储罐泄漏事故风险预测,为使模型性能最优, 用粒子群算法PSO优化SVM模型参数,建立了PSO-SVM风险预测模型。为验证模型风险预测性能,分别采用遗传算法(GA)和网格搜索法(GS)优化SVM参数,并比较测试集与PSO-SVM、GA-SVM、GS-SVM三种模型预测结果的均方误差及相关系数。然后进一步探讨模型中权重调整方式、种群规模对PSO-SVM模型预测性能的影响。研究发现,权重线性递减所建PSO-SVM预测值与测试集相关系数更高、均方误差更小、预测效果更好,种群规模没有影响PSOSVM模型预测值但会影响计算时间,这为危化品泄漏事故的风险预测提供了一种新的方法。     

基于疲劳累积破坏机制的储罐结构动力可靠度分析

针对随机风载荷作用下储罐结构动力可靠性问题,以300 m3的中小型立式低温储罐为研究对象,利用AR模型进行数值模拟得到风载荷的脉动风速时程与脉动功率谱密度函数。采用ANSYS建立储罐三维有限元模型,并对储罐进行动力学分析,计算出储罐结构的随机响应,进而求出随机风载荷作用下储罐结构动力可靠性所需全部数字特征,最后利用疲劳累积损伤机制计算得到储罐的动力可靠度。结果表明:假设结构强度不随时间退化,前5 a动力可靠度基本保持不变,随着使用年限的延长,动力可靠度下降速度明显增大。研究方法可为储罐的动力可靠性及寿命预测提供一定的理论依据。     

Study on the dynamic response of polyurea coated steel tank subjected to blast loadings

Steel tanks are widely used in the storage of various chemical liquids, and the blast resistance of the tanks is very important because of the explosiveness of these liquids. To explore a feasible method to improve the blast resistance of steel tanks, the effect of polyurea coating on the blast resistance of steel storage tank is investigated in this paper. The responses of monolithic steel tanks and polyurea coated tanks under blast loads are studied by field blast experiments using TNT explosive, and the results shows that the polyurea layers are effective in reducing the maximum and residual displacements of the tank. Numerical simulations are performed and validated, and the deformation process and stress and strain distribution of the tanks are analyzed accordingly. The increase on the bending moment of the plastic hinge lines of the tanks and the increase of the area density of the cylindrical shell induced by the polyurea layers are believed to be the two main factors contributing to the displacement reduction effect of polyurea in this paper. The validated numerical model is used to study the influence of polyurea layer's thickness on the deflection of the tank, and a nearly inversely proportional relationship between the thickness and the maximum displacement is found. Three deformation modes of the tanks are identified when subjected to blast load with varying intensity and it is found that the displacement reduction effect of polyurea varies in different deformation modes.     

Sulfur cycle as an electron mediator between carbon and nitrate in a constructed wetland microcosm

• Fe(III) accepted the most electrons from organics, followed by NO₃^‒, SO₄^2‒, and O₂. • The electrons accepted by SO₄^2‒ could be stored in the solid AVS, FeS₂-S, and S⁰. • The autotrophic denitrification driven by solid S had two-phase characteristics. • A conceptual model involving electron acceptance, storage, and donation was built. • S cycle transferred electrons between organics and NO₃^‒ with an efficiency of 15%. A constructed wetland microcosm was employed to investigate the sulfur cycle-mediated electron transfer between carbon and nitrate. Sulfate accepted electrons from organics at the average rate of 0.84 mol/(m³·d) through sulfate reduction, which accounted for 20.0% of the electron input rate. The remainder of the electrons derived from organics were accepted by dissolved oxygen (2.6%), nitrate (26.8%), and iron(III) (39.9%). The sulfide produced from sulfate reduction was transformed into acid-volatile sulfide, pyrite, and elemental sulfur, which were deposited in the substratum, storing electrons in the microcosm at the average rate of 0.52 mol/(m³·d). In the presence of nitrate, the acid-volatile and elemental sulfur were oxidized to sulfate, donating electrons at the average rate of 0.14 mol/(m³·d) and driving autotrophic denitrification at the average rate of 0.30 g N/(m³·d). The overall electron transfer efficiency of the sulfur cycle for autotrophic denitrification was 15.3%. A mass balance assessment indicated that approximately 50% of the input sulfur was discharged from the microcosm, and the remainder was removed through deposition (49%) and plant uptake (1%). Dominant sulfate-reducing (i.e., Desulfovirga, Desulforhopalus, Desulfatitalea, and Desulfatirhabdium) and sulfur-oxidizing bacteria (i.e., Thiohalobacter, Thiobacillus, Sulfuritalea, and Sulfurisoma), which jointly fulfilled a sustainable sulfur cycle, were identified. These results improved understanding of electron transfers among carbon, nitrogen, and sulfur cycles in constructed wetlands, and are of engineering significance.     

大型原油储罐热喷涂防腐蚀技术的应用

金属热喷涂技术是一种有效的长效防腐蚀手段,常用于金属结构的腐蚀防护。从钢结构腐蚀及热喷涂长效防护的角度,阐述了在大型原油储罐建设中使用热喷涂防腐蚀技术的可行性和经济性,并对其热喷涂防腐蚀工艺作了简要说明。     

横向流中曝气气泡生成动力学及模拟研究

采用水平集方法和变物性的单一流体运动方程,结合显式时间步进的ICE数值算法,三维模拟了推流式曝气池内气泡的生成过程.重点研究了横向水流对曝气气泡生成动力学的影响.模拟的气泡形状演变过程与国外学者的可视化实验符合较好.模拟结果显示,与在静止水流中气泡的生成相比,曝气池内水横向流动对气泡的生成过程有重要的影响.由于受到水流施加的横向曳力作用,气泡逐渐倾斜向下游生长;气泡生成的时间明显缩短;生成气泡的体积也显著地减小.     

造纸中段废水与生活污水合并深度处理工艺

采用水解酸化 CAST 混凝 复合滤池与水解酸化 接触氧化 混凝 复合滤池2种组合工艺对造纸中段废水与生活污水进行合并处理对照试验.结果表明,两种工艺都是切实可行的,二级出水均可达到<污水综合排放标准>(GB8978-1996)二级标准,深度处理出水可达中水水质要求.其中以水解酸化 CAST 混凝 复合滤池组合工艺效果最好.     

催化氧化技术治理苯化工装置和罐区含氮挥发性有机物废气

采用催化氧化技术对某石化企业苯胺、硝基苯等生产装置和罐区的含氮挥发性有机物(NVOCs)废气进行集中处理,建成了一套20 000 Nm~3/h规模的安全高效处理装置。采用自主研发的WSH-2N型蜂窝状Pt-Pd-Ce催化剂,在高效氧化有机物的同时,高选择性地将有机氮转化为N_2。运行结果表明,净化气非甲烷总烃质量浓度低于15 mg/m~3,非甲烷总烃去除率大于99%,NO_x质量浓度低于10 mg/m~3,苯、苯胺、硝基苯、环己烷等特征有机污染物浓度均低于检出限,各项指标优于国内外现有技术。     

合流制排水系统溢流污染就地调蓄处理控制技术研究

在对高效混合絮凝斜板沉淀工艺进行现场中试的基础上,将化学强化处理工艺与调蓄池相结合,针对上海市某合流制排水系统,进行调蓄/沉淀池的概念设计,提出主要设计参数,利用计算流体力学(CFD)模型对调蓄/沉淀池进行优化设计.试验和模拟结果表明,调蓄/沉淀池与单纯的调蓄池相比具有更好的溢流污染控制效果和效益/造价比.