Na-Ba/γ-Al2O3的NO和SO2吸附性能研究

研究了Na-Ba/γ-Al2O3吸附催化剂上NO和SO2的吸附-脱附性能.Na、Ba质量分数分别为6.2%、5.4%,焙烧温度和焙烧时间分别为600 ℃和10 h,吸附温度为100 ℃,其对NO、SO2的最大吸附量分别为0.052 4、0.344 mmol/g.同时考察了添加第三活性组份的影响,结果表明,Fe最为有效,Na-Ba/Fe/γ-Al2O3的NO、SO2最大吸附量分别为0.062 4、0.486 mmol/g.漫反射红外光谱研究结果表明,Fe降低了硫酸盐分解温度,促进吸附催化剂的再生.     

Thermal runaway criterion for chemical reaction systems: A modified divergence method

The chemical reaction in certain range of operating conditions may exhibit parametric sensitivity where small changes in one or more of the input parameters lead to changes in the output variables (eg. reaction temperature). The sharp rise of the reaction temperature is a critical behavior that may lead to runaway conditions. Thus, it is of vital importance to determine the critical operating parameters consisting of the parametric sensitivity region under the consideration of intrinsic safety. In this paper, a modified divergence criterion is proposed based on the trace of Jacobian matrix at the maximum temperature. The nonlinear differential equations describing the dynamic behavior of the chemical reaction is linearized locally in the vicinity of the equilibrium point by the small perturbation analysis. The relationship between the perturbation equation and parametric sensitivity of the reaction system is investigated. The critical values computed by the modified divergence criterion are compared with Morbidelli and Varma criterion (MV criterion), Adler and Enig criterion (AE criterion) and divergence criterion (Div criterion). The comparison demonstrates the validity of the new criterion. In addition, the critical explosion pressures of two kinds of hazardous chemicals are computed by the various critical criteria and compared with published experimental data. The results show that the modified divergence criterion could give smaller computational error compared with the previous criteria.     

Fire and explosion hazard analysis during surface transport of liquefied petroleum gas (LPG): A case study of LPG truck tanker accident in Kannur,Kerala, India

This paper presents an analysis and simulation of an accident involving a liquefied petroleum gas (LPG) truck tanker in Kannur, Kerala, India. During the accident, a truck tanker hit a divider and overturned. A crack in the bottom pipe caused leakage of LPG for about 20 min forming a large vapor cloud, which got ignited, creating a fireball and a boiling liquid expanding vapor explosion (BLEVE) situation in the LPG tank with subsequent fire and explosion. Many fatalities and injuries were reported along with burning of trees, houses, shops, vehicles, etc. In the present study, ALOHA (Area Locations of Hazardous Atmospheres) and PHAST (Process Hazard Analysis Software Tool) software have been used to model and simulate the accident scenario. Modeling and simulation results of the fireball, jet flame radiation and explosion overpressure agree well with the actual loss reported from the site. The effects of the fireball scenario were more significant in comparison to that of the jet fire scenario.     

Thermal risk in batch reactors: Case of peracetic acid synthesis

The present paper deals with accidents risk in batch reactors. It identifies the conditions for the occurrence of a thermal runaway and develops a probabilistic approach to assess the relevant risk. It investigates also the conditions for optimal synthesis of peracetic acid (PAA) with hydrogen peroxide (HP) and acetic acid (AA). The kinetic model of reversible reaction and side reaction of PAA synthesis is used to predict reactor temperature and molar ratio of PAA by ASPEN PLUS software. A sensitivity analysis is performed under different conditions such as constant temperature or adiabatic process with different concentrations of sulfuric acid. Assuming a prior cooling system failure, the conditions for reaction runaway triggering a thermal accident are identified in the case of PAA synthesis. Monte Carlo simulations are used in order to calculate the conditional probability of accident and optimize the synthesis of PAA.     

A novel method for evaluation of fire prevention by using water curtain with large droplets

Based on the ability to attenuate thermal radiation of droplets, water curtain plays an important role in fire prevention in the oil and gas terminal, traffic tunnel and other outdoor spaces. Radiation transfer characteristics of large droplets are determined by the Mie theory, and the Two-flux model is used to simplify the radiative transfer equation. Combined with an empirical formula to calculate the droplet diameter, a novel method is given for calculating the transmissivity of water curtain. Based on the method, influences of both the pressure and the width of water curtain on the transmissivity are fit for exponential relationship. Compared with experimental data, an ideal agreement is found between calculation results and experimental data for both single pipe water curtain and double pipe water curtain, only in the case of triplex pipe water curtain the deviation between calculation and experiment is more than 25%. A better calculation result can be obtained under the condition of the optical thin media. The method is effective in the scope of that the transmitted radiation is stronger than the environmental radiation.     

Investigation of thermal treatment on selective separation of post consumer plastics prior to froth flotation

Plastics have become the widely used materials because of their advantages, such as cheapness, endurance, lightness, and hygiene. However, they cause waste and soil pollution and they do not easily decompose. Many promising technologies are being investigated for separating mixed thermoplastics, but they are still uneconomical and unreliable. Depending on their surface characteristics, these plastics can be separated from each other by flotation method which is useful mineral processing technique with its low cost and simplicity.The main objective of this study is to investigate the flotation characteristics of PET and PVC and determine the effect of plasticizer reagents on efficient plastic separation. For that purpose, various parameters such as pH, plasticizer concentration, plasticizer type, conditioning temperature and thermal conditioning were investigated. As a result, PET particles were floated with 95.1% purity and 65.3% efficiency while PVC particles were obtained with 98.1% purity and 65.3% efficiency.     

Distribution of copper,silver and gold during thermal treatment with brominated flame retardants

The growing consumption of electric and electronic equipment results in creating an increasing amount of electronic waste. The most economically and environmentally advantageous methods for the treatment and recycling of waste electric and electronic equipment (WEEE) are the thermal techniques such as direct combustion, co-combustion with plastic wastes, pyrolysis and gasification. Nowadays, this kind of waste is mainly thermally treated in incinerators (e.g. rotary kilns) to decompose the plastics present, and to concentrate metals in bottom ash. The concentrated metals (e.g. copper, precious metals) can be supplied as a secondary raw material to metal smelters, while the pyrolysis of plastics allows the recovery of fuel gases, volatilising agents and, eventually, energy. Indeed, WEEE, such as a printed circuit boards (PCBs) usually contains brominated flame retardants (BFRs). From these materials, hydrobromic acid (HBr) is formed as a product of their thermal decomposition.In the present work, the bromination was studied of copper, silver and gold by HBr, originating from BFRs, such as Tetrabromobisphenol A (TBBPA) and Tetrabromobisphenol A-Tetrabromobisophenol A diglycidyl ether (TTDE) polymer; possible volatilization of the bromides formed was monitored using a thermo-gravimetric analyzer (TGA) and a laboratory-scale furnace for treating samples of metals and BFRs under an inert atmosphere and at a wide range of temperatures. The results obtained indicate that up to about 50% of copper and silver can evolve from sample residues in the form of volatile CuBr and AgBr above 600 and 1000 °C, respectively. The reactions occur in the molten resin phase simultaneously with the decomposition of the brominated resin. Gold is resistant to HBr and remains unchanged in the residue.     

Thermal Degradation Mechanism of Low-Density Polyethylene Plastic Wastes in Cyclohexane

The thermal LDPE degradation mechanism harnessing a high-pressure autoclave surrounded by a furnace was investigated in this work. Rates of formation of gas, liquid, and solid during degradation of PE plastic wastes in cyclohexane as solvent at 400 and 425°C have been experimentally determined. Four reaction mechanisms have been proposed and tested to estimates of gas, liquid, and solid. Proposed mechanisms are based on the assumption that the reactions are pseudo-first-order with respect to the reacting species. Pseudo-first-order rate constants for each of the indicated mechanistic steps have been calculated by nonlinear regression analysis. The best fit was obtained by model 2 (pure parallel reaction mechanism), and its activation energy was determined.     

活性炭吸附硫化氢及微波辐照解吸研究

研究了两种活性炭对硫化氢的平衡吸附性能力,并对活性炭床层的穿透性进行了考察;吸附饱和和活性炭在微波辐射的作用下进行解吸。实验表明,解吸效率与微波作用时间及温度有关,在本实验条件下H2S解吸效率达90．1％。