RuO2-IrO2-SnO2/Ti阳极电催化氧化苯酚的研究

以RuO2-IrO2-SnO2/Ti钛网电极为阳极,RuO2-IrO2/Ti钛网电极为阴极,构建了电催化氧化体系,同时以苯酚为底物、硫酸钠为电解质,考察了不同pH、极板间距、电流密度和苯酚初始浓度对苯酚去除率的影响。结果表明,在pH为6.5、极板间距为1.0cm、电流密度为50mA/cm2、苯酚初始质量浓度为1 000mg/L的最佳实验条件下,取硫酸钠质量浓度为20g/L的苯酚模拟废水250mL,120min时苯酚去除率可以达到98.4%。     

阳极初始电势对微生物燃料电池产电的影响

在微生物燃料电池中,阳极电势会对产电菌的富集和生长产生影响.为进一步明确阳极电势的作用,确定适合微生物生长的最佳阳极电势,在微生物燃料电池的阳极室中设置附加电路以改变阳极的初始电势,考察阳极初始电势对产电微生物的影响.将阳极初始电势设为350 mV时,产电微生物的生长明显变慢.而阳极初始电势为-200 mV和200 mV时,微生物的生长速度基本相同.稳定运行后,阳极初始电势分别为350、200和-200 mV的微生物燃料电池,阳极内阻分别为71、43和80 Ω.通过变性梯度凝胶电泳(DGGE)分析微生物燃料电池稳定产电前后阳极微生物群落结构,虽然3个微生物燃料电池的阳极初始电势不同,但稳定后微生物群落结构相似,Clostridium sticklandii、Pseudomonas mendocina、Paenibacillus taejonensis在阳极的富集量最多,MFC对这3种细菌的强化富集作用最明显.     

The selective catalytic reduction of NO over Ce0.3TiOx-supported metal oxide catalysts

A Ce_(0.3)TiO_xoxide carrier was synthesized via a sol–gel process,and Ce_(0.3)TiO_xsupported metal(M=Cd,Mn,Fe,W,Mo)oxide catalysts were prepared by the method of incipient-wetness impregnation.The catalysts were characterized by means of X-ray diffraction(XRD),Brunauer–Emmett–Teller(BET)analysis,scanning electron microscopy(SEM),transmission electron microscopy(TEM),Fourier transform infrared(FT–IR)spectroscopy,UV–Visdiffusereflectancespectroscopy(UV–VisDRS),and Temperature-programmed reduction with H_2(H_2-TPR).The catalytic activities for de-NO_(x )were evaluated by the NH_3-SCR reaction.Among all the catalysts tested,the 2 wt.%Cd/Ce_(0.3)TiO_xcatalyst exhibited the best NH_3-SCR performance,with a wide temperature window of 250–450°C for NO conversion above 90%.Moreover,the catalyst showed N_2 selectivity greater than 99%from 200 to 450°C.     

Electrochemical inactivation of cyanobacteria and microcystin degradation using a boron-doped diamond anode——A potential tool for cyanobacterial bloom control

Cyanobacterial blooms are global phenomena that can occur in calm and nutrient-rich(eutrophic) fresh and marine waters. Human exposure to cyanobacteria and their biologically active products is possible during water sports and various water activities, or by ingestion of contaminated water. Although the vast majority of harmful cyanobacterial products are confined to the interior of the cells, these are eventually released into the surrounding water following natural or artificially induced cell death. Electrochemical oxidation has been used here to damage cyanobacteria to halt their proliferation, and for microcystin degradation under in-vitro conditions. Partially spent Jaworski growth medium with no addition of supporting electrolytes was used. Electrochemical treatment resulted in the cyanobacterial loss of cell-buoyancy regulation, cell proliferation arrest, and eventual cell death. Microcystin degradation was studied separately in two basic modes of treatment: batch-wise flow, and constant flow, for electrolytic-cell exposure. Batch-wise exposure simulates treatment under environmental conditions, while constant flow is more appropriate for the study of boron-doped diamond electrode efficacy under laboratory conditions. The effectiveness of microcystin degradation was established using high-performance liquid chromatography–photodiode array detector analysis, while the biological activities of the products were estimated using a colorimetric protein phosphatase-1 inhibition assay. The results indicate potential for the application of electro-oxidation methods for the control of bloom events by taking advantage of specific intrinsic ecological characteristics of bloom-forming cyanobacteria. The applicability of the use of boron-doped diamond electrodes in remediation of water exposed to cyanobacteria bloom events is discussed.     

光电催化降解10-壬基酚聚氧乙烯醚

采用溶胶-凝胶法制备TiO₂薄膜光电极,以该电极为工作电极,铂丝作对电极,饱和甘汞电极为参比电极,对10-壬基酚聚氧乙烯醚的光电催化降解进行了研究.结果表明,该电极具有n型半导体的特征行为.在外加偏压为+0.6V,pH值为5,H₂O₂浓度为30mg/L的条件下对初始浓度为50mg/L的10-壬基酚聚氧乙烯醚溶液光照4h,降解率达53.26%.讨论了氧的存在、外加偏压、pH值等因素对光电催化反应的影响.     

Degradation of 2,4-dichlorophenol with a novel TiO2/Ti-Fe-graphite felt photoelectrocatalytic oxidation process

Degradation of 2,4-dichlorophenol(2,4-DCP)was studied in a novel three-electrode photoelectrocatalytic(PEC)integrative oxidation process,and the factors influencing the degradation rate,such as applied current,flow speed of O_2,pH,adscititious voltage and initial 2,4-DCP concentration were investigated and optimized.H_2O_2 was produced nearby cathode and Fe~(2 )continuously generated from Fe anode in solution when current and O_2 were applied,so,main reactions,H_2O_2-assisted TiO_2 PEC oxidation and E-Fenton reaction,occurred during degradation of 2,4-DCP in this integrative system.The degradation ratio of 2,4-DCP was 93% in this integrative oxidation process,while it was only 31% in E-Fenton process and 46% in H_2O_2-assisted TiO_2 PEC process.So,it revealed that the degradation of 2,4-DCP was improved greatly by photoelectrical cooperation effect.By the investigation of pH,it showed that this integrative process could work well in a wide pH range from pH 3 to pH 9.     

四钛酸钾晶须对亚甲基蓝吸附性能研究

利用四钛酸钾晶须作为吸附剂,研究了亚甲基蓝在其上的吸附行为,考察了吸附体系pH值、吸附剂用量、吸附时间对其吸附效果的影响.实验结果表明,四钛酸钾晶须对亚甲基蓝有较强的吸附力,得到的吸附等温线能较好的符合Freundlich方程,其R2都能达到0.991以上,吸附动力学可以用拟二级动力学模型描述.在碱性范围内四钛酸钾晶须...     

关于煤矸石制备铝硅钛合金几个问题的讨论

本文对煤矸石酸浸脱杂制备硅钛氧化铝并电解生产铝硅钛合金有关的几个问题进行了讨论,分析了煤矸石酸浸脱杂与处理、硅钛氧化铝组成、电解工艺等条件对煤矸石制备铝硅钛合金的影响。     

Ti/RuO2-IrO2-TiO2电极电解产生活性氯

采用电解法产生活性氯,降解废水中的有机物。考察了活性氯产生量的影响因素,并对Ti/RuO₂-IrO₂-TiO₂电极电解实际含氯废水的处理效果进行了研究。实验结果表明:通过增加Cl^-浓度和电流密度、减少SO₄^2-浓度和极板间距、降低电解温度的方法能够提高活性氯产生量,从而提高电极降解有机物的效果;对于Cl^-浓度为0.005 mol/L、COD为49 mg/L的废水,使用Ti/RuO₂-IrO₂-TiO₂电极,在极板间距为0.5 cm、电解温度为20 ℃、电流密度为20 mA/cm²、初始pH为8.0的条件下电解处理60 min,废水BOD₅/COD值由0.04提高到0.25,COD降至24 mg/L,达到DB 11/307—2013《水污染综合排放标准》中排入地表水体污染物B类排放限值(COD≤30 mg/L)的要求。     

海洋环境Al-Zn-In-Mg-Ti牺牲阳极腐蚀防护研究

以Al-Zn-In-Mg-Ti牺牲阳极为研究对象,在海洋环境下做车辆的牺牲阳极腐蚀防护试验。采用电位自动记录仪采集浸入海水期间车体的动态电位,绘制时间-电位（t-E）曲线图,并分析数据;采用扫描电镜（SEM）和X射线衍射（XRD）等方法对牺牲阳极试样表面腐蚀形貌及成分进行了分析。结果发现,Al-Zn-In-Mg-Ti牺牲阳极增加了车体电位的稳定性,使车体电位部分极化到-800 mV;车体电位达到平衡的时间为7 min,加速了车体电位达到平衡的时间;Al-Zn-In-Mg-Ti牺牲阳极腐蚀产物在表面形成致密氧化层,并在干湿交替的作用下形成龟裂的裂纹,阻止了牺牲阳极的进一步反应。