含砷冶炼废渣高温烧结过程砷的迁移特性

研究了烧结温度和烧结时间对含砷冶炼废渣烧结过程中砷的迁移特性的影响。烧结条件为在10 MPa下加压成型,进空气流量为2 000 mL/min,烧结温度1 000～1 350℃,烧结时间5～120 min。结果表明,烧结过程中存在砷的挥发,但烧结前后砷的总量变化不大,砷的固化率均保持在90%以上。毒性浸出实验表明,不同的烧结条件对烧结体中砷的毒性浸出有重要的影响,从烧结体的环境安全性考虑,最佳的烧结温度和时间分别为1 200℃和45 min。     

加快废钢产业发展 促进钢铁资源循环利用

分析了废钢的应用现状及应用不足的原因,为加快废钢产业发展提出建议。提出为适应当今钢铁工业节能、降耗、环保等方面的发展要求,应大力发展废钢产业,加快废钢资源利用,促进钢铁资源循环利用,实现我国钢铁工业的可持续发展．     

废弃电器电子产品拆解行业发展透析及趋势分析

《废弃电器电子产品处理基金征收使用管理办法》正式实施。基金化管理是借鉴国外成功的“生产者责任延伸制”,作为一种长效机制对处理企业未来的发展具有稳定和促进作用。废弃电器电子产品处理基金化运作的第一阶段已经顺利实行,取得了丰硕的成果和各种经验教训。总结过去和探讨未来是今后管理者、研究者和企业人需要共同完成的课题。     

面向矿山废弃地复垦的炉渣污泥人工土壤的理化特性

通过添加不同比例的燃煤电厂粉煤灰和炉渣对城市污泥进行钝化,配制成不同灰渣比例的人工土壤,对人工土壤的pH、电导率、养分含量、重金属含量以及持水、渗水性能进行了研究。结果表明,污泥人工土壤pH介于7.5～8.0之间,属于弱碱性土壤;电导率变化范围为2.93～3.71 mS/cm,表明盐分含量较高。污泥人工土壤中有效态养分含量随炉渣比例提高而增加,所有配比人工土壤有机质和有效磷、速效钾的含量达到高肥力水平。人工土壤中Cd、Ni、Pb、Cu、Zn含量均明显低于国家农用标准(GB 4284-84、GB 8173-87)。粉煤灰渣对污泥中有效态Cd、Ni、Pb和Cu有钝化作用,使其向无效态转化,对Zn则有活化作用。炉渣对Cd、Ni的钝化作用要优于粉煤灰,而粉煤灰对Pb、Cu的钝化作用要优于炉渣。添加炉渣提高了污泥人工土壤水分的蒸发量,减弱了人工土壤的持水能力,但加入炉渣使人工土壤的渗透系数显著增加,提高了其渗水性能。     

冶金高炉高温熔融处理垃圾飞灰

为了探讨冶金高炉处理垃圾飞灰的可能性,将一定量的垃圾飞灰作为造球原料通过快凝水泥固化制备冷固飞灰球团,模拟高炉温度、气氛条件对飞灰球团进行高温冶金性能实验研究,并采用X射线衍射仪对飞灰球团中物相变化进行了研究。结果表明:在造球原料里配入5%左右的飞灰通过水泥固化造出的球团能达到入炉要求;配入10%飞灰球团的高炉炉料的高温冶金性能变化不大,且能够保持高炉内的工作环境相对稳定,符合当前冶炼要求的炉内工程条件;在高温下飞灰中的重金属能有效还原固封,二恶英能有效分解,为垃圾飞灰的资源化处理开辟了新的途径。     

弧叶型旋转窑烧制污泥陶粒实验研究

实验选取污水污泥、粉煤灰和港口淤泥为原辅材料,采取正交实验设计物料质量配合比与烧制工艺参数,遴选出最佳物料配比和优化的烧制工艺;依照选定物料配比和工艺参数采用弧叶型旋转窑烧制污泥陶粒并测定产品的1 h吸水率,软化系数,堆积密度,表观密度,颗粒级配,粒型系数以及产品浸出毒性等技术指标,选取制得陶粒产品替代全部天然石料配制...     

Changes in mineralogical and leaching properties of converter steel slag resulting from accelerated carbonation at low CO2 pressure

Steel slag can be applied as substitute for natural aggregates in construction applications. The material imposes a high pH (typically 12.5) and low redox potential (Eh), which may lead to environmental problems in specific application scenarios. The aim of this study is to investigate the potential of accelerated steel slag carbonation, at relatively low pCO₂ pressure (0.2 bar), to improve the environmental pH and the leaching properties of steel slag, with specific focus on the leaching of vanadium. Carbonation experiments are performed in laboratory columns with steel slag under water-saturated and -unsaturated conditions and temperatures between 5 and 90 °C. Two types of steel slag are tested; free lime containing (K3) slag and K1 slag with a very low free lime content. The fresh and carbonated slag samples are investigated using a combination of leaching experiments, geochemical modelling of leaching mechanisms and microscopic/mineralogical analysis, in order to identify the major processes that control the slag pH and resulting V leaching. The major changes in the amount of sequestered CO₂ and the resulting pH reduction occurred within 24 h, the free lime containing slag (K3-slag) being more prone to carbonation than the slag with lower free lime content (K1-slag). While carbonation at these conditions was found to occur predominantly at the surface of the slag grains, the formation of cracks was observed in carbonated K3 slag, suggesting that free lime in the interior of slag grains had also reacted. The pH of the K3 slag (originally pH ± 12.5) was reduced by about 1.5 units, while the K1 slag showed a smaller decrease in pH from about 11.7 to 11.1. However, the pH reduction after carbonation of the K3 slag was observed to lead to an increased V-leaching. Vanadium leaching from the K1 slag resulted in levels above the limit values of the Dutch Soil Quality Decree, for both the untreated and carbonated slag. V-leaching from the carbonated K3 slag remained below these limit values at the relatively high pH that remained after carbonation. The V-bearing di-Ca silicate (C2S) phase has been identified as the major source of the V-leaching. It is shown that the dissolution of this mineral is limited in fresh steel slag, but strongly enhanced by carbonation, which causes the observed enhanced release of V from the K3 slag. The obtained insights in the mineral transformation reactions and their effect on pH and V-leaching provide guidance for further improvement of an accelerated carbonation technology.     

铬渣无害化处理技术研究进展

综述了铬渣无害化处理技术的研究进展,分析了各种技术在实际应用过程中的效果,指出各种处理技术的优缺点,详细介绍了固化法中水泥固化和药剂稳定化两种处理技术,提出开发重金属螯合剂是今后铬渣稳定化处理的研究方向.     

输变电项目竣工环保验收存在的问题及对策分析

结合输变电项目环保验收的调查实践,分析了输变电项目竣工环保验收中存在问题,提出对策及建议。     

Preparation of glass-ceramics from molten steel slag using liquid-liquid mixing method

A novel approach to prepare glass-ceramics from molten steel slag (MSS) was proposed. In laboratory, the water-quenched steel slag was melted at 1350 °C to simulate the MSS. A mixture of additive powders in wt.% (55 quartz powder, 5 Na₂O, 16 emery powder, 15 CaO, 8 MgO, 1 TiO₂) were melted into liquid at 1350 °C separately. Then the MSS and the molten additives were mixed homogeneously in order to obtain parent glass melt. The proportion of MSS in the melt was 50 wt.%. The melt was subsequently cast, annealed, heat-treated and transformed into glass-ceramics. Their microstructure and crystallization behavior were analyzed. The samples exhibited excellent properties and displayed bulk crystallization. The major crystallized phase was diopside ((Fe_0.35Al_0.20Mg_0.44)Ca_0.96(Fe_0.08Si_0.70Al_0.20)₂O_6.12), which was uniformly distributed in the microstructure. The novel approach may help iron and steel industry achieve zero disposal of steel slag with utilization of the heat energy of the MSS.