染料废水电催化氧化及降解动力学研究

以新型钛基二氧化铅电极为阳极、石墨为阴极、活性炭-纳米二氧化钛为催化粒子电极降解染料模拟废水酸性红B溶液,考察了槽电压、pH值、催化剂量等对处理效果的影响。实验结果表明:纳米二氧化钛催化剂的催化效果显著,该反应器能够有效的降解酸性红B,降解机制主要是电致H2O2、.OH对有机物的氧化、降解。同时用一级反应拟合了酸性红B溶液COD去除反应,由实验数据确定了反应动力学方程。     

钢渣预处理含铬废水及其废渣与铬渣的固化

用钢渣对含铬废水进行预处理,探讨了钢渣粒度、用量、废水pH值和添加硫酸亚铁还原剂的影响.结果表明,经硫酸亚铁还原处理后再用钢渣处理比单纯用钢渣处理的效果明显提高,采用钢渣/总铬质量比为40的100目钢渣处理经硫酸亚铁还原后的含铬废水,总铬和Cr6 去除率分别达79%和84%,采用钢渣柱进行的两级淋滤实验进一步表明该方法可作为工业上含铬废水处理的预处理段.处理后的废钢渣同工业铬渣一起进行水泥固化,标准养护20 d后固化体表面Cr6 浸出率、破碎至5 mm粒径以下和酸雨淋溶下的浸出液Cr6 浓度均符合安全标准,可作为普通建材或进行填埋处置.     

TSLCDM长袋低压脉冲布袋除尘器及其应用

为了使电炉烟气治理过程中污染源的排放达到国家排放标准,提出一种TSLCDM长袋低压脉冲除尘器(简称TSLCDM除尘器)。通过对该除尘器结构、除尘原理以及不同工况下除尘效率和过滤阻力的分析,得到该除尘器的除尘效率>99.9%,压力损失<1200 Pa,最终排出的烟气含尘质量浓度约5.54 mg/m3,满足了国家的超低排放要求,以泉州某公司电炉项目除尘系统为研究对象,证明了该新型脉冲布袋除尘器在电炉烟气治理除尘系统的应用效果,具有很好的经济和环境效益。     

典型电脱盐废水预处理技术及其应用

针对原油电脱盐废水处理形势日益严峻的问题,介绍了电脱盐废水预处理技术的研究及应用进展,分析了电脱盐废水预处理技术的原理、特点及应用效果,总结了影响电脱盐废水特点的主要因素,指出改进原油开采技术、提高电脱盐装置的运行和管理水平可从源头上改善电脱盐废水水质,进一步开发和应用先进技术对控制电脱盐废水污染具有积极意义。     

原子吸收法测定土壤中铅的方法

通过湿法消解土壤样品,利用石墨炉原子吸收分光光度法(GAAS)和火焰原子吸收分光光度法(FAAS)测定不同土壤样品中铅的含量,以验证2种方法的有效性并加以对比。实验结果表明:2种方法均满足土壤中铅含量的测定要求,测定的标准土样含量均在标准值的不确定度范围内,GAAS方法测定结果更接近保证值。二者的相对标准偏差(RSD)值均低于1.5%,FAAS方法的精密度更高,且具有快速简单等优势。     

单芯铜线过电流故障电弧熔痕的微观特征研究*

为准确认定电气火灾中过电流故障,模拟4~7倍额定电流（Ie）条件下单芯铜导线过电流故障,利用光学显微镜和扫描电子显微镜（SEM）分析过电流故障电弧熔痕的组织特征,并结合Image-Pro Plus软件测定晶粒直径、周长和面积,探究金相组织的量化判据和变化规律。结果表明:当I＝4Ie时,过电流故障电弧熔痕的金相组织主要为方向性较强的树枝晶;当I＝5Ie,6Ie时,金相组织内树枝晶占比减小,胞状晶占比升高;当I＝7Ie时,方向性较弱的胞状晶占主导。随着电流增加,晶粒的平均直径、周长和面积均呈增长趋势。通过火灾案例分析可知,实验结果与现场的电弧熔痕组织特征基本相符,验证火灾事故原因为过电流故障。     

Road traffic injuries among riders of electric bike/electric moped in southern China

Objective: Electric bike/moped-related road traffic injuries have become a burgeoning public health problem in China. The objective of this study was to identify the prevalence and potential risk factors of electric bike/moped-related road traffic injuries among electric bike/moped riders in southern China.

Methods: A cross-sectional study was used to interview 3,151 electric bike/moped riders in southern China. Electric bike/moped-related road traffic injuries that occurred from July 2014 to June 2015 were investigated. Data were collected by face-to-face interviews and analyzed between July 2015 and June 2017.

Results: The prevalence of electric bike/moped-related road traffic injuries among the investigated riders was 15.99%. Electric bike/moped-related road traffic injuries were significantly associated with category of electric bike (adjusted odds ratio [AOR] = 1.36, 95% confidence interval [CI], 1.01–1.82), self-reported confusion (AOR = 1.77, 95% CI, 1.13–2.78), history of crashes (AOR = 6.14, 95% CI, 4.68–8.07), running red lights (AOR = 3.57, 95% CI, 2.42–5.25), carrying children while riding (AOR = 1.96, 95% CI, 1.37–2.85), carrying adults while riding (AOR = 1.68, 95% CI, 1.23–2.28), riding in the motor lane (AOR = 2.42, 95% CI, 1.05–3.93), and riding in the wrong traffic direction (AOR = 1.63, 95% CI, 1.13–2.35). In over 77.58% of electric bike/moped-related road traffic crashes, riders were determined by the police to be responsible for the crash. Major crash-causing factors included violating traffic signals or signs, careless riding, speeding, and riding in the wrong lane.

Conclusion: Traffic safety related to electric bikes/moped is becoming more problematic with growing popularity compared with other 2-wheeled vehicles. Programs need to be developed to prevent electric bike/moped-related road traffic injuries in this emerging country.     

钢渣吸附处理苯酚废水的研究

采用恒温振荡的方法,考察了钢渣粒径、吸附温度、振荡速度、溶液pH值、溶液初始浓度对苯酚去除率的影响。结果表明,在粒径为120~180目、pH=4.0、苯酚溶液浓度在500 mg/L以内、苯酚/钢渣质量比为1∶1 000时吸附效果最好。钢渣对苯酚的吸附能较好地符合Langmuir和Freundlich吸附等温线,线性相关系数分别为0.9971和0.9916,吸附机理为表面吸附。     

活性炭吸附和脱附-等离子体氧化净化有机废气的研究

根据滑动弧放电等离子体适于降解高浓度有机物废气的特性,结合活性炭吸附法,提出了吸附器的吸附浓缩和热脱附-等离子体氧化净化有机废气的方法。在活性炭吸附过程中,最初2 h内甲苯净化率达到100%,随着时间的增加净化率下降;在热脱附滑动弧放电等离子体净化过程中,甲苯降解效率最高为97.3%。将滑动弧放电等离子体反应器出口气相产物收集进行FT-IR检测,发现放电后有CO2、CO、H2O和NO2产生,并分析了甲苯的降解机理。     

利用高炉水淬渣制作多孔吸声材料的研究

为了促进高炉炼铁水淬渣的二次利用,研究了以高炉炼铁水淬渣为原料,以硅微粉或水泥为粘结剂,采用压制成型方法制作的多孔吸声材料的吸声性能及力学性能。结果表明:用颗粒状的高炉炼铁水淬渣制作的多孔吸声材料具有良好的吸声性能,其平均吸声系数可以达到0.70以上;材料的抗压强度可以达到3.0 MPa以上。