微量元素对牛粪低温厌氧发酵的影响

为考察较低温度(<17℃)条件下添加微量金属元素对厌氧发酵产气量的影响,在发酵底物TS(含固率)为10%下采用10 L玻璃瓶作反应器,以牛粪为原料,向厌氧生物反应器中分别添加MnSO4、FeSO4·7H2O、电解锰渣,分析了厌氧消化系统运行过程中的产气量、COD(化学需氧量)和pH的变化。结果表明,锰元素能促进低温下牛粪的厌氧发酵,加速反应启动。当添加6 g MnSO4、100 g电解锰渣时,单位质量VS产气率分别为0.26 mL/g和0.64 mL/g,添加6 g FeSO4·7H2O与空白对照组均未见明显产气。     

水滑石与磷酸银可见光催化剂的活性对比研究

本文合成了具备水滑石结构(LDH)的Zn-Cr LDH、Zn-Ti LDH以及Ag3PO43种半导体光催化剂,并对它们的催化性能进行对比研究。XRD和SEM分析表明,Zn-Cr LDH、Zn-Ti LDH具有层状结构而Ag3PO4呈纳米球状结构。UV-Vis分析表明,Ag3PO4和Zn-Cr LDH能够吸收可见光(>420 nm)。在可见光照射与添加AgNO3作为电子受体的条件下,Zn-TiLDH几乎没有光催化活性,而Ag3PO4的光催化活性高于Zn-Cr LDH。Ag3PO4在光解水实验中180 min内氧气产量约1.2mL,而Zn-Cr LDH约为0.65 mL。光催化降解有机污染物实验中,在Ag3PO4催化作用下,120 min内亚甲基蓝(MB)被完全降解,在240 min内46%的对硝基酚(PNP)被降解,而Zn-Cr LDH相应的去除率分别为61%和27%。     

TiO2/Ti及其改性处理聚乙二醇模拟废水

采用溶胶-凝胶法制备TiO2/Ti负载体系,并以聚乙二醇2000（PEG-2000）为模拟废水对其光催化性能进行研究。实验表明,TiO2/Ti的最佳负载条件为镀膜层数8层、pH值为3、焙烧温度700℃、焙烧时间2 h,掺杂Fe3＋、Ag＋、La3＋、Pt4＋4种金属离子均可有效提高TiO2/Ti对PEG-2000模拟废水的处理效果,在Ag＋掺杂量为0.3%、焙烧温度800℃时,2.5h反应后的COD去除率达到了79.5%。XRD分析表明,金属离子的加入抑制了TiO2由锐钛矿相向金红石相转化。GC-MS分析表明,PEG-2000的光催化是大分子分解为小分子然后被矿化的过程。     

实时荧光定量PCR对A2/O短程硝化系统内氨氧化菌的定量分析

通过控制好氧区低DO浓度以及缩短好氧实际水力停留时间(actual hydraulic retention time,AHRT),在处理低C/N比实际生活污水的A2/O工艺中,成功启动并维持了短程硝化反硝化;系统亚硝酸盐积累率稳定维持在90%左右,氨氮去除率在95%以上。通过提取富集氨氧化菌(ammonia oxidizing bacteria,AOB)的基因组DNA,经两次常规PCR扩增和琼脂糖凝胶电泳,以纯化回收的DNA扩增片段作为实时荧光定量PCR检测AOB数量的DNA标准品,建立了检测AOB数量的实时荧光定量PCR标准曲线。利用实时荧光定量PCR技术比较了A2/O系统在不同运行条件及亚硝酸盐积累率情况下AOB菌群数量。结果表明,随着系统亚硝酸盐积累率的上升,系统内AOB菌群数量也大幅上升。全程硝化和短程硝化时,系统内的AOB菌群数量分别为5.28×109cells/g MLVSS和3.95×1010cells/g MLVSS。此外,亚硝酸盐积累率的下降相对于AOB菌群数量的下降有一定的滞后性。     

电催化氧化技术处理制革综合废水

选择DSA电极中的钛基掺硼金钢石膜电极(Ti/BDD),用于制革综合废水的电催化氧化处理研究,考察了在不同的电流密度、电压、电解质、pH值和电解时间等因素对COD去除率和电流效率的影响。结果表明,控制电流密度为30mA/cm2,电压为8.0 V,电解质(NaCl)浓度为2.0 g/L,pH为4.0,电催化氧化处理2 h后,废水的COD和NH4+-N的去除率分别达到了83.6%和90.3%,BOD/COD为0.45,比能耗为35.34 kWh/kg COD,电流效率为37%。     

MnxCe1-xO2／γ-Al2O3催化剂的制备及其催化甲苯的燃烧性能

以γ-Al2O3为载体,以MnxCe1-xO2为催化活性组分,采用浸渍法制备了一系列负载型MnxCe1-xO2／γ-Al2O3催化剂（x=0、0．2、0．4、0．6、0．8、0．9、1）,在固定床反应器中评价了催化剂对甲苯的催化燃烧性能。结果表明,MnxCe1-xO2／γ-Al2O3催化剂的催化活性与催化剂的焙烧温度、活性组分MnxCe1-xO2的负载量以及Mn、Ce摩尔比有显著关系,其中焙烧温度550℃、负载量为20％、Mn、Ce摩尔比为4：1时,即MnxCe1-xO2／γ-Al2O3催化剂对甲苯的催化性能最佳,反应温度为180℃时,甲苯的转化率达到95％。并在连续100h的稳定性操作后,催化剂的活性基本无变化。采用XRD、BET以及SEM等分析测试手段对催化剂的结构以及表面进行了表征。     

Green accounting and sustainability of the Peruvian metal mining sector

This paper estimates the true economic income of Peru’s metal mining sector for the period 1992–2006, using a model of green economic income based on Hamilton (2000). The total depletion of natural capital caused by metal mining is calculated by estimating, on the one hand, the depreciation of mining resources (using the Hotelling rent approach) and, on the other, the environmental degradation provoked by metal mining activities. The results show that the total loss of natural capital represents between 31% and 51% of the metal mining GDP and between 2% and 4.9% of Peru’s GDP. On the other hand, correcting the usual GDP measure produced by the traditional National Account System (NAS) for the total loss of natural capital caused by mining activities shows that the GDP traditional measure overestimated by 51–64% the true economic income generated by Peruvian's metal mining sector during the period 1992–2006. The importance of the generation, taxation, and disposition of mining economic rents for Peru’s sustainable development in the future is also discussed.     

The evolution of the Canadian mining industry: The role of regulatory punctuation

In this study, we analyze the evolution of Canada's mining industry from 1929 to 2006, focussing on the determinants of the number of firms in the industry and why this number changed over that period. Most empirical studies of industry evolution have focused on manufacturing industries that share similar structural characteristics. Perhaps because of this, extant models of industry evolution tend to ignore industry-specific and national-specific factors that can cause atypical trajectories, that is, heterogeneous industry evolution. Initial inspection of the Canadian mining industry shows that it is atypical in that it exhibits “negative skew” over time in the number of firms rather than the typical “positive skew.” We review two dominant theoretical approaches to industry evolution: the density-dependence theory and variants of industrial organization economics. We also consider possible sources of industry evolution heterogeneity, focussing particularly on “regulatory punctuation”. Using Canadian mining data, we find that the traditional models do not fully explain the changes in population size in Canada's mining industry. As a result, we introduce a number of hybrid models. The results from these hybrid models suggest that Canadian-specific regulatory punctuations, particularly the introduction of significant new taxes, environmental legislation, and incentives have shaped the trajectory of mining firm participation.     

Estimates of synthetic fertilizer N-induced direct nitrous oxide emission from Chinese croplands during 1980-2000

There is increasing concern that agricultural intensification in China has greatly increased N₂O emissions due to rapidly increased fertilizer use. By linking a spatial database of precipitation, synthetic fertilizer N input, cropping rotation and area via GIS, a precipitation-rectified emission factor of N₂O for upland croplands and water regime-specific emission factors for irrigated rice paddies were adopted to estimate annual synthetic fertilizer N-induced direct N₂O emissions (FIE-N₂O) from Chinese croplands during 1980-2000. Annual FIE-N₂O was estimated to be 115.7 Gg N₂O-N year⁻¹ in the 1980s and 210.5 Gg N₂O-N year⁻¹ in the 1990s, with an annual increasing rate of 9.14 Gg N₂O-N year⁻¹ over the period 1980-2000. Upland croplands contributed most to the national total of FIE-N₂O, accounting for 79% in 1980 and 92% in 2000. Approximately 65% of the FIE-N₂O emitted in eastern and southern central China.     

可见光响应型CuO/BiVO4的光催化活性研究

采用浸渍法制备了CuO/BiVO4光催化剂,通过X射线衍射(XRD)、热重/差示扫描量热(TG/DSC)和傅立叶红外光谱(FTIR)对其进行了表征,并在可见光照射下考察了其光催化氧化亚甲基蓝(MB)的动力学特性。结果表明,Cu的掺杂并未改变BiVO4的晶型结构;Cu(NO3)2/BiVO4在热处理(30～300℃)过程中,NO3-已经完全分解,Cu最终以CuO的形式存在于CuO/BiVO4光催化剂体系中;掺杂不同量Cu的CuO/BiVO4中的Cu2+/Bi+(摩尔比)实测值与理论值相近,该系列光催化剂的合成过程具有较高的可信度;在可见光照射下,CuO/BiVO4光催化降解MB反应符合表观一级反应动力学特征;当Cu2+/Bi+为0.050时,反应动力学速率常数(k)达到最高值(0.4334h-1),此时的k比单体BiVO4作用下的提高了1.04倍;由于异质结的存在,CuO/BiVO4与单体BiVO4相比,电子和空穴的利用率大大增加,使得CuO/BiVO4的光催化活性较单体BiVO4有了大幅度提高。