Comparison of Two Manual Methods of Nitrogen Dioxide Determination in Ambient Air

Sodium arsenite (modified Jacobs and Hochheiser method; hereafter referred as SA), the most widely used manual monitoring method for determination of nitrogen dioxide (NO₂) in ambient air, particularly in developing countries has been evaluated and compared with US EPA recommended equivalent method of TGS-ANSA (hereafter referred as ANSA). NO₂ concentrations generated from laboratory test atmosphere were analyzed by these two methods and were compared statistically. Laboratory evaluations showed that SA method has high sensitivity to different sampling conditions, which normally vary during actual field monitoring. Hence, correction factors for absorption efficiency were estimated for SA and ANSA methods. Absorption efficiency of NO₂ in SA method was found to be much lower (64%) as against the reported value of 82% at the method recommended sampling conditions, whereas for ANSA method, it was found 1.0 as against the reported value of 0.93. After applying derived correction factors, both the methods produced almost similar concentration values of NO₂.     

铁路运输业污水治理系统分析

研究了乌鲁木剂铁路局系统污水治理污染控制方法及途径，提出了主要污染物为石油类，其最佳治理对策是：确定重点污染单位、污染源、用最低的治理投入，选择斜板隔油气浮工艺治理重点污染和次重点污染部门，得到较好的治理效果，否定盲目追求“零排放”的高投入方案。     

Controlled-release fertilizer(CRF):A green fertilizer for controlling non-point contamination in agriculture

Fertilizers contribute greatly to high yields but also result in environmental non-point contamination, including the emission of greenhouse gas(N2O) and eutrophication of water bodies. How to solve this problem has become a serious challenge, especially for China as its high ecological pressure. Controlled-release fertilizer(CRF) has been developed to minimize the contamination while keeping high yield and has become a green fertilizer for agriculture. Several CRFs made with special coating technology were used for testing the fertilizer effects in yield and environment through pot experiment and field trial. The result indicated that the CRFs had higher N use efficiency, thus reducing N loss through leaching and volatilization while keeping higher yields. Comparing with imported standard CRFs,the test on CRFs showed similar fertilizer effect but with much lower cost. CRFs application is becoming a new approach for minimizing non-point contamination in agriculture.     

含柠檬酸盐电镀废水的处理

对含柠檬酸盐电镀废水的几种处理方法的比较表明,氯化钡添加法能较好地使柠檬酸盐沉淀,操作简便,处理效果理想,其柠檬酸根离子的去除率达98％以上。     

膨润土吸附－絮凝法处理污水中的重金属离子

研究了天然膨润土对Ｐｂ￣（２＋）、Ｃｄ￣（２＋）、Ｃｒ￣（３＋）的吸附和膨润土的絮凝沉降条件，将吸附与絮凝过程结合起来形成处理污水的新工艺，加入０．０４％膨润土和０．００６％的ＰＡＣ可使低浓度污水中Ｐｂ￣（２＋）脱除９３．１％。     

SBR法处理中药材有机废水工艺研究

应用ＳＢＲ法对中药材有机废水进行了研究。考察了ＣＯＤＣＲ、ＢＯＤ５、ＳＳ、ＮＨ３－Ｈ的处理效果，以及ＰＨ、水温、污泥负荷等条件对去除率的影响。运行结果表明，ＰＨＯ ６．０－９．０、ｔ为１５－３０℃、污沁荷０．３ｋｇＢＯＤ５／ｋｇＭＬＳＳ．ｄ，运行程序：进水０．５ｈ（限制曝气）、曝气１０ｈ、脱氮１．５ｈ，沉降０．５ｈ，排水０．５ｈ、闲置１１ｈ，周期时间２４ｈ时ＣＯＤＣＲ去除率８８％、ＢＯＤ５９４％、     

冷摆辗模具的材料选择及其热处理

模具寿命是冷摆辗的关键问题之一。选择合理的模具材料以及采用适宜的热处理工艺可以提高冷摆辗模具的强韧性,从而提高模具寿命。基于摆动辗压工艺的基本原理,分析研究了冷摆辗模具的受力情况,并对冷摆辗模具材料的选择及热处理工艺作了探讨。     

Al_2O_3光催化降解染料性能研究

液相加热法制备了Al2O3作为光催化剂,研究了不同光源、光照时间、催化剂用量和溶液酸度等条件对常见有机染料光催化降解性能影响。结果表明,用太阳光作为光源照射3h,50mL染料溶液中加入Al2O3 30mg,溶液pH8～10,孔雀石绿,酚藏花红,甲基紫等染料脱色率达93%以上。将使用过的Al2O3经过简单处理,孔雀石绿溶液脱色率仍达到94.1%,催化性能稳定,可以重复利用。通过紫外可见光谱分析,表明染料分子在催化剂和光照条件下发生了降解。     

餐饮废水处理技术探讨

介绍了我国餐饮业的发展趋势，指出餐饮废水已经成为城市的主要高浓度污染源之一，同时适当地讨论了目前餐饮废水处理技术研究的现状以及处理系统的技术要求，最后提出了对不同规模的餐饮废水处理的适当方法。     

1000t/d含油废水旋流分离技术及设备研究

将实验室研制的 HL 型旋流器用压力容器式方式并联起来 ,建立 10 0 0 t/ d规模的示范装置 ,并进行试验。示范装置的试验结果表明 ,与工业测试比较 ,HL型旋流器并没有因为规模的放大而造成性能下降 ,它能取代石化行业目前采用的“一隔二浮”流程中的大部分装置 ,具有明显的经济效益和广阔的应用前景