染料脱色菌的筛选及对活性艳红X-3B的脱色研究

从广州某印染厂生化处理池的活性污泥中筛选到三株对活性艳红X-3B具有高效脱色作用的真菌,其中菌株HMX-3的脱色能力最强。考察了培养时间、温度、培养方式、pH值以及染料浓度对HMX-3脱色能力的影响。结果表明,菌株HMX-3对150mg/L X-3B的24h脱色率达65.8%,经60h可使其完全脱色;HMX-3对活性艳红X-3B脱色的最适温度为25℃~35℃,最佳pH值为6~8,且振荡培养较静置培养条件下的脱色率高;随染料浓度的增加,脱色率降低,但对于400mg/L的X-3B在72h时的脱色率可达86.7%。     

Triton X-100 induced cuboid-like BiVO4 microsphere with high photocatalytic performance

A highly active visible light-induced BiVO₄ photocatalyst was prepared by a simple co-precipitation method using ammonia solution as a pH adjustor and Triton X-100 (TX100) as a structure directing agent. The physical properties of the prepared BiVO₄ photocatalyst were investigated by several techniques such as X-ray diffractometer (XRD), Brunauer–Emmett–Teller (BET) surface area measurement, scanning electron microscopy (SEM), energy dispersive analysis (EDS), Fourier-transformed infrared spectroscopy (FT-IR), photoluminescence (PL), and UV–Vis diffused reflectance spectroscopy (DRS). XRD results revealed the existence of a monoclinic scheelite structure in both the unmodified and the modified samples. The TX100 played a crucial role to control the cuboid-like shape morphology of BiVO₄. The DRS results showed that the as-prepared cuboid BiVO₄ possessed enhanced visible light absorption range compared with that of the unmodified BiVO₄. The photocatalytic activity was evaluated via indigo carmine (IC) degradation under visible light irradiation. The modified BiVO₄ showed higher photocatalytic efficiency than the unmodified BiVO₄ and the commercial P25-TiO₂ which could be ascribed to the better charge separation efficiency.     

三维粒子电极催化氧化活性艳红X-3B实验研究

采用浸渍焙烧法制备了Cu/γ-Al2O3、Cu-Co/γ-Al2O3粒子电极,TiO2/Ti为阳极、石墨为阴极,采用三维电极降解染料模拟废水活性艳红X-3B溶液,考察了粒子电极、槽电压、pH值、电解质浓度等因素对处理效果的影响。实验结果表明:该反应器能够有效的降解X-3B,粒子电极显示了较高的催化活性,双组分粒子电极Cu-Co/γ-Al2O3比单组分粒子电极Cu/γ-Al2O3有着更好的催化效果,降解机制主要是电致·OH的间接氧化和粒子电极表面的直接氧化的协同作用。     

Al-Cu双金属体系对活性艳红X-3B的脱色研究

以典型偶氮染料活性艳红X-3B为模型污染物,采用测定染料去除率、TOC去除率、苯胺生成量的方法及添加EDTA的对照试验,考察Al-Cu双金属体系对偶氮染料废水的脱色机理和脱色动力学.结果表明,在近中性条件下处理30min后脱色率就可达到83%左右;处理120min后脱色率高达96.4%,其中约为34%的色度去除是由于活性艳红X-3B被还原为苯胺,约为20%和30%的色度去除是由于铝离子混凝和铝刨花表面吸附.染料废水脱色是一个先大量吸附再进行内电解还原逐步降解的过程,铝离子的絮凝-吸附作用能有效促进色度的去除.脱色反应可视为表观一级反应,提高反应温度可以加快脱色速率.     

零价铁还原降解活性染料

在分别通氮气,不通氮气和曝气的情况下,在水溶液中用零价铁还原降解活性染料。实验发现：在不同的氛围中,活性染料的降解程度不同,其降解程度为：暴气〉不通氮气〉通氮气。在不同通氮 和曝气的条件下,活性染料的降解过程中有黄色絮状沉淀生成,经红外光谱鉴定为三聚氯氰的取代产物。     

不同光照度下活性艳红X-3B的光催化降解动力学研究

以活性艳红X-3B为模型化合物，以TiO2为光催化剂，研究了不同光照度下污染物的多相光催化降解动力学。结果表明，活性艳红X-3B的光催化降解动力学符合Langmiur—Hinshelwood动力学模型，其中的表观反应速率常数(k)随入射光照度的增加而增大，吸附平衡常数(KA)却随入射光照度的增加而减小，在实验的光照度范围内，k和KA^-1与光照度的平方根成比。     

活性艳红X-3B的厌氧生物降解与机理

以活性艳红X-3B(RBR)为研究对象,分3个不同浓度组研究其在厌氧颗粒污泥作用下的降解性能,并采用生物降解动力学方程拟合其降解过程,同时利用GC-MS分析RBR的生物降解途径.试验结果表明,RBR在厌氧颗粒污泥中降解性能很好,去除率可达93.67%,且其降解过程符合二级反应动力学,其半衰期约为3.561 h.从GC-MS和UV-可见光谱的分析得出,RBR在厌氧颗粒污泥的作用下偶氮键断裂,且生成的芳香胺类化合物进一步降解为小分子的烃类、酚类、醇类和脂类化合物.     

A simple and cheap method for preparation of coupled ZrO2/ZnO with high photocatalytic activities

The objective of this study was to prepare a new photocatalyst with high activities for degradation of organic pollutants. Coupled ZrO₂/ZnO photocatalyst was prepared with a simple precipitation method with cheap raw materials zinc acetate and zirconium oxychloride, and was characterized by X-ray diffraction (XRD) and transmission electron microscopy (TEM). Reactive brilliant red X-3B was used as a model compound to investigate the photocatalytic activity of synthesized catalysts in water under 254 nm UV irradiation. Results show that the optimal calcination temperature and coupling molar ratio of Zr were 350°C And 2.5%, respectively. At the calcination temperature of 350°C, ZrO₂ was dispersed on the surface of hexagonal ZnO in the form of amorphous clusters. The particle size of ZrO₂/ZnO decreased with the decrease of calcination temperature and the increase of Zr coupling amount. ZrO₂/ZnO has better photocatalytic activity for degradation of reactive brilliant red (RBR) X-3B than pure ZnO and P25-TiO₂.     

纳米锐钛型TiO2光电催化降解模拟印染废水的研究

纳米锐钛型TiO2催化降解印染废水具有明显优势,笔者以亚甲基蓝模拟印染生产废水作为光电催化降解研究对象,探讨了其协同性和反应动力学特征,考察了光电催化体系中溶液的电解质、电流强度、pH值、辅助试剂对处理效果的影响,确定了最佳反应条件,取得了较好降解效果,并用活性艳红X-3B模拟废水进行了验证,为该技术的实际工业应用提供了有价值的参考.     

枣庄市大气颗粒物扫描电镜分析和来源识别

应用扫描电镜-X射线能谱对枣庄市大气颗粒物进行定性分析,得出如下结论：（1）枣庄市大气颗粒物中含有燃煤颗粒、土壤颗粒、水泥颗粒、汽车尾气颗粒、石膏颗粒、植物残体颗粒和未知颗粒;（2）依据颗粒粒数百分比统计结果。得出枣庄市大气颗粒物以水泥颗粒、土壤颗粒和燃煤颗粒为主,汽车尾气颗粒和其它颗粒含量很少;（3）对枣庄市大气颗粒物平均粒径进行统计,得出枣庄市大气颗粒物平均粒径集中分布在2．5μm～20岬范围内,其粒数百分比在80％以上。