铁蓝—活性炭生物膜法处理彩色胶片水洗废水的研究

定影漂白废话水用铁蓝法预处理，结果表明，以硫酸亚铁为沉淀剂，投加量为铁氰化物理论值的１．３倍，ＣＮ去除率为９８％，反应生成的普鲁士蓝纯度较高，可供综合利用，铁蓝法除ＣＮ后的出水与显影冲洗废水混合，再经生炭生物膜法处理，ＣＯＤｃｒ去除率为８０％；     

UV/TiO_2膜深度处理垃圾渗滤液的研究

研究了以固定相TiO2为催化剂光催化降解垃圾渗滤液中有机污染物的可行性。试验了制备TiO2膜的适宜条件以及光照时间等各种因素对COD的去除率和UV335脱色率的影响。研究表明,COD为418mg/L的垃圾渗滤液经400W高压汞灯光照30min,COD的去除率和UV335脱色率分别为44.3%和75.0%。光照时间60min时,COD的去除率和UV335脱色率可提高至54%和90%。光照30min后与活性炭柱联用,COD的去除率和UV335脱色率分别提高到68.3%和84.6%。     

膜生物反应器去除废水中阴离子表面活性剂的研究

阴离子表面活性剂是环境中分布广泛且具有代表性的一类有机污染物.采用分置式膜生物反应器(MBR)进行去除模拟废水中阴离子表面活性荆(LAS)的实验,结果表明:MBR对阴离子表面活性荆的去除率高于90%.同时考察了阴离子表面活性荆生物降解的影响因素,确定其适宜降解条件为:气体流量为0.3m3/h、活性污泥浓度为6948mg/L.初步探讨了降解动力学和降解机理,研究表明对阴离子表面活性剂的去除符合拟一级反应动力学过程,且生物降解对其去除起主要作用.     

城市污水高效低耗生物脱氮工艺研究

采用活性污泥与生物膜法相结合工艺处理城市生活污水，可以高效去除污水中的有机物和NH4^ -N。研究结果表明：水力停留时间为7．5h、回流比为1．5、无外加碳源时，COD的去除率大于90％，NH4^ -N的去除率大于99％；平均出水COD小于40mg／L，NH4^ -N小于1mg／L，TN的去除率60％左右；反硝化过程的适宜C／N为4～5。     

不对称氧化铝膜管的微滤性能研究

采用熔模离心法制备的不对称氧化铝微滤膜管的孔径沿径向呈样度分布，控制层孔径均匀。最可几孔径为０．０５μｍ，最大孔径为０．１μｍ的管能滤原液中全部的细菌，获得完全无菌的水，但过滤速率太慢，最可几孔径为０．１μｍ，最大孔径为０．２μｍ、最大孔径０．３μｍ。     

膜生物反应器中膜污染研究进展

膜生物反应器是近年新发展起来的高效废水处理工艺。本文综述了国内外对膜污染机理研究的最新成果 ,介绍了相应的解决措施 ,展望了今后的发展前景。     

物理化学预处理与膜分离技术的应用

将物理化学预处理与膜分离技术深度处理结合应用于工业废水处理，可使其中的Ｃｒ６＋＜０．５ｍｇ／ｌ，Ｚｎ２＋＜２０ｍｇ／ｌ，ｐＨ６～９。用膜分离技术处理造纸废水可回收其中的木质素和糖份，回收率均为６０％左右。     

膜生物反应器与传统活性污泥工艺除污特性比较

比较了膜生物反应器（MBR）和传统活性污泥工艺（CAS）在相同运行条件下对生活污水的除污特性.结果表明,MBR系统对COD、NH3-N和TN的平均去除率比CAS分别高14.4%、51.2%和37.3%.但MBR中膜的截留使系统相对比较封闭,制约了通过排放高磷污泥的生物法除磷,除磷效率仅为32.9%,低于CAS工艺（43.0%）;将MBR与化学除磷工艺相结合,MBR系统除磷效率可达93.3%.     

Treatment of a dyeing wastewater from a woolen mill using an A/O membrane bio-reactor

ＩｎｔｒｏｄｕｃｔｉｏｎＴｈｅｄｙｅｉｎｇｗａｓｔｅｗａｔｅｒｏｆｗｏｏｌｅｎｍｉｌｌｃｏｎｔａｉｎｓａｌｏｔｋｉｎｄｓｏｆｐｏｌｌｕｔａｎｔｓ,ｓｕｃｈａｓａｃｉｄｉｃｄｙｅｓ,ｄｉｓｐｅｒｓｅｄｙｅｓ,ｍｏｒｄａｎｔｄｙｅｓ,ａｕｘｉｌｉａｒｉｅｓ,ｓａｌｔｓａｎｄｓｏｏｎ .Ｔｈｅｅｆｆｌｕｅｎｔｓｆｒｏｍｗａｓｔｅｗａｔｅｒｔｒｅａｔｍｅｎｔｐｌａｎｔｓｆｏｒｔｒｅａｔｍｅｎｔｏｆｔｈｅｄｙｅｉｎｇｗａｓｔｅｗａｔｅｒｏｆｗｏｏｌｅｎｍｉｌｌｓｗｉｔｈｎｏｒｍａｌｂｉｏｌｏｇｉｃａｌｐｒｏｃｅ…     

Test of membrane bioreactor for waste water treatment in a petrochemical complex

Membrane bioreactor (MBR) used in water and waste water treatment is a developing technique for water pollution control and water reuse. This paper describes a membrane-bioreactor for treatment of waste water in a petrochemical complex. The experimental MBR was a lab scale one composed of an activated sludge bioreactor unit and an ultrafiltration membrane unit. The relationship of COD removal with MLSS and HRT in this MBR was studied. The effects of crossflow velocity, backwash interval and volume of flush liquid on the flux were discussed. The results showed that average removal of COD, oil, SS and turbidity in petrochemical waste water by the MBR was 91%, 86%, 92% and 99% respectively. The average removal of NH₃-N and total phosphorous was 85% and 82%. A coefficient of COD removal, k, was 0.017-0.080 L/(mg.d). The membrane flux maintained higher than 60 L/hm2 bar for 34 days without chemical cleaning when the velocity of crossflow was 3.5-3.9 m/s and the backwash interval was 30 minutes and backwash duration at 20 seconds. The results indicated that it is feasible for MBR technology to be used in petrochemical waste water treatment. The treated water could be considered as a source used to make up water for industrial cooling system or to be reused for other purposes.