废弃电器电子产品POPs/PTS减排环境管理实践研究

全球环境基金(GEF)"通过环境无害化管理减少电器电子产品的生命周期内持久性有机污染物和持久性有毒化学品(POPs/PTS)的排放全额示范项目"湖北省作为项目示范省之一.三家废弃电器电子产品拆解企业,分别开展了废弃电器电子产品拆解技术示范、湿法废弃印刷电路板处置BAT/BEP技术示范、利用再生铅连续熔炼炉协同处置阴极射线管含铅锥玻璃项目技术示范.电子废弃物全自动化分类与拆解生产线,为电子废弃物绿色循环与资源化提供了示范模式.     

流动注射分光光度法测定水中痕量氟化物

研究并建立了测定水中痕量氟化物的氟试剂（ＡＬＣ）－流动注射分光光度法。将水样注入到水载流中,与ＡＬＣ－Ｌａ丙酮水溶液混合,在５０℃时反应生成蓝色三元络合物,在分光光度计上于波长６１８ｍｍ处进行检测。Ｆ＾－测定的线性范围为０．０４－３．０ｍｇ／Ｌ,检出限为０．０３６ｍｇ／Ｌ。     

Integrating channel design and assessment methods based on sediment transport capacity in gravel bed streams

Natural channel design (NCD) and analytical channel design (ACD) are two competing approaches to stable channel design that share fundamental similarities in accounting for sediment transport processes with designs based on hybrid fluvial geomorphology and hydraulic engineering methods. In this paper, we highlight the linkage between ACD's capacity/supply ratio (CSR) and NCD's sediment capacity models (FLOWSED/POWERSED), illustrating how ACD and NCD have reached a point of convergent evolution within the stream restoration toolbox. We modified an existing CSR analytical spreadsheet tool which enabled us to predict relative channel stability using both conventional bed load transport equations and regional sediment regression curves. The stable channel design solutions based on measured data most closely matched the Parker (ACD) and/or Pagosa good/fair (NCD) relationships, which also showed the greatest CSR sensitivity in response to channel alterations. We found that CSR differences among the transport relationships became more extreme the further the design width deviated from the supply reach, suggesting that a stable upstream supply reach may serve as the best design analog. With this paper, we take a step toward resolving lingering controversy in the field of stream restoration, advancing the science and practice by reconciling key differences between ACD and NCD in the context of reach scale morphodynamics.     

生活垃圾堆肥工艺条件及其反应动力学研究

为了改善堆肥微环境 ,提高生活垃圾堆肥速率 ,研究堆肥工艺条件及其反应动力学是非常必要的。通过控制堆肥工艺条件 ,如初始温度、含水率、C/N比及堆料颗粒大小 ,研究生活垃圾堆肥过程中生物、化学及物理因素的变化。试验结果表明 ,生活垃圾堆肥反应符合一级反应动力学 ;合理控制堆肥初始反应条件 ,能明显提高堆肥效率。     

有机硅改性环氧树脂的光固化动力学与性能研究

目的研究紫外光固化有机硅改性环氧树脂的固化行为和性能。方法通过介电分析(DEA)研究光引发剂、热引发剂及有机硅含量对紫外光固化脂环族环氧树脂反应过程的影响,利用热重(TG)、差示扫描热(DSC)和显微硬度仪对有机硅树脂改性环氧树脂性能进行分析。结果发现光引发剂与热引发剂对固化效率可起到协同互补的作用,增加光引发剂和热引发剂的浓度,可缩短引发时间,加快固化速率,提高固化效率。与纯环氧树脂相比,有机硅改性环氧树脂的固化效率和初始分解温度都有所下降,但高温阶段降解速率明显降低,500℃的残炭率也得到提高。当加入质量分数为10%的有机硅时,固化物表现出较好的耐热性能,树脂维氏硬度可达31.75HV。结论紫外光可以很好地固化有机硅改性环氧树脂。     

医疗焚烧废渣的固定化试验研究

医疗垃圾属于国家规定的危险废物,焚烧后的残渣同样存在最后稳定化的问题,国外处理方法主要是填埋和基础回填,本文通过对两种胶凝材料(普硅水泥和复合矿渣水泥)对医疗废渣的固定化效果研究,探讨医疗废渣再利用的可行性和影响因素。     

An integrated method for the rapid dewatering and solidification/stabilization of dredged contaminated sediment with a high water content

• An integrated method, called PHDVPSS, was proposed for treating DCS. • The PHDVPSS method showed superior performance compared to conventional method. • Using the method, water content (%) of DCS decreased from 300 to<150 in 3 days. • The 56-day UCS from this method is 12‒17 times higher than conventional method. • Relative to PC, GGBS-MgO binder yielded greater reduction in the leachability. To more efficiently treat the dredged contaminated sediment (DCS) with a high water content, this study proposes an integrated method (called PHDVPSS) that uses the solidifying/stabilizing (S/S) agents and prefabricated horizontal drain (PHD) assisted by vacuum pressure (VP). Using this method, dewatering and solidification/stabilization can be carried out simultaneously such that the treatment time can be significantly shortened and the treatment efficacy can be significantly improved. A series of model tests was conducted to investigate the effectiveness of the proposed method. Experimental results indicated that the proposed PHDVPSS method showed superior performance compared to the conventional S/S method that uses Portland cement (PC) directly without prior dewatering. The 56-day unconfined compressive strength of DCS treated by the proposed method with GGBS-MgO as the binder is 12‒17 times higher than that by the conventional S/S method. DCS treated by the PHDVPSS method exhibited continuous decrease in leaching concentration of Zn with increasing curing age. The reduction of Zn leachability is more obvious when using GGBS-MgO as the binder than when using PC, because GGBS-MgO increased the residual fraction and decreased the acid soluble fraction of Zn. The microstructure analysis reveals the formation of hydrotalcite in GGBS-MgO binder, which resulted in higher mechanical strength and higher Zn stabilization efficiency.     

The performance of nitrate-reducing Fe(II) oxidation processes under variable initial Fe/N ratios: The fate of nitrogen and iron species

•Bacterially-mediated coupled N and Fe processes examined in incubation experiments. •NO₃⁻ reduction was considerably inhibited as initial Fe/N ratio increased. •The maximum production of N₂ occurred at an initial Fe/N molar ratio of 6. •Fe minerals produced at Fe/N ratios of 1–2 were mainly easily reducible oxides. The Fe/N ratio is an important control on nitrate-reducing Fe(II) oxidation processes that occur both in the aquatic environment and in wastewater treatment systems. The response of nitrate reduction, Fe oxidation, and mineral production to different initial Fe/N molar ratios in the presence of Paracoccus denitrificans was investigated in 132 h incubation experiments. A decrease in the nitrate reduction rate at 12 h occurred as the Fe/N ratio increased. Accumulated nitrite concentration at Fe/N ratios of 2–10 peaked at 12–84 h, and then decreased continuously to less than 0.1 mmol/L at the end of incubation. N₂O emission was promoted by high Fe/N ratios. Maximum production of N₂ occurred at a Fe/N ratio of 6, in parallel with the highest mole proportion of N₂ resulting from the reduction of nitrate (81.2%). XRD analysis and sequential extraction demonstrated that the main Fe minerals obtained from Fe(II) oxidation were easily reducible oxides such as ferrihydrite (at Fe/N ratios of 1–2), and easily reducible oxides and reducible oxides (at Fe/N ratios of 3–10). The results suggest that Fe/N ratio potentially plays a critical role in regulating N₂, N₂O emissions and Fe mineral formation in nitrate-reducing Fe(II) oxidation processes.     

Optimization of the O3/H2O2 process with response surface methodology for pretreatment of mother liquor of gas field wastewater

• Real ML-GFW with high salinity and high organics was degraded by O₃/H₂O₂ process. • Successful optimization of operation conditions was attained using RSM based on CCD. • Single-factor experiments in advance ensured optimal experimental conditions. • The satisfactory removal efficiency of TOC was achieved in spite of high salinity. • The initial pH plays the most significant role in the degradation of ML-GFW. The present study reports the use of the O₃/H₂O₂ process in the pretreatment of the mother liquor of gas field wastewater (ML-GFW), obtained from the multi-effect distillation treatment of the gas field wastewater. The range of optimal operation conditions was obtained by single-factor experiments. Response surface methodology (RSM) based on the central composite design (CCD) was used for the optimization procedure. A regression model with Total organic carbon (TOC) removal efficiency as the response value was established (R² = 0.9865). The three key factors were arranged according to their significance as: pH>H₂O₂ dosage>ozone flow rate. The model predicted that the best operation conditions could be obtained at a pH of 10.9, an ozone flow rate of 0.8 L/min, and H₂O₂ dosage of 6.2 mL. The dosing ratio of ozone was calculated to be 9.84 mg O₃/mg TOC. The maximum removal efficiency predicted was 75.9%, while the measured value was 72.3%. The relative deviation was found to be in an acceptable range. The ozone utilization and free radical quenching experiments showed that the addition of H₂O₂ promoted the decomposition of ozone to produce hydroxyl radicals (·OH). This also improved the ozone utilization efficiency. Gas chromatography-mass spectrometry (GC-MS) analysis showed that most of the organic matters in ML-GFW were degraded, while some residuals needed further treatment. This study provided the data and the necessary technical supports for further research on the treatment of ML-GFW.     

羟基自由基和水合电子降解对叔丁基酚的研究

采用电子束辐照水溶液的方法产生水合电子（e_aq^-）,研究了e_aq^-与对叔丁基酚（4-t-BP）的反应,结果表明还原性的e_aq^-不能降解4-t-BP.同时,采用254nm紫外光辐照H₂O₂来产生羟基自由基（·OH）,研究了UV//H₂O₂体系对4-t-BP的降解效果,考察了4-t-BP初始浓度,H₂O₂的添加浓度,溶液初始pH值等因素对反应的影响,结果表明4-t-BP初始浓度越低,H₂O₂的浓度越高,则越有利于反应的进行;溶液pH=6时是反应的最佳pH值.采用HPLC结合GC-MS的分析方法对反应的中间产物进行了定性分析,得出对叔丁基邻苯二酚,对叔丁基酚二聚体和对苯二酚等3种主要中间产物,归纳总结了4-t-BP与·OH的反应路径.