催化湿式氧化法预处理显影废水的研究

考察了催化湿式氧化法对医院显影废水进行预处理的可行性.紫外扫描结果表明,对甲氨基苯酚硫酸盐、对苯二酚等特征污染物被降解为小分子物质,在催化剂Ru/TiO2存在下,催化湿式氧化法与湿式氧化相比,有机物的降解更加彻底.通过考察催化剂用量、温度、压力及pH值等条件对CODCr去除率的影响,确定适宜的反应条件为:催化剂用量为2g·l-1,温度为220℃,压力为1.5MPa,pH为8.9.在上述反应条件下,CODCr去除率达62.5%,色度去除率达98%,BOD5/CODCr值由原来的0.07提高到0.45.     

超滤处理洗涤污水循环利用的中试研究

采用不同材质国产超滤膜聚丙烯（PP）、聚丙烯腈（PAN）和聚砜（PS）,进行了洗涤污水处理循环利用的现场中试研究.结合超滤工艺出水水质和膜污染分析,3种膜材质中PAN膜较优,有效去除了水中浊度、悬浮物、油脂等污染物,一定程度保留了游离阴离子表面活性剂（LAS）,长期循环洗涤对衣物的白度无不良影响.根据相关性分析,超滤出水较高COD值很大程度上是由水中LAS引起的.超滤膜对细菌、大肠菌群的去除率较低,出水通过紫外消毒,当紫外线密度≥3?750 J/m²时,微生物水平能够达到国家饮用水水质标准.根据不同水力反冲洗条件下膜渗透通量和净产水量比较,PAN膜最佳水力反冲洗条件为0.5 h反冲洗2 min.长期运行时超滤膜化学清洗方法采用碱洗法方便有效.     

HPLC-三重四级杆质谱法测定医疗废水中抗生素残留

采用固相萃取/高效液相色谱-三重四级杆质谱法同时测定医疗废水中的20种超痕量抗生素残留,通过优化试验条件,使方法在100μg/L～100μg/L范围内线性良好,方法检出限为024ng/L～122ng/L。空白水样和实际水样3个质量浓度水平的加标回收率分别为80.2%～108%和75.8%～114%,6次测定结果的RSD分别为2.4%～8.4%和1.7%～8.1%。将该方法用于测定重庆市2家三甲医院医疗废水中的超痕量抗生素残留,结果有11种抗生素检出,其余均为未检出。     

复合材料静态处理煤矿高浓度含锰废水的研究

针对目前云南省某煤矿排放废水中Mn~(2+)超标的问题,利用一种新型复合材料进行除锰试验.该复合材料是纳米分子筛与硅藻土经合理复配后,掺入复配絮凝荆形成的.试验中优化了不同材料的复合方式、絮凝剂的复配比例与用量.利用复配的多孔材料,对云南某煤矿含有大量悬浮物、Mn~(2+)质量浓度为5.32 mg/L的黑色废水及Mn~(2+)质量浓度为42.mg/L的红褐色废水进行了Mn~(2+)去除效果研究.结果表明,黑色废水中Mn~(2+)去除率达到70%,出水pH值为7.9;红褐色废水中Mn~(2+)去除率达到91.0%,出水pH值为7.1.与此同时,还研究了废水中Fe~(3+)、固体悬浮物(SS)对Mn~(2+)去除效果的影响,废水中Fe~(3+)的存在使pH降低,并与Mn~(2+)产生竞争吸附,对复合材料除锰有不利影响,而SS的存在对Mn~(2+)的去除效果没有显著的影响.     

固定化生物活性炭纤维处理洗浴废水的研究

采用混凝-砂滤-固定化生物活性炭纤维的组合处理工艺来处理洗浴废水.利用聚合氯化铝和聚丙烯酰胺为混凝剂对废水进行混凝处理,之后将废水通入砂滤柱,废水在曝气池进行曝气后进入固定化生物活性炭纤维(IBACF)单元.IBACF固定化完成后,连续运行30 d,去除率稳定之后,处理后的浊度、LAS、S0D_(Mn)平均值分别为2.2NTU、0.12 mg·L~(-1)、2.33 mg·L~(-1),平均去除率分别为95.2%、94.7%、84.8%.经处理后的洗浴废水各项指标均可以达到生活饮用水卫生标准或城市供水水质标准,可以直接回用于洗浴用水和其他生活杂用水.     

Effect of sulfate on the methanogenic activity of a bacterial culture from a brewery wastewater during glucose degradation

The maximum specific methanogenic activity （SMA） of a sludge originating from a brewery wastewater treatment plant on the degradation of glucose was investigated at various levels of sulfate on a specific loading basis. Batch experiments were conducted in serum bottles at pH 7 and 35℃. A comparison of the values indicates that the SMA of this mixed culture was increased and reached its highest level of 0.128 g CH4 gas COD/（g VSS.d） when biomass was in contact with sulfate at a ratio of 1：0.114 by weight.     

Treated wastewater irrigation effect on soil, crop and environment： Wastewater recycling in the loess area of China

A study was carried out at the Loess Plateau in Dongzhi,China,to test the feasibility of using secondary treatment sewage effluent and to determine whether the water quality would then meet the recommended irrigation norm.Seven crops,including celery,wheat, maize,millet,apples,rapeseed and yellow beans,were tested in the study.Physical and chemical properties of the soil,crop yield and quality and leachate at different soil depths were measured.In most cases,the quality of the crops that made use of treated sewage was not distinctively different from those that did not use treated sewage.However,yields for the former were much higher than they were for the latter.Leachates at different soil depths were analyzed and the results did not show alarming levels of constituents.For a period of approximately 14 months,the treated sewage irrigation had no significant effect on the loess soil and no cases of illness resulting from contact with the treated sewage were reported.With treated sewage irrigation,a slight increase in the organic content of the soil was observed.     

Anaerobic tapered fluidized bed reactor for starch wastewater treatment and modeling using multilayer perceptron neural network

Anaerobic treatability of synthetic sago wastewater was investigated in a laboratory anaerobic tapered fluidized bed reactor(ATFBR) with a mesoporous granular activated carbon(GAC)as a support material.The experimental protocol was defined to examine the effect of the maximum organic loading rate(OLR),hydraulic retention time(HRT),the efficiency of the reactor and to report on its steady- state performance.The reactor was subjected to a steady-state operation over a range of OLR up to 85.44 kg COD/(m~3.d).The COD removal efficiency was found to be 92% in the reactor while the biogas produced in the digester reached 25.38 m~3/(m~3·d) of the reactor. With the increase of OLR from 83.7 kg COD/(m~3.d),the COD removal efficiency decreased.Also an artificial neural network(ANN) model using multilayer perceptron(MLP)has been developed for a system of two input variable and five output dependent variables. For the training of the input-output data,the experimental values obtained have been used.The output parameters predicted have been found to be much closer to the corresponding experimental ones and the model was validated for 30% of the untrained data.The mean square error(MSE)was found to be only 0.0146.     

Improvement of the antifouling characteristics in a bioreactor of polypropylene microporous membrane by the adsorption of Tween 20

Surface modification by physical adsorption of Tween 20 was accomplished on polypropylene microporous membranes (PPMMs). Attenuated total reflection-Fourier transform infrared spectroscopy (ATR/FT-IR) and scanning electron microscope (SEM) were used to characterize the chemical and morphological changes on the membrane surfaces. Water contact angles and relative pure water fluxes were measured. The data showed that the hydrophilic performance for the modified membranes increased with the increase in the adsorption amount of Tween 20 onto the surface or into the pores of polypropylene microporous membranes. To test the antifouling property of the membranes by the adsorption of Tween 20 in a membrane bioreactor (MBR), filtration for active sludge was performed using synthetic wastewater. With the help of the data of water fluxes and the FE-SEM photos of the modified PPMMs before or after operating in a MBR for about 12 d, the PPMMs with monolayer adsorption of Tween 20 showed higher remained flux and stronger antifouling ability than unmodified membrane and other modification membranes studied.     

A study on oxidative degradation of polyacrylamide in wastewater with UV/FENTON/C4H4O62−

The degradation of polyacrylamide (PAM) in simulate wastewater was studied in UV/Fenton/C₄H₄O₆^2? system. The factors such as molecular ratio of H₂O₂/Fe²⁺/C₄H₄O₆^2?, pH, and the dosage of Fenton reagent that could affect the PAM degradation in the UV/Fenton/C₄H₄O₆^2? system were investigated. The experimental results showed that adding C₄H₄O₆^2? to UV/Fenton system could form photosensitive ferrous complexes, which led to higher degradation efficiency of PAM. The degradation rate of PAM could be up to 95.2% under the following conditions: the concentration of H₂O₂, Fe²⁺, and C₄H₄O₆^2? were 22.5, 2.25, and 2.25 mmol/L, respectively (i.e., molecular ratio of H₂O₂/Fe²⁺/C₄H₄O₆^2? was 10:1:1), the pH value was 3.0.