日光/H2O2/草酸铁络合物光解水溶液中的直接耐酸大红

以H2O2/草酸铁络合物作光氧化剂,利用太阳光对水溶液中的直接耐酸大红进行了光氧化降解试验研究。结果表明,在日光照射下,H2O2/草酸铁络合物能使溶液中直接耐酸大红迅速光解,晴天光照15min或阴天光照30-40min,溶液（直接耐酸大红的质量浓度为50mg/L）可褪至无色;溶液的初始pH对染料光解有显著影响;pH为2-4时光解效果最佳;提高H2O2浓度可以提高光解速率,但H2O2的利用率会降低。     

氧和氮等离子体改性细旦涤纶的清洁工艺比较

该文对氧、氮低温等离子体改性细旦涤纶进行了研究,分别探讨了氧、氮等离子体放电参数对提高细旦涤纶上染率的影响,得出了2种工艺的最佳放电参数。实验结果表明:经氧、氮等离子体改性后,细旦涤纶的上染率分别提高了17%和5%,说明氧等离子体改性可显著减少印染废水中的污染物排放量,有利于环境治理,氮等离子体改性效果次之。      

不同环境条件下偶氮染料酸性大红GR的生物降解性能

为了考察不同环境条件下偶氮染料酸性大红GR生物降解性能,采用已驯化的混合菌群作为接种液进行偶氮染料酸性大红GR脱色试验。结果表明,微氧条件下(静置敞口培养),偶氮染料酸性大红GR脱色效果最佳,染料脱色主要发生在菌体的对数生长期。混合菌群对pH、温度适应范围较广,pH为3.32~9.18,温度在20℃~37℃范围内均可以获得较好脱色效果,脱色率均在80%以上。微氧条件下酸性大红GR降解历程表明,偶氮基整个共轭系统被破坏,生成了一种新的结构,使原有的某些精细结构在二阶导数光谱中得以表现,由此探讨其生物降解机理。     

不同染料化合物在颗粒活性炭上的分形吸附规律

研究了颗粒活性炭对6种染料的吸附特征,结果表明,它们的吸附等温线均符合Ffendlich方程;由此计算出颗粒活性炭的表面分形维数均处于2到3之间．不同染料吸附时计算出的分形维数不同,吸附染料过程是在分形表面上发生的反应．吸附动力学过程分为快速吸附和慢吸附两个阶段,而且溶液中剩余染料的浓度变化动力学符合方程：Cout∝t^-α,表明该过程具有类分形动力学特征;并由指数α计算上述动力学反应的分形维数D．在实验的温度范围内,6种染料的吸附量和速度均随着温度的升高而增加;绿色染料吸附时的类分形动力学参数指数α和分形维数D也随之升高,而其它染料不呈现类似的规律．     

颗粒活性炭吸附染料的类分形动力学特征的研究

建立了复杂分子吸附反应时指数h与分形子谱维数ds、分形介质的表面分形维数Ds 的关系式.对吸附动力学数据的模拟表明,不同温度下6种染料在颗粒活性炭表面的吸附过程符合非线性动力学.吸附速率一般随着温度的升高而增加,反应活化能在0 2 0～1 75kJ·mol- 1 之间.上述反应为快速反应.进一步分析表明,该吸附过程具有类分形动力学特征,吸附反应的逐时速率系数k与反应时间t呈指数关系;相应的分形子谱维数ds<2 .随着染料的初始浓度的增加,ds 也随之增加,而h和k0 值通常会随之降低.吸附3种酸性染料时,h和k0 值在本实验的温度范围内均随着温度的升高而增加;其它3种直接性染料也大都呈现h随着温度的升高而增加的趋势.上述吸附反应中有效反应级数x也与ds、Ds 有关,呈现分数反应级数     

用聚(丙烯酸/丙烯酰胺)水凝胶吸附单价阳离子染料的研究

研究了用聚 (丙烯酸 丙烯酰胺 ) [P(AAc AAm) ]水凝胶对较高较大浓度范围 (10 -6— 10 -2 mol L)的阳离子染料碱性藏花红 (SafranineT)溶液的吸附过程和水凝胶经解吸后的再吸附性质 .实验结果表明 :增大P(AAc AAm)水凝胶的交联度和电荷比值有利于吸附过程的进行 ,并强化了引发过程 (initiationprocess)而抑制了协同过程 (cooperativeprocess) .水凝胶经解吸后 ,其吸附能力大大地增强 ,复合度 (β)超过 1,约为 1 5 ,此时 ,协同性和染料分子间的疏水相互作用起了主要作用     

累托石对水中染料碱性桃红的吸附

采用累托石作为水中碱性桃红的吸附剂.考察了振荡时间、pH值、累托石用量、碱性桃红初始浓度等因素对吸附效果的影响.测定了吸附等温线,对吸附动力学规律进行了数学模拟.结果表明,振荡时间、累托石用量、碱性桃红初始浓度等因素对吸附效果有重要影响.对于初始质量浓度为50 mg/L的碱性桃红水溶液,最适宜吸附条件为:振荡时间30 min,累托石用量200 mg/100 mL,pH值为6.累托石对水中碱性桃红的吸附等温线呈"S"型,等温吸附规律可用Freundlich模式较好地描述,吸附动力学规律可用Bangham公式模拟.     

Effect of substituents in hydroxyl radical-mediated degradation of azo pyridone dyes: Theoretical approaches on the reaction mechanism

Understanding the degradation behavior of azo dyes in photocatalytic wastewater treatment is of fundamental and practical importance for their application in textile-processing and other coloration industries. In this study, quantum chemistry, as density functional theory, was used to elucidate different degradation pathways of azo pyridone dyes in a hydroxyl radical (HO^?)-initiated photocatalytic system. A series of substituted azo pyridone dyes were synthesized by changing the substituent group in the para position of the benzene moiety, ranging from strong electron-donating to strong electron-withdrawing groups. The effect of dye molecular structure on the photocatalytic degradation reaction mechanism was analyzed and quantification of substituent effects on the thermodynamic and kinetics parameters was performed. Potential energy surface analysis revealed the most susceptible reaction site for the HO^? attack. The calculated reaction barriers are found to be strongly affected by the nature of substituent group with a good correlation using Hammett σ_p constants and experimentally determined reaction rates. The stability of pre-reaction complexes and transition state complexes were analyzed applying the distortion-interaction model. The increased stability of the transition state complexes with the distancing from the substituent group has been established.     

红芝所产漆酶对蒽醌染料的脱色研究

以红芝Ganoderma lucidum发酵所得漆酶粗酶液对蒽醌染料进行脱色实验,分别考察了反应时间、染料浓度、温度、pH、转速等条件对蒽醌染料脱色的影响。结果表明,红芝漆酶粗酶液对蒽醌染料具有很好的脱色效果,脱色的适宜条件为:染料浓度150mg/L、反应温度40℃、pH值3.5。在上述条件下反应8h,蒽醌染料脱色率可达90%左右,摇床转速对染料脱色影响不大。     

Preparation and characterization of Fe2O3-CeO2-TiO2/γ-Al2O3 catalyst for degradation dye wastewater

In order to develop a catalyst with high activity for catalytic wet oxidation (CWO) process at room temperature and atmospheric pressure, Fe2O3-CeO2-TiO2/γ-Al2O3 catalyst was prepared by consecutive impregnation method and the prepared parameters were optimized. The structure of the catalyst was characterized by BET, XRF, SEM and XPS technologies, and the actual wastewater was used to investigate the catalytic activity of Fe2O3-CeO2-TiO2/γ-Al2O3 in CWO process. The experimental results showed that the prepared catalyst exhibited good catalytic activity when the doping amount of Ti was 1.0 wt% (the weight ratio of Ti to carriers), and the middle product, CeO2-TiO2/γ-Al2O3, was calcined in 450℃ for 2 h. The CWO experiment for treating actual dye wastewater indicated that the COD, color and TOC of actual wastewater were decreased by 62.23%, 50.12% and 41.26% in 3 h,respectively, and the ratio of BOD5/COD was increased from 0.19 to 0.30.