瑞平塘河氟化物污染状况调查及溯源研究

以2016—2020年地表水常规监测结果为依据,发现瑞平塘河自2017年起出现氟化物质量浓度升高现象,2020年其中1个断面氟化物质量浓度平均值达到1.25 mg/L,比2016年高出145%。为此于2021年3—6月,对瑞平塘河流域的氟化物污染状况进行实地调查并开展溯源研究。研究结果显示,2021年氟化物质量浓度超过1.0 mg/L的点位占59.34%,其中超过1.5 mg/L的点位占42.86%,表明大部分河道氟化物质量浓度已经超过水体功能区要求,对生态环境安全构成较大潜在风险。溯源调查结果表明,排除了农业源及矿山源污染的可能,乳胶制品企业排放的废水为瑞平塘河氟化物的污染来源。针对目前该行业的排放标准和环境影响评价均未提及氟化物污染,企业废水处理设施也无除氟工艺单元,缺乏有效的污染防治措施与监管要求等问题。提出,应及时组织开展该区域乳胶制品行业整治提升,增加氟化物处理工艺单元,提升出水水质,确定氟化物排放浓度限值,并对该行业排放标准做进一步研究和完善等建议。     

隧道竖井外流场模拟及风塔外型结构优化研究

为提高长大隧道施工及运营通风过程中竖井通风效率,实现隧道节能通风。依托实际隧道工程,基于Fluent软件,选用RNG k-ε湍流模型,对无竖井风塔、圆柱风塔、矩形风塔和凸台状风塔4种结构、不同环境风速工况下的流场进行数值模拟,并对模拟结果进行交叉比对分析,提出最优化的竖井风塔结构形式。研究结果表明:采用风塔结构竖井出流量要远大于无风塔结构竖井出流量;对于不同竖井风塔外型结构,竖井出流量与环境风速关系呈多项式函数;当倾斜角为45°、圆心角为90°时,凸台结构对应竖井出流量最大,且受环境风影响波动较小,通风稳定性较好。建议竖井出口结构选用矩形或凸台状,实现对环境风的高效利用,提高竖井通风效率。     

Effect of pipes in heat pump system on electric vehicle energy saving

ABSTRACT

Refrigerant pressure drop and temperature change in pipes are normally ignored in the thermodynamic analysis of traditional vehicle air conditioning system, this will result in serious errors. In this Paper, pressure drop and temperature difference are simulated in different pipes of electric vehicle (EV) heat pump system to analysis the effects of pipes in the actual EV heat pump system. The results indicate that the greater the mass flow, the faster pressure drop increases, the temperature difference decreases. Pressure drop of saturated liquid refrigerant is smaller than that of saturated gas refrigerant at the same saturation pressure and mass flow rate. The higher the refrigerant pressure (no phase change), the slower pressure drop decreases, the faster the temperature difference decreases. Pressure drop decreases with the increment of bending angle of the pipe. For EV heat pump system, suitable valves and less branches are helpful for energy saving of the system. Shortening the pipe between compressor and condenser can reduce temperature change obviously. Pressure drop per unit length in the pipe between evaporator and compressor is large especially in heating mode because of lower refrigerant density. It even reaches to over 100 times of that in the pipe between condenser and throttle valve in heating mode and has negative effects on the performance of the system. If the evaporator is closer to the compressor and the number of branches is less, then pressure drop will decrease a lot, which will be advantageous for energy saving of the heat pump system.     

探究城市污水处理项目的环境影响评价

水作为人类赖以生存的主要能源物质,随着社会综合水平的提高,各行业对水资源的需求越是急切。而现阶段城市中大量污水给环境带来很多不利影响,环保公司针对城市污水处理不断在技术上进行突破、完善,将智能化节能技术运用到城市污水处理中,使设备、资源得到充分利用,为人们用水条件带来更加充沛、丰富的保障与支持。为有效处理城市污水,争取在城市污水处理发挥更大作用,带动城市环境可持续发展。     

不同给水管材对管壁附着生物膜铅、镉的解吸动力学研究

给水管壁生物膜会吸附水中的重金属元素积累在管壁生物膜中,在受到扰动时释放回到水体,危害饮用水水质安全。试验以上海管网末梢水为实验对象,研究了PVC、铸铁和紫铜等三种管材上生物膜对铅、镉的解吸特性。结果表明,PVC、铸铁和紫铜附着生物膜对铅的解吸容量qe分别为:5.92211μmol·m^-2、128.3051μmol·m^-2和21.1808,解吸速率常数k分别为:0.001060 m^2·μmol^-1·min^-1、0.000041 m^2·μmol^-1·min^-1和0.000503 m^2·μmol^-1·min^-1,对于镉元素三种材质的解吸容量qe分别为:14.71519μmol·m^-2、18.50481μmol·m^-2和2.25225μmol·m^-2;解吸速率常数k分别为:0.000102 m^2·μmol^-1·min^-1、0.001070 m^2·μmol^-1·min^-1和0.000103 m^2·μmol^-1·min^-1。     

工业水处理中节能优化控制的研究

工业水的处理一直以来都是环境工程当中十分重要的一个环节,而要做好这一环节就需要针对其中存在的问题进行科学合理的优化控制过程,本文从这一点出发,提出工业水处理过程中相关的工作内容。     

关于城市河流水污染防治技术应用和研究

随着我国经济的不断发展,各种工厂也大量的成立,而这也使得很多废弃物及废水被过度排放到湖泊与河流之中,进而导致其出现了严重的污染问题。污染不仅对人们的生活质量产生了影响,同时也对生态的平衡发展产生了很大的阻碍,业已经成为社会各界高度关注和重视的问题。基于此,本文围绕城市河流水污染的现状进行了分析,对于污染产生的原因也进行了阐述,针对城市河流水污染防治技术的应用也进行了探讨和研究,以期可以有效解决我国出现的河流水污染问题,进而为人们及社会营造一个全新、绿色的河流环境。     

水环境监测信息化新技术的应用分析

随着国民经济的快速发展,我国人民的生活水平和质量也随之而提高,对于生态环境以及居住环境的要求也相应提升。水是万物之源,是保障人们生产生活的基本要素之一,为了有效提升水环境质量,先进的水环境监测技术必不可少。随着科学技术的飞速发展,水环境监测技术也在不断调整和优化,逐渐向信息化方向发展,在生态环境保护工作中发挥着不可替代的作用。本文将详细阐述现阶段我国在水环境监测工作中实施的信息化新技术,希望能为相关研究人员提供参考和借鉴。     

Locally enhanced electric field treatment (LEEFT) for water disinfection

• Nanowire-assisted LEEFT is applied for water disinfection with low voltages. • LEEFT inactivates bacteria by disrupting cell membrane through electroporation. • Multiple electrodes and device configurations have been developed for LEEFT. • The LEEFT is low-cost, highly efficient, and produces no DBPs. • The LEEFT can potentially be applicable for water disinfection at all scales. Water disinfection is a critical step in water and wastewater treatment. The most widely used chlorination suffers from the formation of carcinogenic disinfection by-products (DBPs) while alternative methods (e.g., UV, O₃, and membrane filtration) are limited by microbial regrowth, no residual disinfectant, and high operation cost. Here, a nanowire-enabled disinfection method, locally enhanced electric field treatment (LEEFT), is introduced with advantages of no chemical addition, no DBP formation, low energy consumption, and efficient microbial inactivation. Attributed to the lightning rod effect, the electric field near the tip area of the nanowires on the electrode is significantly enhanced to inactivate microbes, even though a small external voltage (usually<5 V) is applied. In this review, after emphasizing the significance of water disinfection, the theory of the LEEFT is explained. Subsequently, the recent development of the LEEFT technology on electrode materials and device configurations are summarized. The disinfection performance is analyzed, with respect to the operating parameters, universality against different microorganisms, electrode durability, and energy consumption. The studies on the inactivation mechanisms during the LEEFT are also reviewed. Lastly, the challenges and future research of LEEFT disinfection are discussed.     

硫酸雾测试方法若干问题思考

简述了我国硫酸雾测试方法的发展历史,分析和总结了《固定污染源废气硫酸雾的测定离子色谱法》(HJ 544—2016)存在的一些争议和问题,包括硫酸雾的定义、测试方法的干扰控制等。分析认为,相比《硫酸工业污染物排放标准》(GB 26132—2010),HJ 544—2016对硫酸雾的定义更加合理。实验结果表明:硫酸盐是测试方法条件下的目标物,滤筒可以显著地捕捉硫酸盐。9组样品滤筒中,被测目标物所占比例为7.9%~69.1%;滤筒和前吸收液中,被测目标物所占比例为93.7%~97.8%。HJ 544—2016新增加的两级串联碱液吸收瓶可以较完全地捕集穿透滤筒后的硫酸雾,同时也会捕集SO2。SO2会对硫酸雾测试产生正干扰,约42.9%的SO2在被吸收后转化为硫酸雾。