浅议“环境试验设备技术条件”新标准

2006年至2008年,89版“环境试验设备技术条件”相继修订发布。本文着重阐述了“环境试验设备技术条件”新旧标准的变化及其与GB／T5170的关系。     

静电激发型袋除尘器的机理及应用前景

静电激发型袋除尘器有别于常规的电袋结合除尘器,其是将电除尘器的预荷电原理作用于烟气后,利用袋除尘器的滤袋做收尘极板来收集粉尘。本文通过分析Max-9^TMESFF的结构介绍了其除尘机理,并分析了它的应用前景。     

垃圾焚烧飞灰处理处置研究进展

针对作为危险废物的垃圾焚烧飞灰,介绍了近年来国内外对其进行处理处置的研究情况.飞灰的固化/稳定化处理主要从水泥(沥青)固化、熔融固化及化学药剂固化几方面进行论述,飞灰中重金属的提取主要从酸碱浸提、生物浸提、螯合剂浸提及电渗析法提取几方面进行论述.     

固相萃取- GC/MS法测定水中邻苯二甲酸酯类

采用固相萃取-GC／MS法测定水中6种邻苯二甲酸酯类有机污染物,比较了不同固相萃取柱对萃取效果的影响,优化了水样pH值、水样流量、穿透体积、洗脱溶剂、洗脱剂体积、洗脱流量等萃取条件。方法在0．050μg/L-800μg/L范围内线性良好,检出限为0．008μg/L～0．03μg／L,标准溶液测定的RSD≤10．5％,实际水样加标回收率为80．0％-100％。     

固相微萃取-气相色谱/质谱联用法测定饮用水中苯类化合物

用固相微苹取(ＳＰＭＥ)－气相色谱/质谱联用法测定饮用水中苯类化合物,以１００μｍ ＰＤＭＳ(聚二甲基硅氧烷)萃取针提取、浓缩、分离与测定九种目标化合物．萃取时间经优化选定为８ｍｉｎ,而热解析时间设定为２ｍｉｎ． 本方法的相对标准偏差小于５%,线性范围宽(２０ｎｇ·ｍｌ－１－１００００ｎｇ·ｍｌ－１),多数化合物的检测限低于５μｇ·ｌ－１．饮用水样品检测显示,样品加标回收率范围在８４%至１１０%内．     

低温浓缩-气相色谱/质谱法分析固定污染源废气中的丙烯腈

建立了固定污染源废气中丙烯腈的气袋采样-低温浓缩-气相色谱/质谱分析方法。结果表明,该法在丙烯腈质量浓度16.1~4 050μg/m~3范围内具有良好的线性,相关系数R~20.999,检出限为9.54μg/m~3,回收率、日内与日间精密度均符合质控要求,能够满足废气中丙烯腈分析的要求。     

Producing biodiesel from waste animal oil by modified ZnO

Biodiesel produced by transesterification of waste animal oil is a promising green fuel in the future. ZnO-Al₂O₃ and ZnO/Zn₂Al composition oxides were prepared by co-precipitation method and impregnation method, respectively. The above catalysts were characterized by X-ray diffraction (XRD), Brunauer--Emmett--Teller (BET) and CO₂ adsorption and temperature-programmed desorption (CO₂-TPD) and show that the high activity for the catalyst is attributed to its high alkalinity. The reaction parameters were optimized and the results show that the transesterification ratio of waste animal oil can reach 98.7% with 10% ZnO/Zn₂Al catalyst after 2 h. Moreover, 10%ZnO/Zn₂Al compound oxides can be active for the successive cycles. The glycerol as a predominant by-product after transesterification is of high purity with high use value.     

Investigation of titanium liquid/gas diffusion layers in proton exchange membrane electrolyzer cells

In a proton exchange membrane electrolyzer cell (PEMEC), liquid/gas diffusion layer (LGDL) is expected to transport electrons, heat, and reactants/products to and from the catalyst layer with minimum voltage, current, thermal, interfacial, and fluidic losses. In addition, carbon materials, which are typically used in PEM fuel cells (PEMFCs), are unsuitable in PEMECs due to the high ohmic potential and highly oxidative environment of the oxygen electrode. In this study, a set of titanium gas diffusion layers with different thicknesses and porosities are designed and examined coupled with the development of a robust titanium bipolar plate. It has been found that the performance of electrolyzer improves along with a decrease in thickness or porosity of the anode LGDL of titanium woven meshes. The ohmic resistance of anode LGDL and contact resistance between anode LGDL and the anode catalyst play dominant roles in electrolyzer performance, and better performance can be obtained by reducing ohmic resistance. Thin titanium LGDLs with straight-through pores and optimal pore morphologies are recommended for the future developments of low-cost LGDLs with minimum ohmic/transport losses.     

5种植物材料的水解释碳性能及反硝化效率

碳源在硝酸盐去除过程中起电子供体的作用,是生物反硝化反应的关键物质之一。为解决污水处理脱氮时碳源不足抑制反硝化反应造成脱氮效率低的问题,本研究选取风车草、甘蔗渣、芦竹、美人蕉和稻草秆5种植物材料作为反硝化碳源,探讨不同植物材料的水解释碳能力和释放规律;并进一步以其水解液作为外加碳源,探讨其对反硝化脱氮效率的影响。研究结果表明,植物材料水解释碳过程符合二级动力学反应规律,不同植物材料的释碳能力具有显著性差异,以甘蔗渣在固液比1∶80时COD释放当量最大,为45.45 mg/L;添加植物水解液可显著提高反硝化脱氮效率,以芦竹水解液脱氮效果最好,达到71.9%。此外,碳氮比是影响脱氮效率的重要因素之一,以碳氮比为9时反硝化脱氮效果最佳。