郑州大气PM10的形貌特征及生物活性研究

采集郑州市区和郊区秋季大气PM₁₀样品,利用场发射扫描电镜（FESEM）和图像分析技术对PM₁₀颗粒进行形貌特征和粒度分布进行分析,同时应用质粒DNA评价法研究了市区和郊区PM₁₀样品的生物活性.结果显示,在市区采集的样品中燃煤飞灰占有相当大的数量,而在郊区采集的样品中矿物质占有较大的数量,粒径分析表明,市区PM₁₀的数量-等效球直径分布较为集中,主要分布在0.1～0.4 μm范围内,郊区则相对比较分散;PM₁₀的体积-等效球直径主要分布在>1 μm范围内.结果表明,在郑州市秋季大气PM₁₀中,数量上细粒子占优势, 而在体积上(质量上)较粗颗粒占优势.质粒DNA评价结果表明,郑州市区和郊区PM₁₀颗粒对DNA的损伤程度不同,市区样品的生物活性大于郊区样品.     

元宵节期间北京PM_(2.5)单颗粒的物理化学特征

采集2014年元宵节期间北京PM2.5样品,使用场发射扫锚电镜-能谱仪观察北京PM2.5单颗粒的显微形貌和元素组成,并利用图像分析系统对PM2.5的粒径进行分析.结果表明:PM2.5的单颗粒类型以烟尘集合体、矿物颗粒和飞灰为主;烟花爆竹燃放产生的PM2.5是造成元宵节期间北京PM2.5浓度升高的主要原因;PM2.5中总颗粒物个数呈现先升高后降低的趋势;元宵节期间北京PM2.5中大部分颗粒物的粒径小于0.7μm;然而,重污染天气PM2.5中粒径大于0.7μm颗粒物的数量明显高于轻污染天气.     

混凝土核心筒的有限元模拟及若干参数的影响分析

运用ABAQUS分析软件,建立水平荷载作用下的钢筋混凝土核心筒有限元模型,进行非线性分析,并将分析结果与大比例试件的试验结果对比,对所采用的有限元模型加以验证。在此基础上,进行改变钢筋混凝土核心筒轴压比、高宽比和筒壁厚度的受力过程模拟分析,研究这些参数对筒体性能的影响。结果表明:随着轴压比的增大,筒体的破坏由受拉向受压破坏转变,筒体最大水平承载力经历先增加后减小的变化,延性变差;随着高宽比的增大,筒体破坏形态由剪切向弯曲破坏转变,延性增加,整体弯曲作用更加明显,最大底部剪力减小;随着壁厚的增大,试件破坏由截面压屈失稳向墙肢底部受弯破坏转变,墙肢破坏区域沿高度方向发展,耗能能力更强,承载力明显增大,变形能力显著增加。     

Comparisons of TGA and DSC approaches to evaluate nitrocellulose thermal degradation energy and stabilizer efficiencies

This study investigated the thermal degradation energy (activation energy, E_a) for nitrocellulose (NC) with low nitrogen content of 11.71 mass%, so-called NC3, by using two different kinds of thermal analysis instruments: thermogravimetric analyzer (TGA) and differential scanning calorimetry (DSC). A comparison of E_a for various nitrogen content NC samples at two scanning rates (5 and 10 °C min^?1) tested by TGA and DSC is also discussed in this paper. Meanwhile, our aim was to analyze the anti-degradation of E_a for NC with high nitrogen content, as so-called NC1. Thermal stability for NC1 with diphenylamine (DPA) was tested via DSC with 10 DPA concentrations in weights of 0, 0.25, 0.50, 0.75, 1.0, 1.25, 1.50, 1.75, 2.0, and 3.0 mass%. Experimental results indicated that E_a of NC3s was 319.91 kJ mol^?1. Moreover, that while dosing DPA into NC1 the best recipe could be employed to avoid any violent NC1 runaway and also can be used to distinguish the differences of thermal decomposition E_a between NC with different nitrogen contents. This study established a fast and efficient procedure for thermal decomposition properties of NC, and could be applied as an intrinsically safer design during relevant operations.     

ISO 26000框架下的煤矿安全管理

随着国际标准化组织制定的社会责任指南(ISO26000)颁布日期的临近,企业社会责任再次被提上日程,企业的各项管理工作也需要在履行社会责任的前提下开展。本文针对煤炭企业安全事故频发的现状,将煤矿安全置于社会责任框架下进行研究。论文在对ISO26000进行概述的基础上,讨论煤炭企业履行社会责任对煤矿安全的影响,提出社会责任框架下,煤矿安全管理的建议。     

铬渣中六价铬水浸动力学研究

采用连续反应器,考察了铬渣水浸工艺参数,研究了铬渣中Cr(VI)的水浸动力学。结果表明,铬渣水浸过程速率为通过固膜的扩散所控制,通过对整个过程分阶段分别进行拟合,建立了Cr(VI)水浸过程的动力学模型,后阶段反应模型在α=0.05上显著,两个反应阶段表观活化能分别为18 kJ/mol和10.25 kJ/mol。     

Proposed Conservation Landscape for Giant Pandas in the Minshan Mountains,China

Abstract: The giant panda (Ailuropoda melanoleuca), is one of the world's most endangered species. Habitat loss and fragmentation have reduced its numbers, shrunk its distribution, and separated the population into isolated subpopulations. Such isolated, small populations are in danger of extinction due to random demographic factors and inbreeding. We used least‐cost modeling as a systematic approach to incorporate satellite imagery and data on ecological and behavioral parameters of the giant panda collected during more than 10 years of field research to design a conservation landscape for giant pandas in the Minshan Mountains. We identified 8 core habitats and 4 potential linkages that would link core habitats CH3, CH4, and CH5 with core habitats CH6, CH7, and CH8. Establishing and integrating the identified habitats with existing reserves would create an efficient reserve network for giant panda conservation. The core habitats had an average density of 4.9 pandas/100 km² and contained approximately 76.6% of the giant panda population. About 45% of the core habitat (3245.4 km²) existed outside the current nature reserves network. Total estimated core habitat decreased between 30.4 and 44.5% with the addition of residential areas and road networks factored into the model. A conservation area for giant panda in the Minshan Mountains should aim to ensure habitat retention and connectivity, improve dispersal potential of corridors, and maintain the evolutionary potential of giant pandas in the face of future environmental changes.     

ESEM–EDX characterisation of airborne particles from an industrialised area of northern Greece

The aim of this study was to characterise individual airborne particles collected from the Ptolemais-Kozani region (Western Macedonia), northern Greece. Throughout a 1-year period (March 2003 to February 2004), we collected several filters that captured airborne particles at seven sampling sites distributed throughout the area. The airborne particles captured on the filters were then characterised by environmental scanning electron microscopy (ESEM) coupled with energy-dispersive X-ray analysis (EDX). The particles were categorised as geogenic, biogenic and anthropogenic. The main anthropogenic airborne particles were fly ash (released from lignite-fired power plants) and carbonaceous (soot and char) and metalliferous (mainly iron- and copper-enriched) particulates. We present here characteristic ESEM and EDX spectra for the airborne particles and underline the presence of characteristic primary and secondary sulphates.     

土壤腐殖酸慢热解表征实验影响因素研究

以土壤提取的腐殖酸为研究对象,进行了差式量热扫描(DSC)和热重分析(TGA)的可重复性实验、样品质量对比实验和预处理对比实验。综合分析了影响慢热解特征温度参数的因素和效应,并根据作用原理将其总结为热滞后效应和反应平衡滞后效应。结果表明,高级热分析技术用于土壤慢热解表征可重复性良好,差式量热扫描与热重分析结果可比性强,然而热分析曲线和热特征参数对实验条件的响应灵敏,其中样品质量和升温速率的影响尤其显著。研究结果表明,慢热解技术用于土壤有机质分析具有良好的准确性和重现性,提出了保障土壤腐殖酸慢热解质量控制的最佳样品量[DSC为(10±0.1)mg]、最佳气体氛围(He)和最佳升温速率(10℃/min)、精确压实程度等实验条件。     

Reaction hazard and mechanism study of H2O2 oxidation of 2-butanol to methyl ethyl ketone using DSC,Phi-TEC II and GC-MS

Methyl ethyl ketone (MEK) oxidation via H₂O₂ with tungsten-based polyoxometalate catalysts has gained much attention with an ever-growing body of knowledge focusing on the development of environmentally benign processes in chemical industry. In this study, two calorimetry techniques, differential scanning calorimetry (DSC) and Phi-TEC II adiabatic calorimetry, were employed to analyze the thermal hazards associated with the 2-butanol oxidation reaction system. Hydrogen peroxide was the oxidant and a tungsten-based polyoxometalate as the catalyst. Gas chromatography-mass spectrometry was used for identification of the organic products. Important thermal kinetic data were obtained including “onset” temperature, heat of reaction, adiabatic temperature rise and self-heat rate. From DSC results, three exothermic peaks were detected with a total heat generation of approximately 1.26 kJ/g sufficiently to induce a thermal runaway. Possible reaction pathway for three stages were proposed based on both DSC and GC-MS results. One exotherm was detected by Phi-TEC II calorimeter and the pressure versus temperature profile together with the DSC and GC-MS data demonstrate the complexity of 2-butanol reaction system under both thermal screening and adiabatic conditions.