活性炭吸附法处理冶金废水的工程设计模型

以博哈特(Bohart)和亚当斯(Adams)方程为推导依据,结合连续进水活性炭模型实验,证明了活性炭吸附法处理冶金废水的可行性,且得出了活性炭吸附高度、工作周期、污染物去除率等重要设计参数之间的关系,为活性炭的工程设计提出了一套有效的参考计算方法和设计程序。     

Enhanced photocatalytic activity of quantum-dot-sensitized one-dimensionally-ordered ZnO nanorod photocatalyst

An efficient photocatalyst was fabricated by assembling quantum dots （QDs） onto one-dimensionally-ordered ZnO nanorods, and the photocatalytic properties for Methyl Orange degradation were investigated by scanning electron microscopy, transmission electron microscopy, X-ray diffraction, UV-Vis-NIR absorption spectroscopy and photoluminescence. The results indicate that the catalyst with assembled QDs is more favorable for the degradation than the pristine ZnO nanorods. The QDs with core-shell structure lower the photocatalytic ability due to the higher carder transport barrier of the ZnS shell layer. Besides its degradation efficiency, the photocatalyst has several advantages given that the one-dimensionally-ordered ZnO nanorods have been grown directly on indium tin oxide substrates. The article provides a new method to design an effective and easily recyclable photocatalyst.     

Formic acid as an alternative reducing agent for the catalytic nitrate reduction in aqueous media

Formic acid was used for the nitrate reduction as a reductant in the presence of Pd:Cu/γ-alumina catalysts. The surface characteristics of the bimetallic catalyst synthesized by wet impregnation were investigated by SEM, TEM-EDS. The metals were not distributed homogeneously on the surface of catalyst, although the total contents of both metals in particles agreed well with the theoretical values. Formic acid decomposition on the catalyst surface, its influence on solution pH and nitrate removal efficacy was investigated. The best removal of nitrate (50 ppm) was obtained under the condition of 0.75 g/L catalyst with Pd:Cu ratio (4:1) and two fold excess of formic acid. Formic acid decay patterns resembled those of nitrate removal, showing a linear relationship between kf (formic acid decay) and k (nitrate removal). Negligible amount of ammonia was detected, and no nitrite was detected, possibly due to buffering effect of bicarbonate that is in situ produced by the decomposition of formic acid, and due to the sustained release of H2 gas.     

活化温度对SCAC制备过程中副产物生成规律的影响

文章研究了污泥-玉米芯活性炭(SCAC)制备过程中,活化温度对副产物(热解气和热解油)生成规律的影响。热解气和热解油分别采用气相色谱仪和气质联用仪进行分析检测。试验结果表明,随着活化温度的升高,SCAC的产量逐渐降低,热解气与热解油的产量则随之增多。不同温度条件下,热解气的主要成分均为H2和CO2,热解气中H2所占的体积百分数随着活化温度的升高而增加,而CO2则相应降低。此外,热解气中CH4的含量也会随着活化温度的上升而略有提高,说明较高的活化温度更有利于热解气的资源利用。热解油组分较为复杂,每个温度条件下的液态产物都包括上百种化合物,可分为烷烃,烯烃,苯类,酚类,腈类,杂环化合物,多环芳烃,有机酸,酰胺,酯类,甾体,醇,酮以及其他类共14大类型,其中以有机酸、腈类和甾体类有机物含量居多。随着活化温度的升高,有机酸和多环芳烃的含量有所增加,而酚类化合物的含量则有所降低;当活化温度升高至650℃以上时,甾体类有机物含量明显降低。     

化学铁盐辅助除磷对生物除磷的影响研究

化学辅助除磷有助于污水厂实现磷达标,但其对生物系统存在潜在的影响。针对除磷药剂对生物除磷过程的影响展开研究,选用硫酸亚铁进行化学辅助除磷。药剂形成的化学污泥干扰生物除磷过程且成分复杂,故以磷酸铁、氢氧化铁模拟化学污泥,由钾离子、K/P摩尔比计算出同步除磷中的生物除磷,来探讨化学污泥对聚磷菌释磷/吸磷过程的影响。结果表明,连续投加硫酸亚铁使聚磷菌的释磷量、吸磷量降低;系统中磷酸铁含量0.075 mmol/L时聚磷菌的释磷和吸磷能力提高了约25%,磷酸铁含量0.15 mmol/L时对聚磷菌吸磷有抑制作用;氢氧化铁对聚磷菌释磷、好氧初期吸磷均有抑制作用。生物污泥与化学污泥存在交互作用。     

ABR反应器中COD/SO_4~(2-)值和硫酸盐负荷对SO_4~(2-)去除影响

利用厌氧折流板反应器,分别考察了反应器启动,及不同COD/SO42-比值和硫酸盐负荷对模拟废水中SO42-去除的影响。实验在(32±0.1)℃,pH为6.0⁶.5的条件下连续运行。结果表明:ABR经过约90 d的启动驯化阶段后,进水硫酸盐及COD浓度分别为1 500 mg/L和3 000 mg/L,水力停留时间为12 h条件下,硫酸盐去除率达到了92%。固定COD/SO42-比值为2.5时,随着进水SO42-浓度的增加(1 5006.5的条件下连续运行。结果表明:ABR经过约90 d的启动驯化阶段后,进水硫酸盐及COD浓度分别为1 500 mg/L和3 000 mg/L,水力停留时间为12 h条件下,硫酸盐去除率达到了92%。固定COD/SO42-比值为2.5时,随着进水SO42-浓度的增加(1 500³ 500 mg/L),SO42-去除率逐渐下降,最低为60%,相反SO42-去除速率随着硫酸盐浓度的增加而增加,最大为7.98 kg(/m3.d);维持恒定的硫酸盐浓度(1 500 mg/L),逐渐缩短水力停留时间以提高反应器中硫酸盐负荷,SO42-去除率呈现先上升后下降的复杂变化趋势,当水力停留时间为6 h时,SO42-去除率达到最大;随着COD/SO42-比值的提高,硫酸盐去除能力增强,且反应体系对硫酸盐负荷的耐受能力也逐渐增强。     

OMS-2负载Pt催化剂的制备及其催化氧化性能研究

采用前掺杂法、沉积-沉淀法和浸渍法制备了氧化锰八面体分子筛(OMS-2)负载Pt催化剂(Pt/OMS-2),对所制催化剂进行了结构和织构表征。并研究了不同制备方法和沉积-沉淀法中不同制备(Pt负载量和溶液的pH值)对Pt/OMS-2催化氧化CO性能的影响。结果表明,沉积-沉淀法制备的Pt/OMS-2-DP催化剂活性最好(T100=100℃)。这与Pt/OMS-2-DP催化剂中Pt颗粒大小及OMS-2载体与Pt之间存在强相互作用有关。Pt负载量明显影响Pt/OMS-2-DP催化剂的催化活性,3Pt/OMS-2-DP催化剂(Pt=3.0 wt%)催化活性最高,这是由于适当Pt负载量,Pt颗粒较小,并与载体OMS-2的相互作用较强,能较好地活化OMS-2晶格氧。pH值对Pt/OMS-2-DP催化剂催化性能影响较大,这与OMS-2的等电点和Pt在不同溶液中存在不同Pt配位体形式有关。     

2,2′-二硝基联苄生产废水的处理研究

对十六烷基三甲基溴化铵改性凹凸棒土、凹凸棒土负载TiO2采用XRD、FTIR以及TG等手段进行了分析和表征,对比了改性凹凸棒土、活性炭、大孔树脂等不同吸附剂和凹凸棒土负载TiO2对二硝基联苄生产废水的处理效果。结果表明:十六烷基三甲基溴化铵改性凹凸棒土的废水中污染物的去除率比凹凸棒土提高了2.5倍;凹凸棒土负载TiO2在波长λ=254 nm下光照0.5 h,对废水中污染物的去除率是凹凸棒土的2.0倍;投加量为3%活性炭在pH为2.0⁵.0时,对该类废水中污染物的去除率可达80%以上。     

硝酸改性活性炭特征及其催化臭氧氧化性能

采用硝酸氧化对颗粒活性炭进行改性处理,研究了硝酸改性后活性炭结构和表面化学性质,及其对酸性大红3R的吸附能力和催化臭氧氧化去除效果的影响。结果表明,硝酸改性后,活性炭比表面积减小,微孔孔容减小,中孔孔容增大。活性炭表面以羧基为主的酸性含氧官能团随着硝酸改性浓度提高而显著增加,并对其吸附能力和催化臭氧氧化能力产生显著影响。硝酸改性活性炭吸附能力在碱性条件下由于表面酸性官能团和酸性大红3R之间的静电作用而有所降低;在酸性条件下由于二者的色散作用而增强。表面酸性官能团在碱性条件下参与臭氧分解,产生·OH,增强了硝酸改性活性炭对酸性大红3R的催化臭氧氧化去除效果。     

GC/MS和GC/AED联用技术分析氯代邻羟基二苯醚类化合物的探讨

本文针对三氯新在脱氯反应过程中会产生多种二苯醚类化合物,提出采用GC/MS与GC-AED联用技术,对所有过程产物做出定性或定量分析,并通过实验证明其可行性.