深海压力–流速耦合环境下基于灰色系统理论的有机涂层寿命预测研究

目的 建立深海压力–流速耦合环境下有机涂层的寿命预测模型,并预测有机涂层在该环境下的服役寿命。方法 首先针对涂层的湿态附着力变化结果,基于灰色系统理论,建立湿态附着力的GM(1,1)模型。随后再基于耦合环境下的试验结果,建立涂层水传输的扩散模型。最后,在此基础上,利用灰色关联分析方法,计算这2种失效影响因素在涂层失效过程中所占的权重因子,并基于这2个影响因素建立涂层失效的数学模型。结果 经过数学统计验证和试验结果对比验证,该模型精度良好,可靠性高。结论 该模型能够对深海压力–流速耦合环境下有机涂层的寿命进行准确预测。     

辐射制冷技术在安全帽上的应用研究*

为缓解夏季配戴安全帽导致的头部高温不适,采用具有光谱选择特性的辐射降温涂料对安全帽表面光学性能进行改性,经光学测试,安全帽的太阳辐射反射率由45%提升至89%,大气窗口发射率由92%提升至95%。对安全帽进行降温效果测试,并基于测试结果建立热力学模型。结果表明:在阳光直射下,改性安全帽内部温度低于普通白色安全帽,温差最大12.2 ℃;在热力学模型中,即使在夏季最热时间段（12∶00～14∶00）,改性安全帽内部温度仍可比普通安全帽低8 ℃,预测平均评价值由普通安全帽的3.5降低至1.0,预测不满意百分比从100%降低至20%。     

可见光活性纳米TiO2光催化涂料的抗菌性能研究

基于过渡金属离子掺杂技术,制备了在室内光辐照条件下具有良好光催化抗菌性能的可见光响应型铁掺杂TiO2光催化涂料.研究结果表明,在可见光活性光催化涂料中添加1%的纳米TiO2时,抗菌效果最好,光照24 h后对大肠杆菌、白色念珠球菌、黑曲霉的杀菌率分别达到99.9%、97.2%、82%.采用致孔剂聚乙二醇6 000对光催化...     

Temporal trends of polyfluoroalkyl compounds (PFCs) in liver tissue of grey seals (Halichoerus grypus) from the Baltic Sea, 1974-2008

Temporal trends of polyfluoroalkyl compounds (PFCs) were examined in grey seal (Halichoerus grypus) liver from the Baltic Sea over a period of 35 years (1974-2008). In total, 17 of 43 PFCs were found, including the perfluoroalkyl sulfonates (C₄-C₁₀ PFSAs), perfluorooctanesulfinate (PFOSi), long chain perfluoroalkyl carboxylates (C₇-C₁₄ PFCAs), and perfluoroalkyl sulfonamides (i.e., perfluorooctane sulfonamide (FOSA) and N-ethyl perfluorooctane sulfonamide (EtFOSA)), whereas saturated and unsaturated fluorotelomer carboxylates, shorter chain PFCAs and perfluoroalkyl phosphonic acids were not detected. Perfluorooctane sulfonate (PFOS) was the predominant compound (9.57-1444 ng g⁻¹ wet weight (ww)), followed by perfluorononanoate (PFNA, 0.47-109 ng g⁻¹ ww). C₆-C₈ PFSAs, PFOSi and C₇-C₁₃ PFCAs showed statistically significant increasing concentrations between 1974 and 1997, with a peak in 1997 and then decreased or levelled off (except for C₁₂ and C₁₃ PFCAs). FOSA had a different temporal trend with a maximum in 1989 followed by significant decreasing concentrations until 2008. Toxicological implications for grey seals are limited, but the maximal PFOS concentration found in this study was about 40 times lower than the predicted lowest observed effect concentrations (LOEC). The statistically significant decreasing concentrations or levelling off for several PFCs in the relative closed marine ecosystem of the Baltic Sea indicate a rapidly responding to reduced emissions to the marine environment. However, the high concentrations of PFOS and continuing increasing concentrations of the longer chain PFCAs (C₁₂-C₁₄) shows that further work on the reduction of environmental emissions of PFCs are necessary.     

石灰法在处理金属表面磷化废水中的应用

介绍了化学沉淀法处理金属表面磷化废水的原理,提出了石灰法处理磷化废水的工艺流程和技术参数,指出pH=10.2～11.5时,可以使PO4 3- 和Zn2 同时达到良好的沉淀效果,满足排放标准的要求.     

轮毂行业涂装车间环境污染与防治

轮毂行业快速增长的同时,涂装车间作业排放的废气、废水、废渣、噪声,对环境造成了严重的污染。分析了轮毂行业涂装车间的环境污染状况,包括污染物的来源和种类,指出采用低污染材料、先进的生产设备,并优化生产工艺,是解决涂装“三废”问题的有效途径。     

浮盘密封圈的原油挥发及结构优化的研究

根据我国大型浮顶储罐的特点,分析浮盘密封圈内油气的形成和集聚过程,总结浮盘密封圈在运行中出现的问题;指出密封圈内的油气挥发是气液相动态平衡的过程,当前浮盘密封圈的主要缺陷是密封圈内油气空间较大和在运行中无法保证有效密封;消除密封圈内原油的气液相界面是抑制密封圈内原油挥发的根本,减少风、气温变化等外界因素对密封圈内原油挥发的影响是降低密封圈内油气浓度的关键;消除密封圈内部的油气空间、消除密封圈内可能存在的放电点、增强密封结构的稳定性是密封圈结构优化的主要途径。     

钛基氧化物涂层电极在污水处理方面的实验研究

用涂刷热分解氧化法研究制作了3种钛基金属氧化物涂层电极：SnO₂-Sb₂O₃-CeO₂/SnO₂-Sb₂O₃/Ti、SnO₂-Sb₂O₃-CoO₂/SnO₂-Sb₂O₃/Ti和SnO₂-Sb₂O₃-CoO₂/IrO₂/Ti,用于处理生活污水,筛选出了处理效果最好的电极：SnO₂-Sb₂O₃-CeO₂/SnO₂-Sb₂O₃/Ti电极。通过SnO₂-Sb₂O₃-CeO₂/SnO₂-Sb₂O₃/Ti电极处理生活污水的静态实验,研究了电解时间、电流密度等因素对电解效果的影响,得出该电极较佳的运行参数是：极板间距1 cm、电流密度10 mA/cm²、电解时间2 h,此时,COD、NH₃-N、总磷、总氮、SS和大肠菌群的去除率分别为94.0％、99.8％、51.8％、70.8%、100％和100％;并用该参数进行了动态实验,连续运行60 d,得到了稳定的出水水质数据。     

Heterostructure CdS/ZnS nanoparticles as a visible light-driven photocatalyst for hydrogen generation from water

(CdS)_x/(ZnS)_1–x nanoparticles were synthesized as a visible light-driven photocatalyst using the stepped microemulsion technique with a series of the ratio factors (x). The photocatalytic test results showed that (CdS)_x/(ZnS)_1-x with x = 0.8 had the highest photo-reactivity for H₂ production from water under visible light. The composite (CdS)_0.8/(ZnS)_0.2 catalyst had a heterogeneous structure that exhibited a much greater photocatalytic hydrogen production activity than either pure CdS or the homogeneous Cd_0.8Zn_0.2S solid solution. ZnS deposition also was shown to largely improve the stability of CdS in the heterostructured CdS/ZnS catalyst. Thermal treatment of the catalyst, i.e., annealing (CdS)_0.8/(ZnS)_0.2 at 723 K, improved the crystallinity of the catalyst and increased its photocatalytic H₂ production rate by more than 36 times. Deposition of Ru on the surface of the catalyst particles by in situ photo-deposition further increased the photo-H₂ generation rate by 3 times. The photocatalyst of 0.5%Ru/CdS/ZnS achieved the highest H₂ production activity, at a rate of 12650 μmol/g-h and with a light to hydrogen energy conversion efficiency of 6.5%.     

几种涂层氙弧灯光老化试验加速性研究

太阳辐射是引起有机材料老化的最主要原因,实验室氙弧灯光老化试验具有较高的加速性。本文通过对有机涂层在广州试验站自然暴露试验结果以及实验室氙弧灯光老化试验结果进行对比研究,得到3种常用有机防护涂层的加速倍数,对于1#、2#样品的加速倍数为9,3#样品的加速倍数为6。