耐镉菌株的分离及其对Cd2+的吸附富集

采用梯度浓度驯化的方法,筛选分离出一株能高度耐镉和富集镉的菌株,初步鉴定为假单胞菌属(Pseudomonas sp.).该菌株在含Cd2+浓度4500mg/L的液体细菌培养基中能够生存,当Cd2+浓度为100mg/L时,pH值为6～8有利于提高菌株耐镉能力.Cd2+为低浓度时菌株积累Cd2+,菌体对Cd2+浓度为100mg/L的积累率达99.1%,冻干菌体对Cd2+的吸附量为8.786mg/g干菌体;当Cd2+浓度大于909mg/L时,菌体表现出外排Cd2+现象.红外分析和电镜观察表明,菌株细胞壁在吸附Cd2+中起重要作用,67.4%的Cd2+吸附在细胞壁上.     

过硫酸钾氧化-紫外光度法测定总氮方法的改进

过硫酸钾氧化紫外光度法测定总氮的空白吸光度高的主要原因是:K2S2O8在220nm波长上有特征吸收,适当降低K2S2O8、NaOH的用量,延长消解时间,使用二次蒸馏水,用低浓度亚砷酸钠溶液,还原消解后剩余的极少量的K2S2O8,可以降低空白吸光度.K2S2O8-NaOH碱溶液不稳定,使用期短,三天后氧化能力迅速降低,原因是:K2S2O8溶液中,加入NaOH,加速了K2S2O8的分解.K2S2O8和NaOH分别配制,并在K2S2O8溶液中,加入少量HCl,抑制其水解.两种溶液可使用丰年以上时间.     

石油化工生产中的吸收过程防火

吸收操作在石油化工企业应用广泛，但其过程存在大量的易燃可燃物质，有形成爆炸性浓度的可能性，设备内压易升高，设备易腐蚀，生产中可能产生引火源，发生事故相互影响大等火灾特点。本文根据工艺及设备特点，分析了其生产过程中存在的危险因素和条件，总结了火灾爆炸事故的预防措施与技术。     

冷原子吸收光度法测定工业用浓盐酸中痕量汞

通过进样管道的设计,可能存在的干扰,以及工作参数的详细研究,建立了用冷原子吸收光度法直接测定工业用浓盐酸中痕量汞的分析方法。实际样品测定结果表明,该方法可靠,准确可行。     

Stability analysis of alkaline nitrobenzene-containing wastewater by a catalyzed Fe-Cu treatment process

Iron and copper bimetallic system (catalyzed Fe-Cu process) is a promising technology for alkaline nitrobenzene-containing wastewater treatment. However, little is currently known about the changes of treatment efficiency with time going. This research investigated the long-term performance of the catalyzed Fe-Cu process to reduce nitrobenzene (NB) in alkaline wastewater. In addition, the changes of the metal surfaces morphologies and matters before and after the reaction were analyzed by scanning electron microscopy (SEM) in conjunction with energy-dispersion spectroscopy (EDS) and X-ray diffraction spectroscopy (XRD). The results showed that the surface properties of copper almost remained unchanged after weeks of operation, which spelled its strong chemical stability and resistance to poisoning. Moreover, the results indicated that there were two reasons for the treatment efficiency decreasing with time. One was the gradual iron element consumption due to corrosion. The other was iron reactivity weakened due to the precipitates accumulation on the surfaces that were mainly Fe₃O₄ and FeCO. __________ Translated from Environmental Pollution & Control, 2006, 28(10): 783–785 [译自: 环境污染与防治]     

瓜尔豆胶废水预处理的方法研究

根据瓜尔豆胶在生产食品添加剂的过程中产生的废水COD的值高迭216000mg/l的特点,分别用如下方法进行处理①调pH=6.84,按0.5%质量比加入活性炭吸附剂,静止20天,此时去除率为87.7%;②用饱和硫酸铝2mL 适量的聚丙烯酰胺絮凝,去除率为36.5%;③原液先蒸馏出1/4体积后在釜液中按3%的质量比加入Ca(OH)2,计算去除率为89.6%④利用铁炭屑以5:1的质量比形成微电池的方法作用两小时后再按3%的质量比加Ca(OH)2絮凝,此条件下去除率高达91.7%.经过比较得出第四种方法是最经济有效的,对该特种废水起到了很好的预处理作用.     

Characterisation of Organic Matter and Carbon Cycling in Rehabilitated Lignite-rich Mine Soils

Open-cast lignite mining in the Lusatian mining district resulted in rehabilitated mine soils containing up to four organic matter types: (1) recent plant litter, (2) lignite deposited by mining activity, (3) carbonaceous ash particles deposited during amelioration of the lignite-containing parent substrate and (4) airborne carbonaceous particles deposited during contamination. The influence of lignite-derived carbon types on the organic matter development and their role in the soil carbon cycle was unknown. This paper presents the findings obtained during a six year project concerning the impact of lignite on soil organic matter composition and the biogeochemical functioning of the ecosystem. The organic matter development after rehabilitation was followed in a chronosequence of rehabilitated mine soils afforested in 1966, 1981 and 1987. A differentiation of the organic matter types and an evaluation of their role within the ecosystem was achieved by the use of ¹⁴C activity measurements, ¹³C CPMAS NMR spectroscopy and wet chemical analysis of plant litter compounds. The results showed that the amount and degree of decomposition of the recent organic matter derived from plant material of the 30 year old mine soil was similar to natural uncontaminated forest soil which suggests complete rehabilitation of the ecosystem. The decomposition and humification processes were not influenced by the presence of lignite. On the other hand it was shown that lignite, which was thought to be recalcitrant because of its chemical structure, was part of the carbon cycle in these soils. This demonstrates the need to elucidate further the stabilisation mechanisms of organic matter in soils.     

Effect of Cross-Linking Waste Protein with Dialdehydes on Its Biodegradation Under Anaerobic Conditions

Most native polymers used in processing and application technologies are admittedly disposable from the environment in a biologic manner, but products possess low mechanical strength. One of the paths to increasing this attribute (if feasible) is their cross-linking, which may, however, affect their readiness to biodegradation. In the presented work this condition was observed on the example of waste protein (Hykol B) cross-linking by means of glutardialdehyde and glyoxal. Degree and course of cross-linking were determined through impedance spectroscopy. The objective of this work also was to obtain data for constructing a sensor capable of following the cross-linking course in real time, for potential industrial application of Hykol in continuous production. Impedance spectroscopy proved to be applicable even to this kind of material marked by considerable water content and exhibiting relatively high electric conductivity; so far it had been used only for materials of low conductivity. An aqueous environment inoculated with digested anaerobic sludge from a municipal wastewater treatment plant was selected for modeling anaerobic conditions. The relation was studied between cross-linking degree given by content of cross-linking agent (determined by impedance spectroscopy) and biodegradation degree under anaerobic conditions. It was confirmed that network density as given by quantity of added agent not only reduced breakdown degree but also slowed the course of the process. This fact is particularly obvious with cross-linking by means of glyoxal; network density is thus dependent on type of employed substance, which affect type and structure of created network. That not merely forms an obstacle during polymer swelling and dissolution but also prevents access of bacteria to source of metabolized organic carbon.     

细水雾阻隔火焰热辐射的模拟研究

从热辐射传递方程出发，根据Mie散射理论,考虑雾滴对热辐射的散射和吸收特性，建立细水雾阻隔火焰热辐射的两通量模型，并给出简化算法；同时建立小尺度模拟实验系统，对理论模型进行验证。结果表明，两通量模型较为合理地预测了细水雾对火焰热辐射的衰减作用。在此基础上，应用上述理论模型进一步探讨火焰温度、细水雾特性参数、雾场厚度对阻隔热辐射效率的影响，为细水雾系统的实际工程应用提供了理论和依据。     

A Parallel Study of SAR Levels in Head Tissues for Three Antennas Used in Cellular Telephones: Monopole, Helix and Patch

Summary This paper is a comparative study of several antennas commonly used in cellular telephones. These include a monopole, a helix-monopole and a patch antenna. Each one of these structures is modeled and numerically tested using finite-difference time-domain simulation and human models based on magnetic-resonance images, which allow for inclusion of details of the human body in the simulation. The testing procedure involves antenna simulation in the proximity of the human head. The behavior of each antenna is evaluated for variable distances from the head geometry (0, 1, 2, 4, 8 and 16 mm). Continuous waveform, representative of the sources used in mobile telephones, (250 mW, 1.8 GHz) is used as the form of the antenna excitation. The simulation outputs used as measures for this comparative study include transmitting and receiving antenna characteristics and the specific absorption rate (SAR). The SAR levels for the head tissues are calculated for and with accordance to the two currently accepted standards: Federal Communications Commission (FCC) and International Commission on Non-Ionizing Radiation Protection (ICNIRP). The computed SAR levels within each of the considered tissues vary for the three antennas under investigation and are within the determined health safety standards. Results suggest that the patch antenna may be the structure of choice when considering safety standards, as its radiation yields the lowest local SAR in the head tissues.