发烟硫酸贮罐清洗安全技术

根据事故隐患分析 ,采取安全措施 ,成功地用中和法清洗发烟硫酸贮罐 ,并提出了贮罐的改进措施。     

采用两级物化法去除黄磷废水中的氟化物

采用向含氟废水中加入适量石灰和聚合氯化铝，然后投加适量钙盐、磷酸和聚丙烯酰胺的二级处理工艺除氟，通过控制合适的pH、钙盐和磷酸的投加量、反应时间、反应温度、搅拌强度和絮凝剂的投加量，可使黄磷废水中氟的质量浓度降至5mg/L，氟的去除率达到99％以上，出水中氟的质量浓度达到GB8978－1996一级排放标准。     

树脂相分光光度法测定水中痕量苦味酸

建立了树脂相分光光度法测定水中痕量苦味酸的新方法。该法灵敏度高,表观摩尔吸光系数为1.08×105L/(mol·cm);精密度理想(测定苦味酸质量浓度为5μg/mL的实验5次,相对标准偏差为1.0%);线性范围为0～7.0μg/mL;以3σ衡量,检出限为0.14μg/mL;加标回收率为97%～103%。采用该法直接测定水样中的苦味酸、间接测定烟草中的烟碱,结果令人满意。     

柠檬酸生产废水处理技术

分析了柠檬酸生产废水的来源及水质特性,综述了厌氧生物法、厌氧-好氧生物组合法、乳状液膜法等在柠檬酸废水处理中的应用,介绍了中和废水回用和利用柠檬酸发酵废液开发糖化酶制剂的技术。     

Comparative Biodegradation Study of Starch- and Polylactic Acid-Based Materials

The degradation of starch- and polylactic acid-based plastic films by microorganisms extracted from compost was studied in a liquid medium. The various degradation products produced were measured throughout the duration of the experiment, and total carbon balances were estimated. For an easily biodegradable material, the evolution of the way carbon repartitioned between different degradation products was quite similar whatever the experimental condition or the type of substrate. On the other hand, for a resistant material exposed to these microorganisms, the nature of the biodegradation depended strongly on the experimental conditions. In the latter case, a differential scanning calorimetry analysis confirmed the importance of the applied norm on the state of the residual material. The consequences for improved methods of estimation of biodegradability of these materials are discussed.     

Application of a Second-Order Kinetic Model to a Complex Melt Polymerization Reaction

A novel copolymer system has been synthesized using methyl hydroquinone diacetate (MHQDA), 1,4 naphthalene dicarboxylic acid (1,4 NDCA), and polybutylene terephthalate (PBT) using the melt polymerization technique. The optimum kinetic parameters pertinent to this system are reported in this study. A simple second-order reaction sequence summarizes catalyzed and uncatalyzed reactions between MHQDA, 1,4 NDCA, and PBT. The kinetic parameters for the copolymerization reaction were determined using a new second-order model. This technique was used to compute the moles of acetic acid generated in the polymerization process. The model was compared to that of the experimentally determined data. Close comparison (percentage error of less than 5%) was obtained between the experimental and theoretical data. The kinetic data support block copolyester formation. The thermal data also supports formation of block polymers.     

仪化热电厂提高循环水浓缩倍率的措施

针对仪化热电厂将循环水用作冲灰水，导致浓缩倍率只有1.6，以及凝汽器铜管腐蚀结垢严重等问题，提出了隔断循环水与冲灰水的直接联系，实现闲路循环，对凝汽器铜管进行酸洗，并对循环水实施加缓蚀阻垢荆、杀菌剂和旁流过滤等办法，全部实施后产生了很好的效益，值得借鉴。     

QUALITY OF HYDROMETEOROLOGICAL DATA IN COLD REGIONS1

ABSTRACT: Many users of hydrometeorological records are not aware of the number of inconsistencies and biases that occur in hydrometeorological records. Examples are presented illustrating how the exposures of sites for measurement of precipitation, wind, snow on the ground, and evaporation determine to a large extent how useful the records are for estimating areal conditions. For areas where precipitation in the form of snow produces a significant portion of the runoff, a smaller number of quality records may be more valuable for modeling than a much larger number of records of lower quality. Information is presented to show that the overall value of an operational hydrometeorological network is dependent upon how consistent and representative of average conditions the collected records are, especially for mountainous areas in cold regions.     

云南近百年来温度雨量的变化特征分析

用气候倾向率、Morlet小波方法,对云南10个站1901-2007年的年降水和平均温度资料分析表明:100年来云南平均增温速率为0.031℃/10a。近50年来全省平均增温速率为0.242℃/10a,略高于全国的增温,增温最大的是滇中的昆明、滇南的普洱,分别为0.442℃/10a和0.409℃/10a,并且西部明显高于东部。100年来云南年降水呈减少趋势,平均速率为7.288mm/10a,近50年来,年降水量减少平均速率为6.66mm/10a。但云南降水的区域分异非常明显,云南的东部、中部降水减少;而滇西北和滇东南地区降水增加。云南气温明显的年代际变化是32年,发生了3次突变。年降水呈明显的年代际及年际振荡,具有16～32年、4～8年周期。     

汞(Ⅱ)和砷(Ⅲ)在草炭土胡敏酸上的吸附

为研究汞和砷在胡敏酸上的吸附特性,从辽宁彰武采集了草炭土并用稀碱法提取胡敏酸。研究胡敏酸对Hg（Ⅱ）和As（Ⅲ）吸附作用,探讨温度（15、25、35、45℃）、pH（3,5,7,9）和离子强度（Ca2+,H2PO4-）对该吸附的影响,并计算吸附活化能。结果表明：温度与胡敏酸对Hg（Ⅱ）的吸附呈显著正相关,而对胡敏酸吸附As（Ⅲ）的影响较小;pH对胡敏酸吸附Hg（Ⅱ）也呈正相关,而胡敏酸对As（Ⅲ）的吸附以中性最好,酸性、碱性下吸附量均降低;Ca2+对Hg（Ⅱ）的吸附有明显的抑制作用,H2PO4-对As（Ⅲ）的吸附影响很小。对等温吸附实验结果拟合证明,胡敏酸对Hg（Ⅱ）和As（Ⅲ）等温吸附更符合Freundlich模型。对动力学吸附实验结果拟合证明,准二级动力学方程能很好地描述胡敏酸对Hg（Ⅱ）和As（Ⅲ）的吸附。Hg和As（Ⅲ）在胡敏酸的吸附活化能分别为23.06 kJ·mol-1和2.65 kJ·mol-1,表明Hg（Ⅱ）在胡敏酸上的吸附以化学吸附为主,As（Ⅲ）在胡敏酸上的吸附以物理吸附为主。