新型悬浮填料澄清池中填料对澄清作用的影响初探

为考察可取代传统二沉池的新型悬浮填料澄清池技术的原理及关键参数,小试试验研究了填料对新型悬浮填料澄清池固液分离过程中附着污泥形成及其絮凝性能的影响,并对填料在澄清中的作用机理进行了探讨。结果表明,当泥水界面上升至填料区后,可以形成较悬浮污泥更加致密稳定的附着污泥区,并形成孔道流,强化了对混合液中污泥颗粒的絮凝效果;填料区可以捕捉去除从悬浮污泥区中“逃逸”的微小污泥絮体,并降低出水浊度,有效地保证了出水水质的稳定性。填料的存在发挥了强大的整流作用,降低了雷诺数Re,提高了弗汝德数Fr,从而改善了污泥絮凝的水力条件,提高了澄清能力。     

污泥膨胀状态下原生动物群落结构分析

系统研究了丝状菌膨胀与非丝状菌膨胀2种典型污泥状态下原生动物的群落结构特征及其演变规律。伴随丝状菌的大量增殖,原生动物总量相应减少,匍匐型纤毛虫及有壳类肉足虫数量迅速上升,占据明显的优势地位,典型原生动物为斜管虫（Chilodonella sp.）、小轮毛虫（Trochilia minuta）以及匣壳虫（Centropyxis sp.）;非丝状菌污泥膨胀对原生动物总量及种群结构影响较小,伴随粘性菌胶团的大量出现,各功能类群的比例变化较小,但原生动物总量持续增加,其中菌食性纤毛虫呈线性增加,典型原生动物为钟虫（Vorticella sp.）。     

三氯生在碳纳米管上的吸附

药品和个人护理用品(PPCPs)已成为一个引起广泛关注的新的环境问题。采用碳纳米管（CNTs）对水溶液中的三氯生进行吸附处理,考察了碳纳米管粒径及用量、温度、pH、振荡时间等因素对三氯生去除率的影响。研究结果表明,碳纳米管能快速吸附水中的三氯生,粒径较小的碳纳米管可获得较高的三氯生去除率;低温有利于吸附反应的进行;pH在6.5～7.0时,三氯生的去除率可达97%。三氯生在碳纳米管上的吸附可以很好地用Langmuir和Freundlich吸附等温方程进行描述。     

木棉基活性炭纤维吸附性能的研究

采用浸渍(NH₄)₂HPO₄化学活化法650℃时制备得到3种新型木棉基活性炭纤维,即只浸渍不预氧化方法处理的AK1(activated kapok),先浸渍后预氧化的AK-2和先预氧化后浸渍的AK-3。利用制备得到的活性炭纤维处理苯酚和亚甲基蓝的模拟废水,AK-2具有苯酚最大吸附量(137.00 mg/g),AK-1具有亚甲基蓝最大吸附量(274.11 mg/g)。吸附苯酚时,在静态平衡实验中,更符合Freundlich吸附等温线;在动力学实验中,更符合准一级反应。吸附亚甲基蓝时,在静态平衡实验中,AK-1更符合Langmuir模型,AK-2 、AK-3更符合Freundlich吸附等温线;在动力学实验中,更符合准二级反应。     

DGGE、T-RFLP 、LH-PCR对两种活性污泥的微生物种群多样性分析的比较

采用基于PCR扩增的分子生态技术DGGE、T-RFLP和LH-PCR,对2种典型污水处理系统中的活性污泥（生活污泥、焦化污泥）进行微生物种群多样性分析;并以此比较3种技术的优劣,提出不同应用条件下研究方法的选择依据。根据实验结果：DGGE得到的条带较多,但误差来源也最多;T-RFLP技术较为灵敏,但需要选择适当的内切酶,严格控制酶切条件,并且文库比对误差较大;而LH-PCR操作简单,结果稳定性较高。虽然目前尚无法判断3种方法的准确性,但LH-PCR在活性污泥的微生物种群多样性分析中已显示出潜在优势。     

污泥活性炭强化SBR法处理垃圾渗滤液的实验研究

为了进一步处理垃圾渗滤液,试验采用污泥活性炭强化序批式间歇反应器（SBR）法进行处理,通过对比普通SBR法试验,得出投加污泥活性炭强化SBR法处理垃圾渗滤液的效果要远远高于普通SBR法。当污泥活性炭的投加量为1.2 g/L,容积负荷为0.5～1.5 kg BOD₅/(m³·d)时,进水1 h,曝气10 h,沉淀1.5 h,闲置1.5 h,处理效果最好,COD的去除率达到了85%,NH³-N的去除率达到了90%。     

固定化假单胞菌降解油烟废气的研究

将从受油烟废气污染严重的土壤中分离筛选的具有较强降解油烟能力的假单胞菌利用活性炭为填料吸附固定后制成填料床生物反应器。实验考察了进气浓度、气体流量、气体停留时间、容积负荷等对油烟去除率的影响,初步研究了生物反应器的抗冲击能力。结果表明,活性炭填料对菌体具有良好的吸附能力,当油烟进气浓度小于100 mg/L,气体流速小于8 L/h,停留时间大于30 s,容积负荷为2.6～18.9 g油烟废气/(m³·h),生物反应器的降解效率可达到95%以上,且活性炭填料床反应器具有较强的抗冲击能力。     

NaCl和KCl对厌氧污泥抑制的动力学研究

在厌氧颗粒污泥和厌氧絮状污泥系统中,进行盐质量浓度(NaCl或KCl质量浓度,下同)对厌氧污泥抑制动力学的研究,得到不同拟合的COD降解动力学方程及参数.实验结果表明:当盐质量浓度为10～30 g/L时,KCl对厌氧污泥的COD比降解速率的抑制程度大于NaCl;当盐质量浓度由0 g/L增至10 g/L时,半速率常数逐渐增加;当盐质量浓度由10 g/L增至30 g/L时,半速率常数逐渐减小;在厌氧污泥系统中,NaCl抑制作用下的盐抑制常数高于KCl,且颗粒污泥的盐抑制常数高于絮状污泥.     

Ru/γ-Al_2O_3和Ru/AC催化剂的制备及其对氨氧化反应的催化性能

分别以γ-Al_2O_3和活性炭(AC)为载体,采用浸渍法制备了Ru质量分数均为2.0%的Ru/γ-Al_2O_3和Ru/AC催化剂,并用X射线衍射仪和透射电子显微镜等方法对催化剂结构进行了表征.实验结果表明:Ru/AC中Ru沉积在AC表面,分散度较低;而Ru/γ-Al_2O_3中Ru进入到γ-Al_2O_3内部,形成了一种高度分散体系.Ru/γ-Al_2O_3对氨的催化活性高于Ru/AC,氨在Ru/γ-Al_2O_3和Ru/AC上的起活温度分别为200 ℃和266 ℃,T_(90)(氨去除率达90%时的反应温度)分别为267℃和320 ℃.随混合气体空速增大,Ru/γ-Al_2O_3催化剂的T_(90)逐渐升高,气体空速分别为3 600,4 800,5 400 h~(-1)时,T_(90)分别为235,266,303 ℃.随反应前混合气体中氨质量分数增加,氨的去除率降低.     

The accounting method and application of CO2 emissions responsibility by the electricity sector at the provincial level in China

When accounting the CO₂ emissions responsibility of the electricity sector at the provincial level in China,it is of great significance to consider the scope of both producers’ and the consumers’ responsibility,since this will promote fairness in defining emission responsibility and enhance cooperation in emission reduction among provinces.This paper proposes a new method for calculating carbon emissions from the power sector at the provincial level based on the shared responsibility principle and taking into account interregional power exchange.This method can not only be used to account the emission responsibility shared by both the electricity production side and the consumption side,but it is also applicable for calculating the corresponding emission responsibility undertaken by those provinces with net electricity outflow and inflow.This method has been used to account for the carbon emissions responsibilities of the power sector at the provincial level in China since 2011.The empirical results indicate that compared with the production-based accounting method,the carbon emissions of major power-generation provinces in China calculated by the shared responsibility accounting method are reduced by at least 10%,but those of other power-consumption provinces are increased by 20% or more.Secondly,based on the principle of shared responsibility accounting,Inner Mongolia has the highest carbon emissions from the power sector while Hainan has the lowest.Thirdly,four provinces,including Inner Mongolia,Shanxi,Hubei and Anhui,have the highest carbon emissions from net electricity outflow- 14 million t in 2011,accounting for 74.42% of total carbon emissions from net electricity outflow in China.Six provinces,including Hebei,Beijing,Guangdong,Liaoning,Shandong,and Jiangsu,have the highest carbon emissions from net electricity inflow- 11 million t in 2011,accounting for 71.44% of total carbon emissions from net electricity inflow in China.Lastly,this paper has estimated the emission factors of electricity consumption at the provincial level,which can avoid repeated calculations when accounting the emission responsibility of power consumption terminals（e.g.construction,automobile manufacturing and other industries）.In addition,these emission factors can also be used to account the emission responsibilities of provincial power grids.