半短程亚硝化与厌氧氨氧化联合脱氮工艺微生物特征研究进展

半短程亚硝化-厌氧氨氧化脱氮技术具有良好的发展前景,该工艺的发展以及应用分子生物学技术对好氧氨氧化菌种群和厌氧氨氧化种群生态学的研究备受人们关注.本文综述了工艺原理和影响因子诸如温度、pH值、氧的可利用性、游离氨浓度等对氨氧化菌及厌氧氨氧化菌的影响,并介绍了应用分子生物学方法对氨氧化菌与厌氧氨氧化菌的类别及分布的研究结果,并对该工艺提出了展望.     

生物活性炭投加量对垃圾渗滤液处理效果的影响

试验对比了不同生物活性炭(biological activated carbon,BAC)投加量对垃圾渗滤液去除COD效果的影响.每升活性污泥中活性炭投加量为0、100、300 g的反应器处理垃圾渗滤液100个周期平均COD去除率分别为12.9%、19.6%、27.7%,表明BAC可以去除部分难降解有机物,并且COD去除率与投加量呈正相关关系.曝气8 h反应器中二氧化碳(CO2)产生量依次为109、193、306 mg,表明生物分解量也与投加量呈正相关关系.分析认为COD去除率与投加量的正相关关系是由于吸附与生物再生的共同作用导致,生物再生是BAC能够生物分解难降解有机物的根本原因.     

壳聚糖活性污泥复合吸附剂的制备研究

为了提高污泥细胞吸附重金属离子的应用能力,采用壳聚糖包埋固定活性污泥,制备了粒径2~3 mm的壳聚糖活性污泥复合吸附剂SCTS.以吸附溶液中CrO2-4的吸附率为指标,通过单因素实验对制备过程中采用的2种固化液及5种发泡剂进行比选,考察了固化液浓度、发泡剂量、交联剂量、活性污泥与壳聚糖用量比值及发泡温度对SCTS吸附能力的影响,由正交实验确定影响因素主次顺序及最优水平组合.结果发现,固化液浓度、发泡剂量、污泥与壳聚糖用量比值及发泡温度对SCTS吸附能力影响较强,影响次序为固化液浓度发泡剂量活性污泥与壳聚糖用量比值发泡温度.最优水平组合为4 g·L-1三聚磷酸钠(STPP)固化液、剂量为吸附剂质量10%的NH4HCO3发泡剂、活性污泥与壳聚糖用量比值0.5、发泡温度100℃,此时CrO2-4吸附率最高可达97.3%.该吸附剂的制备研究为污泥的资源化利用探索了新的途径.     

粉煤灰负载Fe2O3脱除气态单质汞的试验研究

在固定床反应器中研究了利用燃煤电厂固废粉煤灰(FA)负载Fe2O3所制备的Fe2O3/FA催化剂对气态Hg0的脱除情况,发现Fe2O3/FA具有较高的脱除Hg0的能力.同时,考察了Fe2O3负载量、温度、空速、Hg0浓度、烟气成分等对Fe2O3/FA脱除Hg0的影响.结果表明,Fe2O3/FA对Hg0的脱除能力随Fe2O3负载量(1%~10%)的增加和温度(120~200℃)的升高而增强;Fe2O3/FA在较低的空速和Hg0浓度条件下表现出了更高的脱除Hg0的活性;HCl和O2促进了Fe2O3/FA对Hg0的脱除,而SO2和H2O抑制了Fe2O3/FA对Hg0的脱除.逐级化学提取实验结果证实,Fe2O3将Hg0氧化为Hg2+的化合物并吸附在FA上,这是Fe2O3/FA具有较高的脱除Hg0能力的原因.     

DOC/CCRT老化对柴油公交车气态物排放特性的影响

基于重型底盘测功机,研究新鲜及老化氧化型催化器(DOC)、氧化型催化器耦合催化型颗粒捕集器(DOC+CDPF,CCRT)对在用国Ⅲ柴油公交车进行中国典型城市公交车循环CCBC时一氧化碳(CO)、总碳氢化合物(THC)、一氧化氮(NO)、二氧化氮(NO_2)和氮氧化物(NO_x)、二氧化碳(CO_2)等气态物排放特性的影响.结果表明:采用新鲜及老化DOC/CCRT,均可以降低CO、THC、NO排放,增加NO_2排放,NO_x及CO_2排放基本不变;在怠速、加速、减速及匀速这4种工况下,新鲜DOC比老化DOC对CO、THC氧化效率好,新鲜CCRT比老化CCRT对THC氧化效率好,但老化CCRT对CO氧化效率更好,新鲜DOC/CCRT比老化DOC/CCRT对NO减少幅度高,对NO_2增加幅度高,但对NO_x排放总量基本无影响.     

磁性氮掺石墨烯活化过硫酸钾降解水中亚甲基蓝

活化过硫酸盐产生硫酸根自由基的高级氧化技术在水环境污染物治理中引起了广泛的关注和研究.本研究采用水热法制备磁性氮掺石墨烯(M-N-G)作为催化剂.利用SEM、BET、XRD和VSM等手段表征材料,系统研究了该材料活化过硫酸盐降解亚甲基蓝的效能.结果表明:M-N-G的比表面积为94.35 m2·g-1,磁性Fe3O4分布在材料表面,能有效的活化过硫酸钾降解亚甲基蓝.当催化剂的用量为200 mg·L~(-1),过硫酸钾浓度为0.4~0.5 mmol·L~(-1)时,在p H=3~6时对10 mg·L~(-1)亚甲基蓝的降解率达90%以上.体系温度在15~32℃时,降解速率常数在0.0227~0.0488 min-1,反应活化能为33.7 k J·mol-1.EPR分析及自由基漼灭实验证明了体系中有羟基自由基和硫酸根自由基产生.TOC分析结果表明:TOC去除率可达50%.M-N-G经过简单的稀硫酸和水洗后,可高效重复利用4次.该技术方法简单、高效、无二次污染,能为有机污染物废水处理提供一种新的方法选择.     

2,4-二氯酚废水处理的试验研究

研究了活性炭吸附法处理2,4-二氯酚废水的工艺过程。研究结果表明。活性炭对该废水具有良好的吸附效果。此外,还对吸附过程的动力学进行了研究,结果表明吸附过程遵循Lagergren一级动力学模型,并得出25℃和35℃时速率常数分别为k298=0．0072min^-1、k308=0．0118min,吸附活化能Ea=38．5kj／mol。     

Degradation of 2,4-dichlorophenoxyacetic acid in water by ozone-hydrogen peroxide process

IntroductionAt present, several types of organic pollutantsreferred to as environmental endocrine disruptors(ED) have been suggested to be associated withabnormal sexual development (Hu, 2000). It wasreported that the ED led to the decline of reproductive…     

石油化工企业含苯胺消防污水处理技术研究

针对石油化工企业含苯胺的消防污水,利用基于过氧化氢和氯化铁为氧化剂的深度氧化技术,通过氧化、絮凝、过滤和吸附对消防污水进行处理。实验确定氧化剂的投加量为理论投加量,氧化时间1.0h,消防污水pH值为6.86时,絮凝剂最佳使用浓度约为2%,消防污水中苯胺和COD去除率达到99.5%以上,达到了消防污水处理效果。     

Effect of pyrolysis and oxidation characteristics on lauric acid and stearic acid dust explosion hazards

The effect of pyrolysis and oxidation characteristics on the explosion sensitivity and severity parameters, including the minimum ignition energy MIE, minimum ignition temperature MIT, minimum explosion concentration MEC, maximum explosion pressure P_max, maximum rate of pressure rise (dP/dt)_max and deflagration index K_st, of lauric acid and stearic acid dust clouds was experimentally investigated. A synchronous thermal analyser was used to test the particle thermal characteristics. The functional test apparatuses including the 1.2 L Hartmann-tube apparatus, modified Godbert-Greenwald furnace, and 20 L explosion apparatus were used to test the explosion parameters. The results indicated that the rapid and slow weight loss processes of lauric acid dust followed a one-dimensional diffusion model (D1 model) and a 1.5 order chemical reaction model (F1.5 model), respectively. In addition, the rapid and slow weight loss processes of stearic acid followed a 1.5 order chemical reaction model (F1.5 model) and a three-dimensional diffusion model (D3 model), respectively, and the corresponding average apparent activation energy E and pre-exponential factor A were larger than those of lauric acid. The stearic acid dust explosion had higher values of MIE and MIT, which were mainly dependent on the higher pyrolysis and oxidation temperatures and the larger apparent activation energy E determining the slower rate of chemical bond breakage during pyrolysis and oxidation. In contrast, the lauric acid dust explosion had a higher MEC related to a smaller pre-exponential factor A with a lower amount of released reaction heat and a lower heat release rate during pyrolysis and oxidation. Additionally, due to the competition regime of the higher oxidation reaction heat release and greater consumption of oxygen during explosion, the explosion pressure P_m of the stearic acid dust was larger in low concentration ranges and decayed to an even smaller pressure than with lauric acid when the concentration exceeded 500 g/m³. The rate of explosion pressure rise (dP/dt)_m of the stearic acid dust was always larger in the experimental concentration range. The stearic acid dust explosion possessed a higher P_max, (dP/dt)_max and K_st mainly because of a larger pre-exponential factor A related to more active sites participating in the pyrolysis and oxidation reaction. Consequently, the active chemical reaction occurred more violently, and the temperature and overpressure rose faster, indicating a higher explosion hazard class for stearic acid dust.