主动脉动气流分选处理废弃催化剂

废弃催化剂重整后含有富集贵金属的海绵体和烧结磁珠,二者的有效分选是提纯贵金属富集体的重要环节。主动脉动气流分选装置能够对此物料进行干法分选,避免了湿法分选对物料的改性,有利于贵金属富集体的后续提纯。介绍了主动脉动气流分选装置的结构,分析主动脉动气流分选机理及其动力学模型。通过实际物料进行分选试验。结果表明,在脉动频率为7/3 Hz,气流流速为2.50~6.00 m/s时,总分选效率Ef高于94.50%;在气流流速为3.33 m/s时,分选效率最高,总分选效率Ef可达97.63%。     

活性炭对两种生物染料脱色效果的实验研究

以颗粒状活性炭为吸附载体,对两种单体生物染料进行脱色吸附实验研究。通过实验确定出最佳优化条件：活性炭用量80g/L,溶液pH值约为5、5,溶液最佳温度为35℃,搅拌速度为150rpm／min,此时染料脱色率可达98％以上;在几种条件实验过程中,将两种染料进行对比发现：红色染料脱色率一般都比绿色染料脱色率高,而且前者一般比后者反应较敏感。同时,从活性炭的表面结构方面探讨吸附脱色机理,为活性炭深度处理印染废水的研究可提供一定的科学依据。     

Review and future of active disassembly

Disassembly has been widely accepted as a disadvantageous end-of-life activity, but with increasing pressures from directives, such as waste on electrical and electronic equipment, and with increasing pressures to become sustainable disassembly is becoming necessary. Current disassembly methods, including both manual and automated disassembly, need improvements to meet this necessity. This paper will introduce the improvements needed and suggest through literature the validity of active disassembly (AD) to provide these improvements. Past and current research will also be considered to provide a future path for AD. This future path for AD will consider a collaborative effort to solve problems with materials, environmental triggers and costs seen with AD.     

煤质活性炭在饮用水处理应用中值得探讨的问题

本文介绍了煤质活性炭在饮用水处理应用中存在的如何选择活性炭的性能指标,煤质活性炭新旧国家标准的变化及煤质活性炭的再生等值得探讨问题。本文对煤质活性炭饮用水处理的应用具有一定的意义。     

基于重要抽样法的耐压球壳可靠性计算方法研究

目的 解决耐压球壳极小失效概率的可靠性计算问题。方法 在自适应Kriging的基础上,结合重要抽样法提出耐压球壳可靠性计算方法。该方法在较大失效概率下构建的Kriging模型基础上获得重要方向,在重要方向上计算得到较低失效概率下的设计点,以设计点为中心,构建小失效概率的Kriging模型,并通过此模型采用重要抽样法开展可靠性计算。结果 分别使用提出的重要抽样法和蒙特卡洛法计算了2个算例的失效概率,计算结果表明,该方法具有较高的精度和效率。使用该方法对某耐压球壳工作载荷下的失效概率进行了计算,计算得到该球壳失效概率为4.094×10^–96。结论 研究结果可为无失效方程下极低失效概率的可靠性计算问题提供参考。     

催化氧化除锰活性滤料去除地下水中双酚A性能

以催化氧化除锰活性滤料（简称“活性滤料”）为研究对象,考察了地下水中锰污染对于活性滤料去除双酚A效能的影响.结果表明,进水中含有高浓度锰（5mg/L）时,会显著降低活性滤料对于双酚A的去除能力;同时,双酚A也会降低活性滤料对锰的去处能力.双酚A脱附实验结果表明,脱附的双酚A量不足双酚A去除总量的10%,且双酚A去除过程中初期总有机碳（TOC）去除率保持在12%~25%,之后持续保持在0.1%~4%,表明活性滤料去除双酚A存在吸附过程,但是以氧化去除为主.扫描电子显微镜（SEM）和X射线衍射（XRD）分析结果表明,双酚A的去除会导致滤料表面微观形态改变以及新物相的生成;傅里叶变换红外光谱（FTIR）结果表明双酚A的去除会消耗滤料表面羟基基团,且表面残留络合物.本文研究分析提出活性滤料去除双酚A的主要步骤包括双酚A首先吸附到活性滤料表面形成络合物、活性滤料与表面络合物发生氧化反应,部分反应物中间体脱附3个过程.     

Identification of close relationship between atmospheric oxidation and ozone formation regimes in a photochemically active region

Understanding ozone (O₃) formation regime is a prerequisite in formulating an effective O₃ pollution control strategy. Photochemical indicator is a simple and direct method in identifying O₃ formation regimes. Most used indicators are derived from observations, whereas the role of atmospheric oxidation is not in consideration, which is the core driver of O₃ formation. Thus, it may impact accuracy in signaling O₃ formation regimes. In this study, an advanced three-dimensional numerical modeling system was used to investigate the relationship between atmospheric oxidation and O₃ formation regimes during a long-lasting O₃ exceedance event in September 2017 over the Pearl River Delta (PRD) of China. We discovered a clear relationship between atmospheric oxidative capacity and O₃ formation regime. Over eastern PRD, O₃ formation was mainly in a NO_x-limited regime when HO₂/OH ratio was higher than 11, while in a VOC-limited regime when the ratio was lower than 9.5. Over central and western PRD, an HO₂/OH ratio higher than 5 and lower than 2 was indicative of NO_x-limited and VOC-limited regime, respectively. Physical contribution, including horizontal transport and vertical transport, may pose uncertainties on the indication of O₃ formation regime by HO₂/OH ratio. In comparison with other commonly used photochemical indicators, HO₂/OH ratio had the best performance in differentiating O₃ formation regimes. This study highlighted the necessities in using an atmospheric oxidative capacity-based indicator to infer O₃ formation regime, and underscored the importance of characterizing behaviors of radicals to gain insight in atmospheric processes leading to O₃ pollution over a photochemically active region.     

吸附-电氧化法降解气态乙二醇乙醚乙酸酯(EGEA)的研究

采用吸附-电氧化两步联动降解VOCs,结果表明,相同电压下以铁作为阳极时的CODCr脱除率达到80%以上,比用不锈钢阳极时高40%左右.电解质溶液的pH值和CODCr值随时间有规律地变化,也验证了反应器中所发生的反应.     

不同相对分子质量的有机物对膜通量的影响

采用截留分子量分别为10、30kDa的聚醚砜膜和100kDa的聚偏氟乙烯膜对原水进行分级处理,并采用截留分子量分别为150kDa的聚偏氟乙烯膜和0.1μm的醋酸纤维素膜对出水进行膜过滤试验,研究不同相对分子质量的有机物对膜通量的影响.结果表明,虽然相对分子质量>30kDa的大分子有机物仅为总有机物的15%,但它分别引起微滤膜的通量下降86%和超滤膜通量下降54%.混凝处理可以去除相对分子质量>100kDa的有机物,这部分有机物导致通量下降40%以上.因此,尽管混凝处理仅去除10%的有机物,但改善通量的效果显著.粉末活性炭可以去除相对分子量<30kDa的小分子有机物,这部分有机物对通量下降的贡献程度甚低.因此,尽管粉末活性炭去除76%的有机物,但改善通量的效果甚微.预处理改善通量的效果并不取决于去除有机物的多少,而是取决于所去除的有机物对通量的影响大小.     

Proposing an information criterion for individual-based models developed in a pattern-oriented modelling framework

Individual-based models (IBMs) have been improved in quality and reliability in recent years with an approach called pattern-oriented modelling (POM). POM proposes guidelines to develop models reproducing multiple patterns observed on the field and to test systematically how well the IBMs reproduce them. POM studies used generally traditional methods of goodness of fit such as the sum of squares evaluation or ad hoc comparisons of fitting errors and variations. Model selection, however, can be a rigorous statistical approach based on information theory and information criteria such as the Akaike's information criterion (AIC) or the deviance information criterion (DIC). So far, it has not been tried to link POM to these rigorous techniques. The main problems to achieve that are: (a) the difficulty to have likelihood functions for IBMs’ parameters and (b) the possibility to obtain posterior distributions of IBMs’ parameters given the patterns to reproduce. In a first part, this paper answers problem (a) by proposing and explaining how to calculate a deviance measure (POMDEV) for models developed in a context of POM. And while answering the second problem, a second part of the paper proposes an information criterion for model selection in a POM context (the pattern-oriented modelling information criterion: POMIC). This criterion does not yet have the same theoretical foundation as, e.g., AIC, but uses formal analogies to the DIC. In a third part POMIC is tested with a modelling exercise. This exercise shows the potential of POMIC to use multiple patterns for selecting among multiple potential submodels and eventually select the most parsimonious and well fitting model version. We conclude that POMIC, although being a heuristically derived approach, can greatly improve the POM framework.