碱矿渣胶凝材料固化重金属污泥的研究

主要原材料为高炉矿渣的碱矿渣胶凝材料(HAS)、掺3%沸石的HAS、掺5%沸石的HAS、水泥等4种固化材料被用来固化人工合成含铅、镉、铬等重金属的污泥。污泥固化体中污泥与固化材的掺和比例为4:1。实验结果表明,HAS固化剂对重金属污泥的固化效果要好于水泥,其污泥固化体的无侧限抗压强度高于水泥固化体,同时其固化体的重金属浸出量明显低于水泥。沸石的掺入使HAS固化体的重金属浸出量减小,且随着沸石掺加量的增大,HAS固化体的重金属浸出量相应的减少。     

电气柜疲劳强度校核及结构优化

针对多孔闭孔型发泡硅橡胶D型空心密封条的超弹性特性,通过试验找出了密封条回弹力与压缩量之间的关系,提出了密封条满足IP X5的判别方程式,同时对方程式进行了试验验证,最后对密封条进行了阿累尼乌斯图寿命推算,为变流器柜门IP防护设计提供了重要参考。     

Potential effects of particulate matter from combustion during services on human health and on works of art in medieval churches in Cyprus

Indoor and outdoor particulate matter (PM_0.3-10) number concentrations were established in two medieval churches in Cyprus. In both churches incense was burnt occasionally during Mass. The highest indoor PM_0.5-1 concentrations compared with outdoors (10.7 times higher) were observed in the church that burning of candles indoors was allowed. Peak indoor black carbon concentration was 6.8 μg m⁻³ in the instances that incense was burning and 13.4 μg m⁻³ in the instances that the candles were burning (outdoor levels ranged between 0.6 and 1.3 μg m⁻³). From the water soluble inorganic components determined in PM₁₀, calcium prevailed in all samples indoors or outdoors, whilst high potassium concentration indoors were a clear marker of combustion. Indoor sources of PM were clearly identified and their emission strengths were estimated via modeling of the results. Indoor estimated PM_0.3-10 mass concentrations exceeded air quality standards for human health protection and for the preservation of works of art.     

Salinity increases mobility of heavy metals in soils

The effect of salinity induced by CaCl₂, MgCl₂, NaCl and Na₂SO₄ on the mobility of Cu, Cd, Pb and Zn was studied. An increase of ionic strength by any salts promoted a higher release of Cd than the others metals. When CaCl₂ and NaCl were applied, Cd and Pb showed the highest degree of mobilization. When MgCl₂ was applied, Cd and Cu were mobilized the most. Finally, an increase of Na₂SO₄ also promoted the strongest mobilization of Cd and Cu.As the total heavy metal content was higher, the percentage of Pb and Cu released upon salinization decreased, indicating that these metals are strongly bound to soil constituents. An increase of carbonates in the soil promoted a higher release of Pb for all used salts and for Zn when MgCl₂ and NaCl were used. This indicates that Pb and Zn are adsorbed on the surface of carbonate crystals. An increase of fine particles promoted a decrease of percentage of released Cd for all salts, indicating that Cd is strongly retained in the fine fractions.The main mechanism regulating Pb and Cd mobility was competition with Ca²⁺ for sorption sites followed for metal chloro-complexation, association between the Cd/Pb-sulfates and competition with Mg²⁺. The main mechanism regulating Cu mobility was the formation of Cu-sulfate, followed by competition with cations (Mg > Ca) and chloride. For Zn, competition with Ca²⁺ for sorption sites was the most important process for its mobility; followed by Zn-sulfate association and, finally, chloride and competition with Mg with the same effect.     

城市垃圾焚烧飞灰特性及水泥固化试验研究

试验分析了重庆市某城市垃圾焚烧发电厂飞灰的化学成分,研究了原飞灰的浸出毒性,考察了水泥对原飞灰和酸洗预处理飞灰中重金属的固化效果. 结果表明:飞灰中重金属Pb和Zn的浸出质量浓度均超过《危险废物浸出毒性鉴别标准》(GB5085.3-2007),因而被认为是危险废物,必须对之进行稳定化处理;酸洗预处理飞灰固化试块的抗压强度得到了一定程度的提高,其重金属Pb和Zn的浸出毒性均较相同配比、相同养护时间的原飞灰固化试块有明显降低;酸洗预处理飞灰固化试块抗压强度随掺入飞灰比例的降低和养护时间的延长而加大,在养护28 d时其抗压强度最高,达4.25 MPa;酸洗预处理飞灰固化试块在养护28 d时,其重金属Pb和Zn的浸出质量浓度分别比原飞灰所制固化试块降低了10.6%～59.0%和7.4%～73.7%.      

氢化物发生-原子荧光光谱法测定废水中砷探讨

砷是对人体有害的元素,当人体每天的摄入量超过100ug或更高时,对人体就会产生严重的危害,而有些工业废水中合有一定量的砷元素,如果这些工业废水不经处理排放到水中会我们的身体造成很大程度的伤害,所以我对某工厂的工业废水进行检测,检测其排放废水中所含有砷元素的多少。火焰原子荧光和石墨炉原子荧光的检测能力无法满足测定的要求,...     

高强度钢纵梁内板的成形性分析

重点对高强度钢纵梁内板的成形性进行了分析,并且在详细分析零件几何特点的基础上,对此模型的圆角半径进行了修改,修改后零件的成形性得到了显著提高。     

Preparation of steel slag porous sound-absorbing material using coal powder as pore former

The aim of the study was to prepare a porous sound-absorbing material using steel slag and fly ash as the main raw material, with coal powder and sodium silicate used as a pore former and binder respectively. The influence of the experimental conditions such as the ratio of fly ash, sintering temperature, sintering time, and porosity regulation on the performance of the porous sound-absorbing material was investigated. The results showed that the specimens prepared by this method had high sound absorption performance and good mechanical properties, and the noise reduction coefficient and compressive strength could reach 0.50 and 6.5 MPa, respectively. The compressive strength increased when the dosage of fly ash and sintering temperature were raised. The noise reduction coefficient decreased with increasing ratio of fly ash and reducing pore former, and first increased and then decreased with the increase of sintering temperature and time. The optimum preparation conditions for the porous sound-absorbing material were a proportion of fly ash of 50% (wt.%), percentage of coal powder of 30% (wt.%), sintering temperature of 1130°C, and sintering time of 6.0 hr, which were determined by analyzing the properties of the sound-absorbing material.     

铝合金LC52对接焊海洋大气应力腐蚀研究

在设计制作的恒载荷大气应力腐蚀试验装置上，进行了铝合金LC52对接焊拉伸试样的海洋大气应力腐蚀试验研究。，对海洋大气应力腐蚀试验中断裂的、加载应力为0.5σ。的试样分析表明．铝合金LC52焊接件在海南海洋大气环境下存在应力腐蚀开裂：Cl^-富集于SCC部分的含钙和／或含硫的第二相质点，促进了应力腐蚀开裂．获得了铝合金LC52焊接的海洋大气SCC失效特征。     

三峡库区滑坡地带岩石特性的研究

针对三峡库区组成滑坡岩层的主要岩石——泥质岩、灰岩、砂岩,通过显微镜观察、X射线分析显微镜的定量分析及室内岩石力学强度试验,对各岩石的特性进行了分析。显微镜及X射线定量分析结果表明风化较弱的泥质岩基本上含有石英与钙质矿物,后者由于易溶于水而导致岩石的孔隙率增加。孔隙的一部分连接形成了裂缝, 从而使岩石的强度下降。各岩石的单轴压缩试验结果表明砂岩的强度最高,发生了风化的泥质砂岩的强度最低。在饱和状态下紫红色泥岩及风化了的泥质砂岩的单轴压缩强度降低最显著,比自然干燥状态下降低了大约50%, 推测是受粘土矿物含量的影响。所有岩石都表现出在峰值强度之前应力与应变几乎呈线性关系,而峰值强度之后应力急剧下降的脆性特征。这种在饱和状态下岩石强度大幅度下降与脆性特征表明在治理滑坡时需要采取十分周密及复杂的预防措施。