出口小家电产品环境适应性试验中常见问题及分析

本文介绍了小家电产品在环境检测中常见的安全问题,分析其通常存在的不符合IEC标准的条款和产生的原因,提出了解决类似问题的措施,从而提高出口小家电产品的安全性能.     

Impact of Human Activities on Carbon Dioxide (CO<Subscript>2</Subscript>) Emissions: A Statistical Analysis

Summary The balance of evidence suggests a perceptible human influence on global ecosystems. Human activities are affecting the global ecosystem, some directly and some indirectly. If researchers could clarify the extent to which specific human activities affect global ecosystems, they would be in a much better position to suggest strategies for mitigating against the worst disturbances. Sophisticated statistical analysis can help in interpreting the influence of specific human activities on global ecosystems more carefully. This study aims at identifying significant or influential human activities (i.e. factors) on CO₂ emissions using statistical analyses. The study was conducted for two cases: (i) developed countries and (ii) developing countries. In developed countries, this study identified three influential human activities for CO₂ emissions: (i) combustion of fossil fuels, (ii) population pressure on natural and terrestrial ecosystems, and (iii) land use change. In developing countries, the significant human activities causing an upsurge of CO₂ emissions are: (i) combustion of fossil fuels, (ii) terrestrial ecosystem strength and (iii) land use change. Among these factors, combustion of fossil fuels is the most influential human activity for CO₂ emissions both in developed and developing countries. Regression analysis based on the factor scores indicated that combustion of fossil fuels has significant positive influence on CO₂ emissions in both developed and developing countries. Terrestrial ecosystem strength has a significant negative influence on CO₂ emissions. Land use change and CO₂ emissions are positively related, although regression analysis showed that the influence of land use change on CO₂ emissions was still insignificant. It is anticipated, from the findings of this study, that CO₂ emissions can be reduced by reducing fossil-fuel consumption and switching to alternative energy sources, preserving exiting forests, planting trees on abandoned and degraded forest lands, or by planting trees by social/agroforestry on agricultural lands.     

废弃混凝土的水热固化与力学强度

为实现废弃混凝土的资源化规模利用,将废弃混凝土回收、粉碎后,掺入适量氢氧化钙(Ca(OH)2)、碱性激发剂(NaOH)和水,经均匀混合、模压成型后,在高温饱和水蒸气环境中转化为具有较高机械强度的块状制品。实验系统考察了原料配比以及反应温度和时间等因素对水热固化样品劈裂抗拉强度(简称劈拉强度)和微观结构的影响。研究结果表明:Ca(OH)2掺量为20%时对于结晶性水化硅酸钙(托勃莫来石相)的形成最为有利,水化产物彼此交织成密实结构,实现了最高的样品力学强度;NaOH的引入可激发废弃混凝土的水热反应活性,但掺量不宜过高;水热反应条件下,样品的劈拉强度随环境温度的升高或反应时间的延长而明显增大,但温度过高、时间过长,会因晶型转变及内部结晶应力等原因而导致样品力学强度降低。     

微波调质对剩余污泥结构及其脱水性能的影响

研究了微波辐射功率及微波时间对剩余污泥脱水特性的影响,测试分析了微波处理后污泥的粒径（d0.5）、分形维数（D3）、絮体强度（FS）、表面相对疏水性（RH）,以及这些参数与污泥脱水性能之间的相关性。结果表明,微波功率为540 W、微波时间为15 s时污泥脱水性能最好,此时d0.5、D3、FS、RH相对原污泥都有明显增大。从多元线性模型拟合结果可知,污泥特性参数d0.5、D3、FS对污泥比阻均有显著影响。     

络合-陶瓷膜耦合技术资源化处理模拟低浓度含铜废水

以聚丙烯酸(PAA)和壳聚糖(CTS)作为络合剂,耦合孔径200 nm的陶瓷膜处理模拟低浓度含铜废水,采用ICP-MS、TOC、SEM表征与Darcy膜污染模型对处理效果和膜污染情况进行表征;对比研究不同络合剂对Cu²⁺截留效果与资源化回用效率的影响;并探讨对应的膜污染机理。结果表明：溶液pH通过影响聚合物络合活性位点对Cu²⁺截留率起决定性作用;在pH=6、P/M≥5或C/M=10的优化条件下,Cu²⁺截留率接近100%;PAA相对于CTS对Cu²⁺的络合效率更高,而CTS具备更好的抗杂质离子干扰能力;酸解、循环回用的PAA与CTS对Cu²⁺截留率稳定在99%以上。膜污染阻力分布计算和SEM、EDX微观表征表明,滤饼污染为膜污染主要形式,CTS更易造成不可逆的膜孔堵塞污染。     

加卸荷条件下岩石力学特性与声发射特征

为了探究真三轴复杂应力变化条件下岩石强度及破坏模式,通过真三轴卸荷扰动测试系统对砂岩试件进行不同第二主应力加卸荷试验,讨论在加卸荷过程中岩石的力学特性及声发射特征。试验结果表明:第二主应力的增加对试件的承载能力起到先增强后弱化的效果;不同第二主应力加卸荷声发射能量及累计振铃计数变化趋势大体一致,耗散能量比在载荷达到岩石损伤强度时突增;声发射能量峰值提前于试件轴向应力跌落,声发射能量和累计振铃计数大幅突增可作为岩石破坏的前兆;在低载荷下岩石中活动主要是裂隙压密与发育,在达到岩石损伤强度后岩石中的活动主要是裂纹贯通形成破裂面,砂岩试件声发射定位点集中区域与试件主要破裂面基本吻合。     

爆破荷载作用下隧道中隔岩稳定性研究

为研究爆破动力荷载作用下隧道中隔岩稳定性评价标准,以福州地铁2号线为工程背景,结合强度折减动力分析法和数值模拟,同时考虑中隔岩塑性区贯通、位移超过规范值、计算不收敛3种判据,综合对隧道中隔岩进行动力安全系数分析,研究隧道不同净距、不同开挖进尺后行洞隧道爆破开挖对隧道整体安全系数的影响。研究结果表明:中隔岩塑性区贯通时特征点位移和规范中位移限值较为接近,可共同作为评价中隔岩稳定性的最终评价标准;隧道净距越大、进尺越小,隧道整体安全系数越高;对围岩质量较差且净距小于1.6 m的双线隧道进行爆破开挖时,建议将爆破进尺控制在2 m以内。研究结果可为类似工程提供理论参考依据。     

多排抗滑桩治理工程的有限元设计计算与优化

在现行计算方法中,通常采用不平衡推力法等传统方法设计抗滑桩.尽管国内外岩土工程技术人员通过研究使传统算法取得了较大的进展,但仍有许多不完善的地方,特别对于多排抗滑桩治理工程的设计计算,传统方法更难胜任,而采用有限元强度折减法则能解决这些问题.通过文中工程实例的设计计算可以看出,由于有限元强度折减法可以充分考虑桩—土之间...     

Echolocation call design and limits on prey size: a case study using the aerial-hawking bat Nyctalus leisleri

The echolocation calls used by Nyctalus leisleri during search phase in open air space are between 9 and 14 ms long, with the peak energy between 24 and 28 kHz. The pulses are shallowly frequency-modulated with or without an initial steep frequency-modulated component. The diet consists primarily of small flies (Diptera), including many chironomids (wingspan 9–12 mm) and yellow dung flies (Scatophaga; wingspan 24 mm), but also of some larger insects such as dung beetles (Coleoptera; Scarabaeoidea), caddis-flies (Trichoptera) and moths (Lepidoptera). The echo target strength of some prey items was measured. Contrary to models based on standard targets such as spheres or disks, the echo strength of real insects was found to be virtually independent of the emitted frequency within the 20–100 kHz frequency range. A model was used to calculate probable detection distances of the prey by the bat. Using narrow-band calls of 13.7 ± 2.7 ms duration, a bat would detect the two smallest size classes of insect at greatest range using calls of 20 kHz. The results may therefore explain why many species of large and medium sized aerial-hawking bats use low-frequency calls and still eat mostly relatively small insects. The data and model challenges the assumption that small prey are unavailable to bats using low-frequency calls.     

高浓度洗毛废水生物降解的研究

根据高浓度洗毛废水的水质特性,选择、驯化出高效污泥和菌株,并对生物降解该废水时的工艺、污泥量、时间三要素进行了深入的研究．结果表明,对于物化处理彻底的废水, Ｈ／ Ｏ 工艺（ 水解／ 好氧工艺） 与好氧工艺处理差异不大;７０ ％ 左右物化效果时, Ｈ／ Ｏ 工艺处理时, Ｃ Ｏ Ｄｃｒ 去除率增加;废水在处理过程中成分变化大,后段水可用筛选优势菌的方法处理．实验室流动模型运行结果为：在原水ρ（ Ｃ Ｏ Ｄｃｒ） １８５４４ ｍｇ／ Ｌ 和设定ｔ Ｈ Ｒ（ 延滞期） 下,混凝后出水ρ（ Ｃ Ｏ Ｄｃｒ） ５３２２ ｍｇ／ Ｌ,水解池出水ρ（ Ｃ Ｏ Ｄｃｒ） ４７６３ ｍｇ／ Ｌ,好氧池出水 Ｃ Ｏ Ｄｃｒ１９９ ．９ ｍｇ／ Ｌ,总 Ｃ Ｏ Ｄｃｒ去除率为９８ ．９ ％