饱和-非饱和介质热-水-应力耦合二维有限元分析

从建立应力平衡方程、水连续性方程、能量守恒方程和弹塑性矩阵开始,使用Galerkin方法,将各控制方程分别在空间域和时间域进行离散,初步开发出了一个用于分析饱和-非饱和介质热-水-应力耦合弹塑性问题的二维有限元程序.通过对一个假定的核废料地下处置的热-水-应力耦合问题进行数值计算,在定性上验证了本程序的正确性.     

液滴撞击超疏水冷表面的反弹/黏附特性对比研究*

为研究液滴撞击超疏水冷表面动力学现象,通过开展去离子水液滴撞击CuO超疏水表面实验,研究表面温度对液滴碰撞后响应方式的影响,分析铺展直径与反弹高度变化规律。结果表明:液滴撞击超疏水冷表面出现反弹与黏附2种响应方式,临界表面温度介于-25 ℃~-20 ℃之间;液滴反弹工况下,表面温度越低,液滴与超疏水冷表面之间接触时间越长,液滴最大反弹高度越小;液滴黏附工况下,随表面温度降低,液滴回缩程度减小,稳定铺展直径增大。研究结果可为表面结冰界面现象与防冰/除冰机理研究提供参考。     

接管高应变区缺陷的安全评定概率方法研究

随着计算机技术飞速发展,Ｍｏｎｔｅ Ｃａｒｌｏ 法在压力容器可靠性分析中得到广泛应用。但对于小概率情形,利用直接抽样的Ｍｏｎｔｅ Ｃａｒｌｏ 法进行失效概率计算,费用较高。为此,笔者提出了几种新的失效概率近似计算方法,并以压力容器接管为例,对其断裂失效概率进行了计算,同时还和直接抽样的Ｍｏｎｔｅ Ｃａｒｌｏ 法的计算数值进行了比较。结果表明,新的失效概率近似计算方法具有精度高、节省机时的优点。     

基于尺度效应的灰岩强度研究

通过水口山康家湾矿采集的岩样,利用岩石力学试验机对不同直径和不同高度的灰岩进行了大量的单轴压缩试验,研究了不同高径比岩样的变形和破坏形式。结果表明:岩石高度对岩石强度峰值以前的变形特性没有显著的影响;当直径一定时,随着长度的增大,岩样的破裂形式由复杂的平行破坏变为剪切破坏。同时指出通过增加垫块的刚度可以减小端面的摩擦效应。同时对由于取样造成的岩样强度降低的原因进行了分析。     

飞机结构表面涂层体系改进研究

针对多型飞机表面涂层体系抗腐蚀性能差这一亟待解决的问题,采用制造状态、大修状态及纳米复合涂层对设计的典型飞机蒙皮对接结构模拟件进行涂装,并利用划格法对涂层体系的层间附着力进行表征。采用加速模拟环境试验的方法,对纳米复合涂层的防腐性能进行考核验证。试验结果表明,纳米复合涂层体系的层间附着力、防腐性能和耐老化性能明显优于制造状态、大修状态涂层体系,在飞机中应用纳米复合涂层可以显著改善结构的抗腐蚀品质。     

Performances of biological aerated filter employing hollow fiber membrane segments of surface-improved poly （sulfone） as biofilm carriers

Using the surface of poly （sulfone） hollow fiber membrane segments as grafted layer, the hydrophilic acrylamide chain was grafted on by UV-photoinduced grafting polymerization. The gained improvement of surface wettability for the modified membrane was tested by measuring the contact-angle as well as FTIR spectra. Then correlation between the hydrophilic ability of support material and the biofilm adherence ability was demonstrated by comparing the pollutant removal rates from urban wastewater via two identical lab-scale up-flow biological aerated filters, one employed the surface wettability modified poly （sulfone） hollow fiber membrane segment as biofilm carder and the other employed unmodified membrane segment as biofilm carder. The experimental results showed that under the conditions of influent flux 5 L/h, hydraulic retention time 9 h and gas to liquid ratio （G/L） 10： 1, the removal rates of chemical oxygen demand （COD） and ammonium nitrogen （NH4^＋-N） for the modified packing filter and the unmodified packing filter was averaged at 83.64% and 96.25%, respectively, with the former filter being 5%-20% more than the latter. The effluent concentration of COD, NH4^＋-N and turbidity for the modified packing filter was 25.25 mg/L, 2 mg/L and 8 NTU, respectively. Moreover, the ammonium nitrogen removal performance of the filter packing the modified PSF was compared with the other bioreactor packing of an efficient floating medium. The biomass test indicated that the modified membrane matrixes provided better specific adhesion （3310-5653 mg TSS/L support）, which gave a mean of 1000 mg TSS/L more than the unmodified membrane did. In addition, the phenomenon of simultaneous denitrification on the inner surface of the support and nitrification on the outer surface was found in this work.     

细菌粘膜对船体表面污损生物附着的影响

细菌粘膜是一个复杂而又可以控制的生态系，它对海中设施有影响，也和大型污损生物的附着有关。本文研究了防污漆表面细菌粘膜的组成，并利用筛选得到的菌株制成人工细菌粘膜验证其对污损生物的附着影响作用，实验结果得到具有抑制作用和促进作用的菌体。     

两亲性壳聚糖制备优化及其气浮除藻研究

对壳聚糖（CTS）进行了两亲改性,通过响应曲面实验对比各因素对取代度影响的显著程度且优选出最佳的制备条件,并采用3种两亲性CTS进行了表面改性气浮（PosiDAF）除藻实验,对比了不同条件下的除藻效果且探究除藻机理.结果表明,两亲性CTS水溶性增强,但热稳定性降低;对响应值影响的显著程度为：碳链长度>反应时间>反应温度>原料投加比;以丁基N-2羟丙基三甲基壳聚糖氯化铵（C4-HTCC）为改性剂,投加量为1.0mg/L时改性气浮除藻效果最佳,可达93.47%,源于其改性的微气泡具有较强的静电吸引作用.     

产朊假丝酵母生物吸附Cu2+影响因素及吸附机理的研究

选取产朊假丝酵母作为生物吸附材料,在确立Cu2 最佳吸附条件的基础上,通过细胞内pH值荧光探测剂测定酵母吸附重金属前后的pH值变化,以及运用phengreen细胞内外重金属荧光探测剂进行重金属分布定位,对酵母生物吸附的机理进行了初步的探讨.实验结果表明,最佳吸附条件为PH 4.49～5.04,[酵母]:[Cu2 ]为60:1;酵母细胞内pH值随吸附时间的增加而有所升高,并由酸性变为弱碱性,与此同时酵母死亡率也随吸附时间的增加而迅速增加;生物吸附主要集中在细胞壁的结合位点上,在细胞内部基本没有;生物吸附过程分为2个步骤,首先是一个快速过程,然后是一个慢速过程,但吸附中出现的慢速过程并不一定代表重金属由细胞外进入细胞内.     

Role of hydrogen bond capacity of solvents in reactions of amines with CO2: A computational study

Various computational methods were employed to investigate the zwitterion formation,a critical step for the reaction of monoethanolamine with CO_2,in five solvents(water,monoethanolamine,propylamine,methanol and chloroform) to probe the effect of hydrogen bond capacity of solvents on the reaction of amine with CO_2 occurring in the amine-based CO_2 capture process.The results indicate that the zwitterion can be formed in all considered solvents except chloroform.For two pairs of solvents(methanol and monoethanolamine,propylamine and chloroform) with similar dielectric constant but different hydrogen bond capacity,the solvents with higher hydrogen bond capacity(monoethanolamine and propylamine) facilitate the zwitterion formation.More importantly,kinetics parameters such as activation free energy for the zwitterion formation are more relevant to the hydrogen bond capacity than to dielectric constant of the considered solvents,clarifying the hydrogen bond capacity could be more important than dielectric constant in determining the kinetics of monoethanolamine with CO_2.