Influence of organic waste type and soil structure on the bacterial filtration rates in unsaturated intact soil columns

Organic wastes are considered to be a source for the potentially pathogenic microorganisms found in surface and sub-surface water resources. Following their release from the organic waste matrix, bacteria often infiltrate into soil and may be transported to significant depths contaminating aquifers. We investigated the influence of soil texture and structure and most importantly the organic waste properties on the transport and filtration coefficients of Escherichia coli and total bacteria in undisturbed soil columns. Intact soil columns (diameter 16 cm and height 25 cm) were collected from two soils: sandy clay loam (SCL) and loamy sand (LS) in Hamadan, western Iran. The cores were amended with cow manure, poultry manure and sewage sludge at a rate of 10 Mg ha(-1) (dry basis). The amended soil cores were leached at a steady-state flux of 4.8 cm h(-1) (i.e. 0.12 of saturated hydraulic conductivity of the SCL) to a total volume of up to 4 times the pore volume of the columns. The influent (C(0)) and effluent (C) were sampled at similar time intervals during the experiments and bacterial concentrations were measured by the plate count method. Cumulative numbers of the leached bacteria, filtration coefficient (lambda(f)), and relative adsorption index (S(R)) were calculated. The preferential pathways and stable structure of the SCL facilitated the rapid transport and early appearance of the bacteria in the effluent. The LS filtered more bacteria when compared with the SCL. The effluent contamination of poultry manure-treated columns was greater than the cow manure- and sewage sludge-treated ones. The difference between cow manure and sewage sludge was negligible. The lambda(f) and S(R) values for E. coli and total bacteria were greater in the LS than in the SCL. This indicates a predominant role for the physical pore-obstruction filtration mechanisms as present in the poorly structured LS vs. the retention at adsorptive sites (chemical filtration) more likely in the better structured SCL. While the results confirmed the significant role of soil structure and preferential (macroporous) pathways, manure type was proven to have a major role in determining the maximum penetration risk of bacteria by governing filtration of bacteria. Thus while the numbers of bacteria in waste may be of significance for shallow aquifers, the type of waste may determine the risk for microbial contamination of deep aquifers.     

Gas/particle partitioning of atmospheric PCDD/Fs in a satellite town in Eastern China

Gas/particle partitioning of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) in ambient air was investigated in a satellite town in Eastern China from April 2007 to January 2008 comprehending large temperature variations (from 3 to 34 °C, daily average). Molecular weight, molecular structure and ambient temperatures are the three major factors that govern the gas/particle partitioning of atmospheric PCDD/Fs throughout the year. Generally, good agreements were obtained (except for winter) between measured particulate fractions and theoretical estimates of both the Junge–Pankow adsorption model and Harner Bidleman absorption model using different sets of subcooled liquid vapor pressure and octanol–air partition coefficient (K_oa), respectively. Models utilizing estimates, derived from gas chromatographic retention indices (GC-RIs), are more accurate than that of entropy-based. Moreover, during winter, the K_oa-based model using the GC-RIs approach performs better on lower chlorinated PCDD/Fs than that of -based. Furthermore, possible sources of mismatch between measured and predicted values in winter (3–7 °C) were discussed. Gas adsorption artifact was demonstrated to be of minor importance for the phenomena observed. On the other hand, large deviations of slopes (m_r) and intercepts (b_r) in logK_p vs. plots from theoretical values are observed in the literature data and these are found to be linearly correlated with ambient temperatures (P<0.001) in this study. This indicates that the non-equilibrium partitioning of PCDD/Fs in winter may be significantly influenced by the colder temperatures that may have slowed down the exchange between gaseous and particulate fractions.     

针铁矿对Pb~(2+)的吸附特征及影响因素研究

通过恒温振荡平衡法研究了Pb~(2+)在针铁矿上的等温吸附和吸附动力学特征,探讨了吸附的影响因素.结果表明:(1)随Pb~(2+)平衡浓度和pH的增大,针铁矿对Pb~(2+)的吸附量逐渐增大.(2)针铁矿对Pb~(2+)的等温吸附可用Freundlich和Langmuir方程较好地拟合.(3)在相同温度和pH下,随离子强度的提高,针铁矿对Pb~(2+)的吸附量增大.(4)在相同离子强度和pH下,针铁矿对Pb~(2+)的吸附量总体随温度升高而增大.针铁矿对Pb~(2+)的吸附是自发进行的吸热反应.(5)针铁矿吸附Pb~(2+)的过程可分为初始的快吸附和随后的慢吸附2个阶段.pH影响吸附反应快慢,随pH增大吸附速率增大;随着pH的增大,达到平衡吸附的时间缩短.吸附动力学方程用Elovich方程拟合最佳.     

沸石改性及其去除水中氨氮的实验研究

通过实验研究了沸石改性条件及其对水中氨氮吸附去除的影响。结果表明,加热改性与无机酸改性不能显著提高沸石对氨氮的吸附量。利用NaOH改性的最佳浓度为1 mol/L,此条件下对氨氮吸附量可提高到650.68 mg/kg,为天然沸石的2.82倍。利用无机盐改性时,对氨氮吸附效果最好的是NaCl改性沸石,其次为KCl改性沸石与CaCl₂改性沸石。随着NaCl溶液浓度和改性时间的增加,改性沸石对氨氮的吸附量显著增加,可达天然沸石的3～4倍;在NaCl浓度为150 g/L与改性时间为18 h条件下,改性沸石对氨氮吸附量可达887.35 mg/kg,为天然沸石的3.84倍。     

铁改性海泡石除锑的影响因素研究

选择廉价海泡石, 用氯化铁对其改性。研究铁改性海泡石对锑的吸附特性。结果表明,氯化铁浓度、吸附时间、初始锑浓度以及温度等因素对锑的吸附影响较大,溶液初始pH影响不明显。在初始锑浓度50 mg/L,pH 6.8,5%氯化铁改性海泡石投加量为2 g/L,吸附90 min, 温度35℃下,吸附量可达21.6 mg/g。海泡石对吸附锑具有缓冲特性,溶液的初始pH值在3.1～10.1范围时,吸附后溶液的最终pH值为8～8.5。IMS吸附锑是放热过程。改性后海泡石比表面积增大,表面羟基数量增加,导致其吸附能力增强。通过XRD谱图并未发现铁晶体的存在。     

板栗壳对重金属Cr（Ⅵ）吸附性能的研究

从废弃的植物材料中筛选出一种Cr(Ⅵ)高效吸附剂——板栗壳。研究了pH、接触时间、板栗壳用量、温度和Cr (Ⅵ)初始浓度对Cr(Ⅵ)吸附活性的影响。结果表明, 板栗壳的最佳pH为2～3。在pH 2时,Cr(Ⅵ)的去除率达99.7%。在15～35℃的温度范围内,板栗壳对Cr(Ⅵ)的去除率随温度的升高而增加。30℃时,Cr(Ⅵ)的去除率可达99%。板栗壳用量对Cr(Ⅵ)的去除有明显影响。由0.2 g增加到0.4 g时, Cr(Ⅵ)的去除率从90.6%提高到99%。在较宽的铬初始浓度范围内,板栗壳对Cr (Ⅵ)有明显的去除作用。     

污水污泥裂解及其性能的研究

以碘吸附值为裂解残渣吸附性能的指标,通过单因素实验和正交实验,确定了制备裂解残渣的最佳工艺条件,并对残渣的表面元素组成、孔结构组成、晶相组成和吸附性能等性质进行了表征。结果显示：以浓度均为5 mol/L的ZnCl₂和H₂SO₄作活化剂、复配比2∶1、活化温度600℃、活化时间1 h、固液比1∶2.5,制得的裂解残渣酸洗后碘值平均值可达892.8 mg/g;用制备的裂解残渣对苯酚废水进行处理,室温下振荡5 min,苯酚去除率即可达到87.9%,且符合Langmuir吸附等温线方程和Freundlich吸附等温线方程。     

三氯生在碳纳米管上的吸附

药品和个人护理用品(PPCPs)已成为一个引起广泛关注的新的环境问题。采用碳纳米管（CNTs）对水溶液中的三氯生进行吸附处理,考察了碳纳米管粒径及用量、温度、pH、振荡时间等因素对三氯生去除率的影响。研究结果表明,碳纳米管能快速吸附水中的三氯生,粒径较小的碳纳米管可获得较高的三氯生去除率;低温有利于吸附反应的进行;pH在6.5～7.0时,三氯生的去除率可达97%。三氯生在碳纳米管上的吸附可以很好地用Langmuir和Freundlich吸附等温方程进行描述。     

木棉基活性炭纤维吸附性能的研究

采用浸渍(NH₄)₂HPO₄化学活化法650℃时制备得到3种新型木棉基活性炭纤维,即只浸渍不预氧化方法处理的AK1(activated kapok),先浸渍后预氧化的AK-2和先预氧化后浸渍的AK-3。利用制备得到的活性炭纤维处理苯酚和亚甲基蓝的模拟废水,AK-2具有苯酚最大吸附量(137.00 mg/g),AK-1具有亚甲基蓝最大吸附量(274.11 mg/g)。吸附苯酚时,在静态平衡实验中,更符合Freundlich吸附等温线;在动力学实验中,更符合准一级反应。吸附亚甲基蓝时,在静态平衡实验中,AK-1更符合Langmuir模型,AK-2 、AK-3更符合Freundlich吸附等温线;在动力学实验中,更符合准二级反应。     

季铵化木屑纤维素的制备及其对水中苯酚的吸附性能研究

以3-氯-2-羟丙基三甲基氯化铵(CTA)为醚化剂,对木屑纤维素进行了改性。探讨了改性木屑纤维素用量、pH值、吸附温度、吸附时间和苯酚初始浓度等因素对静态吸附效果的影响。结果表明,木屑纤维素经改性后,对水中的苯酚的吸附过程存在化学吸附,对水中的苯酚的吸附容量得到明显提高。