Enhanced struvite recovery from wastewater using a novel cone-inserted fluidized bed reactor

The feasibility of struvite recovery at low （12.5 mg/L） and high （120 mg[L） phosphorus concentrations was studied by constructing a novel fluidized bed reactor with cones （FBRwc） and without cones （FBRwoc）. The crystallization process was continuously operated for 133 days under different hydraulic retention times （HRT = 1-10 hr）, pH （7.5-10）, and molar ratios of Mg/P （0.75-1.75）, N/P （1-10） and Ca/Mg （0-2）. The optimum operating conditions of HRT, pH, Mg/P and N/P molar ratios were found to be 2 hr, 9, 1.25, and 7.5, respectively. Under these optimum conditions, the phosphorus precipitation efficiencies of FBRwc were 93% for low and 98% for high phosphorus influent; however, the efficiencies were 78% and 81% for FBRwoc, respectively. Due to crystal losses at each junction （17%-31%）, the crystal recovery efficiency of FBRwoc was relatively low （47%-65%） for both influent concentrations. However, the losses were minimal in FBRwc, which showed 75% and 92% crystal recovery for low and high phosphorus concentrations, respectively. At low calcium concentration, crystal chemical analysis showed the product to be pure struvite （〉 99%）. The scanning electron microscope and X-ray diffraction results further confirmed that the crystal recovered from FBRwc contained pure struvite, which could be considered a high quality fertilizer. Except HRT, all parameters （pH, Mg/P, N/P and Ca/Mg） were found to be influencing factors for FBRwc performance. Overall, inserting cones in each part of the reactor played a significant role in enhancing struvite recovery from a wide range of phosphorus-containing wastewater.     

Turbosorp湍流吸收循环流化床烟气脱硫技术在改造工程中的应用

循环流化床半干法烟气脱硫技术是目前世界上主流脱硫工艺技术之一,主要适用于大中型燃煤电厂的烟气脱硫,在国内外拥有大量成功运行的工程案例。本文章基于本公司实践论述Turbosorp湍流吸收循环流化床脱硫技术的技术特点、关键工艺控制要点以及在机组改造工程中的技术优势,为同类型机组改造工程中的方案选择提供参考。     

Emissions of SO2, NO and N2O in a circulating fluidized bed combustor during co-firing coal and biomass

This paper presents the experimental investigations of the emissions of SO2, NO and N2O in a bench scale circulating fluidized bed combustor for coal combustion and co-firing coal and biomass. The thermal capacity of the combustor is 30 kW. The setup is electrically heated during startup. The influence of the excess air, the degree of the air staging, the biomass share and the feeding position of the fuels on the emissions of SO2, NO and N2O were studied. The results showed that an increase in the biomass shares resulted in an increase of the CO concentration in the flue gas, probably due to the high volatile content of the biomass. In co-firing, the emission of SO2 increased with increasing biomass share slightly, however, non-linear increase relationship between SO2 emission and fuel sulfur content was observed. Air staging significantly decreased the NO emission without raising the SO2 level. Although the change of the fuel feeding position from riser to downer resulted in a decrease in the NO emission level, no obvious change was observed for the SO2 level. Taking the coal feeding position R as a reference, the relative NO emission could significantly decrease during co-firing coal and biomass when feeding fuel at position D and keeping the first stage stoichiometry greater than 0.95. The possible mechanisms of the sulfur and nitrogen chemistry at these conditions were discussed and the ways of simultaneous reduction of SO2, NO and N2O were proposed.     

曝气调节-水解酸化-生物接触氧化工艺处理城镇生活污水

介绍了采用曝气调节-水解酸化-两级生物接触氧化为主的工艺处理城镇生活污水的工程实例。经过调试运行,污水处理系统运行稳定,工艺运行成本低,污染物处理效果好。其中COD、BOD5、SS与氨氮去除率均在85%以上,出水水质优于GB 8978-1996《污水综合排放标准》一级排放标准。     

循环式活性污泥法中厌氧生物选择区的运行条件研究

研究了循环式活性污泥法中厌氧生物选择区的停留时间、进水有机物浓度和系统中泥龄、曝气时间等运行参数对选择区内厌氧释磷以及有机物的吸收贮存的影响。结果表明，选择区停留时间lh，系统泥龄5d，曝气2h，进水有机物浓度COD／TP=60--70，选择器中释磷效果及微生物的吸附性能最优，可去除进水中78％的COD。而且污泥沉降性能良好，试验运行过程中，SVI一直保持在30--40ml／g左右。     

生物监测及其在水环境污染防治中的应用进展研究

环境是人类生存的载体,是保证人类可持续发展的重要因素.因此,对环境中污染因子的监测也越来越重要.而生物监测是一种新型的监测技术,被认为是未来监测技术的重要方法,但由于其方法本身、技术的原因, 限制了其应用..随着水环境污染状况的日益加剧,对水体环境的监测以及水体安全的及时预警响应要求极为迫切,水环境生物监测是环境监测的重要内容.对生物监测技术在水环境中的应用进行了论述,并从技术、方法、应用等角度进行了具体分析,并对应用技术进行了总结.最后对生物监测技术的前景进行了展望.     

一株好氧反硝化菌的反硝化性能研究

从长期运行的生物滤塔中筛选出一株好氧反硝化菌株A1,经鉴定为恶臭假单胞菌Pseudomonas putida。文章目的是对A1的反硝化特性进行研究,结果表明A1菌株在好氧条件下能有效去除培养液中的硝酸盐氮,24h脱氮率可达到94.84%。C/N对菌株A1的好氧反硝化能力有很大影响,当C/N>5时,基本能够进行完全的反硝化。和其他已报道的好氧反硝化菌相比,A1菌株有着更高的氧耐受浓度。菌株A1能够以硝酸盐或亚硝酸盐和氧气为电子受体进行协同呼吸,硝酸盐呼吸和亚硝酸盐呼吸都具有较高的脱氮效率,并且亚硝酸盐呼吸要较硝酸盐呼吸更容易进行。以丁二酸盐、葡萄糖和乙酸盐作为碳源时,其脱氮效果均要明显好于乙醇作为碳源。     

BAC生物活性炭法及其在水处理中的应用

介绍了生物活性炭(BAC)法去除有机物的方式,不同进水水质条件下的特征穿透曲线。总结了BAC法的优缺点以及国、内外对BAC生物再生的研究与观点,以及BAC技术的研究与应用进展。     

生物流化床短程硝化的快速启动及影响因素研究

采用内循环生物流化床反应器处理模拟高浓度氨氮废水,以确定其对处理高浓度氨氮废水的可行性,同时对试验条件进行了优化。结果研究表明:控制温度为(31±1)℃,利用反应器自身流化所携带溶解的空气,反应器内DO值可维持在1.5~2.5 mg/L,调节pH为8.0~8.5。经过42 d的污泥驯化适应时期,进水氨氮(NH4+-N)浓度由50 mg/L提高到300 mg/L。由于流化床采用填料载体微生物膜与活性污泥双重作用,同时载体呈流化状态,接触均匀,有巨大的比表面积,可以使床内保持高浓度的生物量,从而达到高效快速的传质效果。在HRT由开始的16 h缩短到8 h的条件下,氨氮(NH4+-N)的去除率达到90%以上,亚硝氮(NO2--N)的积累率达到75%。且在以后30 d的稳定运行阶段,氨氮(NH4+-N)去除率和亚硝氮(NO2--N)积累率均保持稳定。同时反应器最后出水水质澄清,无需二沉池及污泥处理。     

BAF去除氨氮关键影响因素研究

为探讨曝气生物滤池去除氨氮的关键因素,选取沈阳仙女河污水处理厂(40万t/d)现场进行实地研究。通过测定不同条件下(pH、进水COD浓度、溶解氧、温度、水力负荷)的氨氮去除率,并进行主成分分析结果显示,影响BAF工艺脱氮的关键因素是温度、溶解氧和水力负荷。当温度在14~30℃之间时,氨氮的去除率一直维持较高,当温度低于14℃时,氨氮的去除率较低;随着溶解氧浓度的增大,氨氮的去除率也随之升高,当溶解氧增加到5.6 mg/L时,氨氮的去除率达到80%~90%,接近饱和状态;在水力负荷为3.08~4.15 m3/(m.2h)之间时,氨氮的去除率上升,超过该值,则氨氮去除率下降。