曝气强度对AOA膜生物反应器脱氮除磷性能的影响

考察了曝气强度为2.5、3.75和5.0 m3.（m2.h）-1条件下,厌氧/好氧/缺氧序批式膜生物反应器（AOA MBR）对模拟生活污水同时脱氮除磷性能的影响.结果表明,曝气强度对AOA MBR中COD的去除无显著影响,去除效率均在90%以上.氨氮的去除效果随着曝气强度的增加而提高,3个曝气强度下的平均去除率分别为8...     

Effect of artificial aeration on the performance of vertical-flow constructed wetland treating heavily polluted river water

Three lab-scale vertical-flow constructed wetlands (VFCWs), including the non-aerated (NA), intermittently aerated (IA) and continuously aerated (CA) ones, were operated at different hydraulic loading rates (HLRs) to evaluate the effect of artificial aeration on the treatment efficiency of heavily polluted river water. Results indicated that artificial aeration increased the dissolved oxygen (DO) concentrations in IA and CA, which significantly favored the removal of organic matter and NH₄⁺-N. The DO grads caused by intermittent aeration formed aerobic and anoxic regions in IA and thus promoted the removal of total nitrogen (TN). Although the removal efficiencies of COD_Cr, NH₄⁺-N and TN in the three VFCWs all decreased with an increase in HLR, artificial aeration enhanced the reactor resistance to the fluctuation of pollutant loadings. The maximal removal efficiencies of COD_Cr, NH₄⁺-N and total phosphorus (TP) (i.e., 81%, 87% and 37%, respectively) were observed in CA at 19 cm/day HLR, while the maximal TN removal (i.e., 57%) was achieved in IA. Although the improvement of artificial aeration on TP removal was limited, this study has demonstrated the feasibility of applying artificial aeration to VFCWs treating polluted river water, particularly at a high HLR.     

城市滞流河道黑臭发生及控制研究

为了研究常州市老城区典型河道—北市河的黑臭现象发生原因,采用自主研发的一套滞流型河道沉积物污染释放与抑制装置,通过综合黑臭指数分析表明黑臭现象的发生耗时很长,由此推断导致水体黑臭发生的主要原因是外源污染物的排入。此外还从曝气深度和净化剂2个方面出发,研究其对黑臭的控制作用。在实验装置中选定距表面50 cm、100 cm、150 cm 3个深度,采用间歇纯氧曝气方式对水体进行处理,水质变化情况表明采用100 cm深度进行曝气对水体黑臭的控制效果最好。在净化剂比选实验中,在实验柱中分别投加商品钝化剂、过氧化氢、过氧化钙,并设置空白对照实验,监测水质参数随时间的变化情况,采用层次分析法进行净化剂的优选,分析结果表明过氧化钙的净化效果最好。     

The study of production and inventory policy of manufacturing/remanufacturing environment in a closed-loop supply chain

The life cycle of electronic and electrical equipment has been ruthlessly shortened due to the rapid promotion of new products. Such a phenomenon has thereby resulted in serious environmental pollution and damages to the natural ecology. In order to reduce electronic wastes and increase recycling products, a manufacturing/remanufacturing simulation model was constructed through a series of inventory management policies. The model included the use of the traditional supply chain structures for the forward movement of goods to consumers, as well as a number of specialised operations required to perform reverse supply chain activities. Such a model took into account all the supply chain members such as the suppliers, manufacturers, logistics centres and customers at the same time. Finally, a case study on the application of the model was conducted.     

铁炭曝气微电解对炸药废水的试验研究

采用铁炭曝气微电解对炸药废水进行预处理,处理结果表明:当炸药废水调节pH值为2,反应时间2h,物质A投加量2g/L,铁屑与活性炭体积比为1∶1时,进水TOC为2600mg/L,COD为2500mg/L,NH3-N为190mg/L,出水TOC为250mg/L,COD为400mg/L,NH3-N为20mg/L,去除率分别为90.5%、82%和89.6%,BOD5/COD由0.16提高到0.38。     

化学预处理与生化组合处理兰炭生产污水

通过现场中试实验对曝气微电解、强化混凝、催化电氧化作预处理提高兰炭污水的可生化性进行了探讨.并对通过预处理与生化处理的组合实现兰炭污水达到污水排放标准的可行性进行了研究.结果表明,原水首先调节pH值为3左右,在通过120min的曝气微电解处理后,可使有机物由25000mg/L下降到10000mg/L,氨氮由3000mg/L降到1200mg/L,COD和NH3-N的去除均可达到60%;然后调节曝气微电解出水的pH值为8~9,通过投加200mg/L PAC、4.5mg/L PAM强化混凝后,出水COD和NH3-N可去除50%;强化混凝后出水再通过120 min的催化电氧化反应器的高级氧化处理,废水中COD去除率可达65%,NH3-N去除率为60%;催化电氧化反应器出水最后通过厌氧/好氧生物接触处理,其出水COD<150mg/L,NH3-N<25 mg/L.     

气泡尺寸对曝气池内气液两相流数值模拟的影响

为探索在曝气池气液两相流数值模拟中气泡尺寸对两相流流动特性的影响,采用大涡模拟和欧拉－拉格朗日方法建立了曝气池两相流数学模型.基于模型实验得到的工程上常用的微孔曝气盘的气泡尺寸分布,在数值模拟中设定了3种气泡尺寸分布方案,比较了不同的气泡尺寸设定方案对计算曝气池内水流流速和气含率等参数的影响.结果表明,气泡尺寸对水流流场具有较大的影响,而对气含率分布的影响在大部分区域不明显,只在气含率峰值附近影响较显著;使用多组气泡尺寸的设定方案可以提高计算结果的准确性,采用单组气泡尺寸时应尽量使其接近平均气泡直径.     

微污染水体夜间曝气控藻效果研究

设计和开发了一种适用于小城镇的曝气控藻设备,通过底泥围隔实验,研究了夜间曝气对微污染水体的治理效果。结果表明:曝气可以有效抑制氮素循环中反硝化作用和底泥向上覆水中释放磷元素,对氮、磷营养元素的抑制率高达80%;曝气对叶绿素a浓度影响极其显著(p<0.01);曝气能有效抑制藻类增长,并防止围隔内的藻类优势种转变为容易引发"水华"的铜绿微囊藻(Microcystis aeruginosa)。     

生活垃圾填埋短期好氧预处理工艺优化研究

以模拟有机生活垃圾为底物,通过实验研究了通风和温度协同控制作用下,填埋短期好氧预处理过程垃圾VS、含水率和有机组分的代谢情况.结果表明,好氧预处理过程VS降解主要发生在反应前期(0~6d),占实验全过程降解量的68%~85%;同时垃圾含水量的15%~26%以渗滤液和气体的形式被去除,并且延长通风时间能够增加后者所占比例.反应前期堆体自发升温到高温状态(50~55℃)比控制堆体温度维持在中温状态(42~47℃)更利于碳水化合物的代谢,但对粗蛋白降解的影响不明显.而在中温状态下粗脂肪和木质纤维素的降解率更高.继续延长预处理时间至14d,不同通风和温度的组合对VS和水分总体去除差距不大.控制填埋好氧预处理周期在6d并尽量维持堆体温度在50~55℃,成本-效益较高.     

臭氧接触池臭氧投加方式的优化

臭氧接触池内臭氧(O₃)投加方式是影响臭氧接触池反应效率的关键因素. 以密云水库水为处理对象,对臭氧接触池内臭氧投加方式进行优化,通过考察气液接触方式和投加点个数对ρ(O₃)、传质效率及有机物去除率的影响,确定最优臭氧投加方式. 结果表明,适当增加布气点个数可有效增强气液传质,提高有机物去除率,但当布气点个数高于3个时,臭氧传质效率无明显提升,而且造成出水ρ(O₃)过高,不利于后续工艺的进行. 采用三段式臭氧投加方式,臭氧投加比为3∶3∶1时,密云水库水中臭氧传质效率达78.1%,有机物去除率为47.5%; 向密云水库水中添加3mg/L腐殖酸后,该投加比下臭氧传质效率为76.8%,有机物去除率为40.3%,出水ρ(O₃)为0.26mg/L,不会对后续工艺产生影响;并且该条件下臭氧利用率最高,BrO₃-生成量最低,为最佳臭氧投加比.