生物膜填料塔SO2废气净化性能研究

采用生物膜填料塔净化SO2废气,研究结果表明:当气体流量从100L/h增加到300L/h时,SO2净化效率由86.4%下降到73.2%;生化去除量随着入口SO2气体浓度的升高而增大;随着温度的升高,SO2净化效率和生化去除量都随之提高,且20℃以上时,净化效率可达90.9%以上,生化去除量可达75 mg/L·h以上,更利于微生物降解SO2.     

The effects of leachate recirculation with supplemental water addition on methane production and waste decomposition in a simulated tropical landfill

In order to increase methane production efficiency, leachate recirculation is applied in landfills to increase moisture content and circulate organic matter back into the landfill cell. In the case of tropical landfills, where high temperature and evaporation occurs, leachate recirculation may not be enough to maintain the moisture content, therefore supplemental water addition into the cell is an option that could help stabilize moisture levels as well as stimulate biological activity. The objectives of this study were to determine the effects of leachate recirculation and supplemental water addition on municipal solid waste decomposition and methane production in three anaerobic digestion reactors. Anaerobic digestion with leachate recirculation and supplemental water addition showed the highest performance in terms of cumulative methane production and the stabilization period time required. It produced an accumulated methane production of 54.87 l/kg dry weight of MSW at an average rate of 0.58 l/kg dry weight/d and reached the stabilization phase on day 180. The leachate recirculation reactor provided 17.04 l/kg dry weight at a rate of 0.14l/kg dry weight/d and reached the stabilization phase on day 290. The control reactor provided 9.02 l/kg dry weight at a rate of 0.10 l/kg dry weight/d, and reached the stabilization phase on day 270. Increasing the organic loading rate (OLR) after the waste had reached the stabilization phase made it possible to increase the methane content of the gas, the methane production rate, and the COD removal. Comparison of the reactors' efficiencies at maximum OLR (5 kgCOD/m(3)/d) in terms of the methane production rate showed that the reactor using leachate recirculation with supplemental water addition still gave the highest performance (1.56 l/kg dry weight/d), whereas the leachate recirculation reactor and the control reactor provided 0.69 l/kg dry weight/d and 0.43 l/kg dry weight/d, respectively. However, when considering methane composition (average 63.09%) and COD removal (average 90.60%), slight differences were found among these three reactors.     

利用废渣盐石膏制作轻型墙体材料

研究利用海盐化工产生的废渣盐石膏经过一定工艺处理,生产轻型墙体材料盐石膏空心条板,该产品与天然石膏空心条板相比,原料采用及生产工艺都有较大改进,生产成本却大幅度下降。经测试,该产品完全可替代天然石膏空心条板,技术性能指标达到了国家规定的相关标准。     

UASB法处理城市生活垃圾焚烧场渗滤液

垃圾焚烧场的渗滤液具有pH低、污染成分复杂、COD_(Cr)浓度高、可生化性好等特点。本研究探索了UASB法处理焚烧场渗滤液时的快速启动方法,考察了水力停留时间、容积负荷对COD_(Cr)去除率的影响及产气量与COD_(Cr)去除率的关系,结果表明,在水力停留时间6d、容积负荷5kg/(m3.d)的情况下,COD_(Cr)去除率可达到93%,每升原水产气量可达22.5L,折合热值492.7kJ。     

废弃物燃烧生成的可吸入颗粒物中多环芳烃的排放特性

将木粉、谷壳、甘蔗渣、垃圾衍生燃料(RDF)四种废弃物在两种过量空气系数下进行燃烧,采集其烟气中的可吸入颗粒物(PM10)样品并分析,获得了颗粒物中多环芳烃的质量分数和排放特性,并对不同环数的芳烃进行了比较,最后分析了不同样品中的多环芳烃的毒性参数.     

pH值与乙酸对易腐有机垃圾水解过程的抑制

通过外部添加水解酶比较和区分pH值和乙酸对水解的影响,结果表明:以固相挥发性固体和元素碳的减少以及液相有机碳的增加表征水解率,在pH=7时最大,144h的水解率可达66.9%;与pH=7相比,pH=8-9时,水解率降低8%-24%;pH=5-6,水解率降低40%-60%.20g·l-1乙酸的加入抑制了水解,在不同pH值条件下与不添加乙酸的水解相比,抑制程度为2%-35%,pH=7时乙酸的抑制最显著,可达35%.颗粒态物料的水解过程动力学符合Chen-Hashimoto公式.     

Fe-pillared clay as a Fenton-type heterogeneous catalyst for cinnamic acid degradation

Fe-pillared montmorillonite has been used as a Fenton-type heterogeneous catalyst for the removal of cinnamic acid in water. The influences of the cinnamic acid, catalyst and H2O2 concentrations and pH on the removal rate of cinnamic acid have been studied. The results show that the efficiency of Fe-pillared montmorillonite is higher than that of the Fe ions in the homogeneous phase, and less sensitive to pH.     

废轮胎流化床气化特性试验研究

为了掌握废轮胎在流化床内的气化特性,利用自行设计的小型流化床试验装置系统,对废轮胎在不同的过量空气系数下在400～700℃温度范围内进行了空气气化实验.分析了废轮胎气化效率、固定碳转化率、气化气热值、产气量以及气化气成分随气化温度、过量空气系数的变化规律.结果表明,废轮胎气化的最佳运行条件为气化初始温度700℃,过量空气系数α=0.4.在此条件下得到的气化气成分主要包括CH₄、CO、H₂、C₂H₆和高分子有机化合物,此时的气化效率为47.96%,气化气低位热值为4 804kJ/m³.     

城市有机垃圾间歇厌氧消化pH控制动力学研究

对厌氧消化系统的物料及电离平衡进行分析,利用底物降解和微生物生长动力学建立城市有机垃圾间歇厌氧消化pH值控制模型,并研制开发了间歇厌氧消化过程pH值与产气量最优化计算机软件.运用该模型可预测不同厌氧消化过程的最佳pH值,从而通过控制厌氧系统的pH值使系统产气量达到最大,通过2组对比实验验证模型的有效性.结果表明,在相同的实验条件下厌氧系统的pH控制在最佳值时系统产气较未对pH值控制时稳定,且总产气量平均提高20%左右.     

再生聚丙烯的洁净化和高质化应用

聚丙烯以其优异的机械性能、高的性价比和多重改性方式成为重要的通用树脂之一,这些产品废弃后产生了种类繁多和数量巨大的再生聚丙烯.通过将再生聚丙烯根据性能和来源进行分类,然后分类阐述各再生聚丙烯物料特点,结合再生聚丙烯改性方式,为高质化应用提出方向.