沈大高速公路沿线气象因子特征研究

选用沈大高速公路沿线 7个气象台站 195 5～ 1995年的累年气象要素值 ,通过对影响高速公路运行和车辆尾气污染物排放、扩散相关的气象因子分析 ,为今后的高速公路建设和沈大高速公路管理 ,提供较科学的依据。     

催化湿式氧化处理H—酸溶液的反应动力学

两阶段一级反应动力学模型和广义动力学模型被用来描述湿式氧化（ＷＡＯ）及催化湿式氧化（ＣＷＡＯ）反应过程，并确定了动力学参数。２个模型的计算值均与实验值相符，而广义动力学模型相对现准确些。２个确定均表明反尖分２个步骤：首先是Ｈ－酸被迅速氧化成小分子有机酸，后者再缓慢氧化，这２个步骤由模型参数加以表征，因而模型可被用来对ＣＷＡＯ催化剂进行评价。     

焦化废水专用混凝剂对污染物的去除效果与规律

通过烧杯搅拌实验得出了焦化废水专用混凝剂对废水中的 COD_Cr、色度、F^-和总 CN^- 等主要污染物的去除情况随投加量和混凝 pH值变化的规律 ,给出了最佳投加量、最佳混凝 pH范围等操作参数 ,并通过现场混凝模拟实验考察了混凝处理效果对废水水质波动的承受能力 .结果表明 ,在最佳有效投加量 300 mg/L和混凝 pH值为 6.0～ 6.5的操作条件下 ,专用混凝剂对各污染物都有良好的去除效果 ,且受进水水质波动的影响很小 .     

大气污染物垂直梯度自动监测系统的研制

设计的大气污染物垂直梯度自动监测系统是用 2个电磁阀实现 3个高度的气体采样 ,依靠分析仪器自身的抽气泵将气体样品通过聚四氟乙烯管抽入各分析仪器进行测量 ,并用一台微机和一块 AD/DA转换板实施对电磁阀的控制和数据采集 .现场观测实验表明 ,对于 25m长的采样管清洗时间可设置 1 min,而采样管长度间的差异不会导致测量 O₃、SO₂、NO和 NO₂ 小时平均浓度存在显著性差异 .     

兰州城市大气污染和可能的技术控制措施

利用大气污染源和环境监测等资料,计算分析了兰州市区大气污染及其治理现状。结果表明,在兰州市区,燃煤占全部能源的71 %; S02年排放量为5. 96万t,烟尘为6. 54万t ;汽车尾气己成为主要大气污染源之一。市区S02浓度日均值在采暖期超标,而TSP一年四季都超 标。指出采用以集中供热、煤气、型煤和控制汽车尾气为主要措施,兼顾绿化和太阳能利用,制定市区大气污染治理方案比较合理。      

Risk-Based Prioritization of Air Pollution Monitoring Using Fuzzy Synthetic Evaluation Technique

Air pollution monitoring programs aim to monitor pollutants and their probable adverse effects at various locations over concerned area. Either sensitivity of receptors/location or concentration of pollutants is used for prioritizing the monitoring locations. The exposure-based approach prioritizes the monitoring locations based on population density and/or location sensitivity. The hazard-based approach prioritizes the monitoring locations using intensity (concentrations) of air pollutants at various locations. Exposure and hazard-based approaches focus on frequency (probability of occurrence) and potential hazard (consequence of damage), respectively. Adverse effects should be measured only if receptors are exposed to these air pollutants. The existing methods of monitoring location prioritization do not consider both factors (hazard and exposure) at a time. Towards this, a risk-based approach has been proposed which combines both factors: exposure frequency (probability of occurrence/exposure) and potential hazard (consequence).This paper discusses the use of fuzzy synthetic evaluation technique in risk computation and prioritization of air pollution monitoring locations. To demonstrate the application, common air pollutants like CO, NO_x, PM₁₀ and SO_x are used as hazard parameters. Fuzzy evaluation matrices for hazard parameters are established for different locations in the area. Similarly, fuzzy evaluation matrices for exposure parameters: population density, location and population sensitivity are also developed. Subsequently, fuzzy risk is determined at these locations using fuzzy compositional rules. Finally, these locations are prioritized based on defuzzified risk (crisp value of risk, defined as risk score) and the five most important monitoring locations are identified (out of 35 potential locations). These locations differ from the existing monitoring locations.     

An Assessment on Variation of Sulphur Dioxide and Particulate Matter in Erzurum (Turkey)

Sulphur dioxide and PM₁₀ levels are investigated in Erzurum during the periods of 1990–2000 heating season to assess air pollution level. For that reason, emissions of sulphur dioxide and particulate matter were calculated by using consumption of fuels and Turkish emission factors. These emission values were evaluated together with air pollution levels, which were measured at six stations in Erzurum atmosphere during 1990–2000 winter periods. Results reveal that in 1990–1994 heating period, there is an increasing trend in the emissions and air pollution levels over Erzurum, and the air quality limits were not met. The daily 24 h limit (short-term limit) was exceeded 127 days in 1992–1993 winter period. The reason for this increase was found to be the switching to use of low-quality fossil fuels instead of cleaner ones. Results also indicated that there was a considerable decrease in emissions of air pollutants and air pollution levels after 1995. This can be explained by the consumption of more high-quality fossil fuels. The correlation coefficient of SO₂ with PM₁₀ is obtained as r² = 0.85, which is a high value supporting the idea that both pollutants are emitted from the same source.     

Measurements of Ozone Concentrations in Zagreb

Ozone concentrations were measured in Zagreb at four sites from May 1999 to April 2001 in order to categorize the air quality with respect to ozone. In the summer of 2000, the ozone measurements were also extended to four sites in the suburbs of Zagreb. Methods of active and passive sampling with nitrite ion as a reagent were used. In the northern part of the town ozone was analyzed by an automatic device. Automatic device measurements in the years 1999 and 2000 showed that hourly averages of ozone concentrations did not exceed the Croatian recommended value of the 98th percentile (180 g m^–3). Over the two-year period, 24-h averages occasionally exceed 110 g m^–3 in city center and in the northern part of the town. Regardless of these isolated examples, ozone was well within acceptable concentrations. Ozone concentrations measured in summer 2000 were higher in the suburbs of Zagreb than in the city. The 98th percentile values higher than 110 g m^–3 were recorded at three sites.     

Air Pollution and Heat Exposure Study in the Workplace in a Glass Manufacturing Unit in India

Air pollution in the workplace environment due to industrial operation have been found to cause serious occupational health hazard. Similarly, heat stress is still most neglected occupational hazard in the tropical and subtropical countries like India. The hot climate augments the heat exposure close to sources like furnaces. In this study an attempt is made to assess air pollution and heat exposure levels to workers in the workplace environment in glass manufacturing unit located in the State of Gujarat, India. Samples for workplace air quality were collected for SPM, SO₂, NO₂ and CO₂ at eight locations. Results of workplace air quality showed 8-hourly average concentrations of SPM: 165–9118 μg/m³, SO₂: 6–9 μg/m³ and NO₂: 5–42 μg/m³, which were below the threshold limit values of workplace environment. The level of CO₂ in workplace air of the plant was found to be in the range 827–2886 μg/m³, which was below TLV but much higher than the normal concentration for CO₂ in the air (585 mg/m³). Indoor heat exposure was studied near the furnace and at various locations in an industrial complex for glass manufacturing. The heat exposure parameters including the air temperature, the wet bulb temperature, and the globe parameters were measured. The Wet Bulb Globe Temperature (WBGT), an indicator of heat, exceeded ACGIH TLVs limits most of the time at all the locations in workplace areas. The recommended duration of work and rest have also been estimated.     

城市大气中颗粒物的研究现状及健康效应

综述了大气尘(TSP、PM10、PM2.5)的研究现状,重点围绕TSP、PM10、PM2.5的物理特征、化学组成(有机组成、重金属元素的总含量及其各化学形态分布)及其源解析进行描述,也提及了大气颗粒物与健康的关系.