亚甲蓝湿式氧化影响因素研究

以湿式氧化技术对亚甲蓝水溶液进行处理,用水样COD去除率评价处理效果.考察了反应时间、温度、氧分压、搅拌速度、进水pH值以及进水浓度对处理效果的影响,并进行机理分析.实验确定的最佳操作工艺条件为:反应温度210℃、氧分压2.0 MPa、搅拌速度880 r/min、进水pH=11.30.在此条件下,COD为2 000mg/L的亚甲蓝水溶液,反应90min时COD去除率达93.2%.     

利用高温废气治理焦化酚氰污水项目实践

阐述了利用焦炉、窑炉、电厂等高温废气处理焦化污水的理论及工业实践,该工艺具有投资省、运行费用低的突出优点.     

气浮+生物接触氧化工艺处理食品加工废水

通过气浮 生物接触氧化工艺处理速冻食品加工废水的实验、设计和工程运行,结果表明:废水COD去除率能达到97%以上,使得最终出水的COD＜100mg/l.该工艺对冲击负荷有较强的适应性.     

多相催化湿式氧化法处理高浓度难降解有机废水的研究

在高压反应釜内，采用自制颗粒贵金属催化剂催化湿式氧化法处理高浓度饲料抗氧化剂合成废水，探讨了温度、压力、进水pH等反应条件对废水处理效果的影响。在温度为220℃、总压为8MPa条件下，COD，TOC，TN和色度的去除率分别达到77．0％，66．1％，70．2％，91％；处理后的废水pH很低，催化剂显示出较好的耐酸性；随进水pH的增加，COD的去除率逐渐降低，出水pH增加。     

ACCURACY OF LAKE AND STREAM TEMPERATURES ESTIMATED FROM THERMAL INFRARED IMAGES1

Emitted thermal infrared radiation (TIR, λ= 8 to 14 μm) can be used to measure surface water temperatures (top approximately 100 μm). This study evaluates the accuracy of stream (50 to 500 m wide) and lake (300 to 5,000 m wide) radiant temperatures (15 to 22°C) derived from airborne (MASTER, 5 to 15 m) and satellite (ASTER 90 m, Landsat ETM+ 60 m) TIR images. Applied atmospheric compensations changed water temperatures by ?0.2 to +2.0°C. Atmospheric compensation depended primarily on atmospheric water vapor and temperature, sensor viewing geometry, and water temperature. Agreement between multiple TIR bands (MASTER ‐ 10 bands, ASTER ‐ 5 bands) provided an independent check on recovered temperatures. Compensations improved agreement between image and in situ surface temperatures (from 2.0 to 1.1°C average deviation); however, compensations did not improve agreement between river image temperatures and loggers installed at the stream bed (from 0.6 to 1.6°C average deviation). Analysis of field temperatures suggests that vertical thermal stratification may have caused a systematic difference between instream gage temperatures and corrected image temperatures. As a result, agreement between image temperatures and instream temperatures did not imply that accurate TIR temperatures were recovered. Based on these analyses, practical accuracies for corrected TIR lake and stream surface temperatures are around 1°C.     

Effects of particle thermal characteristics on flame microstructures during dust explosions of three long-chain monobasic alcohols in a half-closed chamber

To reveal clearly the effects of particle thermal characteristics on flame microstructures during organic dust explosions, three long-chain monobasic alcohols, solid at room temperature and similar in physical-chemical properties, were chosen to conduct experiments in a half-closed chamber. In the experiments, the dust materials were dispersed into the chamber by air to form dust clouds and the hybrids were ignited by an electrical spark. A high-speed optical schlieren system was used to record the flame propagation behaviors. A fine thermocouple and an ion current probe were respectively used to measure the flame temperature profile and the reaction behaviors of the combustion zone. Based on the experimental results, combustion behaviors and flame microstructures in dust clouds with different thermal characteristics were analyzed in detail. As a result, it was found that the dust flame surfaces were completely covered by cellular structures that significantly increased the flame frontal areas. Flame propagated more quickly and the number of the cellular cells increased as increasing the volatility of the particles. On the contrary, maximum temperature and the thickness of the preheated zone decreased as increasing the volatility of the particles. According to the ion current profile, the particles in the preheat zone were pyrolyzed to intermediate radicals and the radicals' fraction in the higher volatile dust flame was higher than that in the lower volatile dust flame.     

Connecting the Dots: Public Engagement with Environmental Data

Air pollution and other environmental hazards are often imperceptible and need to be made publicly visible. The paper argues for the importance of visualizations in drawing public attention to imperceptible hazards and in providing the public with access to empirical data describing the risks. It also argues for critical inquiry into hazards’ selective visibility as it is produced by visualizations. The impact of visualizations and their selective visibility are considered through the example of a public art project called Particle Falls installed in 2014 in Pittsburgh, a city with a long history of both ignoring air pollution and working to ameliorate this problem. I examine the impact and selective visibility of Particle Falls by considering the underlying production of data, as well as context and support systems for this visualization, and by comparing it with other visualizations of local air quality.     

Efficiency enhancement in solar air heaters by modification of absorber plate-a review

This paper outlines a complete review on modifications made on the absorber plate of solar air heaters in order to improve the turbulence and heat transfer rate, thereby efficiency. Corrugated sheets, fins, extended surfaces, wire mesh, porous medium, etc., are a few of the modifications used. Most of such alterations in the absorber plate resulted with an increase in efficiency but associated with drawback of increased pumping power due to raising friction factor. Pumping power is considered here as a predominant comparison parameters of various solar air heaters with different absorber plate in terms of effective efficiency.     

中国城市热岛时空特征及其影响因子的分析

全球气候变暖背景下,城市热岛效应会加重城市地区的热胁迫,对人类健康和生存发展提出严峻挑战.近年来我国雾-霾污染情况严重,但雾-霾对城市热岛影响的认识仍较匮乏.本研究基于MODIS遥感卫星地表温度数据,明确了我国2003~2013年白天、夜间以及四季城市热岛的空间变化,并从生物物理学和生物化学角度定量分析其控制机制.结果表明,影响我国白天城市热岛强度的主要因素为人口、农田灌溉和植被活动.纬度、降水量、反照率以及气溶胶浓度是夜间城市热岛强度的主控因子.从对比城乡粗糙度、反照率等生物物理学属性的角度,揭示了乡村背景环境对城市热岛分析的重要影响.结果表明,雾-霾治理可以缓解我国夜间城市热岛现象和热胁迫,有利于缓解区域甚至全球气候变化.