限氧EGSB反应器内颗粒污泥性能研究

研究限氧EGSB反应器内颗粒污泥的沉淀性能、产甲烷活性、形态、抗温度和负荷冲击等特性,以分析限氧EGSB反应器长期高效稳定运行的可行性.结果表明,限氧运行使得颗粒污泥的沉速降低,但仍能保持20.07～51.86 m/h的高沉速,保证了限氧EGSB反应器内约42 g/L的高污泥浓度;加入适量氧并没有对甲烷菌产生毒害作用,反而有所提高,提高幅度为11.94%.限氧EGSB反应器内颗粒污泥表面和内部微生物没有出现明显的分区分布,中高进水浓度时没有出现甲烷八叠球菌的明显优势;限氧EGSB反应器内颗粒污泥在经历温度和COD负荷双重冲击后,COD去除率明显降低,出水VFA明显增高,产气量明显降低,甚至出现不产气的情况.COD去除率的恢复很快,仅需20 d;出水VFA和产气也逐渐恢复,但有所滞后;微生物的恢复要慢些,扫描电镜结果表明,有些颗粒污泥表面的微生物细胞仍存在收缩现象.     

接种不同污泥启动厌氧氨氧化ASBR反应器研究

采用ASBR反应器,分别以好氧硝化污泥和厌氧颗粒污泥为种泥,通过对氨氮、亚硝酸盐氮等指标的监测和数据分析、污泥颜色的观察,研究2个厌氧氨氧化反应器启动的可行性及其差异.结果表明,2个厌氧氨氧化反应器均可成功启动;采用好氧硝化污泥启动厌氧氨氧化反应器耗时142 d,启动前后污泥颜色变化不大,亚硝酸盐氮浓度超过20 mmol/L会对厌氧氨氧化产生明显的抑制作用;采用厌氧颗粒污泥启动厌氧氨氧化反应器耗时249 d,启动前后污泥颜色变化很大,从黑色逐渐变为砖红色,亚硝酸盐氮浓度超过13.4 mmol/L会对厌氧氨氧化产生抑制作用;分别用以上2种污泥启动的厌氧氨氧化ASBR反应器中占优势地位的厌氧氨氧化菌不同.     

基于CFD的内构件强化内循环流化床流场结构分析

针对流化床内部流体结构的复杂性和缺乏有效放大设计理论的问题,以漏斗型导流内构件强化的内循环流化床的气液运动为研究对象,利用欧拉-欧拉双流体模型构建了能描述其复杂流动的CFD数学模型,通过宏观流场、气含率分布、液体速度分布解析内构件对气液混合传质的作用原理.数值模拟结果表明:双流体模型能较好地揭示流化床内气液流场结构,流...     

内循环(IC)反应器运行规律研究

研究采用自制内循环(IC)反应器,以实验室模拟废水为进水,接种城市污水处理厂的剩余污泥,对反应器的启动及运行过程进行研究,在经过污泥驯化、颗粒培养、调整及稳定的不同阶段连续运行.结果表明:启动初期反应器pH过低,产甲烷菌生长受抑制,导致VFA累积,容易酸化.通过改变模拟废水中微量元素的浓度及添加缓冲溶液,酸化的反应器可...     

Aerobic granules cultivated and operated in continuous-flow bioreactor under particle-size selective pressure

A novel method based on the selective pressure of particle size （particle-size cultivation method, PSCM） was developed for the cultivation and operation of aerobic granular sludge in a continuous-flow reactor, and compared with the conventional method based on the selective pressure of settling velocity （settling-velocity cultivation method, SVCM）. Results indicated that aerobic granules could be cultivated in continuous operation mode by this developed method within 14 days. Although in the granulation process, under particle-size selective pressure, mixed liquor suspended solids （MLSS） in the reactor fluctuated greatly and filamentous bacteria dominated the sludge system during the initial operation days, no obvious difference in profile was found between the aerobic granules cultivated by PSCM and SVCM. Moreover, aerobic granules cultivated by PSCM presented larger diameter, lower water content and higher specific rates of nitrification, denitrifieation and phosphorus removal, but lower settling velocity. Under long term operation of more than 30 days, aerobic granules in the continuous-flow reactor could remain stable and obtain good chemical oxygen demand （COD）, NH4^＋-N, total nitrogen （TN） and total phosphorus （TP） removal. The results indicate that PSCM was dependent on the cultivation and maintenance of the stability of aerobic granules in continuous-flow bioreactors.     

SFBR中好氧颗粒污泥的培养及特性研究

接种自行培养的活性污泥,以模拟废水为基质,采用连续进水、间歇出水及厌氧/好氧交替的运行模式,尝试了在SFBR中进行好氧颗粒污泥的培养,并研究了好氧颗粒污泥的特性及反应器对污染物的去除效果.结果表明,通过逐步缩短沉降时间,28 d时成功培养出好氧颗粒污泥,所形成的好氧颗粒污泥呈黄色、形状不规则,且粒径较小(平均粒径0.56 mm),正常情况下的SVI保持在70 mL·g-1以下,EPS在59 d时达到最大值(以MLVSS计)373.24 mg·g-1,较培养初期增加了约2.5倍,运行后期由于颗粒出现解体,导致EPS急剧下降;反应器在运行过程中未能保持较高的污泥量,中后期MLSS始终在3 000mg·L-1以下;在63 d的运行时间里,除异常波动外,反应器对COD的去除率基本维持在90%左右,正常情况下出水COD小于100 mg·L-1,反应器对NH+4-N、TIN的去除效果波动较大,去除率分别为44.45%~94.72%及43.87%~93.13%,反应器对TP的去除率在44.50%~97.40%之间,正常情况下TP去除率可维持在60%以上;限于自动控制水平,夜间长时间的好氧饥饿期容易造成丝状菌过度生长,使得AGS在生长竞争中处于劣势,最终导致了AGS的解体.     

连续流反应器短程硝化的快速启动与维持机制

如何快速稳定地启动短程硝化工艺对低C/N比废水的处理具有十分重要的实际应用价值.针对城市污水厂以连续流工艺为主的现状,故对连续流反应器短程硝化的快速启动与维持进行研究.结果表明,利用间歇曝气,依次控制3个阶段的停/曝时间(15 min/45 min、45 min/45 min和30 min/30 min),连续流反应器经过60 d左右的运行,可以成功实现短程硝化的快速启动.控制停/曝时间为30 min/30 min,进水氨氮浓度为50或100 mg·L~(-1)时,亚硝化率分别可达90%或95%.另外,间歇曝气有利于抑制硝化菌(NOB)的活性,而缩短水力停留时间(HRT)可淘洗出NOB,两者结合可以更好地维持短程硝化.     

SCAR处理城市生活污水的效能及其微生物群落动态分析

利用强化循环厌氧反应器(SCAR)处理模拟城市生活污水,研究不同负荷条件下的反应器运行特征、污泥特性及微生物种群结构.结果表明,水力停留时间(HRT)为6 h可以作为反应器高效运行的关键控制参数,该条件下污水化学需氧量(COD)去除率达到75%以上.随着反应器容积负荷的逐渐提高,颗粒污泥中辅酶F420和产甲烷活性(SMA)逐渐增加,胞外聚合物(EPS)含量也不断提高,其中紧密黏附EPS(TB-EPS)含量的增加尤其明显.厌氧颗粒污泥性状和反应器对污染物的去除效率同时受到污泥负荷和HRT的影响,微生物的群落结构及其在反应器中的空间分布也受到污泥负荷的影响,不同代谢特征微生物在反应器不同空间位置的相对丰度随着污泥负荷的调整而改变.     

低温条件IASBR处理养猪沼液脱氮性能研究

以实际养猪沼液为研究对象,考察分步进水间歇曝气序批式生物反应器(IASBR)在低温条件下的脱氮性能.结果表明:IASBR反应器的硝化性能临界水温为10℃,水温低于10℃时硝化性能急剧下降,水温10℃以上时氨氮去除率达到90%以上,且水温15℃以上氨氮负荷极限可达到0.30 kg·m~(-3)·d~(-1);低碳氮比(COD/TN)1.7±0.3条件下,反硝化性能临界水温为20℃,20℃以上时TN去除率可保持在80%以上,最高达90%,20℃以下时脱氮效率明显降低,出现亚硝态氮积累现象.此外,IASBR反应器脱氮除磷效率高,温度对TOC和TP去除率的影响不敏感.不排泥条件下,进水COD/TN为3.1±0.4时,TN去除率高达90%以上,TOC和TP去除率分别高达83.6%±3.9%和58.5%±17.8%;随后COD/TN降低至1.7±0.3后,TN去除率仍高达80%以上,TOC和TP去除率仅略有降低分别为77.3%±4.6%、53.1%±10.1%.     

Emergency shutdown of fluidized bed reaction systems

With several industrial applications of fluidized bed technology recently commercialized worldwide, it becomes essential to develop safe operation methods for fluidized bed reaction systems (FBRSs) to prevent any influence on their process values, which lead to accidents. To preventing any disaster or malfunction in an FBRS, an emergency shutdown system (ESD) is initiated, closing the reaction system in case of any abnormality by effectively isolating the flammable gas. However, an ESD is also prone to the “inactivation problem,” in which in the case of failure it initiates the emergency shutdown, even when the operating conditions of the reaction system are abnormal. It is also vulnerable to a “malfunction problem,” where the emergency shutdown is performed even when the operating conditions of the reaction system are normal. In this study, these problems were solved by investigating a reaction system through the monitoring of appropriate parameters and setting up of trigger levels, which reflect the uniqueness of an FBRS using an ESD. The parameters were identified by analyzing the scenario leading to an accident. The trigger levels were determined as the points at which the loss is smaller in the presence of an ESD, as compared to the value of the loss function in the presence or absence of an ESD. Furthermore, the ESD design model was applied as a case study in the ammoxidation process of propylene. The results showed that an ESD can prevent an approximately 8 billion yen of loss due to accidents in plant operations, against an investment of 200 million yen.