Hydrogen generation from polyvinyl alcohol-contaminated wastewater by a process of supercritical water gasification

Gasification of polyvinyl alcohol(PVA)-contaminated wastewater in supercritical water(SCW)was investigated in a continuous flow reactor at 723-873 K,20-36 MPa and residence time of 20-60 s.The gas and liquid products were analyzed by GC/TCD,and TOC analyzer.The main gas products were H_2,CH_4,CO and CO_2.Pressure change had no significant influence on gasification efficiency. Higher temperature and longer residence time enhanced gasification efficiency,and lower temperature favored the production of H_2. The effects of KOH catalyst on gas product composition were studied,and gasification efficiency were analyzed.The TOC removal efficiency(R_(TOC)),carbon gasification ratio(R_(CG))and hydrogen gasification ratio(R_(HG))were up to 96.00%,95.92% and 126.40% at 873 K and 60 s,respectively,which suggests PVA can be completely gasified in SCW.The results indicate supercritical water gasification for hydrogen generation is a promising process for the treatment of PVA wastewater.     

渗滤液场内处理的有机物去除特征和植物毒性评价

摘要：以3种不同处理水平的渗滤液为研究对象,从有机物去除特征和植物毒性角度研究通过渗滤液循环回灌和终场覆盖层灌溉2个单元处理生活垃圾填埋场渗滤液的可行性.结果表明,循环回灌对老港渗滤液中的小分子量亲水性物质类(HyI)有机物去除效果较好,去除率为91.2%;终场覆盖层灌溉对循环回灌出水中的高分子量腐殖质类(HS)有机物去除效果较佳,去除率为85.7%;两者串联组合的场内循环处理工艺对老港渗滤液中的溶解性有机物(DOM)去除 率高达96.9%,且对HS和HyI均具较高的去除效果,去除率分别为96.6%和97.0%;循环回灌和覆盖层灌溉这2个处理单元还具有梯级降低渗滤液植物毒性的作用.     

利用电厂粉煤灰处理染料中间体废水

利用电厂粉煤灰，采用吸附法处理难生化降解的染料中间体二硝基氯化苯废水。结果表明，该法处理效果好，ＣＯＤＣｒ和色度去除率都很高，处理水可达标排放。而且此法处理成本大大低于活性炭吸附法。     

生物反应器填埋条件下垃圾生物质组分的初期降解规律

在经甲烷化填埋层渗滤后的渗滤液循环回灌的新鲜垃圾填埋层内,以生物质分类表征为基础,分析了新鲜垃圾填埋层内固相各生物质组分（总糖、蛋白质、脂肪、纤维素和木质素）的初期降解规律.结果表明,垃圾中原有总糖组分和蛋白质的快速水解发酵是新鲜垃圾填埋后产生高有机质浓度渗滤液的主要机制;脂肪和纤维素的降解产物不是填埋初期高有机质浓度渗滤液的主要来源;纤维素是填埋层稳定产甲烷阶段的主要碳源,其水解速率可能是甲烷化过程的限速步骤;纤维素/木质素之质量比可作为指示填埋垃圾稳定化的指标.各生物质组分的初期降解速率常数均在0.01至0.1之间,而填埋气体中甲烷体积分数在60d内达到45%.食品垃圾组分富集的生活垃圾,应用生物反应器填埋技术时,必须具备足够的降解容量以代谢填埋初期固相中总糖和蛋白质快速水解产生的酸性液相产物.     

Immobilization of activated sludge using improved polyvinyl alcohol （PVA） gel

The microbial immobilization method using polyvinyl alcohol(PVA)gel as an immobilizing material was improved and used for entrapment of activated sludge.The oxygen uptake rate(OUR)was used to characterize the biological activity of immobilized activated sludge.Three kinds of PVA-immobilized particles of activated sludge,that is,PVA-boric acid beads,PVA-sodium nitrate beads and PVA-orthophosphate beads were prepared,and their biological activity was compared by measuring the OUR value.The bioactivity of both autotrophic and heterotrophic microorganisms of activated sludge was determined using different synthetic wastewater media (containing 250 mg/L COD and 25 mg/L NH_4~ -N).The experimental results showed that the bioactivity and stability of the three kinds of immobilized activated sludge was greatly improved after activation.With respect of the bioactivity and the mechanical stability,the PVA-orthophosphate method may be a promising and economical technique for microbial immobilization.     

介孔ZnO负载Fe-Cu-Zr复合催化剂用于催化燃烧降解乙酸丁酯

采用醇热法制备了有序球状介孔ZnO负载Fe-Cu-Zr复合催化剂,应用BET、SEM、XRD、XPS等对不同物质的量比催化剂进行了表征,研究了催化降解乙酸丁酯的活性及其影响因素,并推测了降解机理.结果表明,铁铜锆复合催化剂颗粒均匀,分散性较好,孔径大部分小于50 nm,比表面积为46～68 m²·g^-1.各活性成分能够共存和协同发挥作用,铁、铜、锆离子吸附在氧化锌晶胞内,粒子间量子作用力促使晶胞表面积略有变大.锆能够提高3种活性成分间的作用力,可以调节表面电子密度,促使结合能向低的方向偏移,增强催化剂的氧化还原能力.随着锆比例的增大,催化剂的活性也随之增强;随着初始浓度、空速、相对湿度的增加,乙酸丁酯降解效率均有所下降.在乙酸丁酯初始浓度为2590 mg·m^-3、空速为9000 h^-1的工况下,ZnO-3M催化剂降解乙酸丁酯的T₅₀为116℃,T₉₀为200℃,270℃时CO₂转化率达96%,具有良好的低温催化活性和稳定性.乙酸丁酯催...     

Simplified creation of polyester fabric supported Fe-based MOFs by an industrialized dyeing process: Conditions optimization, photocatalytics activity and polyvinyl alcohol removal

MIL-53(Fe) was successfully prepared and deposited on the surface carboxylated polyester (PET) fiber by an optimized conventional solvothermal or industrialized high temperature pressure exhaustion (HTPE) process to develop a PET fiber supported MIL-53(Fe) photocatalyst ([email protected]) for the degradation of polyvinyl alcohol (PVA) in water under light emitting diode (LED) visible irradiation. On the basis of several characterizations, [email protected] was tested for the photocalytic ability and degradation mechanism. It was found that temperature elevation significantly enhanced the formation and deposition of MIL-53(Fe) with better photocatalytic activity. However, higher temperature than 130°C was not in favor of its photocatalytic activity. Increasing the number of surface carboxyl groups of the modified PET fiber could cause a liner improvement in MIL-53(Fe) loading content and photocatalytic ability. High visible irradiation intensity also dramatically increased photocatalytic ability and PVA degradation efficiency of [email protected] Na₂S₂O₈ was used to replace H₂O₂ as electron acceptor for further promoting PVA degradation in this system. [email protected] prepared by HTPE process showed higher MIL-53(Fe) loading content and slightly lower PVA degradation efficiency than that prepared by solvothermal process at the same conditions. These findings provided a practical strategy for the large-scale production of the supported MIL-53(Fe) as a photocatalyst in the future.