Supercritical water oxidation of polyvinyl alcohol and desizing wastewater：Influence of NaOH on the organic decomposition

Polyvinyl alcohol is a refractory compound widely used in industry. Here we report supercritical water oxidation of polyvinyl alcohol solution and desizing wastewater with and without sodium hydroxide addition. However, it is difficult to implement complete degradation of organics even though polyvinyl alcohol can readily crack under supercritical water treatment. Sodium hydroxide had a significant catalytic effect during the supercritical water oxidation of polyvinyl alcohol. It appears that the OH ion participated in the C-C bond cleavage of polyvinyl alcohol molecules, the CO2-capture reaction and the neutralization of intermediate organic acids, promoting the overall reactions moving in the forward direction. Acetaldehyde was a typical intermediate product during reaction. For supercritical water oxidation of desizing wastewater, a high destruction rate (98.25%) based on total organic carbon was achieved. In addition, cases where initial wastewater was alkaline were favorable for supercritical water oxidation treatment, but salt precipitation and blockage issues arising during the process need to be taken into account seriously.     

介质阻挡放电中添加乙炔对NO脱除的影响

利用介质阻挡放电(DBD)进行模拟烟气脱除NO实验,通过改变乙炔体积分数和烟气水蒸汽含量研究添加乙炔对NO脱除效率的影响.结果表明:烟气中添加乙炔强化了NO氧化作用,随着乙炔体积分数的提高,NO脱除率逐渐增加.在NO/N2/O2/C2H2/H2O体系中,水的电负性和离解反应消耗大量高能电子,降低了活性自由基的生成,NO脱除速率随之减慢;能量密度低于400 J·L-1时,相对湿度(RH)为0的情况下脱出效果最好.但随着能量密度的增加,H2O不会影响最终的NO脱除率;H2O的添加可以产生更多的·OH自由基,促进NO2向HNO3转化,使出口NO2浓度大幅度降低.     

糖蜜酒精厂环境保护验收清洁生产评价研究

糖蜜是糖厂榨糖后的副产品,含有可发酵性的糖45％∽52％,是直接用于发酵生产酒精的较好的原料.文章以广西某糖蜜酒精厂为例,在调查了解酒精厂生产工艺与装备、资源能源利用指标、污染物产生指标、废物回收利用率和环境管理要求等五个方面的基础上,认真细致分析环境保护竣工验收监测数据及生产报表数据,按照（HJ 581-2010）《清洁生产标准酒精制造业》（国家环境保护部）的要求对酒精厂清洁生产水平进行评价,并根据评价结果提出进一步提高清洁生产水平的建议和要求.     

典型岩溶区地下河中溶解态脂类生物标志物来源解析及其变化特征

利用气相色谱-质谱联用仪(GC-MS)测定了青木关地下河中溶解态类脂物的含量.研究了其在地下河中的来源、组成及迁移特征.结果表明,7~11月,各溶解态类脂物的平均含量随着青木关地下河运移距离的增加呈降低趋势,其中以溶解态饱和直链脂肪酸的下降最为显著,即由最初的5 704 ng·L~(-1)下降到1 043 ng·L~(-1),减少了约81.71%.正构烷烃能够较为详尽地指征地下河中溶解性有机质来源,而饱和直链脂肪酸、脂肪醇则对藻类和细菌等微生物有较好的指示意义.随着地下河运移距离增加,有机质输入类型呈现多样化,可能与岩溶地表不均一性有关.正构烷烃三端元图解中,水生植物的输入为地下河中溶解性有机质的主要来源,其次分别为陆地高等植物和藻类、细菌等微生物,但随着地下河运移距离的增加水生植物的相对贡献量逐渐减少.青木关地下河中正构烷烃TAR值对降雨有一定的指示意义,而饱和直链脂肪酸CPI、L/H值则指示细菌降解活动.     

活性污泥的固定化及其性能研究

用改进聚乙烯醇-硼酸法将活性污泥制成固定化颗粒,考察了改进聚乙烯醇-硼酸法的最佳条件及固定化颗粒的性能。实验结果表明：改进聚乙烯醇-硼酸法的最佳条件为聚乙烯醇质量分数6．5％、包泥比（包埋剂与活性污泥质量比）1．2：1、二氧化硅质量分数1．5％、活性炭质量分数0．3％、海藻酸钠质量分数0．6％;用最佳条件下制得的固定化颗粒处理模拟化工废水,连续运行15d后的COD去除率达90％以上,且固定化颗粒耐冲击负荷和pH变化能力强;固定化颗粒对模拟化工废水的COD去除速率随进水COD的变化曲线类似于米氏方程所描述的反应初速度随底物浓度的变化规律。     

皂素清洁生产工艺的研究(Ⅰ)

黄姜淀粉经过!-淀粉酶液化,加糖化酶和酵母进行边糖化边发酵生产酒精。发酵后黄姜渣用酸水解法提取薯蓣皂素。黄姜淀粉利用率为86.30%,耗酸量为传统工艺的55%,废水的总COD比传统工艺减少了60.25%,皂素收率比传统工艺提高20.37%。     

Aerobic degradation of methyl tert-butyl ether by a Proteobacteria strain in a closed culture system

The contamination of methyl ten-butyl ether （MTBE） in underground waters has become a widely concerned problem all over the world. In this study, a novel dosed culture system with oxygen supplied by H2O2 was introduced for MTBE aerobic biodegradation. After 7 d, almost all MTBE was degraded by a pure culture, a member of β-Proteobacteria named as PMI, in a closed system with oxygen supply, while only 40% MTBE was degraded in one without oxygen supply. Dissolved oxygen （DO） levels of the broth in closed systems respectively with and without H2O2 were about 5-6 and 4 mg/L. Higher DO may improve the activity of monooxygemase, which is the key enzyme of metabolic pathway from MTBE to tert-butyl alcohol and finally to CO2, and may result in the increase of the degrading activity of PM1 cell. The purge and trap GC-MS result of the broth in closed systems showed that tea-butyl alcohol, isopronol and acetone were the main intermediate products.     

CN-测定中显色剂配制方法的选择与保存时间

对2种氰化物显色剂配制方法进行了对比,发现用无水乙醇配制的显色剂具有方便,经济,实用,无毒且显色剂保存期长等优势。     

Influence of Technological Process on Biodegradation of PVA/Waxy Starch Blends in an Aerobic and Anaerobic Environment

Improving biodegradability of PVA/starch blends is a reality already documented by a number of works. Admittedly, mechanical properties of products (for example, tensile strength) are somewhat worse, but suitable composition optimizing or chemical modifying of starch may eliminate the problem to a large degree. This work is an attempt to find another potential effect influencing biodegradability, that of technological procedure for producing films from these blends on an extruder. The procedure with a so-called pre-extrusion step (two-stage) and dry-blend (single-stage) produced blends of slightest differences in achieved biodegradability (virtually within limits of experimental error) in aerobic (76 vs. 79%) as well as anaerobic breakdown (48 vs. 52%). Conversely, morphological analysis exhibited superior homogeneity of films prepared by the two-stage process; their tensile strength was also higher.     

Effect of Cell-to-matrix Ratio in Polyvinyl Alcohol Immobilized Pure and Mixed Cultures on Atrazine Degradation

Atrazine biodegradation by immobilized pure and mixed cultures was examined. A pure atrazine-degrading culture, Agrobacterium radiobacter J14a (J14a), and a mixed culture (MC), isolated from an atrazine-contaminated crop field, were immobilized using phosphorylated-polyvinyl alcohol (PPVA). An existing cell immobilization procedure was modified to enhance PPVA matrix stability. The results showed that the matrices remained mechanically and chemically stable after shaking with glass beads over 15 days under various salt solutions and pH values. The immobilization process had a slight effect on cell viability. With the aid of scanning electron microscopy, a suitable microstructure of PPVA matrices for cell entrapment was observed. There were two porous layers of spherical gel matrices, the outside having an encapsulation property and the inside containing numerous pores for bacteria to occupy. J14a and MC were immobilized at three cell-to-matrix ratios of 3.5, 6.7, and 20 mg dry cells/mL matrix. The atrazine biodegradation tests were conducted in an aerobic batch system, which was inoculated with cells at 2,000 mg/L. The tests were also conducted using free (non-immobilized) J14a and MC for comparative purpose. The cell-to-matrix ratio of 3.5 mg/mL provided the highest atrazine removal efficiency of 40–50% in 120 h for both J14a and MC. The free cell systems, for both cultures, presented much lower atrazine removal efficiencies compared to the immobilized cell systems at the same level of inoculation.