水热+厌氧消化对污泥碳、氮、磷溶出的影响

研究了水热预处理和厌氧消化联合作用时温度对污泥中碳、氮、磷溶出的影响。结果表明:水热处理温度越高越有利于污泥中碳氮磷的溶出,当水热温度为200 ℃时,SCODCr的溶出率较原泥提高了5.9倍;氨氮和总氮的溶出率分别提高了7.2和8.7倍;磷酸根和总磷的溶出率分别提高了0.2和6.1倍。厌氧消化后污泥中碳磷浓度下降,而氮浓度上升。厌氧消化后累积产气量与水热温度有关:当温度为160 ℃时,最大累积产甲烷量为12 223 L/mg-CO D C H 4 (以每mg COD的产甲烷量计),较原泥提高了14.5倍。根据试验结果,提出了从水热和厌氧消化污泥中回收氮磷的策略,即水热处理污泥后可在污泥清液中投加镁源进行磷的回收,厌氧消化中溶出的氮可通过加入吸附材料进行吸附回收。在污泥中氮磷资源回收的同时,可通过水热过程提高污泥厌氧过程中累积产甲烷量。     

结晶沉淀-树脂吸附组合工艺回收黄连素废水中铜试验研究

通过多批次的小试试验考察了结晶沉淀-树脂吸附组合工艺对黄连素含铜废水的处理效果,并对产生的碱式氯化铜(TBCC)结晶沉淀进行X射线衍射(XRD)成分分析。结果表明:反应pH为7.0~9.0时,废水中超过99.9%的Cu ²⁺以碱式氯化铜结晶沉淀的形式得以回收,反应生成的碱式氯化铜沉淀通过水洗后,其成分符合GB/T 21696—2008《饲料添加剂 碱式氯化铜》质量标准。剩余的废水再经过树脂吸附工艺处理后,出水Cu ²⁺浓度小于1.0 mg/L。在小试试验的基础上,开展了中试试验研究,其结果进一步验证了小试试验的运行效果及该工艺的可行性。通过该处理工艺既可综合利用废水中的铜资源,又可将废水的pH由小于1调至大于7,有利于实现制药废水综合处理和达标排放。     

铅酸蓄电池行业生产者责任延伸制在我国实施的难点和解决方案

为解决我国废弃产品环境污染问题和再生资源循环利用的困境,加快生态文明建设和循环经济发展,国务院现已推行生产者责任延伸制度。该项制度的推行实施,可减轻环境治理负担,推动循环经济和清洁生产模式,促进企业技术升级,但该项制度在具体实施过程中尚存在一些问题。以铅蓄电池行业为例,存在的主要问题包括相关制度不健全、回收利用体系不完善、缺乏多部门联动监管机制和有效的经济激励政策等。针对上述问题,结合河南省的废铅蓄电池收集处理制度试点工作,提出铅酸蓄电池行业生产者责任延伸制实施的建议方案,为生产者责任延伸制度更好地推行和实施提供参考。     

含油污泥三相离心分离处理技术研究

针对原油生产过程中产生的大量含油污泥,油泥成分复杂、严重污染周边环境且造成资源浪费的情况,采用三相离心分离工艺对含油污泥进行处理。通过室内试验研究,确定了含油污泥处理的最佳条件。添加分离剂能够改善油泥分离性能,提高油泥温度能够改善油泥流动效果,摸索出油泥离心分离的最佳时间和离心速率,并对分离后的三相物质进行物性检测。该工艺处理含油污泥可以有效的回收原油,处理后固相减量75%,实现含油污泥减量化、资源化处理的目的。     

基于生物膜法磷回收工艺厌氧释磷研究

城市污水经过碳回收后的低碳源进水水质将对活性污泥法强化除磷（EBPR）工艺的运行带来困难.本研究基于生物膜法磷回收的序批式反应器（Biofilm-SBR）对低碳、低磷进水进行磷回收,在BSBR反应器好氧无碳源、厌氧低碳源投加的运行基础上,研究了该工艺在低碳模式下厌氧磷释放的关键影响因素.同时,研究了不同的碳源浓度和碳源投加方式对BSBR工艺释磷的影响.最后,分析了系统中生物膜蓄磷量的变化,并探究其与碳源消耗、释磷效果的量化关系.结果表明,该系统在好氧无碳源、厌氧仅200 mg·L^-1的碳源投加下,即可取得115 mg·L^-1（可溶性磷）的富磷回收液.系统的C_upt/P_rel（释放单位质量磷的COD消耗量）平均为（11.12±1.03）mg·mg^-1,最大蓄磷量为124 mg·g^-1.     

Residual dynamics of thiacloprid in medical herbs marjoram, thyme, and camomile and in soil

Thiacloprid is a new insecticide of the chloronicotinyl family. To assess its risk after application, residual characteristics of thiacloprid in marjoram, thyme, and camomile and in soil were studied under field conditions. The active ingredient was extracted from the plant material using a mixture of acetone-water. After filtration, the extract was concentrated to the aqueous phase, diluted with water, and portioned against ethyl acetate on a matrix solid phase dispersion column. Thiacloprid was extracted from soil using a mixture of methanol-water, filtered, and re.extracted （clean up） with dichloromethane. The residues were quantified using HPLC-MS-MS. The methods were validated by recovery experiments. Thiacloprid residues in marjoram, thyme, and camomile and in soil persisted beyond 10, 14, 14, and 21 d but no residues were detected after 14, 21, 21, and 28 d, respectively. The data obtained in this study indicated that the biexponential model is more suitable than the first-order function to describe the decline of thiacloprid in fresh marjoram, fresh thyme, and dried camomile flowers with half-life （t1/2） of 1.1, 0.7, and 1.2 d, respectively. However, both the first-order function and biexponential model were found to be applicable for dissipation of thiacloprid in soil with almost the same t1/2 values of 3.5 and 3.6 d. The results indicated that thiacloprid dissipates rapidly and does not accumulate in the tested herbs and in soil.     

空塔钠碱法烟气脱硫实验研究

在内径200mm,高度1100mm的喷淋塔内,采用Na2CO3作为吸收剂进行SO2吸收实验,重点研究了液气比(L/G)、空塔气速、进口SO2质量浓度、吸收液pH及初始浓度对脱硫效率的影响。通过实验得到该系统适宜操作条件:吸收液pH值在6.5～7.5之间,液气比在1～1.5之间,吸收液初始浓度5%,空塔气速1.6m/s,在此条件下,进口SO2质量浓度在3000mg/m3以内,脱硫效率可以达到80%以上。     

Oxidation inhibition of sulfite in dual alkali FGD system

A laboratory-scale well-mixed thermostatic reactor with continuously blasting air was used to investigate the oxidation inhibition of sulfite in dual alkali flue gas desulfurization （FGD） system. The effects of operating parameters such as pH value and catalyst concentration on the oxidation were studied. Sodium thiosulfate was used in the system, and was found that it significantly inhabited the sulfite oxidation. In the absence of catalyst, sodium thiosulfate at 12.67 mmol/L had an inhibition efficiency of approximately 98%. While in the presence of catalyst, sodium thiosulfate at 26.72 mmol/L had an inhibition efficiency less than 85.0%. The oxidation reaction order of sulfite in the sodium thiosulfate was determined to be -1.90 and 4）.55 in the absence and presence of the catalyst, respectively. Apparent activation energy of oxidation inhibition was calculated to be 53.9 kJ/mol. Pilot tests showed that the consumption rate of thiosulfate agreed well with the laboratory-scale experimental results.     

厌氧水解酸化-好氧氧化A1/A2/O工艺剩余污泥减量

在碱减量印染废水A₁/A₂/O生物处理系统,通过污泥回流、把剩余污泥回流到A₁段,利用A段污泥的水解、酸化和O段微生物的好氧氧化作用可有效实现对回流剩余污泥的减量,同时O段好氧污泥的表观产率系数下降,系统产生的剩余污泥量减少.厌氧水解酸化-好氧氧化A₁/A₂/O工艺实现污泥减量由3段共同完成:A₁段实现回流剩余污泥的“液化”和惰性化;A₂段对系统污泥减量起到了强化作用;而O段微生物的合成作用在逐渐减弱.6个月连续运行的动态试验表明,在A₁段的容积负荷(COD_Cr)为2.54 kg·(m³·d)^-1、水力停留时间为7.56h条件下,A₁段利用水解酸化作用对回流剩余污泥的减量达到67.87%,系统O段好氧污泥的表观产率系数也下降到试验初始时的45.5%.在A₁/A₂/O污泥减量系统中,各段污泥性状发生了变化,A₁段污泥[MLVSS/MLSS]值从试验开始时的0.718 2下降到0.592 2,A₂段污泥[MLVSS/MLSS]值从0.667 3下降到0.526 7,剩余污泥的减量是活性污泥逐渐惰性化过程,污泥的粒度分析也证明了这一点.     

建筑垃圾资源化处理工艺改进研究

在分析国内建筑垃圾分类及传统处理工艺现状的基础上,针对传统工艺存在的问题进行改进和优化。所设计的新型处理工艺流程从提高破碎比、改善筛分效果,增强骨料强度和降低扬尘4个方面进行了改进,重点为破碎后骨料的颗粒整形强化工艺、凝胶强化工艺、破碎喷淋除尘工艺。具体表现为:在通用处理流程的基础上,把破碎环节改进为筛分后再进行二次破碎,改进筛分为多次筛分,利用不同的筛分原理实现不同筛分效果;骨料形成后的回收环节增加凝胶喷淋提高骨料强度,弥补了当前处理工艺流程的不足,提高了建筑垃圾的处理效率及品质,可为建筑垃圾资源化处理提供参考。