Tween 80和鼠李糖脂对稻草酶解的影响

采用纤维素酶促水解的方法,以稻草为底物,探讨了添加化学表面活性剂Tween 80和生物表面活性剂鼠李糖脂对酶解过程的糖产率、酶稳定性、纤维素转化率的作用以及对酶动力学特征和酶在纤维素上吸附的影响.结果表明,不同浓度的Tween 80和鼠李糖脂对稻草酶解有不同程度的促进,添加0.016%和0.048%Tween 80使糖产率分别提高18.07%和11.98%,而添加0.01%和0.03%鼠李糖脂使糖产率分别增加了23.01%和22.16%,相比较鼠李糖脂的效果更好.表面活性剂能有效增强酶的稳定性,添加高浓度表面活性剂的酶稳定性优于添加低浓度表面活性剂,添加浓度为0.048%的Tween 80得到最高相对CMCA(羧甲基纤维素酶活)108.06%和最高相对FPA(滤纸酶活)80.26%.表面活性剂能提高酶解反应的纤维素转化率,而且添加鼠李糖脂的转化率明显高于Tween 80.表面活性剂不仅能够提高最大反应速度并使米氏常数变大,而且显著地降低了纤维素酶在纤维素上的吸附.     

碱性过硫酸钾氧化-钼酸铵分光光度法测定水中的总磷及其不确定度的评定

经过消解前加入氢氧化钠和改用聚四氟乙烯消化管等方面的改进,碱性过硫酸钾氧化-钼酸铵分光度法的实际操作更简便,更适用于各类水样的监测。它具有较低的捡出限（O．004mg／L）,较高的精密度（RSD=1．1％）和较好的准确度（测定标样溶液相对误差1．6％,加标回收率为97．2％-102．1％）。测定IERM测量审核样的结果也较好（取得了合格证书）。不确定度的评定依照相关标准的原则进行,并使用残差来量化曲线不碹定度分量,减少了工作量。经评定,改进方法的扩展不确定度为3．2％。     

Combined alkaline and ultrasonic pretreatment of sludge before aerobic digestion

Alkaline and ultrasonic sludge disintegration can both be used as pretreatments of waste activated sludge (WAS) for improving the subsequent anaerobic or aerobic digestion. The pretreatment has been carried out using different combination of these two methods in this study. The effect was evaluated based on the quantity of soluble chemical oxygen demand (SCOD) in the pretreated sludge as well as the degradation of organic matter in the following aerobic digestion. For WAS samples with combined pretreatment, the released COD was in high level than those with ultrasonic or alkaline treatment. When combined with the same ultrasonic treatment, NaOH treatment resulted in more solubilization of WAS than Ca(OH)2. For combined NaOH and ultrasonic treatments with different sequences, the released COD were in the order: simultaneous treatment > ultrasonic treatment following NaOH treatment > NaOH treatment following ultrasonic treatment. For simultaneous treatment, low NaOH dosage (100 g/kg dry solid), short duration (30 min) of NaOH treatment, and low ultrasonic specific energy (7 500 kJ/kg dry solid) were beneficial for sludge disintegration. Using combined NaOH and ultrasonic pretreatment with the optimium parameters, the degradation efficiency of organic matter was increased from 38.0% to 50.7%, which is much higher than with ultrasonic (42.5%) or with NaOH pretreatment (43.5%) in the subsequent aerobic digestion at the same retention time.     

Combination effect of pH and acetate on enzymatic cellulose hydrolysis

The productivity and efficiency of cellulase are significant in cellulose hydrolysis. With the accumulation of volatile fatty acids (VFAs), the pH value in anaerobic digestion system is reduced. Therefore, this study will find out how the pH and the amount of acetate influence the enzymatic hydrolysis of cellulose. The effects of pH and acetate on cellulase produced from Bacillus coagulans were studied at various pH 5-8, and acetate concentrations (0-60 mmol/L). A batch kinetic model for enzymatic cellulose hydrolysis was constructed from experimental data and performed. The base hypothesis was as follows: the rates of enzymatic cellulose hydrolysis rely on pH and acetate concentration. The results showed that the suitable pH range for cellulase production and cellulose hydrolysis (represents efficiency of cellulase) was 2.6-7.5, and 5.3-8.3, respectively. Moreover, acetate in the culture medium had an effect on cellulase production (K1= 49.50 mmol/L, n=1.7) less than cellulose hydrolysis (K1=37.85 mmol/L, n=2.0). The results indicated that both the pH of suspension and acidogenic products influence the enzymatic hydrolysis of cellulose in an anaerobic environment. To enhance the cellulose hydrolysis rate, the accumulated acetate concentration should be lower than 25 mmol/L, and pH should be maintained at 7.     

水解(酸化)工艺预处理难降解有机废水应用技术分析

本文对水解(酸化)工艺进行了原理分析,论述了该工艺的优缺点,以及对后续工艺的影响.分析论述了该工艺对几种典型的难降解有机废水的降解机理.认为水解(酸化)作为难降解有机废水的预处理工艺具有很高的推广应用价值.     

基于批式呼吸计量法的溶解性COD组分划分

利用批式好氧呼吸计量法结合溶解性慢速水解COD(S_H)水解动力学拟合提出了溶解性COD(SCOD)的组分划分方案.上海2个污水处理厂进水的SCOD组分划分结果表明,A厂沉砂池出水(典型生活污水)的SCOD中含有43.5%～58.6% S_H、 21.8%～35.2%易生物降解COD(S_S)和15.4%～30.9%溶解性惰性COD(S_I); B厂沉砂池出水(长距离输送的合流制污水)SCOD中含有34.5%～45.2% S_H、 29.3%～37.7% S_S和25.6%～31.2% S_I. 9组不同水样的试验拟合结果表明,一级动力学能够很好地描述S_H的水解过程,A厂和B厂进水S_H的水解速率常数分别为28.00～39.77 d^-1和26.48～29.52 d^-1.该组分划分方案能够实现S_S积分区域的理论划分,并消除溶解性微生物产物对S_I测定的影响.     

受限空间环境压力对三元锂离子电池热失控影响*

为研究三元锂离子电池在空运低压环境中的安全性,通过自主设计搭建的封闭式变压实验舱开展相关实验,对不同荷电状态（SOC）下的三元锂离子电池在不同压力环境（101,80,60,40 kPa）下的热失控特性进行研究,采集电池热失控过程中的温度以及实验舱内的压力变化,并对热失控后实验舱内的气体成分进行分析。结果表明:三元锂离子电池热稳定性随着SOC的升高而下降,常压下100%SOC的电池热失控温度可达650.8 ℃,初始环境压力越低,相同SOC的电池热失控最高温度越低。随着环境压力的降低,相同SOC的电池在热失控后会生成更多CO,且电解液占比升高。研究结果可为锂离子电池空运安全性研究提供理论依据。     

加氢站用45 MPa高压储氢瓶式容器火烧试验模拟*

为研究加氢站用高压储氢容器在火灾下的安全性能,采用计算流体力学（CFD）方法对45 MPa高压储氢瓶式容器火烧试验过程进行模拟研究,结合气瓶火烧试验,分析高压储氢容器火灾下的热响应过程,研究不同因素对储氢容器压力泄放装置动作时间的影响。结果表明:613 s以内试验压力与模拟数据的最大相对误差为3.9%,模型误差在可接受范围;不同充装介质对安全泄放装置动作时间影响不大;不同充装压力对容器内介质压升速率影响较大,充装水平较高时压力泄放装置更快动作,较低的充装压力下容器内介质温升较快;不同环境温度对介质温升影响较小。     

Use of artificial roughness for performance enhancement of solar air heaters—a review

The performance characteristics of a solar air heater can effectively be improved by providing artificial roughness in the form of protrusions and dimples of various shapes, sizes, and orientations on the underside of heated surface. An extensive literature review on artificial roughness elements has been carried and the correlations developed for heat transfer and friction factor for roughened solar air collector have been discussed and presented in this paper. The performance parameter has also been computed and compared with various kinds and shapes of roughness geometries using correlations developed by various investigators. The optimum values of the roughness parameters obtained by several investigators have also been discussed.     

RGO/TiO2光催化降解2,4-二氯苯氧乙酸研究

通过Hummers法及紫外光/热还原工艺制得还原氧化石墨烯(RGO),采用溶胶-凝胶-煅烧法,以RGO和钛酸酊脂为前驱体制备出RGO/TiO2光催化复合材料,并利用XRD、FT-IR等对其进行了表征.对RGO/TiO2光催化降解性能的研究发现,复合光催化剂RGO/TiO2对2,4-二氯苯氧乙酸(2,4-D)的光催化降解活性显著优于纯TiO2,并且发现负载量和pH值对光催化降解性能有较大的影响:RGO/TiO2投加量为1.2g·L~(-1)、RGO负载量2%、pH为3、初始浓度为50 mg·L~(-1)反应12 h,2,4-D去除率达到98.75%;2,4-D降解率随着RGO/TiO2投加量的增大先增大后减小;RGO/TiO2对2,4-D的降解为脱氯还原和催化氧化过程,产生氯酚、苯酚等中间产物.