单轴应力对煤自燃特性参数和导热系数的影响研究

为探究单轴应力作用下煤氧化和传热特性,利用自制荷载加压煤自燃特性参数测定装置对炉体内长焰煤煤样进行程序升温。结合程序升温过程中煤临界温度Tc和Tg,对其进行阶段划分:阶段1为30℃~Tc;阶段2为Tc~Tg。计算了不同单轴应力下2个阶段煤表观活化能和平均耗氧速率。根据能量守恒得出程序升温过程煤导热系数随温度的变化,进一步分析煤导热系数与单轴应力的关系。结果表明:阶段1单轴应力为4 MPa时为临界轴压,煤表观活化能最大,平均耗氧速率最小;阶段2煤表观活化能和平均耗氧速率随单轴应力增大均呈抛物线变化,单轴应力为2.7 MPa时为临界轴压,煤表观活化能最大,平均耗氧速率最小;阶段1和2煤导热系数随温度升高均先减小后增大,并且煤导热系数随单轴应力增大呈三次函数变化。     

磷酸活化植物基活性炭对水溶液中铅的吸附

以棉秆与互花米草为原料,采用磷酸活化法制备了低成本的植物基活性炭,通过静态实验研究了其对重金属铅的吸附性能。结果表明,在活化温度为500℃、活化时间为2 h条件下,制备的棉秆和互花米草活性炭比表面积为1 570m2/g和856 m2/g,含氧酸官能团含量分别为1.43 mmol/g和1.27 mmol/g。在25℃下,两种活性炭对重金属铅的Langmuir最大吸附量分别为119 mg/g和111 mg/g,吸附最佳pH为4.3,吸附平衡符合Freundlich方程,离子交换在吸附过程中发挥了重要作用。     

珠江三角洲潮土和水稻土酸缓冲特性试验研究

珠江三角洲潮土和水稻土对不同种类的酸具有一定的缓冲性,不同种类的酸对不同类型土壤的酸化趋势不同。大旺水稻土对酸的敏感性强于龙山潮土,龙山潮土属于稍易受害的稍敏感土壤,大旺水稻土属于易受害的敏感土壤;同一土壤对酸的缓冲能力比对碱的缓冲能力强;不同种类的酸对土壤的敏感性不同,土壤对硝酸的敏感性强于对硫酸的敏感性;土壤加酸后酸缓冲曲线和土壤中铝释放曲线的交点可以作为衡量土壤对酸敏感性的指标,交点越低,敏感性越强;加酸后土壤中铝的释放可以用模型y=nx+k来预测。     

罐底含油泥热解动力学参数计算方法的优选

在化学反应设计中反应动力学是较重要的因素。为得到更合理的污泥热解动力学参数计算方法,利用热重分析仪,在氮气气氛下对罐底含油污泥的热解特性进行研究。根据热重实验数据,分别采用Coats-Redfern法、Kissinger法、FWO法和Popescu法计算污泥热解动力学参数,并获取罐底泥热解制油的主要阶段(第2阶段)的反应活化能E、频率因子A并分析各种方法反应机理。通过对比不同计算方法得到动力学参数及拟合曲线与实验曲线的相关性,确定了最佳罐底含油污泥热解动力学参数计算方法。研究表明,Popescu法得到罐底泥的热解过程符合Jander方程,活化能E为101.43 kJ/mol,与FWO法得到的91.20 kJ/mol相近,且预测曲线与实验曲线有较好的相关性(0.9816),说明Popescu法计算罐底泥热解动力学参数更合适。     

用煤矸石合成4A沸石分子筛处理氨氮废水

以煤矸石为原料,采用碱熔-水热法合成4A沸石分子筛。由于煤矸石中铝、硅主要以高岭土形式存在,其活化过程是合成4A沸石分子筛关键环节。为提高4A沸石分子筛钙离子的交换能力,增加对模拟废水氨氮的去除率,实验考察了碳酸钠与煤矸石质量比、活化温度、活化时间、晶化温度和晶化时间对4A沸石分子筛钙离子交换能力的影响,同时也考察了模拟废水的pH、4A沸石分子筛加入量及吸附时间对氨氮去除率的影响。结果表明,最佳工艺条件为,碳酸钠与煤矸石质量比为0.9、活化温度为800℃、活化时间1.5 h、晶化温度90℃和晶化时间3 h。合成4A沸石分子筛的钙离子交换能力为310 mg/g,在pH为6的100 mL模拟氨氮废水中加入6 g 4A沸石分子筛吸附40 min后,废水中氨氮的去除率达到86%。通过最佳工艺条件合成4A沸石分子筛,在处理氨氮废水方面具有一定的应用前景。     

Phenol depletion by thermally activated peroxydisulfate at 70°C

The ability of thermal activated peroxydisulfate (PS) of mineralizing phenol at 70 °C from contaminated waters is investigated. Phenol in concentrations of 10⁻⁴ to 5 × 10⁻⁴ M is quantitatively depleted by 5 × 10⁻³ to 10⁻² M activated PS in 15 min of reaction. However, mineralization of the organic carbon is not observed. Instead, an insoluble phenol polymer-type product is formed. A reaction mechanism including the formation of phenoxyl radicals and validated by computer simulations is proposed. High molecular weight phenolic products are formed by phenoxyl radical H-abstraction reactions. This is not the case for the room temperature degradation of phenol by sulfate radicals where sulfate addition to the aromatic ring mainly leads to the generation of hydroxycyclohexadienyl radicals leading to hydroxybenzenes and oxidized open chain products. Therefore, a change in the reaction mechanism is observed with increasing temperature, and thermal activation of PS at 70 °C does not lead to the mineralization of phenol. Thus PS activation at 70 °C may be considered a potential method to reduce the load of phenol in polluted waters by polymerization.     

硫酸铝渣去除水中磷研究

分别以蒸馏水和太湖水为例,研究了硫酸铝渣去除水中磷的能力,并分析了其对水体Al3+、SO24-以及pH的影响.结果表明:(1)除太湖水pH为9.0、10.0两种条件外,随着磷平衡浓度的增加,硫酸铝渣除磷量趋于某一定值,其规律符合Langmuir吸附等温式;太湖水pH为9.0、10.0两种条件下,硫酸铝渣除磷量符合Fre...     

聚硅酸锌铝的制备及其性能研究

以硅酸钠、硫酸锌、硫酸铝为原料,通过共聚法制备了无机高分子絮凝剂聚硅酸锌铝（PSZAS）,研究了Na₂SiO₃的摩尔浓度、活化时间、Al/Si、Zn/Si 配比及絮凝剂的投加量对絮凝效果的影响,用X-射线衍射（XRD）和电子扫描电镜（SEM）对该絮凝剂的结构及形貌进行了表征。结果表明：当硅酸钠的浓度为0.4 mol/L,硅酸活化时间为2 h,Si∶Al∶Zn=1∶1∶1.5,絮凝剂投加量为20 mL/L废水时,絮凝剂的电中和能力和吸附架桥能力最强,絮凝剂对含H-酸染料模拟废水的絮凝效果最好。     

Batch sorption dynamics and equilibrium for the removal of lead ions from aqueous phase using activated carbon developed from coffee residue activated with zinc chloride

Lignocellulosic materials are good precursors for the production of activated carbon. In this work, coffee residue has been used as raw material in the preparation of powder activated carbon by the method of chemical activation with zinc chloride for the sorption of Pb(II) from dilute aqueous solutions.The influence of impregnation ratio (ZnCl₂/coffee residue) on the physical and chemical properties of the prepared carbons was studied in order to optimize this parameter. The optimum experimental condition for preparing predominantly microporous activated carbons with high pore surface area (890 m²/g) and micropore volume (0.772 cm³/g) is an impregnation ratio of 100%. The developed activated carbon shows substantial capability to sorb lead(II) ions from aqueous solutions and for relative impregnation ratios of 75 and 100%, the maximum uptake is practically the same. Thus, 75% represents the optimal impregnation ratio.Batch experiments were conducted to study the effects of the main parameters such as contact time, initial concentration of Pb(II), solution pH, ionic strength and temperature. The maximum uptake of lead(II) at 25 °C was about 63 mg/g of adsorbent at pH 5.8, initial Pb(II) concentration of 10 mg/L, agitation speed of 200 rpm and ionic strength of 0.005 M. The kinetic data were fitted to the models of pseudo-first order and pseudo-second order, and follow closely the pseudo-second order model. Equilibrium sorption isotherms of Pb(II) were analyzed by the Langmuir, Freundlich and Temkin isotherm models. The Freundlich model gives a better fit than the others.Results from this study suggest that activated carbon produced from coffee residue is an effective adsorbent for the removal of lead from aqueous solutions and that ZnCl₂ is a suitable activating agent for the preparation of high-porosity carbons.     

高碱度水库水混凝过程中残留铝控制

针对高碱度水库水源的某水厂残留铝超标问题,选取碱化度(B)与Alb含量不同的3种铝盐絮凝剂,研究不同投量与pH值下混凝效果与残留铝浓度水平。结果表明,碱化度和Alb含量显著影响混凝效果。DOC和浊度的去除率随着3种絮凝剂AlCl3(B=0)、PACl-1(B=1.2)、PACl-2(B=2.2)投量增大而升高。3种絮凝剂投量在1.5～2.0 mg/L(以铝计)范围内,总铝和溶解铝含量最低。对于该水厂自制的絮凝剂PACl-2,可通过降低絮凝剂碱化度,或将水的pH值降低至7～7.5之间,以此可以提高PACl-2混凝效果,而且可以降低出厂水残留铝浓度。考虑工程应用可行性,可优先考虑调整絮凝剂生产工艺。