兰州市南山季节性土壤微生物特征及影响因素

为了探究不同季节和不同植被类型对土壤微生物分布的影响,以兰州市南山不同海拔的两种植被类型为研究对象,采用稀释涂布平板法测定了土壤微生物的季节动态变化特征.结果表明：研究区内细菌数量占微生物总数的96.22%~99.80%,远高于真菌和放线菌数量.土壤微生物类群随季节变化呈现明显差异,其总数整体表现为夏季最高,为89.22×10⁶cfu/g soil,分别是春、秋、冬季的12.02、3.28、2.74倍,其中夏季细菌数量最高,真菌与放线菌数量均在春季达到最大值.人工林样地土壤微生物数量略低于荒坡,环境因子中土壤含水量和有机碳含量高于荒坡.随着海拔的升高,pH值逐渐上升,土壤温度、有机碳与全氮含量逐渐下降,土壤微生物总数则呈现先减少后增加的趋势.相关分析表明,不同季节各微生物类群与环境因子的相关系数各有不同,春季放线菌与有机碳,秋季真菌与有机碳、全氮均呈极显著正相关（P<0.01）.冗余分析表明,环境因子中有机碳与第一物种轴的相关系数最高,为0.520,说明土壤有机碳含量是影响土壤微生物类群分布的主导因素.     

Seasonal variation and size distribution of biogenic secondary organic aerosols at urban and continental background sites of China

Size-resolved biogenic secondary organic aerosols(BSOA) derived from isoprene and monoterpene photooxidation in Qinghai Lake, Tibetan Plateau(a continental background site) and five cities of China were measured using gas chromatography/mass spectrometry(GC/MS). Concentrations of the determined BSOA are higher in the cities than in the background and are also higher in summer than in winter. Moreover, strong positive correlations(R2= 0.44–0.90) between BSOA and sulfate were found at the six sites,suggesting that anthropogenic pollution(i.e., sulfate) could enhance SOA formation,because sulfate provides a surface favorable for acid-catalyzed formation of BSOA. Size distribution measurements showed that most of the determined SOA tracers are enriched in the fine mode( 3.3 μm) except for cis-pinic and cis-pinonic acids, both presented a comparable mass in the fine and coarse( 3.3 μm) modes, respectively. Mass ratio of oxidation products derived from isoprene to those from monoterpene in the five urban regions during summer are much less than those in Qinghai Lake region. In addition, in the five urban regions relative abundances of monoterpene oxidation products to SOA are much higher than those of isoprene. Such phenomena suggest that BSOA derived from monoterpenes are more abundant than those from isoprene in Chinese urban areas.     

7B04铝合金和30CrMnSiA钢短期腐蚀的电化学行为研究

目的研究7B04铝合金和30CrMnSiA合金钢试样的电化学性能。方法采用电化学实验、扫描电子显微镜(SEM)、腐蚀坑深度测试分别对7B04铝合金和30CrMnSiA合金钢试样在是否经过天然海水浸泡的情况下进行测试分析,得到微观腐蚀形貌和腐蚀坑深度以及试样表面不带锈和带锈时的电化学性能。结果随着Na Cl浓度增大,7B04铝合金和30CrMnSiA钢的自腐蚀电流变大,两者之间存在明显的电位差,接触后会发生电偶腐蚀。电偶电流与阴阳极面积比和Na Cl浓度有关,阴阳极面积比增大或Na Cl浓度升高均会导致电偶效应增强。经过海水短期浸泡后,7B04铝合金表面的锈层不仅没有起到抑制腐蚀的作用,反而使自腐蚀加重,但电偶效应确实有所减弱。结论沿海设备在使用过程中应竭力避免铝合金在锈层下工作。     

飞机用铝合金腐蚀行为和腐蚀预测研究现状及问题分析

针对不同的航空铝合金结构及部位,从腐蚀机理、腐蚀行为和腐蚀预测技术三方面较为系统地分析了研究现状及进展。在此基础上,明确了航空铝合金腐蚀预测技术需要进一步研究的问题,分别为飞机结构表面腐蚀环境的确定问题,材料在海洋大气环境下腐蚀电化学性能的准确测量问题,腐蚀预测模型的选取问题。     

微波消解-ICP-OES联合测AZ61镁合金中Zn、Mn、Al的不确定度分析

目的研究AZ61镁合金中合金元素成分分析过程中的不确定度因素,以提高分析结果的准确性。方法采用微波消解仪消解样品,以电感耦合等离子体发射光谱仪(ICP-OES)测定AZ61镁合金中锌、锰、铝元素的含量。分析测试过程中产生不确定度的因素,并且进行评定和计算。结果采用微波消解-ICP-OES法测定镁合金中锌、锰、铝元素的含量时,测量不确定度主要由样品溶液稀释、移液枪、标准曲线以及测试的重复性引起,AZ61镁合金主要的合金成分为锌(1.1270%±0.0433%)、锰(0.1797%±0.0064%);铝(6.4468%±0.2029%)。结论对分析过程中产生的不确定度因素进行分析及评定,可以确保分析结果的可靠性以及准确性,从而更好地控制镁合金的性能,提高镁合金的装备环境适应性。     

DZ125合金HY3包覆型涂层退除研究

目的 研究化学法退除DZ125合金HY3包覆型涂层。方法 采用真空电弧镀技术（AIP）在定向凝固镍基高温合金DZ125上制备包覆型涂层HY3,利用化学方法完全退除基体上的涂层,通过失重法研究对比1#和2#退除溶液退除HY3涂层和DZ125合金的退除速率,采用扫描电镜（SEM）对退除后的HY3涂层和DZ125基体的微观组织进行观察。结果 经过100 min,2#溶液可以将20 ?m左右的HY3涂层完全退除,采用1#溶液需要超过100 min才能完全退除涂层。两种对DZ125合金的腐蚀性很小,对于同一种合金而言,1#溶液和2#溶液对合金的腐蚀速率比值为1︰13。在1#溶液中,合金与涂层腐蚀速率的比值为1︰87.65;在2#退除溶液中,合金与涂层腐蚀速率的比值为1︰6.81。结论 1#溶液更加适合退除DZ125合金上的HY3涂层。     

兰州地区大气臭氧时空变化及影响因素研究

本文采用OMI臭氧遥感数据,结合甲醛垂直柱浓度、气象数据以及经济数据,分析了2005~2015年兰州地区臭氧柱浓度时空变化格局,并探索了影响臭氧的新气象因子,总结达到臭氧污染的日照、气压等气象条件,确定影响臭氧柱浓度的主要人为源并确定其限域。结果表明:1)2005~2015年夏季柱浓度值最高,冬季、秋季次之,春季最低;夏季波动幅度最大,其余三季波动幅度较小且平稳。2)11年中,臭氧柱浓度具有较大的波动。2005年至2010年快速增长到最高值331.997 DU。2010年之后,臭氧柱浓度缓慢下降,2014年起有回升趋势。3)OMI遥感数据具有较高的可靠性,并根据AQI的线性关系划分了臭氧柱浓度的污染等级。结果指示了11年大气臭氧空间变化,2005~2009年5年间研究区全区空气质量一直处于良,2010年全区轻度污染,后两年污染逐渐减弱,2013~2015年全区恢复至良。4)根据兰州发展的趋势以及周边城市的关系,划分了兰州经济圈及功能区,并结合臭氧柱浓度空间分布图得出臭氧污染与经济特征的密切关系。5)正弦模型拟合后臭氧柱浓度变化趋势呈不明显的周期性,说明臭氧的人为来源贡献较大。6)创新探索影响臭氧污染的新气象因子(日照、气压等参数),并确定其重要人为源限域。     

铝合金的实验室盐雾试验腐蚀行为图像特征提取

目的提取铝合金材料在盐雾箱试验中可以表征腐蚀程度的表面形貌图像特征量。方法首先,对采集于表面化学清洗过的试样原始图像进行图像增强等预处理,突出腐蚀部位;其次,基于数字图像处理的分形和小波分解方法提取出分形维数和小波能量特征值。结果与以质量损失量为基础的腐蚀深度特征值进行相关性对比,基于图像分析的特征提取法的准确度和精度比较高。结论该方法可以应用于对试样的腐蚀程度进行定性和定量分析,判断并预测试样的腐蚀速度。     

Monitoring Air Quality in Mountains: Designing an Effective Network

A quantitatively robust yet parsimonious air-quality monitoring network in mountainous regions requires special attention to relevant spatial and temporal scales of measurement and inference. The design of monitoring networks should focus on the objectives required by public agencies, namely: 1) determine if some threshold has been exceeded (e.g., for regulatory purposes), and 2) identify spatial patterns and temporal trends (e.g., to protect natural resources). A short-term, multi-scale assessment to quantify spatial variability in air quality is a valuable asset in designing a network, in conjunction with an evaluation of existing data and simulation-model output. A recent assessment in Washington state (USA) quantified spatial variability in tropospheric ozone distribution ranging from a single watershed to the western third of the state. Spatial and temporal coherence in ozone exposure modified by predictable elevational relationships ( 1.3 ppbv ozone per 100 m elevation gain) extends from urban areas to the crest of the Cascade Range. This suggests that a sparse network of permanent analyzers is sufficient at all spatial scales, with the option of periodic intensive measurements to validate network design. It is imperative that agencies cooperate in the design of monitoring networks in mountainous regions to optimize data collection and financial efficiencies.     

Cumulative impact assessment in environmental planning: A coastal wetland watershed example

Several theoretical, analytical, and institutional difficulties have impeded the development and application of the assessment of cumulative environmental impacts. Watershed development on coastal wetlands offers an ideal context for evaluating the land disturbance target approach to cumulative impact assessment. A model land use planning system involving a time series approach was developed for Elkhorn Slough in California. The approach included four major components: evaluation of erosion susceptibility, measurement of land disturbance, establishment of a land disturbance target, and a comparison of existing and target land disturbance values. Further research is needed to test the transferability of the approach in a wide range of coastal watersheds and to verify the applicability of the methods to other cumulative impact problems.