热电池失效分析及等效加速贮存试验技术

目的建立基于实测环境载荷的热电池等效加速贮存试验技术,掌握其在环境载荷作用下的性能退化规律。方法在分析热电池组成和所受环境载荷情况的基础上,分析热电池的主要失效模式,设计基于实测环境数据的等效加速贮存试验,开展热电池等效加速贮存试验,分析热电池性能和热图像的变化情况,利用粒子滤波算法对电池剩余电容量进行预测。结果随加速循环次数(时间)的增加,热电池的电容量下降。热图像表明,热电池经过等效加速贮存试验后,其放电过程表面温度要高于初始放电表面温度。粒子滤波算法能够有效模拟电容量的退化过程,电池剩余电容量预测结果与试验结果误差在10%以内。结论等效加速贮存试验得到了热电池的性能退化规律,从而为热电池的贮存试验提供一种解决方案。     

滇中高原水库外源污染负荷贡献解析与环境容量核算

为探究高原型水库上游流域的污染负荷来源及其贡献率,并计算水库的水环境容量,以云南高原柴石滩水库为研究对象,应用排污系数法估算了水库上游流域污染来源,运用水文和水质同步监测资料计算入库污染负荷,采用富营养化模型核算了不同水质目标情景下水库TN和TP的最大容量.结果表明：(1)柴石滩水库及其以上流域主要特征污染物为TN和TP;(2)水库上游流域的COD和TP主要来源于农村面源污染,贡献率分别为49.40%和50.11%; NH⁺₄-N和TN主要来源于城镇生活污染,贡献率分别为45.76%和33.77%;农村面源污染贡献中,陆良县COD和TP贡献率最大,分别为34.82%和36.82%;城镇生活污染贡献中,麒麟区COD、 NH⁺₄-N、 TN和TP贡献率最大,均高达65%.(3)COD、 NH⁺₄-N、 TN和TP污染负荷入河量分别为28 050.90、2 465.16、4 680.54和870.93 t·a^-1,TN和TP污染负荷入库量分...     

A conceptual framework: Redefining forest soil's critical acid loads under a changing climate

Federal agencies of several nations have or are currently developing guidelines for critical forest soil acid loads. These guidelines are used to establish regulations designed to maintain atmospheric acid inputs below levels shown to damage forests and streams. Traditionally, when the critical soil acid load exceeds the amount of acid that the ecosystem can absorb, it is believed to potentially impair forest health. The excess over the critical soil acid load is termed the exceedance, and the larger the exceedance, the greater the risk of ecosystem damage. This definition of critical soil acid load applies to exposure of the soil to a single, long-term pollutant (i.e., acidic deposition). However, ecosystems can be simultaneously under multiple ecosystem stresses and a single critical soil acid load level may not accurately reflect ecosystem health risk when subjected to multiple, episodic environmental stress. For example, the Appalachian Mountains of western North Carolina receive some of the highest rates of acidic deposition in the eastern United States, but these levels are considered to be below the critical acid load (CAL) that would cause forest damage. However, the area experienced a moderate three-year drought from 1999 to 2002, and in 2001 red spruce (Picea rubens Sarg.) trees in the area began to die in large numbers. The initial survey indicated that the affected trees were killed by the southern pine beetle (Dendroctonus frontalis Zimm.). This insect is not normally successful at colonizing these tree species because the trees produce large amounts of oleoresin that exclude the boring beetles. Subsequent investigations revealed that long-term acid deposition may have altered red spruce forest structure and function. There is some evidence that elevated acid deposition (particularly nitrogen) reduced tree water uptake potential, oleoresin production, and caused the trees to become more susceptible to insect colonization during the drought period. While the ecosystem was not in exceedance of the CAL, long-term nitrogen deposition pre-disposed the forest to other ecological stress. In combination, insects, drought, and nitrogen ultimately combined to cause the observed forest mortality. If any one of these factors were not present, the trees would likely not have died. This paper presents a conceptual framework of the ecosystem consequences of these interactions as well as limited plot level data to support this concept. Future assessments of the use of CAL studies need to account for multiple stress impacts to better understand ecosystem response.     

大吨位预应力锚具组装件锚固性能足尺试验

广州西塔节点层系采用大直径体外预应力拉索直接对钢管柱施加楼层平面内方向的体外预应力.选取3根φ7×199的预应力锚具组装件进行了50次周期荷载试验及静载锚同性能足尺试验.采用两台YC-1350型液压千斤顶同步顶推箱梁对预应力试验索进行张拉,测定拉索的周期载荷性能、静载锚同性能、拉伸弹性模量以及极限拉力时的总应变和锚杯与锚板间相对位移,考核锚具拉伸时锚固情况、拉伸过程及卸载后锚具的变形情况.结果表明,经过50次循环加载后试验索均无断丝,破断荷载超过12151kN,其他各项指标也均符合要求,因而能保证广州西塔体外预应力设计的安全性.     

Determination of ammonium on an integrated microchip with LED-induced fluorescence detection

A simply fabricated microfluidic device integrated with a fluorescence detection system has been developed for on-line determination of ammonium in aqueous samples. A 365-nm light-emitting diode (LED) as an excitation source and a minor band pass filter were mounted into a polydimethylsiloxane (PDMS)-based microchip for the purpose of miniaturization of the entire analytical system. The ammonium sample reacted with o-phthaldialdehyde (OPA) on-chip with sodium sulfite as reducing reagent to produce a fluorescent isoindole derivative, which can emit fluorescence signal at about 425 nm when excited at 365 nm. Effects of pH, flow rate of solutions, concentrations of OPA-reagent, phosphate and sulfite salt were investigated. The calibration curve of ammonium in the range of 0.018-1.8 μupg/mL showed a good linear relationship with R² = 0.9985, and the detection limit was (S/N = 3) 3.6 × 10^-4 μupg/mL. The relative standard deviation was 2.8% (n = 11) by calculating at 0.18 μupg/mL ammonium for repeated detection. The system was applied to determine the ammonium concentration in rain and river waters, even extent to other analytes fluorescence detection by the presented device.     

Three-dimensional hydrodynamic and water quality model for TMDL development of Lake Fuxian, China

Lake Fuxian is the largest deep freshwater lake in China. Although its average water quality meets Class I of the China National Water Quality Standard (CNWQS), i.e., GB3838-2002, monitoring data indicate that the water quality approaches the Class II threshold in some areas. Thus it is urgent to reduce the watershed load through the total maximum daily load (TMDL) program. A three-dimensional hydrodynamic and water quality model was developed for Lake Fuxian, simulating flow circulation and pollutant fate and transport. The model development process consists of several steps, including grid generation, initial and boundary condition configurations, and model calibration processes. The model accurately reproduced the observed water surface elevation, spatiotemporal variations in temperature, and total nitrogen (TN), total phosphorus (TP), and chemical oxygen demand (COD) concentrations, suggesting a reasonable numerical representation of the prototype system for further TMDL analyses. The TMDL was calculated using two interpretations of the water quality standards for Class I of the CNWQS based on the maximum instantaneous surface and annual average surface water concentrations. Analysis of the first scenario indicated that the TN, TP and COD loads should be reduced by 66%, 68% and 57%, respectively. Water quality was the highest priority; however, local economic development and cost feasibility for load reduction can pose significant issues. In the second interpretation, the model results showed that, under the existing conditions, the average water quality meets the Class I standard and therefore load reduction is unnecessary. Future studies are needed to conduct risk and cost assessments for realistic decision-making.     

BAF去除氨氮关键影响因素研究

为探讨曝气生物滤池去除氨氮的关键因素,选取沈阳仙女河污水处理厂(40万t/d)现场进行实地研究。通过测定不同条件下(pH、进水COD浓度、溶解氧、温度、水力负荷)的氨氮去除率,并进行主成分分析结果显示,影响BAF工艺脱氮的关键因素是温度、溶解氧和水力负荷。当温度在14~30℃之间时,氨氮的去除率一直维持较高,当温度低于14℃时,氨氮的去除率较低;随着溶解氧浓度的增大,氨氮的去除率也随之升高,当溶解氧增加到5.6 mg/L时,氨氮的去除率达到80%~90%,接近饱和状态;在水力负荷为3.08~4.15 m3/(m.2h)之间时,氨氮的去除率上升,超过该值,则氨氮去除率下降。     

不同载体材料对厌氧氨氧化效果影响的研究

文章分别采用水性聚氨酯(WPU)和活性炭2种材料作为生物载体,在2个不同的上流式厌氧污泥床(UASB)反应器中接种包埋污泥和生物活性炭,采用人工配水进行连续实验,观测厌氧氨氧化反应器启动过程中各种含氮化合物的变化,以考察不同载体材料对厌氧氨氧化过程的影响。文章在生物活性炭反应器中成功驯化了采自污水处理厂的普通厌氧污泥,证明了从环境中驯化培养厌氧氨氧化菌的可能性。通过2个阶段中脱氮效率的比较,发现以水性聚氨酯包埋材料作为未驯化细菌载体并无明显优势,反而成为传质的障碍;而采用生物活性炭则可以迅速达到提高局部生物量、聚集功能菌、屏蔽不利环境的干扰等作用,是理想的微生物载体。     

好氧/除磷颗粒对亚硝化颗粒污泥启动的影响

在室温下,采用R1、R2、R3三组相同的SBR反应器接种污水厂回流污泥,比较了添加好氧颗粒、除磷颗粒对亚硝化颗粒污泥启动及稳定运行的影响.结果表明,在S1(0~22 d)阶段,R1、R2、R3均用了19 d启动亚硝化.在S2阶段(23~56d),R1不添加颗粒污泥,R2、R3分别添加20%好氧颗粒和20%除磷颗粒诱导亚硝化絮状污泥颗粒化,R1、R2和R3分别在76、42 d和56 d平均粒径达到412、468、400μm,均成功实现颗粒化.在S3阶段(57~108 d),进水氨氮负荷和COD负荷分别由0.4 kg·(m~3·d)~(-1)提高到0.5 kg·(m~3·d)~(-1)和0.2 kg·(m~3·d)~(-1)提高到0.5 kg·(m~3·d)~(-1),R1、R2反应器中颗粒粒径增加明显,但R3发生了污泥膨胀.在运行末期(108 d),R1和R2的平均粒径分别达到689μm和893μm.接种好氧颗粒和除磷颗粒均能快速实现亚硝化污泥的颗粒化,并且接种好氧颗粒的亚硝化颗粒污泥系统能适应较高C/N比进水,耐冲击负荷,能长期稳定运行.     

高速公路路面雨水径流下渗系统性能研究

为了分析径流下渗系统在径流削减和污染控制方面的性能,本文对一个高速公路路面雨水径流下渗系统性进行了监测.结果表明,降雨量、径流量、径流削减量和径流排放量之间存在明显的正相关性(r=0.82～0.97,p0.05).该系统表现出高效的径流削减能力,当降雨量小于20 mm时,可以削减70%以上的径流量.与径流削减相比,该系统在污染物负荷控制方面更为有效.当降雨量在0～10 mm之间时,污染负荷的削减率几乎为100%;而当降雨在10～20 mm之间时,污染负荷的削减率仍然可以超过60%.相对总氮(TN)和总磷(TP)而言,下渗系统对悬浮物(SS)和化学需氧量(COD_(Cr))的去除能力要更高、更稳定.研究表明,径流下渗系统作为雨水管理的工具,在径流削减和改善水质方面具有良好的性能.