炼油厂"三泥"离心脱水处理研究

通过对目前炼油厂“三泥”性状的调查，利用已有污泥处理设施进行了炼油厂“三泥”离心分离的现场试验，并分析了影响“三泥”离心分离处理工艺的主要因素，发现了离心机转速和絮凝剂投加量对“三泥”离心分离的有关规律和最佳操作条件，在此基础上，提出了适合炼油厂“三泥”处理系统的优化方案。     

Effect of Cross-Linking Waste Protein with Dialdehydes on Its Biodegradation Under Anaerobic Conditions

Most native polymers used in processing and application technologies are admittedly disposable from the environment in a biologic manner, but products possess low mechanical strength. One of the paths to increasing this attribute (if feasible) is their cross-linking, which may, however, affect their readiness to biodegradation. In the presented work this condition was observed on the example of waste protein (Hykol B) cross-linking by means of glutardialdehyde and glyoxal. Degree and course of cross-linking were determined through impedance spectroscopy. The objective of this work also was to obtain data for constructing a sensor capable of following the cross-linking course in real time, for potential industrial application of Hykol in continuous production. Impedance spectroscopy proved to be applicable even to this kind of material marked by considerable water content and exhibiting relatively high electric conductivity; so far it had been used only for materials of low conductivity. An aqueous environment inoculated with digested anaerobic sludge from a municipal wastewater treatment plant was selected for modeling anaerobic conditions. The relation was studied between cross-linking degree given by content of cross-linking agent (determined by impedance spectroscopy) and biodegradation degree under anaerobic conditions. It was confirmed that network density as given by quantity of added agent not only reduced breakdown degree but also slowed the course of the process. This fact is particularly obvious with cross-linking by means of glyoxal; network density is thus dependent on type of employed substance, which affect type and structure of created network. That not merely forms an obstacle during polymer swelling and dissolution but also prevents access of bacteria to source of metabolized organic carbon.     

活性灭火剂(ACP)的发展和存在的问题

介绍了活性灭火剂(ACP)的历史发展、灭火原理、配方原则、对配方要求和使用场合。可使读者对ACP获得较全面的了解。     

祁连山—河西走廊地区5级以上地震前水氡短临异常特征

在充分整理单台水氡资料的基础上,对发生在祁连山—河西走廊活动断裂系的5级以上地震进行了短临阶段水氡异常的分析研究。内容主要包括:异常出现的频次、持续时间、异常结束到发震的时间、异常的范围等。进而对该地区5级以上地震水氡短临前兆异常的特征作了归纳。     

活性污泥吸附重金属Cr6+的研究

以活性污泥为材料，采用不同时间、温度、pH进行吸附重金属Cr^6 的研究。实验结果表明，当吸附时间为15min，吸附温度为28℃，吸附pH=7时具有较好吸附效果。在此条件下，当重金属Cr^6 浓度为50mg/L，其吸附率可达97．2％。     

含油污泥固化处理后油的迁移研究

利用紫外分光光度计和索氏抽提器,研究了温度、土壤含水率以及水泥与污泥的不同比例等因素在不同时间对含油污泥固化后油迁移的影响。试验结果表明:对于强度为3.84MPa的污泥固化块,油的迁移量从240h迁移6.8mg变为480h迁移178mg,之后变化较小。在20℃～30℃时,随着温度的增加,迁移量从6.8mg增加到20.6mg,超过30℃以后迁移量的增幅变小。水泥与污泥的比例从1∶0.8增加到1∶1.4,油的迁移量从256mg降到27.2mg,之后未检测到。960h后,迁移量达到348mg,此时土壤中油含量为1.16%,在环境的自净作用下,土壤能完全容纳;强度大于9.56MPa时未检测到油。这表明用固化法处理油田含油污泥是安全可靠的。     

改进型石灰混凝法去除城市污水二级出水中有机物的研究

将石灰混凝处理后的沉淀泥渣进行回流，对石灰混凝法进行改进，研究改进后的石灰混凝法对城市污水二级出水中有机物的去除效果。结果表明，活性泥渣回流有利于提高石灰混凝法对城市污水二级出水中有机物的去除。回流位置在石灰投加前、复合絮凝剂投加后，最佳回流量为新泥渣产生量的100％～200％，活性泥渣回流的最佳pH为11．0～11．5；活性泥渣中CaCO3、Mg(OH)2、Fe(OH)3等沉淀物以及有机高分子絮体均有助于提高其对有机物的去除效果，其中Mg(OH)2沉淀物起主导作用；含循环泥渣的活性污泥回流，对有机物的去除效果无明显影响。     

Environmental assessment of supercritical water oxidation of sewage sludge

Environmental aspects of using supercritical water oxidation (SCWO) to treat sewage sludge were studied using a life cycle assessment (LCA) methodology. The system studied is the first commercial scale SCWO plant for sewage sludge in the world, treating sludge from the municipal wastewater treatment facility in Harlingen, TX, USA. The environmental impacts were evaluated using three specific environmental attributes: global warming potential (GWP), photo-oxidant creation potential (POCP) and resource depletion; as well as two single point indicators: EPS2000 and EcoIndicator99. The LCA results show that for the described process, gas-fired preheating of the sludge is the major contributor to environmental impacts, and emissions from generating electricity for pumping and for oxygen production are also important. Overall, SCWO processing of undigested sewage sludge is an environmentally attractive technology, particularly when heat is recovered from the process. Energy-conserving measures and recovery of excess oxygen from the SCWO process should be considered for improving the sustainability potential.     

气田污泥脱水工艺研究

在对气田废水处理中产生的污泥进行处理时,普遍存在着干化周期长、含水率高等问题,严重影响了废水处理装置的处理能力。脱水剂优化选择实验以及污泥脱水性能实验结果表明:先加入聚合氯化铝并搅拌15 s,再加入阴离子聚丙烯酰胺并搅拌混合30 s,最后加入FO4190SH搅拌,混合凝聚30 s后静止分层,其凝聚效果较好。在污泥脱水性能的各项指标中,真空脱水均好于重力脱水,特别是对于新鲜污泥滤层,真空(45 kPa)脱水速度比重力脱水速度约高8倍。     

稠油污水生化性处理技术研究

为了探讨稠油污水能否使用生物法处理,以生活污水和农药厂生化池原菌种经过诱导驯化,分别培养了可以在稠油污水中生长的好氧菌种革兰氏阴性菌G-1和厌氧菌种革兰氏阴性菌G-2.以G-2和G-1对稠油污水进行顺序处理,可使其BOD5/CODCr达到0.26;采用SBR法对新疆稠油污水放大处理试验的结果：COD降至150 mg/L以下,各项指标达到GB8978-1998二级排放标准.