生态工程组合工艺应用于城市污水处理厂尾水深度处理

针对城市污水处理厂尾水的特点,采用生态氧化池／垂直流人工湿地／自然湿地生态工程组合工艺对其进行深度处理,重点分析了运行效果和去除机理。数据结果表明,该工艺运行稳定,系统出水COD,BOD5,NH3-N和TP平均分别为14．4,3．4,0．84,0．19mg／L,平均去除率均在65％以上,出水水质达到《地表水环境质量标准》（GB3838-2002）中Ⅳ类标准。     

强制性内循环快速启动IC厌氧反应器过程的研究

如何在短时间内快速启动厌氧反应器是厌氧处理工程中的关键。本文对IC厌氧反应器分别进行强制性内循环启动和常规启动实验。结果表明 ,强制性内循环启动的反应器充分利用了内循环缓冲 pH和抗冲击负荷的能力 ,创造良好的微生物生长环境 ,最终只用了 5 4天就完成整个启动 ,比常规方式启动缩短近一个月 ,是一种值得借鉴的启动方式     

餐厨垃圾和剩余污泥厌氧混合发酵过程的动态膜强化特性研究

比较了厌氧动态膜生物反应器（DMBR）与完全混合式反应器（CSTR）在处理餐厨垃圾（FW）和剩余污泥（WAS）时的发酵产气过程,验证了高负荷餐厨垃圾和剩余污泥混合发酵时DMBR系统运行的稳定性,考察了动态膜（DM）基材孔径（300目、200目和100目）对DMBR运行性能及其固液分离效果的影响.结果表明：一体式DMBR能够强化餐厨垃圾和剩余污泥混合发酵的高负荷稳定运行,DMBR过膜滤液中平均总挥发性脂肪酸（TVFA）为86.1 mg·L^-1,低于CSTR排泥中TVFA的浓度（527.3 mg·L^-1）.当动态膜基材孔径为300目时,DMBR过膜滤液中总有机物（TCOD）为（1.6±1.1）g·L^-1,相应的固液分离效果优于200目（（3.2±1.9）g·L^-1）和100目（（32.0±1.3）g·L^-1）动态膜基材,即当动态膜基材孔径为100目时,DMBR过膜滤液中TCOD比300目动态膜基材高6.7倍.与200目动态膜基材孔径相比,300目动态膜基材相应的跨膜压差增长缓慢,反洗频率和运行能耗均较低,而100目动态膜基材孔径过大,固液分离效果较低.因此,在高负荷餐厨垃圾和剩余污泥混合发酵系统中,选用300目动态膜基材形成的动态膜过滤效果最优.此外,本文还对比分析了有机废物和废水处理领域中较优的动态膜基材孔径及DMBR的应用情况,为拓展DMBR在有机物处理领域的应用提供依据.     

短程硝化—厌氧氨氧化组合工艺在脱氮领域的研究进展

基于全程硝化反硝化的传统生物脱氮工艺在硝化过程中需要大量氧气供应,反硝化过程需要有机物作为碳源,存在能耗与药耗过大的问题.为了降低废水脱氮的成本,短程硝化(PN)—厌氧氨氧化(ANAMMOX)组合工艺(PNA工艺)得到了高速发展.综述了PNA工艺的影响因素,重点介绍了4种基于PN与ANAMMOX原理开发的衍生PNA工艺...     

Ⅰ Ⅱ-ASBR中厌氧颗粒污泥的微生物组成及特性

在35℃下以奶粉人工合成废水为底物连续运行了两段厌氧反应器(ⅠⅡ-ASBR),且于ⅠⅡ两柱中形成了两种不同的厌氧颗粒污泥,为了解厌氧颗粒污泥的微生态结构及生物学特性,对ⅠⅡ两柱中厌氧颗粒污泥的形态及微生物组成进行扫描电镜观察,并测定了其不同基质中的比产甲烷活性、辅酶F420和胞外多聚物的含量。结果表明:ⅠⅡ-ASBR反应器ⅠⅡ两柱中厌氧颗粒污泥形态及微生物组成差异明显,Ⅰ柱的厌氧颗粒污泥大而密实,Ⅱ柱的较小,呈多孔的网状结构,Ⅰ柱中厌氧颗粒污泥以甲烷八叠球菌、球菌及短杆菌为主,丝状菌较少,Ⅱ柱则以丝状菌、短杆菌为主,球菌较少;Ⅰ柱颗粒污泥利用葡萄糖、甲酸、丙酸的产甲烷活性较高,利用乙酸的活性相对较低,Ⅱ柱颗粒污泥利用葡萄糖、乙酸的产甲烷活性较高,而利用甲酸、丙酸的产甲烷活性较低;辅酶F420的含量Ⅱ柱比Ⅰ柱明显要高,而胞外多聚物含量Ⅰ柱比Ⅱ柱的高。     

厌氧菌对硝基苯污染河道底泥的修复研究

在厌氧条件下,以长期受硝基苯（NB）污染的化工厂排污口底泥和河道底泥混合为菌源,分离纯化出4株能厌氧降解硝基苯的细菌。其中菌株N-O在低温（10℃）条件下可以快速去除20 mg·L^-1的硝基苯。在松花江（吉林市段）底泥中分别接种10 mL·L^-1、20 mL·L^-1、30 mL·L^-1、40 mL·L^-1（菌悬液/处理溶液）N-O菌进行NB降解研究,结果表明接种30 mL·L^-1时,N-O菌对底泥中NB的降解效果明显,72h内达到了NB的完全去除;但是该菌对降解副产物苯胺（AN）几乎没有去除效果,寻求在厌氧环境下同步降解NB、AN的优势菌,将非常迫切。     

UASB反应器处理染料及印染废水的研究进展

综述了国内外UASB反应器处理染料及印染废水的研究概况.分析了UASB反应器处理废水存在的问题,并给出了相应的建议.展望了UASB反应器处理染料及印染废水的发展趋势,指出厌氧UASB-好氧法组合工艺是目前处理染料及印染废水的一种经济而有效的方法.     

炭纤维载体固定床厌氧发酵启动运行效果实验

以开发高效率、抗冲击性能强的高浓度有机废水沼气发酵技术为目的,用传统的 UASB反应器作为对照,研究了以炭纤维为生物膜载体的固定床厌氧反应器的启动运行效果。反应器进口废水 COD 为 5 000 mg/L, 水力停留时间 (HRT) 由213 h 逐步缩短为35 h,进水有机容积负荷(OLR)由0.56 kg COD/ (m³·d)提到3.45 kg COD/(m³·d)。结果表明,固定床反应器厌氧发酵的效率比对照高,出水 pH 值也比对照稳定;运行到第 50 d 时,固定床厌氧反应器和对照的 COD去除率分别由第 7 d 的36.56%和33.58%上升到87.9%和62.6%;固定床厌氧反应器的容积比产气率最高为1.16 m³/(m³·d),累计产气量为415.59 L,而对照的容积比产气率最高值仅为0.31 m³ /(m³·d),累计产气量为 71.66 L,前者最高容积比产气率和累计产气量分别是后者的3.74倍和5.78倍。固定床厌氧反应器的启动速度、COD 去除率和产甲烷效率显著地高于对照反应器。     

Prevention of an atmospheric storage tank bund failure

Secondary containment (bunds, drip trays, interceptors/sumps) is an integral part of many chemical, petrochemical, as well as agricultural, food and pharmaceutical facilities. Bunds are the built-in cases for accidental liquid substance spillage where there is a hazard that a substance could leak into the surroundings and the potential of health or environmental damage. The authors focus on the cases installed in large-volume atmospheric tanks storing hazardous chemicals in liquid form, where the bund failure occurred. In the first part of the study, a database of these accidents was created, numbering a total of 15 items. Attention was paid to the course of the accident, its causes and consequences. Several basic representative scenarios of bund failure have also been developed. The second part of the study is devoted mainly to the measures against the bund failure, such as risk assessment, technical and organizational measures. The aim of this study is to provide readers (including experts in the field of safety engineering, maintenance experts and building designers) with the information that can subsequently be used in the risk assessment of bund failure, possibly also for planning the construction of new bunds, or revitalization and maintenance of the existing ones.     

Integrated measures for preservation, restoration and improvement of the environmental conditions of the Lagoon Olho d'Água basin

The Lagoon Olho d'Água in Pernambuco State, Northeast Brazil has received increasing environmental concern due to significant stress from pollution in the catchment. The existing environmental problems are the result of great pressure from a broad range of human activities, especially in the last 10 years. Serious pollution exists mainly from some industrial and urban activities, which increased intensively after the eighties. There is a strong social and economical pressure for housing and construction near the lagoon, due to the available land nearby beaches and estuarine zone, and recently by growing tourism activities. Uncontrolled land use by low-income communities and the pressure for construction by developers have led to landfilling and to deterioration of water quality in the lagoon catchment. Improvement of the environmental conditions in the catchment needs integrated measures. Guidelines and some specific actions involving several institutions have been established and refer to sanitation and urban infrastructure as the main priorities. A main target is the construction of low-cost sewage system with smaller and decentralised treatment plants.