乳状液膜法处理煤制兰炭废水

以磷酸三丁酯(TBP)为载体、煤油为膜溶剂、NaOH水溶液为内水相,采用乳状液膜法处理兰炭废水。实验结果表明:当TBP体积分数为4%、表面活性剂质量分数为4%、内水相NaOH质量分数为12%、油内比(乳状液的油相与内水相的体积比)为3∶2、乳水比为1∶5、萃取时间为15min时,废水中的酚类(以苯酚计)去除率达到85%以上,COD去除率达83%以上。     

UASB-SBR-絮凝工艺处理地沟油制生物柴油废水

采用UASB-SBR-絮凝工艺处理地沟油制生物柴油废水,考察了各个阶段的废水处理效果。实验结果表明：UASB稳定运行阶段进水COD约为15000mg/L时,COD去除率约为87%,出水COD在2500mg/L以下,出水挥发性脂肪酸（VFA）浓度为4~6mmol/L,最佳容积负荷为15.0kg/（m3·d）;采用SBR处理UASB出水,当容积负荷为1.5kg/（m3·d）时,出水COD在200mg/L以下,COD去除率在83%以上,ρ（NH₃-N）在5mg/L以下,TP约为25mg/L。向SBR出水中加入质量分数为5%的聚合氯化铝进行化学除磷,加入量为5mL/L,处理后废水TP为4~6mg/L。处理后废水的COD,ρ（NH₃-N）,TP均达到CJ343-2010《污水排入城市下水道水质标准》的A类要求。     

Degradation of rizazole in water–sediment systems

This study investigated the degradation of rizazole in water-sediment systems (West Lake system, WL; Beijing–Hangzhou Grand Canal system, BG) with two different types of sediments under aerobic and anaerobic conditions. The half-lives of rizazole in the WL water phase (14.59–15.13 d) were similar to those in the BG water phase (15.90–16.46 d). Within 3–7 d, the rizazole concentration in the sediments reached the maximum values, i.e., equilibrium. Rizazole dissipation was faster in the WL sediment phase with higher organic matter content (T_1/2 = 18.99–19.09 d) compared with the BG sediment phase (T_1/2 = 31.08–33.32 d). Rizazole degradation was slightly faster in the West Lake water-sediment system (WL system) (T_1/2 = 17.11–18.05 d) than in the Beijing–Hangzhou Grand Canal water—sediment system (BG system) (T_1/2 = 20.51–25.02 d). The aerobic degradation of rizazole was similar to its anaerobic degradation in the water-sediment system. The findings are useful to understand the behavior of pesticide in environment.     

腐熟蓝藻与厌氧污泥混合厌氧发酵特性

采用批次小试实验对不同腐熟程度的蓝藻进行厌氧发酵产沼气实验研究。结果表明,新鲜蓝藻在30-35℃时腐熟7 d后,可在35℃的厌氧温度下获得最高的产气速率和246 mL/g COD的产气量,产气潜力为354 mL/g（VS）。厌氧反应15 d后,累计产气量、COD和VFA浓度趋于稳定。淀粉酶和脱氢酶的活性在厌氧反应初期受到抑制,蛋白酶活性和辅酶F420浓度在厌氧系统中逐渐增加,分别在第6天达到27.66μmol/（g VS·min）和第15天达到0.62μmol/g（VS）。15-18d是腐熟蓝藻适宜的中温厌氧发酵时间,少于以新鲜蓝藻为基质的厌氧消化时间。蓝藻腐熟过程促进了厌氧反应,腐熟7 d的蓝藻厌氧系统具有更高的微生物活性和产甲烷能力。     

离子交换法选择性回收污泥厌氧消化液中的磷

为探讨高效选择性回收污泥厌氧消化液中磷的离子交换方法,采用静态实验和动态实验研究了4种阴离子交换树脂（D213、D202、D301和DSQ）的磷回收性能,筛选了适合富磷污泥厌氧消化液选择性磷回收的高交换容量树脂。实验结果表明,D213、D202、D301和DSQ 4种树脂对正磷浓度为70 mg/L的厌氧消化液进行动态处理时,其最大穿透体积分别为3、7、17和90 BV;DSQ树脂磷交换容量远高于其他3种树脂,达到6 860 mg P/L湿树脂,是目前报道的高磷交换容量树脂的3~4倍;DSQ树脂能有效地抵抗厌氧消化液中有机质和硫酸根等阴离子的干扰;用NaOH溶液再生DSQ树脂并回收磷,磷洗脱率超过96%,洗脱液是高浓度含磷液,可作为磷矿石的优质替代品。研究表明,DSQ树脂是一种高效选择性分离磷的树脂,适用于污泥厌氧消化液的磷回收。     

膜电解法在线再生酸性蚀刻液及回收铜新技术

采用极化曲线法研究了酸性蚀刻液阴、阳极电化学行为,并构建了离子膜电解反应体系,考察了在线再生酸性蚀刻液及回收铜的效果。结果表明,阳极氧化过程发生浓差极化,存在极限电流密度,Cu＋含量越高,极限电流密度越大;阴极还原分4步反应进行,存在极限电流密度;强化溶液传质可有效提高阴、阳极极限电流密度,有利于避免电解过程中析出氯气和氢气;在线实验表明,通过监控阳极液ORP,可避免析出氯气;分步降低电流电解有利于避免析出氢气,形成致密的金属铜块;在电流为9～24A范围内分4步电解23．5h可再生酸性蚀刻液23．5L,同时电沉积回收510g铜,纯度高达99．98％。阴极电流效率达到95．2％,吨铜电耗3251kWh。电解过程中无氯气和氢气析出,无废液排放,表明膜电解法在线再生酸性蚀刻液具有良好的应用前景。     

昆明市污水排水系统产甲烷规律的模拟实验研究

通过对昆明市餐饮和居民生活污水厌氧模拟实验研究,初步探讨生活污水中CH4的产生规律,实验结果表明,在自然条件下,餐饮和居民生活污水中产生的甲烷浓度最大值分别为1.63 mg/L和3.82 mg/L。并且将COD、硫酸盐、硫化物、TN的浓度变化与甲烷浓度变化进行Pearson简单相关性分析,结果表明,1/COD、COD/硫酸盐和1/TN与甲烷在置信度为0.01时极显著相关,硫化物与甲烷在置信度为0.05时不相关;COD、硫酸盐和TN浓度的变化对生活污水中甲烷的产生起关键性作用。对居民生活污水中甲烷产生规律进行温度和pH控制分析研究,实验结果表明,生活污水在25~30℃时,24 h内甲烷产生量最大值为8.6494 mg/L,明显大于其他温度段的甲烷产生量;在pH为7~8之间时,甲烷的产生量在24 h内达到的最大值为3.0477 mg/L,明显高于其他pH控制段的甲烷产生量。     

深型地下土壤渗滤系统中氮的去除途径

为了系统研究氮在深型地下土壤渗滤系统中的去除途径,本次实验采用直径30cm,高200cm的有机玻璃柱模拟地下土壤渗滤系统;柱内分层装填取自北京顺义的土壤。在水力负荷为8cm／d的条件下,取得了较好的脱氮效果;氨氮去除率为99．80％;TN去除率为83．68％。通过观察氮沿土柱深度的变化规律发现,在1．30m以上的区域随着氨氮浓度的降低硝氮浓度逐渐增大,同时总氮浓度也在不断降低,约有30．55％在此区域被去除;通过氮元素质量平衡证明这部分氮是通过厌氧氨氧化反应去除的。在1．30m以下反硝化反应是脱氮的主要途径,在此过程中难降解有机物被利用。     

季节性城市生活垃圾成分分析及厌氧消化特性研究

城市生活垃圾的成分及特性随着季节和人类在不同季节的生活习惯而变化,针对我国北方城市研究了一年中不同季节的城市生活垃圾成分特点,对影响厌氧发酵过程的相关成分如总有机碳（TOC）、总氮（TN）、蛋白质、脂肪和还原糖等进行了测定分析。通过厌氧消化实验,测得不同季节城市生活垃圾pH值、日产气量、沼气甲烷含量、甲烷累积量、挥发性脂肪酸（VFAs）和氧化还原电位（ORP）等参数的变化规律,分析相应变化的影响因素。结果表明,二、三季度的含水率分别为64．81％和67．50％,高于一、四季度,一季度发酵原料中蛋白质和脂肪含量分别为12．56％和8．86％,明显高于其他3个季度。一季度甲烷累积量最高,达到17616mL,单位发酵原料的产气量为204．8mL／g,也是4个季度中最高的,说明蛋白质、脂肪等有机成分含量对厌氧发酵过程及结果影响比较明显。为进一步的城市生活垃圾厌氧消化制取生物燃气的工艺条件提供依据。     

Relationships between anaerobic consortia and removal efficiencies in an UASB reactor degrading 2,4 dichlorophenol (DCP)

To gain more insight into the interactions between anaerobic bacteria and reactor performances (chemical oxygen demand-COD, 2,4 dichlorophenol-2,4 DCP removals, volatile fatty acid-VFA, and methane gas productions) and how they depended on operational conditions the microbial variations in the anaerobic granular sludge from an upflow anaerobic sludge blanket (UASB) reactor treating 2,4 DCP was studied. The study was composed of two parts. In the first part, the numbers of methanogens and acedogens in the anaerobic granular sludge were counted at different COD removal efficiencies. The relationships between the numbers of methanogens, the methane gas production and VFA production were investigated. The COD removal efficiencies increased to 74% from 30% while the number of total acedogens decreased to 10 from 30 cfu ml(-1). The number of total methanogens and acedogens varied between 11 x 10(3) and 10 x 10(9)MPN g(-1) and 10 and 30 cfu ml(-1) as the 2,4 DCP removal efficiencies were obtained between 60% and 99%, respectively. It was seen that, as the number of total acedogens decreased, the COD removal efficiencies increased. However, the number of total methanogens increased as the COD removal efficiencies increased. Correlations between the bacterial number and with the removal efficiencies obtained in different operational conditions were investigated. From the results presented in this paper a high correlation between the number of bacteria, COD removals, methane gas percentage, 2,4 DCP removals and VFA was observed. In the second part, methanogen bacteria in the anaerobic granular sludge were identified. Microbial observations and biochemical tests were applied to identify the anaerobic microorganisms from the anaerobic granular sludge. In the reactor treating 2,4 DCP, Methanobacterium bryantii, Methanobacterium formicicum, Methanobrevibacter smithii, Methanococcus voltae, Methanosarcina mazei, Methanosarcina acetivorans, Methanogenium bourgense and Methanospirillum hungatei were identified.