Measuring the Impact of Urbanization on Channel Widths Using Historic Aerial Photographs and Modern Surveys1

Abstract: Land use in a watershed is commonly held to exert a strong influence on trunk channel form and process. Land use changes act over human time‐scales, which are short enough to measure effects on channels directly using historic aerial photographs. We show that high‐resolution topographic surveys for the channels of paired watersheds in the Lehigh Valley, Pennsylvania, are comparable, but have channel widths that have changed dramatically in the past five decades. The two watersheds, Little Lehigh Creek and Sacony Creek, are similar in most aspects except in their respective amount of urban land use. Aerial photographs of the urbanized Little Lehigh Creek show that a majority of the measured widths (67 of 85) were statistically wider in 1999 than in 1947. In contrast, the measured widths from the agricultural Sacony Creek are more evenly distributed among those that widened (18), narrowed (28), and those that were statistically unchanged (6) from 1946 to 1999. From 1946 to 1999 the only section of Sacony Creek that widened was that reach downstream of the only sizable urban area in the watershed. The current land use in Sacony Creek watershed resembles that of 1946, while the Little Lehigh Creek watershed has more than tripled its urban area. These data, in concert with other recent hydrologic data from the watersheds suggest that the increase in urban area‐generated peak discharges is the mechanism behind the widening that occurred in the Little Lehigh Creek. These wider channels can affect water quality, aquatic habitat, suspended sediment loads, and river esthetics.     

Alluvial Sedimentation and Erosion in an Urbanizing Watershed,Gwynns Falls,Maryland1

Abstract: Earlier measurements of stream channel geometry on 19 reaches were repeated to provide a longitudinal study of stream channel adjustment over 13 years (1987‐2000) in the urbanizing Gwynns Falls, Maryland watershed. We observed both enlargement and reduction in channel size, depending on the extent of upstream development, the timing and location of urbanization and upstream channel adjustment, and the presence of hydrologic constrictions and grade controls. Based on a relatively simple visual assessment of the composition, size, and extent of instream sediment storage, we categorized stream reaches into three phases: aggraded (7 sites), early erosion (7 sites), and late erosion (5 sites). Aggraded sites had point and lateral bars mantled with fine‐grained sediment and experienced some reduction in cross‐sectional area, primarily through the deposition of fine‐grained material on bars in the channel margins. Early erosion sites had smaller bars and increases in channel cross‐sectional area as a consequence of the evacuation of in‐channel fine‐grained sediment. Fine‐grained sediments were either entirely absent or found only at a few high bar elevations at late erosion sites. Sediment evacuation from late erosion sites has both enlarged and simplified channels, as demonstrated by an increase in cross‐sectional area and a strong decrease in channel width variation. Channel cross‐sectional area enlargement, reduced channel width variation, and channel incision were ubiquitous at erosion sites. As a result, overbank flows were less common in the erosion sites as determined by high water marks left by a 2‐year flood that occurred during the study period. Principal causes for channel changes appear to be increased high flow durations and reduced sediment supply. Spatial variation in channel conditions could not be tied simply to sub‐basin impervious cover or watershed area. In‐channel sediment storage is a useful indicator of channel form and adjustment. When combined with information on development and sedimentation conditions in the contributing drainage, instream sediment storage can be used to effectively assess future channel adjustments.     

SIZING OF SURFACE WATER RUNOFF DETENTION PONDS FOR WATER QUALITY IMPROVEMENT1

ABSTRACT: Historically, storm water management programs and criteria have focused on quantity issues related to flooding and drainage system design. Traditional designs were based on large rainfall‐runoff events such as those having two‐year to 100‐year return periods. While these are key criteria for management and control of peak flows, detention basin designs based on these criteria may not provide optimal quality treatment of storm runoff. As evidenced by studies performed by numerous public and private organizations, the water quality impacts of storm water runoff are primarily a function of more frequent rainfall‐runoff events rather than the less frequent events that cause peak flooding. Prior to this study there had been no detailed investigations to characterize the variability of the more frequent rainfall events on Guam. Also, there was a need to develop some criteria that could be applied by designers, developers, and agency officials in order to reduce the impact of storm water runoff on the receiving bodies. The objectives of this paper were three‐fold: (1) characterize the hourly rainfall events with respect to volume, frequency, duration, and the time between storm events; (2) evaluate the rainfall‐runoff characteristics with respect to capture volume for water quality treatment; and (3) prepare criteria for sizing and designing of storm water quality management facilities. The rainfall characterization studies have provided insight into the characteristics of rainstorms that are likely to produce non‐point source pollution in storm water runoff. By far the most significant fmdings are the development of a series of design curves that can be used in the actual sizing of storm water detention and treatment facilities. If applied correctly, these design curves could lead to a reduction of non‐point source pollution to Guam's streams, estuaries, and coastal environments.     

光助氧化技术在水处理中应用

对UV／H2O2技术、UV／O3技术、UV／O3／H2O2技术、photo—Fenton技术以及UV／TiO2技术进行了总结,对不同技术的原理、研究进展及应用进行了评述,并对今后光助氧化技术的研究方向提出了一些建议。     

Degradation of duloxetine: Identification of transformation products by UHPLC-ESI(+)-HRMS/MS, in silico toxicity and wastewater analysis

Duloxetine (DUL), an antidepressant drug, has been detected in surface water and wastewater effluents, however, there is little information on the formation of its transformation products (TPs). In this work, hydrolysis, photodegradation (UV irradiation) and chlorination experiments were performed on spiked distillated water, under controlled experimental conditions to simulate abiotic processes that can occur in the environment and wastewater treatment plants (WWTPs). Eleven TPs, nine from reaction with UV light and two from chlorine contact, were formed and detected by ultra-high performance liquid chromatography coupled to quadrupole time-of-flight mass spectrometry, and nine of them had their chemical structures elucidated upon analyses of their fragmentation patterns in MS/MS spectra. The formation and degradation of the TPs were observed. The parent compound was completely degraded after 30?min in photodegradation and after 24?hr in chlorination. Almost all TPs were completely degraded in the experiments. The ecotoxicity and mutagenicity of the TPs were predicted based on several in silico models and it was found that a few of these products presented more ecotoxicity than DUL itself and six TPs showed positive mutagenicity. Finally, wastewater samples were analyzed and DUL and one TP, possibly formed by chlorination process, were detected in the effluent, which showed that WWTP not only did not remove DUL, but also formed a TP.     

Ergonomics Oriented to Processes Becomes a Tool for Continuous Improvement

Abstract

A holistic view is essential for quality initiatives such as Total Quality Management (TQM), Standard No. ISO 9001:1994 (International Organization for Standardization [ISO], 1994), Concurrent Engineering, Business Reengineering, and Business Process Improvement. The challenge is knowing how to transition from this theoretical concept to implementation. The relationship between quality interest and anergonomics program will be the focus of this discussion. An ergonomics oriented improvement program includes (a) ergonomics or fitting the job to the person; (b) integration of operations management, safety engineering, medical management, and employees as co-owners of the process; (c) the emphasis of ergonomic precepts in the engineering of new processes and improvement of current processes; and (d) the emphasis of employees taking responsibility for their own well being and the improvement of their work environment. The parallel between the continuous improvement process delineated by the quality-system requirements in Standard No. ISO 9001:1994 (ISO, 1994) and the improvement contributions of ergonomics are very revealing (Getty, Abbott, & Getty, 1995). It is the contention of this approach that if the precepts of ergonomics were applied to the work environment, it would support the objective of world class quality and productivity, resulting in improved global competitiveness of businesses.     

A Two‐Decade Watershed Approach to Stream Restoration Log Jam Design and Stream Recovery Monitoring: Finney Creek,Washington

A federal, state, and private partnership leveraged resources and employed a long‐term, systematic approach to improve aquatic habitat degraded by decades of intensive forest management in Finney Creek, a tributary to the Skagit River of Northwest Washington State. After more than a decade of work to reduce sediment sources and the risk of landslides within the watershed, log jam installation commenced in 1999 and progressed downstream through 2010. Log jam design was adapted as experience was gained. A total of 181 log jams, including 60 floating log ballasted jams, were constructed along 12 km of channel. The goal was to alter hydraulic processes that affect aquatic habitat formation along 39 km of stream with emphasis on 18.5 km of lower Finney Creek. Aquatic habitat surveys over a five‐year period show an increase in the area of large pools and an accompanying increase in residual and maximum pool depth in the lower river reach. Channel cross sections show a generally deeper channel at the log jams, better channel definition in the gravel deposits at the head of the log jams, and improved riffle and thalweg development below the log jams. Stream temperature in the upper river decreased by 1.0°F in the first three years, and 1.1°F in the lowest treated reach over nine years. There is a trend of less stream heating over the restoration time period. Photo points show that riparian vegetation is recolonizing gravel bars.     

不同污水处理工艺中全氟和多氟烷基物质的来源、去除效率及生态风险

使用固相萃取-超高效液相色谱串联质谱法,测定广西3个污水处理厂（P1、P2、P3）中17种全氟和多氟烷基物质（PFASs）。结果显示,共检测出10种PFASs,检出率为33.3%～100%。进、出水中PFASs质量浓度分别为32.0～86.4和23.0～39.6 ng/L。全氟丁烷磺酸（PFBA）、全氟戊酸（PFPeA）和全氟辛酸（PFOA）是进、出水中的主要污染物。厌氧-缺氧-好氧（AAO）工艺对PFASs的去除率为49.0%;改良型序批反应器（MSBR）工艺对PFASs的去除率为72.2%,氧化沟工艺对PFASs的去除率为25.0%。P1和P3进水中的PFASs主要来源于生活污水,P2进水中的PFASs来源包括生活污水和工业废水。P1出水中的全氟十二烷酸（PFDoDA）对纳污河流的鱼类和水蚤构成高生态风险,对藻类构成中等生态风险,P2和P3出水对纳污河流构成的生态风险较低。