固体厌氧消化原料流变特性研究综述

厌氧消化原料的流变特性是厌氧消化工艺设计和运行的重要参数。本文从研究对象、实验操作、研究内容和结果、影响因素以及发展方向等方面对固体厌氧消化原料,特别是污泥的流变特性研究现状进行了概述。研究表明,污泥来源广泛,成分复杂,属于非牛顿流体的范畴,其流变特性受多种因素影响,其中污泥的总悬浮固体(TSS)(或混合液悬浮固体(MLSS))和温度是最主要的影响因素。大部分研究采用层流剪切实验对物料的流变特性进行表征,研究对象范围有待于扩大。尚需针对流体本构方程的改进,共消化对于原料流变特性的影响,混合液固、液相指标与流变参数的关系等方面开展研究,为利用流变参数作为工艺控制参数提供理论依据,并解决工程放大等问题。     

衡山PM_（2.5）中痕量金属元素的分析

建立了微波消解-电感耦合等离子体质谱法同时测定PM2.5中12种痕量金属元素的方法。对不同消解体系进行了讨论,确定采用HNO3＋H2O2消解体系。方法检出限在0.01～6.4 ng/m3之间,精密度为0.5%～8.9%,加标回收率在69.2%～92.6%之间。应用该方法测定了衡山PM2.5中痕量金属元素的含量,讨论了痕量元素的浓度分布特征,对各元素进行了相关性分析,并应用富集因子法对来源进行了分析。     

无汞开管法快速测定工业废水中的COD

文章对化学需氧量的几种测定方法进行对比,研究了无汞开管法快速测定方法的实验条件与干扰因素,并与标准方法进行对照,总结出炼油废水应用无汞开管法监测COD的适用范围与注意事项,可供同类企业应用该方法时借鉴。     

Effects of bed materials on the performance of an anaerobic sequencing batch biofilm reactor treating domestic sewage

The objective of this study was to determine the best performance of an anaerobic sequencing batch biofilm reactor (AnSBBR) based on the use of four different bed materials as support for biomass immobilization. The bed materials utilized were polyurethane foam (PU), vegetal carbon (VC), synthetic pumice (SP), and recycled low-density polyethylene (PE). The AnSBBR, with a total volume of 7.2L, was operated in 8-h batch cycles over 10 months, and fed with domestic sewage with an average influent chemical oxygen demand (COD) of 358+/-110mg/L. The average effluent COD values were 121+/-31, 208+/-54, 233+/-52, and 227+/-51mg/L, for PU, VC, SP, and PE, respectively. A modified first-order kinetic model was adjusted to temporal profiles of COD during a batch cycle, and the apparent kinetic constants were 0.52+/-0.05, 0.37+/-0.05, 0.80+/-0.04, and 0.30+/-0.02h(-1) for PU, VC, SP, and PE, respectively. Specific substrate utilization rates of 1.08, 0.11, and 0.86mg COD/mgVS day were obtained for PU, VC, and PE, respectively. Although SP yielded the highest kinetic coefficient, PU was considered the best support, since SP presented loss of chemical constituents during the reactor's operational phase. In addition, findings on the microbial community were associated with the reactor's performance data. Although PE did not show a satisfactory performance, an interesting microbial diversity was found on its surface. Based on the morphology and denaturing gradient gel electrophoresis (DGGE) results, PE showed the best capacity for promoting the attachment of methanogenic organisms, and is therefore a material that merits further analysis. PU was considered the most suitable material showing the best performance in terms of efficiency of solids and COD removal.     

餐厨垃圾厌氧消化中硬脂酸钙的形成及作用

在稳定运行的餐厨垃圾单相厌氧消化体系中,出现白色颗粒状物质,且随着负荷的提高,其数量和粒径不断增加。利用能谱技术分析白色颗粒的元素组成,结合傅里叶红外光谱和13C核磁共振技术分析白色颗粒中的官能基团。经过研究分析认为,该白色颗粒的主要成分为长链羧酸钙盐,具体为硬脂酸钙。同时,对其形成过程进行了分析。该物质的形成对餐厨垃圾中油脂的去除提供了新的思路和途径。     

Enhancement of thermophilic anaerobic digestion of thickened waste activated sludge by combined microwave and alkaline pretreatment

Pretreatment of thickened waste activated sludge (TWAS) by combined microwave and alkaline pretreatment (MAP) was studied to improve thermophilic anaerobic digestion efficiency. Uniform design was applied to determine the combination of target temperature (110–210°C), microwave holding time (1–51 min), and NaOH dose (0–2.5 g NaOH/g suspended solids (SS)) in terms of their effect on volatile suspended solids (VSS) solubilization. Maximum solubilization ratio (85.1%) of VSS was observed at 210°C with 0.2 g-NaOH/g-SS and 35 min holding time. The effects of 12 different pretreatment methods were investigated in 28 thermophilic batch reactors by monitoring cumulative methane production (CMP). Improvements in methane production in the TWAS were directly related to the microwave and alkaline pretreatment of the sludge. The highest CMP was a 27% improvement over the control. In spite of the increase in soluble chemical oxygen demand concentration and the decrease in dewaterability of digested sludge, a semi-continuous thermophilic reactor fed with pretreated TWAS without neutralization (at 170°C with 1 min holding time and 0.05 g NaOH/g SS) was stable and functioned well, with volatile solid (VS) and total chemical oxygen demand (TCOD) reductions of 28% and 18%, respectively, which were higher than those of the control system. Additionally, methane yields (L@STP/g-CODadded, at standard temperature and pressure (STP) conditions of 0°C and 101.325 kPa) and (L@STP/g VSadded) increased by 17% and 13%, respectively, compared to the control reactor.     

Effects of free ammonia on volatile fatty acid accumulation and process performance in the anaerobic digestion of two typical bio-wastes

The effect of free ammonia on volatile fatty acid(VFA)accumulation and process instability was studied using a lab-scale anaerobic digester fed by two typical bio-wastes:fruit and vegetable waste(FVW)and food waste(FW)at 35°C with an organic loading rate(OLR)of 3.0 kg VS/(m~3·day). The inhibitory effects of free ammonia on methanogenesis were observed due to the low C/N ratio of each substrate(15.6 and 17.2,respectively). A high concentration of free ammonia inhibited methanogenesis resulting in the accumulation of VFAs and a low methane yield. In the inhibited state,acetate accumulated more quickly than propionate and was the main type of accumulated VFA. The co-accumulation of ammonia and VFAs led to an "inhibited steady state" and the ammonia was the main inhibitory substance that triggered the process perturbation. By statistical significance test and VFA fluctuation ratio analysis,the free ammonia inhibition threshold was identified as 45 mg/L. Moreover,propionate,iso-butyrate and valerate were determined to be the three most sensitive VFA parameters that were subject to ammonia inhibition.     

有机废物厌氧消化工艺应用现状及前景展望

与其他常规处理方法相比,利用厌氧消化技术处理有机废物更具有优嚏,因为它不仅可以有效减少污省染,还可以产生很好的经济效益和巨大的环境效益。简要介绍了厌氧消化技术的机理、影响因素、类型,以及在有机废物处理领域的应用现状,并重点介绍了国外近年来发展形成的典型厌氧消化工艺,同时分析了厌氧消化技术在有机废物资源化处理领域的广阔应用前景。     

餐厨垃圾厌氧消化运行试验研究

采用猪粪厌氧消化的消化污泥为接种物,在中温(37℃)条件下,以连续进料的方式对餐厨垃圾的湿式厌氧消化进行了启动以及运行试验,监测整个实验过程中产气量、pH、VFA、碱度等能够反映厌氧消化的系统指标。结果表明:本实验中系统最佳有机负荷为2.8 kg/(m~3·d)(以VS计),超过此负荷后,依靠系统自身恢复和人工调节,pH很难恢复正常运行状态。正常运行过程中,pH稳定在7.5~8.0,VFA稳定在2 000 mg/L左右,碱度在6 000~9 000 mg/L,氨氮在1 500~2 000 mg/L,底物含水率为96%~98%。系统超负荷运行后,产气量和pH下降,VFA浓度上升,碱度、氨氮、含水率基本保持稳定。     

ABR处理硫酸盐有机废水的相分离特性研究

为了考察厌氧折流板反应器(ABR)处理含硫酸盐有机废水的相分离特性,采用有效容积为32L的五隔室ABR,通过为期132d的启动试验,研究了启动运行过程中各隔室COD和SO24-降解情况、VFA和S2-分布规律及颗粒污泥微生物相变化状况.结果表明,采用低负荷低增幅方式启动,在132d内成功启动ABR并达到稳定,COD和SO24-的负荷分别由1.5kg·(m3·d)-1逐渐提高到3.3kg·(m3·d-1)和由0.07kg·(m3·d-1)逐渐提高到0.18kg·(m3·d-1),COD和SO24-的去除率分别为95%和85%左右.各隔室COD沿程呈递减趋势,其去除主要由第1、4、5隔室完成,SO42-的去除主要由前面三隔室承担,前面三隔室的VFA和S2-浓度较高,到最后两隔室则急剧降低;随负荷的增加,承担COD及SO42-主要去除作用的隔室后移,前面三隔室的VFA和S2-最高点及最后两隔室的VFA和S2-的急剧降低位置也后移;各隔室的微生物经长期运行驯化后表现出良好的种群配合和高度的特异性,具有明显的产酸相与产甲烷相、硫酸盐还原相与硫单质生成相的分离特征.