不同流态下微波辐射对污水污泥性质的影响研究

通过对不同流态下微波辐射对污水污泥性质的影响进行研究,考察了不同流态下微波辐射作用处理后污泥沉降性能、脱水性能的变化,以及微波辐射作用下流态对污泥挥发性悬浮固体(VSS)溶解率、上清液中COD和污泥微观形态的影响.结果表明,流态对污泥的沉降性能和脱水性能有一定影响,微波辐射功率越高,流态对污泥沉降性能和脱水性能的影响越显著.微波辐射功率较低时,雷诺数Re越大,污泥的沉降比(SV)、比阻和泥饼含水率越小;微波辐射功率较高时,Re为2300的临界流态下污泥的沉降性能和脱水性能最好.随着Re的增大,VSS溶解率和上清液中COD升高,微波辐射功率分别为300、500、700和900W时,Re为3000的紊流流态下上清液中COD分别达到1.1、2.1、3.6和6.7g·L-1.SEM观察结果表明,微波辐射及流态产生的协同剪切应时适宜时,有利于污泥颗粒的絮凝反应,高强度的微波辐射和紊流产生的较大剪切应力导致污泥絮体被打碎.     

剩余污泥中木质纤维素稳定并转化能源可行性分析

剩余污泥中往往含有大量木质纤维素物质,在厌氧消化过程中难以降解,最终被浓缩于熟污泥中,这就是导致污泥有机物稳定并转化能源效率低下的主要原因之一.本文分析了剩余污泥中木质纤维素的含量与来源;阐述了木质纤维素的结构特点以及对其生物降解的关键技术所在;揭示了污泥常规预处理与木质纤维素预处理存在工艺条件不同的相似技术.文章结合两种预处理技术的特点和工艺条件,从原理、技术等角度分析了通过强化剩余污泥预处理而同时达到破解木质纤维素的技术思路.为此,提出了将污泥细胞破碎与木质纤维素破解耦合的观点,以期将污泥中木质纤维素的稳定与能源转化合二为一,从而构建木质纤维素稳定化、能源化与碳减排三位一体的技术策略     

活性污泥絮体的分形结构分析

通过小角光散射(small-angle light scattering,SALS)实验确定出活性污泥絮体的分形区域,对絮体粒径分布进行了拟合分析,采用原子力显微镜(AFM)和激光共聚焦扫描显微镜(CLSM)对絮体在不同尺度下的形貌进行了观测.结果显示,污泥絮体是由一系列的絮团结合而成,絮体表面凹凸不平,有各种"孔洞","缝隙",絮体内部存在一系列的孔隙.较大尺度的絮体同时存在多种孔道结构,构成絮体中营养物和水流的运输通道;污泥絮体在0.5～50μm之间具有明显的分形结构,表明活性污泥絮体在较小的粒径时已经具有一定的分形特征,活性污泥的粒度分布属于Gamma分布方式,证明污泥絮体的成长过程是一种絮团-絮团的凝聚过程.     

聚磷污泥去除高浓度铅的影响因素研究

利用聚磷活性污泥去除废水中的铅[ρ(Pb2+)=150.0 mg·L-1],研究了反应体系内不同溶解氧状况和初始pH值对污泥除铅的效率和稳定性的影响.结果表明,厌氧条件下,pH 6时,铅的去除率随时间增长呈上升趋势,32 d后铅去除率达99.8%,其中有机物及硫化物结合态铅、残渣态分别占41.8%和52.6%,污泥中铅的稳定性良好.好氧条件下,在相对较短时间内铅的去除率随pH上升而增加,反应2 h时,pH 6、pH 4和pH 2对应的铅的去除率分别为99.9%、96.9%和30.3%;而好氧32 d后pH 6、pH 4和pH 2的污泥中残渣态铅含量分别为3 072.3、4 726.8和2 359.1 mg·kg-1,分别占污泥中总铅的41.8%、65.8%和88.8%.综合考虑除铅率和除铅后污泥稳定性,好氧且pH 4理论上是聚磷污泥除铅的最佳条件.     

Cost-performance analysis of nutrient removal in a full-scale oxidation ditch process based on kinetic modeling

A full-scale oxidation ditch process for treating sewage was simulated with the ASM2d model and optimized for minimal cost with acceptable performance in terms of ammonium and phosphorus removal. A unified index was introduced by integrating operational costs (aeration energy and sludge production) with effluent violations for performance evaluation. Scenario analysis showed that,in comparison with the baseline (all of the 9 aerators activated), the strategy of activating 5 aerators could save aeration energy significantly with an ammonium violation below 10%. Sludge discharge scenario analysis showed that a sludge discharge flow of 250–300 m3/day (solid retention time (SRT), 13–15 days) was appropriate for the enhancement of phosphorus removal without excessive sludge production. The proposed optimal control strategy was: activating 5 rotating disks operated with a mode of "111100100" ( "1"represents activation and "0" represents inactivation) for aeration and sludge discharge flow of 200 m3/day (SRT, 19 days). Compared with the baseline, this strategy could achieve ammonium violation below 10% and TP violation below 30% with substantial reduction of aeration energy cost (46%) and minimal increment of sludge production (< 2%). This study provides a useful approach for the optimization of process operation and control.     

Biodegradation of 2-methylquinoline by Enterobacter aerogenes TJ-D isolated from activated sludge

Bacterial strain Enterobacter aerogenes TJ-D capable of utilizing 2-methylquinoline as the sole carbon and energy source was isolated from acclimated activated sludge under denitrifying conditions. The ability to degrade 2-methylquinoline by E. aerogenes TJ-D was investigated under denitrifying conditions. Under optimal conditions of temperature (35℃) and initial pH 7, 2-methylquinoline of 100 mg/L was degraded within 176 hr. The degradation of 2-methylquinoline by E. aerogenes TJ-D could be well described by the Haldane model (R² > 0.91). During the degradation period of 2-methylquinoline (initial concentration 100 mg/L), nitrate was almost completely consumed (the removal efficiency was 98.5%), while nitrite remained at low concentration (< 0.62 mg/L) during the whole denitrification period. 1,2,3,4-Tetrahydro-2-methylquinoline, 4-ethyl-benzenamine, N-butyl-benzenamine, N-ethyl-benzenamine and 2,6-diethyl-benzenamine were metabolites produced during the degradation. The degradation pathway of 2-methylquinoline by E. aerogenes TJ-D was proposed. 2-Methylquinoline is initially hydroxylated at C-4 to form 2-methyl-4-hydroxy-quinoline, and then forms 2-methyl-4-quinolinol as a result of tautomerism. Hydrogenation of the heterocyclic ring at positions 2 and 3 produces 2,3-dihydro-2-methyl-4-quinolinol. The carbon-carbon bond at position 2 and 3 in the heterocyclic ring may cleave and form 2-ethyl-N-ethyl-benzenamine. Tautomerism may result in the formation of 2,6-diethyl-benzenamine and N-butyl-benzenamine. 4-Ethyl-benzenamine and N-ethyl-benzenamine were produced as a result of losing one ethyl group from the above molecules.     

三槽氧化沟内底推位置与积泥厚度的分析研究

氧化沟工艺由于进水中含有大量的无机颗粒,无机颗粒的沉淀导致沟内积泥较厚。为了不影响正常生产,依据经验数据,依次对1号、2号氧化沟安装底推。对沟内积泥情况及影响因素进行分析比较,得出氧化沟的积泥主要由进水中密度较大的无机颗粒造成,且积泥规律与底推安装位置和运行情况相关。     

Differences in rheological and fractal properties of conditioned and raw sewage sludge

Rheological tests for raw and conditioned activated sludge(AS) or anaerobic digested sludge(ADS) show that power-law relationships can be used to describe the evolution of several rheological parameters,i.e.,limiting viscosity(η∞),yield stress(τy),cohesion energy of the sludge network(Ec),and storage modulus(G’),with total suspended solid(TSS) content in raw and conditioned sludge.A gel-like structure that behaves similar to weak-link flocs/aggregates was observed in AS and ADS.As derived from the double-logarithmic plots of G’-TSS content,the mass fractal dimensions of the raw and conditioned AS or ADS flocs/aggregates were 2.70 and 2.53 or 2.85 and 2.79,respectively.The rheological tests also indicate that both polymer conditioning and increased TSS content led to improved elastic behavior,cohesion energy,and yield stress of the sludge network,as well as expanded the corresponding linear viscoelastic range.The porosity of AS or ADS flocs/aggregates will be improved by polymer conditioning.     

活化温度对SCAC制备过程中副产物生成规律的影响

文章研究了污泥-玉米芯活性炭(SCAC)制备过程中,活化温度对副产物(热解气和热解油)生成规律的影响。热解气和热解油分别采用气相色谱仪和气质联用仪进行分析检测。试验结果表明,随着活化温度的升高,SCAC的产量逐渐降低,热解气与热解油的产量则随之增多。不同温度条件下,热解气的主要成分均为H2和CO2,热解气中H2所占的体积百分数随着活化温度的升高而增加,而CO2则相应降低。此外,热解气中CH4的含量也会随着活化温度的上升而略有提高,说明较高的活化温度更有利于热解气的资源利用。热解油组分较为复杂,每个温度条件下的液态产物都包括上百种化合物,可分为烷烃,烯烃,苯类,酚类,腈类,杂环化合物,多环芳烃,有机酸,酰胺,酯类,甾体,醇,酮以及其他类共14大类型,其中以有机酸、腈类和甾体类有机物含量居多。随着活化温度的升高,有机酸和多环芳烃的含量有所增加,而酚类化合物的含量则有所降低;当活化温度升高至650℃以上时,甾体类有机物含量明显降低。     

原子吸收火焰法次灵敏线测定污水和电镀污泥中高含量的锌

对采用原子吸收火焰法次灵敏线测定污水和电镀污泥中高含量的锌进行了研究。试验结果表明：在锌浓度50．0～600．0mg/L之间,溶液锌含量与吸光度呈线性关系。线性回归方程为y＝0．000661x-0．0007,相关系数γ＝0．9998。方法检出限为25．0mg/L,相对标准误差（RSD）＜2．96％,加标回收率为92．5％～105％,与标准法的相对误差＜2．76％。